Fatma Ahmed Aly

Using two green and sensitive spectrofluorimetric methods, we quantified two cephalosporins, cefepime (CFM) and cefazolin (CFZ), in raw and pharmaceutical formulations. The first method is based on the reaction between CFM and fluorescamine (borate buffer, pH 8), which yields a highly fluorescent product. After excitation at 384 nm, the fluorescent product emits light at 484 nm. At concentration ranges from 12.0 to 120.0 ng ml ⁻¹ , the relative fluorescence intensity/concentration curve was linear with a limit of quantification (LOQ) of 2.46 ng ml ⁻¹ . The second method relied on measuring the CFZ quenching action on acriflavine fluorescence through formation of an ion-associate complex using Britton–Robinson buffer at pH 8. We measured acriflavine fluorescence at 505 nm after excitation at 265 nm. The decrease in acriflavine fluorescence intensity was CFZ concentration-dependent. Using this method, we quantified CFZ in concentrations ranging from 1 to 10 µg ml ⁻¹ with a LOQ of 0.48 µg ml ⁻¹ . We studied and optimized the factors influencing reaction product formation. Moreover, we adapted our methods to the investigation of the mentioned drugs in raw and pharmaceutical formulations with greatly satisfying results. We statistically validated our methods according to International Council on Harmonisation Guidelines. The obtained results were consistent with those obtained with the official high-performance liquid chromatography methods.

The combination between cetirizine (CET), phenylpropanolamine (PPA) and nimesulide (NMS) under trade name Nemeriv Cp tablet is prescribed for nasal congestion, cold, sneezing, and allergy. Among all published methods for the three drugs; there is no reported method concerning estimation of CTZ, PPA and NMS simultaneously and this motivates us to develop new and simple methods for their assay in pure form and tablet preparations. Two new methodologies were described for the simultaneous quantification of cetirizine (CTZ), PPA and NMS. Spectrophotometric procedures relies on measuring the amplitudes of the third derivative curves at 238 nm for CTZ, 218 nm for PPA and 305 nm for NMS. The calibration graphs were rectilinear over the ranges of 8–90 µg/mL for CTZ, 20–100 µg/mL for PPA and 20–200 µg/mL for NMS respectively. Regarding the HPLC method; monolithic column (100 mm × 4.6 mm i.d) was used for the separation. The used mobile phase composed of 0.1 M phosphate buffer and methanol in the ratio of 40:60, v/v at pH 7.0. The analysis was performed using UV detector at 215 nm. Calibration curves showed the linearity over concentration ranges of 5–40, 10–100 and 10–120 µg/mL for CTZ, PPA and NMS. Application of the proposed methods to the laboratory prepared tablets was carried out successfully. The results were compared with those obtained from previously published methods and they were satisfactory. Graphical abstract Graphical abstract represents the chemical structures, representative chromatogram for the HPLC separation of a PPA, b NMS and c CTZ and third derivative absorption spectra of a PPA, b NMS and c CTZ for the spectrophotometric method.

A new simple, accurate and sensitive sequential injection analysis chemiluminescence (CL) detection method for the determination of cefditoren pivoxil (CTP) has been developed. The developed method was based on the enhancement effect of silver nanoparticles on the CL signal arising from a luminol–potassium ferricyanide reaction in the presence of CTP. The optimum conditions relevant to the effect of luminol, potassium ferricyanide and silver nanoparticle concentrations were investigated. The proposed method showed linear relationships between relative CL intensity and the investigated drug concentration at the range 0.001–5000 ng/mL, (r = 0.9998, n = 12) with a detection limit of 0.5 pg/mL and quantification limit of 0.001 ng/mL. The relative standard deviation was 1.6%. The proposed method was employed for the determination of CTP in bulk drug, in its pharmaceutical dosage forms and biological fluids such as human serum and urine. The interference of some common additive compounds such as glucose, lactose, starch, talc and magnesium stearate was investigated. In addition, the interference of some related cephalosporins was tested. No interference was recorded. The obtained sequential injection analysis‐CL results were statistically compared with those from a reported method and did not show any significant differences. Copyright © 2014 John Wiley & Sons, Ltd.

A simple, rapid and highly sensitive spectrofluorimetric method was developed for determination of gemifloxacin mesylate (GFX) in tablets. The method is based on measuring the native fluorescence of GFX in isopropanol at 400 nm after excitation at 272 nm. The fluorescence–concentration plot was rectilinear over the range of 0.01–0.50 µg/mL with a lower detection limit of 1.19 ng/mL and quantification limit of 3.6 ng/mL. The method was fully validated and successfully applied to the determination of GFX tablets with an average percentage recovery of 99.65 ± 0.532. The method was extended to the stability study of GFX. The drug was exposed to acidic, alkaline, oxidative and photolytic degradation according to International Conference on Harmonization guidelines. The rate of GFX degradation was found at its highest in acidic conditions, and in its lowest in the neutral one. However, it was stable under dry heat and photolytic degradation conditions. Copyright © 2013 John Wiley & Sons, Ltd.

Simple and sensitive kinetic spectrophotometric methods were established for the determination of alfuzosin hydrochloride in bulk and in its pharmaceutical preparations using alkaline potassium permanganate as an oxidizing agent. The methods involve determination of alfuzosin HCl by kinetic studies of its oxidation at room temperature for a fixed time of 15 min. The absorbance of the colored manganate ions was measured at 610 nm. Alternatively, the decrease in the absorbance of permanganate upon addition of the studied drug was also measured at 525 nm. The absorbance-concentration plots in both procedures were rectilinear over the range of 2.0–30.0 μg/mL. The different experimental parameters affecting the development were carefully studied and optimized. The determination of alfuzosin HCl by the fixed concentration and initial rate methods is also feasible with the calibration equations obtained but the fixed time method has been found to be more applicable. Both procedures were applied to the determination of alfuzosin HCl in formulations. The results obtained were in good agreement with those obtained using reference methods.

Rapid, simple and highly sensitive flow‐injection (FI) chemiluminescence (CL) and flow‐injection electrogenerated chemiluminescence (ECL) methods were developed for the determination of escitalopram oxalate (ESC), a selective serotonin reuptake inhibitor used as an antidepressant drug. The CL method was based on the CL reaction of ESC with acidic cerium(IV) and tris(2,2'‐bipyridyl)ruthenium(II) (Ru). Various experimental parameters affecting CL intensity were carefully studied and optimised. The method enabled the determination of 0.001‐50 µg/mL of ESC in bulk form with a correlation coefficient r = 0.9999. The limit of detection (LOD) was 0.01 ng/mL (S/N = 3). The ECL method was based on the ECL reaction of Ru with the drug in an acidic medium, permitting the determination of ESC in the range of 0.00001‐70 µg/mL with r = 0.9999 and LOD of 1 x 10^‐4 ng/mL. The proposed methods were applied to the determination of ESC in commercial tablets. The results were compared statistically with those obtained from a published method using t‐ and F‐tests. Copyright © 2012 John Wiley & Sons, Ltd.

A simple and sensitive spectrofluorimetric method was developed for the determination of ezetimibe in its pharmaceutical formulations. The proposed method is based on investigation of the fluorescence spectral behavior of ezetimibe in sodium dodecyl sulfate (SDS) micellar system. In aqueous solution of acetate buffer pH 5.0, the fluorescence intensity of ezetimibe was greatly enhanced, 200% enhancement, in the presence of SDS. The fluorescence intensity of ezetimibe was measured at 380 nm after excitation at 268 nm. The fluorescence-concentration plot was rectilinear over the range of 0.03–3.0 μg/mL with lower detection limit of 3.08 × 10⁻³ μg/mL. The method was successfully applied to the analysis of ezetimibe in its commercial tablets; the results were in good agreement with those obtained with the reported method. The application of the proposed method was extended to the stability studies of ezetimibe after exposure to different forced degradation conditions, such as acidic, alkaline, photo and oxidative conditions, according to ICH guidelines.