Nobuyuki Matsumoto
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Nobuyuki Matsumoto has a total of 17 co-authors. Here are the top co-authors by number of shared publications:
- Jonathan S. Lindsey
Department of Chemistry, North Carolina State University, Raleigh, NC 27695-8204, USA
3 shared publications - Ippei Takashima
Laboratory of Bioorganic & Natural Products Chemistry, Kobe Pharmaceutical University, 4-19-1, Motoyamakita, Higashinada, Kobe, Hyogo 658-8558, Japan
2 shared publications - Zhiyuan Wu
Oncurie, Inc., Raleigh, NC 27608, USA
2 shared publications - Akira Takagi
Laboratory of Bioorganic & Natural Products Chemistry, Kobe Pharmaceutical University, 4-19-1, Motoyamakita, Higashinada, Kobe, Hyogo 658-8558, Japan
1 shared publication - Haoyu Jing
Department of Chemistry, North Carolina State University, Raleigh, NC 27695-8204, USA
1 shared publication - Hikaru Fujita
Faculty of Pharmaceutical Sciences, Institute of Medical, Pharmaceutical, and Health Sciences, Kanazawa University, Kakuma-machi, Kanazawa 920-1192, Japan
1 shared publication
Latest Publications
- Open Access
- 23 August 2023
- Published by World Scientific Pub Co Pte Ltd in Journal of Porphyrins and Phthalocyanines
- Vol. 27 (11) , 1502-1551
Bacteriochlorin syntheses - Status, problems, and exploration
Bacteriochlorins – Nature’s near-infrared (NIR) chromophores – are distinguished by an intense ([ ] ∼;105 M[ ]cm[ ] long-wavelength absorption band in the ∼;700–1000 nm. The development of routes to prepare synthetic, tailorable bacteriochlorins holds promise for multiple disciplines where NIR-light-promoted photoactivity is of interest. A de novo route to bacteriochlorins equipped with a stabilizing gem-dimethyl group in each pyrroline ring was discovered in 2003. Continued development in this arena over 20 years has led to additional routes as well as methods to install substituents at selected positions about the perimeter of the macrocycle. The present paper reports studies that highlight substantial limitations of existing synthetic routes, including stymied access to multi-bacteriochlorin arrays and the inability to install (in a rational way) distinct groups at opposite sides of the macrocycle. The origins of the limitations are traced to particular stages of the chemistry ranging from derivatizing pyrroles, creating pyrrolines, constructing and elaborating dihydrodipyrrins, coupling dihydrodipyrrins, and forming macrocycles. Through exploration of a dozen aspects of bacteriochlorin syntheses, 60 new compounds (and nine known compounds via improved syntheses) have been prepared and characterized; the data include 20 single-crystal X-ray diffraction analyses. The research taken together points to areas of focus to fulfill the promise of this fascinating class of compounds.
- 23 August 2023
- Published by World Scientific Pub Co Pte Ltd in Journal of Porphyrins and Phthalocyanines
- Vol. 27 (11) , 1502-1551
Open AccessBacteriochlorin syntheses - Status, problems, and exploration
Bacteriochlorins – Nature’s near-infrared (NIR) chromophores – are distinguished by an intense ([ ] ∼;105 M[ ]cm[ ] long-wavelength absorption band in the ∼;700–1000 nm. The development of routes to prepare synthetic, tailorable bacteriochlorins holds promise for multiple disciplines where NIR-light-promoted photoactivity is of interest. A de novo route to bacteriochlorins equipped with a stabilizing gem-dimethyl group in each pyrroline ring was discovered in 2003. Continued development in this arena over 20 years has led to additional routes as well as methods to install substituents at selected positions about the perimeter of the macrocycle. The present paper reports studies that highlight substantial limitations of existing synthetic routes, including stymied access to multi-bacteriochlorin arrays and the inability to install (in a rational way) distinct groups at opposite sides of the macrocycle. The origins of the limitations are traced to particular stages of the chemistry ranging from derivatizing pyrroles, creating pyrrolines, constructing and elaborating dihydrodipyrrins, coupling dihydrodipyrrins, and forming macrocycles. Through exploration of a dozen aspects of bacteriochlorin syntheses, 60 new compounds (and nine known compounds via improved syntheses) have been prepared and characterized; the data include 20 single-crystal X-ray diffraction analyses. The research taken together points to areas of focus to fulfill the promise of this fascinating class of compounds.
- 6 October 2020
- Published by Royal Society of Chemistry (RSC) in Chemical Communications
- Vol. 56 (87) , 13327-13330
A fluorogenic probe using a catalytic reaction for the detection of trace intracellular zinc
A reaction-based fluorescent probe with cephem scaffold has been applied for signal amplification system to detect trace intracellular zinc.
- 6 October 2020
- Published by Royal Society of Chemistry (RSC) in Chemical Communications
- Vol. 56 (87) , 13327-13330
A fluorogenic probe using a catalytic reaction for the detection of trace intracellular zinc
A reaction-based fluorescent probe with cephem scaffold has been applied for signal amplification system to detect trace intracellular zinc.
- 12 August 2020
- Published by Royal Society of Chemistry (RSC) in New Journal of Chemistry
- Vol. 44 (33) , 14266-14277
Engineering of an archaeal phosphodiesterase to trigger aggregation-induced emission (AIE) of synthetic substrates
Aggregation-induced emission (AIE) probes that can be triggered by enzymatic activity are sought for applications across the life sciences. The compound 2-(2-hydroxyphenyl)benzothiazole (HBT) is non-fluorescent in solution but exhibits AIE. To adapt HBT for potential clinical applications, two phosphoester derivatives (1 and 2) were prepared. For extension to molecular brachytherapy (delivery of a radionuclide), one phosphoester derivative (3) was prepared wherein a bromine atom is incorporated as a site for subsequent radioiodide substitution. Each probe 1–3 requires phosphatase action to engender AIE. For specificity in diagnostic and therapeutic applications, a heterologous (i.e., foreign to humans) enzyme was sought for conversion of 1–3 from aqueous-soluble to aqueous-insoluble form. Here, an archaeal phosphodiesterase PDE-MJ0936 (wild-type) was systematically engineered for activity toward 1–3. PDE-MJ0936 is a hyperthermal enzyme (activity at 70 °C and pH 9.8) and exists as a dimer, which together limit life science applications. Ten PDE mutants were engineered by site-directed mutagenesis to achieve a monomeric structure, wider substrate scope, and elastic substrate docking under physiological conditions. Among the mutants, PDE-C141D exhibited efficient activity towards bis(4-nitrophenyl)phosphate (Km = 0.28 mM, kcat = 3.0 s−1 and kcat/Km = 1.1 × 104 M−1 s−1) and efficiently hydrolyzed 3 at 37 °C and pH 7.0, conditions under which PDE-MJ0936 is silent. The substrates 1–3 are relatively resistant to alkaline phosphatase, PDE-MJ0936 and fetal bovine serum. The development of enzymatically triggered substrates and the complementary heterologous enzymes may support diverse applications in the life sciences.
- 12 August 2020
- Published by Royal Society of Chemistry (RSC) in New Journal of Chemistry
- Vol. 44 (33) , 14266-14277
Engineering of an archaeal phosphodiesterase to trigger aggregation-induced emission (AIE) of synthetic substrates
Aggregation-induced emission (AIE) probes that can be triggered by enzymatic activity are sought for applications across the life sciences. The compound 2-(2-hydroxyphenyl)benzothiazole (HBT) is non-fluorescent in solution but exhibits AIE. To adapt HBT for potential clinical applications, two phosphoester derivatives (1 and 2) were prepared. For extension to molecular brachytherapy (delivery of a radionuclide), one phosphoester derivative (3) was prepared wherein a bromine atom is incorporated as a site for subsequent radioiodide substitution. Each probe 1–3 requires phosphatase action to engender AIE. For specificity in diagnostic and therapeutic applications, a heterologous (i.e., foreign to humans) enzyme was sought for conversion of 1–3 from aqueous-soluble to aqueous-insoluble form. Here, an archaeal phosphodiesterase PDE-MJ0936 (wild-type) was systematically engineered for activity toward 1–3. PDE-MJ0936 is a hyperthermal enzyme (activity at 70 °C and pH 9.8) and exists as a dimer, which together limit life science applications. Ten PDE mutants were engineered by site-directed mutagenesis to achieve a monomeric structure, wider substrate scope, and elastic substrate docking under physiological conditions. Among the mutants, PDE-C141D exhibited efficient activity towards bis(4-nitrophenyl)phosphate (Km = 0.28 mM, kcat = 3.0 s−1 and kcat/Km = 1.1 × 104 M−1 s−1) and efficiently hydrolyzed 3 at 37 °C and pH 7.0, conditions under which PDE-MJ0936 is silent. The substrates 1–3 are relatively resistant to alkaline phosphatase, PDE-MJ0936 and fetal bovine serum. The development of enzymatically triggered substrates and the complementary heterologous enzymes may support diverse applications in the life sciences.
- 13 December 2019
- Published by Royal Society of Chemistry (RSC) in New Journal of Chemistry
- Vol. 44 (3) , 719-743
Enzymatically triggered chromogenic cross-linking agents under physiological conditions
The ability to cross-link molecules upon enzymatic action under physiological conditions holds considerable promise for use in diverse life sciences applications. Here, an enzymatically triggered “click reaction” has been developed by exploiting the longstanding indigo-forming reaction from indoxyl β-glucoside. The covalent cross-linking proceeds in aqueous solution, requires the presence only of an oxidant (e.g., O2), and is readily detectable owing to the blue color of the resulting indigoid dye. To achieve facile indigoid formation in the presence of a bioconjugatable tether, diverse indoxyl β-glucosides were synthesized and studied in enzyme assays with four glucosidases including from tritosomes (derived from hepatic lysosomes) and rat liver homogenates. Altogether 36 new compounds (including 15 target indoxyl-glucosides for enzymatic studies) were prepared and fully characterized in pursuit of four essential requirements: enzyme triggering, facile subsequent indigoid dye formation, bioconjugatability, and synthetic accessibility. The 4,6-dibromo motif in a 5-alkoxy-substituted indoxyl-glucoside was a key design feature for fast and high-yielding indigoid dye formation. Two attractive molecular designs include (1) an indoxyl-glucoside linked to a bicyclo[6.1.0]nonyl (BCN) group for Cu-free click chemistry, and (2) a bis(indoxyl-glucoside). In both cases the linker between the reactive moieties is composed of two short PEG groups and a central triazine derivatized with a sulfobetaine moiety for water solubilization. Glucosidase treatment of the bis(indoxyl-glucoside) in aqueous solution gave oligomers that were characterized by absorption, dynamic light-scattering, and 1H NMR spectroscopy; optical microscopy; mass spectrometry; and HPLC. Key attractions of in situ indigoid dye formation, beyond enzymatic triggering under physiological conditions without exogenous catalysts or reagents, are the chromogenic readout and compatibility with attachment to diverse molecules.
- 13 December 2019
- Published by Royal Society of Chemistry (RSC) in New Journal of Chemistry
- Vol. 44 (3) , 719-743
Enzymatically triggered chromogenic cross-linking agents under physiological conditions
The ability to cross-link molecules upon enzymatic action under physiological conditions holds considerable promise for use in diverse life sciences applications. Here, an enzymatically triggered “click reaction” has been developed by exploiting the longstanding indigo-forming reaction from indoxyl β-glucoside. The covalent cross-linking proceeds in aqueous solution, requires the presence only of an oxidant (e.g., O2), and is readily detectable owing to the blue color of the resulting indigoid dye. To achieve facile indigoid formation in the presence of a bioconjugatable tether, diverse indoxyl β-glucosides were synthesized and studied in enzyme assays with four glucosidases including from tritosomes (derived from hepatic lysosomes) and rat liver homogenates. Altogether 36 new compounds (including 15 target indoxyl-glucosides for enzymatic studies) were prepared and fully characterized in pursuit of four essential requirements: enzyme triggering, facile subsequent indigoid dye formation, bioconjugatability, and synthetic accessibility. The 4,6-dibromo motif in a 5-alkoxy-substituted indoxyl-glucoside was a key design feature for fast and high-yielding indigoid dye formation. Two attractive molecular designs include (1) an indoxyl-glucoside linked to a bicyclo[6.1.0]nonyl (BCN) group for Cu-free click chemistry, and (2) a bis(indoxyl-glucoside). In both cases the linker between the reactive moieties is composed of two short PEG groups and a central triazine derivatized with a sulfobetaine moiety for water solubilization. Glucosidase treatment of the bis(indoxyl-glucoside) in aqueous solution gave oligomers that were characterized by absorption, dynamic light-scattering, and 1H NMR spectroscopy; optical microscopy; mass spectrometry; and HPLC. Key attractions of in situ indigoid dye formation, beyond enzymatic triggering under physiological conditions without exogenous catalysts or reagents, are the chromogenic readout and compatibility with attachment to diverse molecules.