Zhi-Jue Quan
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Zhi-Jue Quan has a total of 30 co-authors. Here are the top co-authors by number of shared publications:
W. Lu
3 shared publicationsFengyi Jiang
National Institute for LED on Si Substrate, Nanchang University, Nanchang 330047, People's Republic of China
2 shared publicationsJunlin Liu
National Institute for LED on Si Substrate, Nanchang University, Nanchang 330047, People's Republic of China
2 shared publicationsW. D. Hu
Chinese Academy of Science
2 shared publicationsX. N. Hu
Chinese Academy of Science
2 shared publicationsZ. F. Li
Chinese Academy of Science
2 shared publications
Latest Publications
- Open Access
- 11 May 2020
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 127 (18) , 185704
Effect of hole blocking layer on V-pit hole injection and internal quantum efficiency in GaN-based yellow LED
Five types of GaN-based yellow light-emitting diodes (LEDs) with both a V-pit and a hole blocking layer (HBL) have been investigated numerically. The simulation results show that the GaN hole blocking layer in the p region (HBLP) can not only increase the ratio of the hole current via the V-pit, but also increase the electron leakage into the p layer via the flat region, leading to the lower internal quantum efficiency (IQE). Compared to the GaN HBLP, the Al0.5Ga0.5N HBLP is helpful in suppressing the electron leakage via the flat region to the p layer; however, it increases the electron leakage via the V-pits to the p layer, resulting in an unsatisfactory improvement of IQE. In order to settle out this issue, the AlN hole blocking layer in the n region (HBLN) is designed in the sidewall of the V-pit. It is found that the HBLN can not only alleviate the electron leakage via the V-pits to the p layer, more importantly, but also block the hole leakage via the V-pits to the n layer, leading to the improvement of IQE.
- 11 May 2020
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 127 (18) , 185704
Open AccessEffect of hole blocking layer on V-pit hole injection and internal quantum efficiency in GaN-based yellow LED
Five types of GaN-based yellow light-emitting diodes (LEDs) with both a V-pit and a hole blocking layer (HBL) have been investigated numerically. The simulation results show that the GaN hole blocking layer in the p region (HBLP) can not only increase the ratio of the hole current via the V-pit, but also increase the electron leakage into the p layer via the flat region, leading to the lower internal quantum efficiency (IQE). Compared to the GaN HBLP, the Al0.5Ga0.5N HBLP is helpful in suppressing the electron leakage via the flat region to the p layer; however, it increases the electron leakage via the V-pits to the p layer, resulting in an unsatisfactory improvement of IQE. In order to settle out this issue, the AlN hole blocking layer in the n region (HBLN) is designed in the sidewall of the V-pit. It is found that the HBLN can not only alleviate the electron leakage via the V-pits to the p layer, more importantly, but also block the hole leakage via the V-pits to the n layer, leading to the improvement of IQE.
- 1 January 2019
- Published by Acta Physica Sinica, Chinese Physical Society and Institute of Physics, Chinese Academy of Sciences in Acta Physica Sinica
- Vol. 68 (19) , 196103-196103-9
Effects of p-layer hole concentration and thickness on performance of p-i-n InGaN homojunction solar cells
采用数值模拟的方法, 研究了p层空穴浓度和厚度对不同铟组分InGaN p-i-n同质结太阳电池性能的影响规律及其内在机理. 模拟计算的结果显示: 随着p层空穴浓度和厚度的增加, 太阳电池的转换效率均呈先增加、后略微下降的趋势; 而且铟组分越高, p层空穴浓度和厚度的影响越大. 为更好地理解这一规律, 本文从太阳电池的收集效率、I-V特性、内建电场和载流子输运等方面分析, 阐述了其背后的物理机理; 研究结果对InGaN太阳电池的结构设计及实验制备有一定的理论指导意义.
- 1 January 2019
- Published by Acta Physica Sinica, Chinese Physical Society and Institute of Physics, Chinese Academy of Sciences in Acta Physica Sinica
- Vol. 68 (19) , 196103-196103-9
Effects of p-layer hole concentration and thickness on performance of p-i-n InGaN homojunction solar cells
采用数值模拟的方法, 研究了p层空穴浓度和厚度对不同铟组分InGaN p-i-n同质结太阳电池性能的影响规律及其内在机理. 模拟计算的结果显示: 随着p层空穴浓度和厚度的增加, 太阳电池的转换效率均呈先增加、后略微下降的趋势; 而且铟组分越高, p层空穴浓度和厚度的影响越大. 为更好地理解这一规律, 本文从太阳电池的收集效率、I-V特性、内建电场和载流子输运等方面分析, 阐述了其背后的物理机理; 研究结果对InGaN太阳电池的结构设计及实验制备有一定的理论指导意义.
- 15 February 2016
- Published by Springer Nature in Optical and Quantum Electronics
- Vol. 48 (3) , 1-8
Effect of V-shaped Pit area ratio on quantum efficiency of blue InGaN/GaN multiple-quantum well light-emitting diodes
- 15 February 2016
- Published by Springer Nature in Optical and Quantum Electronics
- Vol. 48 (3) , 1-8
Effect of V-shaped Pit area ratio on quantum efficiency of blue InGaN/GaN multiple-quantum well light-emitting diodes
- 18 November 2015
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 118 (19) , 193102
A new interpretation for performance improvement of high-efficiency vertical blue light-emitting diodes by InGaN/GaN superlattices
The effect of InGaN/GaN superlattices (SLs) on quantum efficiency and forward voltage of vertical blue InGaN/GaN multiple quantum well (MQW) light-emitting diodes (LED) grown on Si substrate has been experimentally and theoretically investigated. We have prepared two LED samples, in which the 30 and 45 periods of SLs are inserted between MQW active layers and n-GaN layer, respectively. Electroluminescence measurement shows that the LED with 45 periods of SLs has higher quantum efficiency but lower forward voltage. It is observed that V-shaped pits grow up in size with an increase in SLs period number by means of scan transmission electron microscope and secondary ion mass spectrometry. Further numerical simulations confirm that the performance improvement of LED by SLs is mainly ascribed to enhancing hole injection from the V-shaped pits.
- 18 November 2015
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 118 (19) , 193102
A new interpretation for performance improvement of high-efficiency vertical blue light-emitting diodes by InGaN/GaN superlattices
The effect of InGaN/GaN superlattices (SLs) on quantum efficiency and forward voltage of vertical blue InGaN/GaN multiple quantum well (MQW) light-emitting diodes (LED) grown on Si substrate has been experimentally and theoretically investigated. We have prepared two LED samples, in which the 30 and 45 periods of SLs are inserted between MQW active layers and n-GaN layer, respectively. Electroluminescence measurement shows that the LED with 45 periods of SLs has higher quantum efficiency but lower forward voltage. It is observed that V-shaped pits grow up in size with an increase in SLs period number by means of scan transmission electron microscope and secondary ion mass spectrometry. Further numerical simulations confirm that the performance improvement of LED by SLs is mainly ascribed to enhancing hole injection from the V-shaped pits.
- 14 November 2014
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 116 (18) , 183107
Roles of V-shaped pits on the improvement of quantum efficiency in InGaN/GaN multiple quantum well light-emitting diodes
The roles of V-shaped pits on the improvement of quantum efficiency in InGaN/GaN multiple quantum well (MQW) light-emitting diodes are investigated by numerical simulation. The simulation results show that V-shaped pits cannot only screen dislocations, but also play an important role on promoting hole injection into the MQWs. It is revealed that the injection of holes into the MQW via the sidewalls of the V-shaped pits is easier than via the flat region, due to the lower polarization charge densities in the sidewall structure with lower In concentration and {10–11}-oriented semi-polar facets.
- 14 November 2014
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 116 (18) , 183107
Roles of V-shaped pits on the improvement of quantum efficiency in InGaN/GaN multiple quantum well light-emitting diodes
The roles of V-shaped pits on the improvement of quantum efficiency in InGaN/GaN multiple quantum well (MQW) light-emitting diodes are investigated by numerical simulation. The simulation results show that V-shaped pits cannot only screen dislocations, but also play an important role on promoting hole injection into the MQWs. It is revealed that the injection of holes into the MQW via the sidewalls of the V-shaped pits is easier than via the flat region, due to the lower polarization charge densities in the sidewall structure with lower In concentration and {10–11}-oriented semi-polar facets.
- 1 March 2007
- Published by Elsevier in Infrared Physics & Technology
- Vol. 50 (1) , 1-8
Effects of carrier degeneracy and conduction band non-parabolicity on the simulation of HgCdTe photovoltaic devices
- 1 March 2007
- Published by Elsevier in Infrared Physics & Technology
- Vol. 50 (1) , 1-8
Effects of carrier degeneracy and conduction band non-parabolicity on the simulation of HgCdTe photovoltaic devices
- 6 January 2007
- Published by Springer Nature in Optical and Quantum Electronics
- Vol. 38 (12-14) , 1107-1113
Modeling of dark characteristics for long-wavelength HgCdTe photodiode
- 6 January 2007
- Published by Springer Nature in Optical and Quantum Electronics
- Vol. 38 (12-14) , 1107-1113
Modeling of dark characteristics for long-wavelength HgCdTe photodiode
- 15 October 2006
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 100 (8) , 084503
Parameter determination from resistance-voltage curve for long-wavelength HgCdTe photodiode
A data-processing approach has been developed to obtain device parameters from resistance-voltage curves measured on long-wavelength HgCdTe -on- photodiodes. The physical model used for curve fitting includes the dark current mechanisms induced by diffusion, generation recombination, trap-assisted tunneling, and band-to-band tunneling. Moreover, the series resistance effect is also taken into account. Six parameters, which include the dopant density in the region, the ratio of mobility to lifetime of electrons in the region, the effective lifetime in the depletion region, the relative energy position of trap level and its density in the depletion region, and the series resistance , can be extracted from measured curves. The fitting procedure has been presented in detail and the error ranges of the extracted parameters have been discussed. By fitting to the characteristics of three long-wavelength devices with different Cd compositions, the applicability of our data-processing approach has been verified for obtaining those basic parameters.- 15 October 2006
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 100 (8) , 084503
Parameter determination from resistance-voltage curve for long-wavelength HgCdTe photodiode
A data-processing approach has been developed to obtain device parameters from resistance-voltage curves measured on long-wavelength HgCdTe -on- photodiodes. The physical model used for curve fitting includes the dark current mechanisms induced by diffusion, generation recombination, trap-assisted tunneling, and band-to-band tunneling. Moreover, the series resistance effect is also taken into account. Six parameters, which include the dopant density in the region, the ratio of mobility to lifetime of electrons in the region, the effective lifetime in the depletion region, the relative energy position of trap level and its density in the depletion region, and the series resistance , can be extracted from measured curves. The fitting procedure has been presented in detail and the error ranges of the extracted parameters have been discussed. By fitting to the characteristics of three long-wavelength devices with different Cd compositions, the applicability of our data-processing approach has been verified for obtaining those basic parameters.