Current Organizations / Institutes

The organizations/institutes from the scholar's latest article

Previous Organizations / Institutes

The organizations / institutes from the scholar's other articles in the past ten years


Rasha Hosny has a total of 85 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Multifunctional poly(citric acid)-based ionic liquid polymer composite for scale control and emulsion stabilization: structural and interfacial mechanistic evaluation

    by Mostafa Y. Nassar, Elbadawy A. Kamoun, Norah Alsadun, Emad M. Masoud, R. Hosny, Mahmoud F. Mubarak

    Mineral scale formation and emulsion instability are major challenges in high-salinity oilfield systems, leading to operational inefficiencies and reduced oil recovery. In this study, a partially bio-based ionic liquid polymer, poly(2-hydroxypropane-1,2,3-tricarboxylic acid)-based ionic liquid polymer (HPTA-ILP), was synthesized from citric acid and evaluated as a multifunctional additive for simultaneous scale inhibition and emulsion stabilization. The polymer was characterized using FTIR, XRD, and ¹H NMR, confirming the formation of an amorphous, ionically functionalized polymer network. Dynamic scale loop tests under high-pressure and high-temperature conditions (190 °F, 1500 psi) demonstrated effective inhibition of calcium-based scale formation, with a minimum inhibitor concentration (MIC) of 200 ppm. At this concentration, the polymer achieved an emulsion stability index (ESI) of 85% and improved oil recovery efficiency to 87%. The inhibition mechanism involves calcium ion complexation, adsorption on crystal growth sites, and interfacial stabilization through electrostatic and steric effects. These results highlight the potential of HPTA-ILP as a multifunctional additive for improving flow assurance and enhanced oil recovery performance in high-salinity environments.

  • Open Access

    Garcinia derived adsorbents for efficient ammonium removal from wastewater in fixed bed column systems

    by Mona S. S. Soliman, Mahmoud F. Mubarak, R. Hosny

    Ammonium contamination in wastewater poses serious risks to aquatic environments and requires efficient continuous treatment strategies. This study evaluates a Garcinia-derived biosorbent for NH 4 + removal in a laboratory-scale fixed-bed column and quantitatively examines the influence of flow rate, influent concentration, and bed height on dynamic adsorption behavior. Breakthrough and exhaustion were defined at C t /C o = 0.05 and C t /C o = 0.95, respectively. Decreasing the flow rate from 2.0 to 0.5 mL min −1 increased the Thomas capacity from 10.5 to 18.5 mg g −1 and extended breakthrough time from < 100 to ~ 240 min. Increasing bed height from 5 to 20 cm enhanced q max from 12.0 to 23.5 mg g −1 . Model validation using the Thomas and Yoon–Nelson equations showed good agreement with experimental data (R 2 = 0.89–0.99, RMSE = 0.021–0.065, MAE = 0.018–0.054). The mass transfer zone (MTZ) length and empty bed contact time (EBCT) were estimated to provide additional insight into column hydrodynamics. The results demonstrate the potential applicability of Garcinia-based biosorbent for laboratory-scale continuous ammonium removal and provide useful operational insights for fixed-bed adsorption systems.


  • Eco-Friendly Scale Inhibition Strategies for Produced Water Management in Enhanced Oil Recovery: A Comprehensive Review

    by Amal A. Nassar, Ayman K. El-Sawaf, Mahmoud F. Mubarak, Rasha Hosny

    Mineral scale formation remains a major challenge in the management of produced water during enhanced oil recovery (EOR) operations. Although conventional scale inhibitors such as phosphonates and polycarboxylates are effective, they are becoming increasingly undesirable due to their limited biodegradability and long-term environmental persistence. This review critically examines recent advances in environmentally friendly scale inhibition strategies, including biodegradable polymers, plant-based additives, nanostructured materials, and hybrid formulations. Particular emphasis is placed on their performance under the high-temperature and high-salinity conditions characteristic of EOR systems as well as their compatibility with polymers and surfactants used in chemical flooding processes. The mechanisms of scale controlsuch as nucleation delay, crystal distortion, particle dispersion, and surface passivationare discussed based on laboratory investigations and reported field-scale applications. In addition, the review highlights the growing role of data-driven control strategies, predictive dosing, and digital monitoring in optimizing inhibitor deployment. Field-scale evidence from the literature indicates that eco-friendly and nanotechnology-enhanced inhibitors can reduce scaling-related downtime by approximately 20–40% while simultaneously decreasing chemical consumption by 15–30% under harsh EOR conditions. Overall, this work provides a structured framework linking environmental sustainability with materials innovation, offering guidance for the development of next-generation scale inhibitors that satisfy both operational demands and regulatory requirements in modern petroleum engineering.


  • Open Access

    Enhanced oil recovery from sandstone reservoir using cationic hyperbranched polyamidoamine dendrimer surfactant flooding under real reservoir conditions

    by Samah A. M. Abou-Alfitooh, Ammona S. Mohamed, Fatma M. Abdelhafiz, Ahmed Zahran, R. Hosny

    This study investigates the application of a synthesized cationic hyperbranched polyamidoamine (PAMAM) dendrimer surfactant (G2-C12) as a novel chemical agent for enhanced oil recovery (EOR) in sandstone reservoirs under realistic high-salinity and high-temperature conditions. The dendrimer was synthesized via a divergent approach involving Michael addition, amidation, and quaternization, yielding a structurally defined amphiphilic macromolecule. Its performance was evaluated through interfacial tension (IFT) measurements, salinity-dependent behavior, wettability alteration tests, and core flooding experiments. The surfactant reduced IFT from 27 mN/m to 5 mN/m at 2000 ppm, which was identified as the critical micelle concentration (CMC). Contact angle measurements confirmed a significant shift from oil-wet to strongly water-wet conditions (10.87°–34.57°). Additional salinity tests established the optimal brine strength, while core flooding results demonstrated an incremental oil recovery of 29.09% at reservoir-representative conditions. These findings underscore the dendrimer’s dual-function mechanism, operational stability, and strong potential as a high-performance EOR surfactant under challenging field environments.


  • Open Access

    Diminishing the mobility ratio and interfacial tension of a tertiary flooded sandstone reservoir using microparticles as a reinforcement agent with biopolymer composite

    by Samah A. M. Abou-Alfitooh, M. Ramzi, Mostafa G. Temraz, Rasha Hosny, Osama M. Elnaggar

    Approaches for enhancing oil recovery are important for maximizing the recovery factor of oil after the vanishing natural pressure of a hydrocarbon reservoir. This study attempted to boost the oil recovery factor at the expense of the saturation of remaining oil after a secondary flood using xanthan gum and its modified form through blending with microcrystalline cellulose (MCC), where their effectiveness was evaluated. To evaluate the effect of MCC on native biopolymer, thermal gravimetric analysis (TGA), interfacial tension (ITF), and rheological studies were assessed. The results indicated that MCC enhanced the rheology properties of the biopolymers. It also reduced the interfacial force between crude oil and polymer slug solution (12.54 mN/m) more than the formation water (18.8 mN/m) and biopolymer solution alone (16.28 mN/m). Full reservoir conditions (confining pressure, reservoir temperature, and actual oil) were applied in this work on two subsurface core samples (A&B), trying to enhance the oil recovery. The original oil in place was evaluated for the reservoir core samples (50.9% p.v. & 60.3% p.v. for A & B, respectively), and the oil permeabilities were 81.6 & 80.97 md at the residual water saturation recorded as the base permeability. To assess the residual oil saturation, the secondary flooding using formation water was carried out up to the stage of no more oil displaced out of the tested samples, where the permeability of water at the residual oil saturation was measured 6.05 & 7.5 md for A & B, respectively. Finally, plug samples were flooded chemically, and additional oil recovery was recorded. The flooding experiments indicated that the MCC with xanthan gum was more effective for enhancing the oil recovery factor (29.09% Sor) than that of the native biopolymer separately (20% Sor), this is due to its higher viscosity, higher ability for IFT reduction, and better emulsion stability. The article’s innovation lies in proving that the presence of microcrystalline cellulose supports the performance of xanthan gum as an enhanced oil recovery agent in severe conditions of oil reservoirs.

  • Open Access

    Influence of interface defects and Zr doping on the photocatalytic activity of TiO2 nanofibers in water splitting

    by Mehrdad Mehdikhanloo, Zahra Hagheh Kavousi, Massomeh Ghorbanloo, Amr A. Nada, Heba H. El-Maghrabi, Rasha Hosny, Fouad Zahran, Roman Viter, Djamel Bezzerga, Jisang Hong, et al.


  • Open Access

    Synthesis and evaluation of amino acid ionic liquid for enhanced oil recovery: experimental and modeling simulation studies

    by E. M. Mansour, R. Hosny, Ammona S. Mohamed, Fatma M. Abdelhafiz

    Recovering the remaining oil after primary and secondary extraction methods poses a significant challenge. Enhanced oil recovery (EOR) techniques, which involve injecting fluids into reservoirs, aim to increase recovery rates. Ionic liquids, known for their adaptability, are emerging as promising agents in EOR, improving oil displacement by reshaping fluid properties and interacting with reservoir rocks. This study investigates the eco-friendly amino acid ionic liquid, AAIL [G0.5 C12][Pro], for EOR applications, focusing on its characterization and performance. Using pre-prepared quaternary ammonium salt PAMAM G0.5 C12 and proline, AAIL [G0.5 C12][Pro] was synthesized and confirmed via FTIR and 1H-NMR analyses. Rheological analysis identified 7 g of AAIL [G0.5 C12][Pro] as the optimal concentration for peak performance. Laboratory sand-pack displacement experiments demonstrated an 11% increase in oil recovery at this concentration. Further, a 3D reservoir model simulation validated the enhanced oil recovery potential of AAIL [G0.5 C12][Pro]. The study introduces the novel amino acid ionic liquid [G0.5 C12][Pro], which demonstrates superior effectiveness in enhancing oil recovery through significant wettability modification and interfacial tension reduction, underscoring its potential as an effective and environmentally friendly EOR agent compared to other ionic liquids and conventional methods.


  • Open Access

    In-situ upgrading of Egyptian heavy crude oil using matrix polymer carboxyl methyl cellulose/silicate graphene oxide nanocomposites

    by Eman M. Mostafa, Alaa Ghanem, Rasha Hosny, Raghda El-Nagar

    This study delves into catalytic aquathermolysis to enhance the economic viability of heavy oil production by in-situ upgrading technique. It is known that introducing nanocatalysts would promote the aquathermolysis reaction. Therefore, in this study, the effect of matrix polymer carboxyl methyl cellulose/silicate graphene oxide nanocomposites (CSG1 and CSG2) in the catalytic aquathermolysis of Egyptian heavy crude oil was studied. Characterization techniques including Fourier-transform infrared (FTIR), X-ray diffraction (XRD), Dynamic light scattering (DLS), Brunauer–Emmett–Teller (BET) surface area analysis, Scanning electron microscopy (SEM), and thermogravimetric analysis (TGA) were used to evaluate the structure of the synthesized nanocomposites. Results reveal CSG2 has higher crystallinity and superior dispersion compared to CSG1, and both exhibited a good stability in aqueous suspensions. CSG2 enriched with graphene oxide, demonstrates superior thermal stability, suitable for high-temperature applications such as catalytic aquathermolysis process. Single factor and orthogonal tests were used to assess the catalytic aquathermolysis performance of the prepared nanoparticles. The obtained results revealed that the optimum conditions to use CSG1 and CSG2 are 40% water concentration, 225 °C temperature, and 0.5 wt% catalyst percentage. Where, CSG2 showed better viscosity reduction (82%) compared to CSG1 (62%), highlighting its superior performance in reducing the viscosity of heavy oil. Numerical results from SARA analysis, gas chromatography, and rheological testing confirmed the catalytic aquathermolysis's efficacy in targeting asphaltene macromolecules and producing lighter hydrocarbon fractions.


  • Open Access

    Copper benzene-1,3,5-tricarboxylate based metal organic framework (MOF) derived CuO/TiO2 nanofibers and their use as visible light active photocatalyst for the hydrogen production

    by Mitra Saffari, Zahra Hagheh Kavousi, Massomeh Ghorbanloo, Amr A. Nada, Maged F. Bekheet, Djamel Bezzerga, Jisang Hong, Ali Morsali, Yaovi Holade, Roman Viter, et al.