Hocine Belmili
Research Subjects
Research Interests
Hocine Belmili has a total of 46 co-authors. Here are the top co-authors by number of shared publications:
- Mohamed Fayçal Almi
Unité de développement des équipements solaires (UDES)/EPST-CDER, Bou-Ismail, 42415, W. Tipaza, Algeria
5 shared publications - Ridha Cheikh
Biskra University
5 shared publications - Fateh Krim
University of Setif-1
4 shared publications Sabri Boulouma
Unité de Développement des Equipements Solaires, UDES/Centre de Développement des Energies Renouvelables, CDER, Bou-Ismail, 42415, W. Tipaza, Algeria
4 shared publicationsB. Bendib
Unité de développement des équipements solaires (UDES)/EPST-CDER, Bou-Ismail, 42415, W. Tipaza, Algeria
3 shared publicationsBoualem Bendib
Unité de Développement des Equipements Solaires, UDES/Centre de Développement des Energies Renouvelables, CDER, Bou-Ismail, 42415, W. Tipaza, Algeria
3 shared publications
Latest Publications
- Open Access
- 15 April 2020
- Published by IntechOpen
Robust Nonlinear Control Strategy for Small Wind Turbines: A Case Study
This chapter presents a case study of robust nonlinear control strategy using nonlinear feedback control technique based on Lyapunov theory and associated with robust control laws. The proposed approach aims to enhance robustness of the wind turbine control scheme. In fact, we selected as a case study, the most used electrical generator in small-scale wind applications, the Permanent Magnet Synchronous Generator (PMSM). Indeed, the control strategy presented in this chapter allows an efficient operation of the wind turbine in the standalone operating mode, offers a nonlinear handling of the WECS(s) and guarantees maximum wind power harvesting and robustness against critical working conditions. Talking about stability, in several wind generator control schemes; a such classical PI controllers-based scheme can easily be disturbed by any uncertainty of the system parameters, thus, in this chapter, we focused on how to overcome this issue by proposing a robust control strategy based on nonlinear controller derived from the Lyapunov Theory. The chapter presents numerical simulations within Matlab/SIMULINK environment. These results proved the effectiveness and the benefits of the proposed approach.
- 15 April 2020
- Published by IntechOpen
Open AccessRobust Nonlinear Control Strategy for Small Wind Turbines: A Case Study
This chapter presents a case study of robust nonlinear control strategy using nonlinear feedback control technique based on Lyapunov theory and associated with robust control laws. The proposed approach aims to enhance robustness of the wind turbine control scheme. In fact, we selected as a case study, the most used electrical generator in small-scale wind applications, the Permanent Magnet Synchronous Generator (PMSM). Indeed, the control strategy presented in this chapter allows an efficient operation of the wind turbine in the standalone operating mode, offers a nonlinear handling of the WECS(s) and guarantees maximum wind power harvesting and robustness against critical working conditions. Talking about stability, in several wind generator control schemes; a such classical PI controllers-based scheme can easily be disturbed by any uncertainty of the system parameters, thus, in this chapter, we focused on how to overcome this issue by proposing a robust control strategy based on nonlinear controller derived from the Lyapunov Theory. The chapter presents numerical simulations within Matlab/SIMULINK environment. These results proved the effectiveness and the benefits of the proposed approach.
- Open Access
- 31 March 2020
- Published by Fundatia Romania de Maine in Journal of Economic Development, Environment and People
- Vol. 9 (1) , 27-59
Techno-economic study of BIPV in typical Sahara region in Algeria
Building in urban areas in the Sahara region is confronted with two main issues: (i) the climate change and (ii) the energy consumption. In order to deal with the latest issues, experts want to focus all their efforts on the use of renewable energy, and most particularly solar energy that is widely available at the Sahara. In this work, we have carried out a comprehensive survey related to benefits, techniques, and criteria affecting the energy efficiency of using BIPV and its advantages over glazing. To be clearer, we have selected as a case of study of a contemporary building covered by standard glazing and replaced by BIPV located in a Sahara region in Algeria. Moreover, the point of view of urban architectural, and energy economy, have been well investigated. Where the necessary time period was calculated to recover the total amounts of expenses for BIPV technology in the event that it is installed on the roof and then in the event that this technology is installed in the facades. As a result, using BIPV in this specific region of a hot climate has to be a dominant idea to reduce both energy consumption and economical
- 31 March 2020
- Published by Fundatia Romania de Maine in Journal of Economic Development, Environment and People
- Vol. 9 (1) , 27-59
Open AccessTechno-economic study of BIPV in typical Sahara region in Algeria
Building in urban areas in the Sahara region is confronted with two main issues: (i) the climate change and (ii) the energy consumption. In order to deal with the latest issues, experts want to focus all their efforts on the use of renewable energy, and most particularly solar energy that is widely available at the Sahara. In this work, we have carried out a comprehensive survey related to benefits, techniques, and criteria affecting the energy efficiency of using BIPV and its advantages over glazing. To be clearer, we have selected as a case of study of a contemporary building covered by standard glazing and replaced by BIPV located in a Sahara region in Algeria. Moreover, the point of view of urban architectural, and energy economy, have been well investigated. Where the necessary time period was calculated to recover the total amounts of expenses for BIPV technology in the event that it is installed on the roof and then in the event that this technology is installed in the facades. As a result, using BIPV in this specific region of a hot climate has to be a dominant idea to reduce both energy consumption and economical
- 9 May 2019
- Published by Springer Nature in International Journal of System Assurance Engineering and Management
- Vol. 10 (4) , 632-643
Dynamic behavior analysis under a grid fault scenario of a 2 MW double fed induction generator-based wind turbine: comparative study of the reference frame orientation approach
- 9 May 2019
- Published by Springer Nature in International Journal of System Assurance Engineering and Management
- Vol. 10 (4) , 632-643
Dynamic behavior analysis under a grid fault scenario of a 2 MW double fed induction generator-based wind turbine: comparative study of the reference frame orientation approach
- 1 December 2018
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1-6
Modeling and Simulation of PV Generator Characteristics under LabVIEW
The basic device of a photovoltaic (PV) system is the solar cell. In the research literature, there exist several models to describe PV cells, the most commonly used is the single-diode model, because of its accuracy and simplicity. In this paper, the single-diode solar cell model is implemented under LabVIEW software and the current-voltage (I-V) and power-voltage (P-V) characteristics of PV generator are simulated at different temperature and solar irradiance conditions. This allows investigating the variation of maximum power points (MPP) and predicting system's behavior under different environmental conditions.
- 1 December 2018
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1-6
Modeling and Simulation of PV Generator Characteristics under LabVIEW
The basic device of a photovoltaic (PV) system is the solar cell. In the research literature, there exist several models to describe PV cells, the most commonly used is the single-diode model, because of its accuracy and simplicity. In this paper, the single-diode solar cell model is implemented under LabVIEW software and the current-voltage (I-V) and power-voltage (P-V) characteristics of PV generator are simulated at different temperature and solar irradiance conditions. This allows investigating the variation of maximum power points (MPP) and predicting system's behavior under different environmental conditions.
- Open Access
- 1 October 2017
- Published by Elsevier in Energy Procedia
- Vol. 136, 330-335
Study, design and manufacturing of hybrid vertical axis Savonius wind turbine for urban architecture
- 1 October 2017
- Published by Elsevier in Energy Procedia
- Vol. 136, 330-335
Open AccessStudy, design and manufacturing of hybrid vertical axis Savonius wind turbine for urban architecture
- Open Access
- 1 October 2017
- Published by Elsevier in Energy Procedia
- Vol. 136, 481-487
The Saharan Setting facing future climate
- 1 October 2017
- Published by Elsevier in Energy Procedia
- Vol. 136, 481-487
Open AccessThe Saharan Setting facing future climate
- 1 May 2017
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1-6
Transient Behavior Analysis for a 2 MW Grid-Connected DFIG-Based WECS Under Partial Symmetrical Voltage Dips
Aiming to deeply understand the DFIG transient behavior if a grid fault occurs; then describe its equivalent model under this case, this paper deals with a theoretical analysis of a typical 2 MW DFIG-based WECS using the Superposition Principle Theory to analyze a partial symmetrical grid dips. Therefore the study has been achieved with emphasis on the impact of each voltage dip on the DFIG behavior. In fact as the DFIG is directly integrated to the grid via its stator and is controlled via its rotor by means of voltage-source current-regulated converter, the analysis aims to evaluate the low-voltage ride-through (LVRT) capability of the system, in which it can be known how the large induced rotor electromotive force can disturb the control scheme and what are the limits of such vulnerable rotor converter to keep working permanently, momentarily or even lost control definitely. The proposed analysis has been evaluated by simulation results using MATLAB/Simulink.
- 1 May 2017
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1-6
Transient Behavior Analysis for a 2 MW Grid-Connected DFIG-Based WECS Under Partial Symmetrical Voltage Dips
Aiming to deeply understand the DFIG transient behavior if a grid fault occurs; then describe its equivalent model under this case, this paper deals with a theoretical analysis of a typical 2 MW DFIG-based WECS using the Superposition Principle Theory to analyze a partial symmetrical grid dips. Therefore the study has been achieved with emphasis on the impact of each voltage dip on the DFIG behavior. In fact as the DFIG is directly integrated to the grid via its stator and is controlled via its rotor by means of voltage-source current-regulated converter, the analysis aims to evaluate the low-voltage ride-through (LVRT) capability of the system, in which it can be known how the large induced rotor electromotive force can disturb the control scheme and what are the limits of such vulnerable rotor converter to keep working permanently, momentarily or even lost control definitely. The proposed analysis has been evaluated by simulation results using MATLAB/Simulink.
- Open Access
- 1 February 2017
- Published by Elsevier in Energy Procedia
- Vol. 107, 76-84
Optimized Control and Sizing of Standalone PV-wind Energy Conversion System
- 1 February 2017
- Published by Elsevier in Energy Procedia
- Vol. 107, 76-84
Open AccessOptimized Control and Sizing of Standalone PV-wind Energy Conversion System
- 1 January 2017
- Published by Inderscience Publishers in International Journal of Computer Applications in Technology
- Vol. 55 (3) , 232-243
Development of an ontology-based generic optimisation tool for the design of hybrid energy systems
The reliability and cost of energy systems and diversity of weather are the two main concerns for Hybrid Energy Systems (HES) optimisation in the face of energy scarcity. Many techniques for sizing and optimisation of such systems have been developed. However, these techniques are developed independently of each other and require end-users to know a priori the techniques to use as well as data inputs of each. There is no sharing of data between the various techniques although they can use the same data. The novelty of this study is to develop an ontology-based system that offers the end-user an optimal design solution without having to know in advance the optimisation techniques. To that effect, we present an ontology-based generic tool that includes most used energy sources for optimising HES. The proposed tool has been applied and tested on an isolated wind-photovoltaic hybrid power system with battery storage.
- 1 January 2017
- Published by Inderscience Publishers in International Journal of Computer Applications in Technology
- Vol. 55 (3) , 232-243
Development of an ontology-based generic optimisation tool for the design of hybrid energy systems
The reliability and cost of energy systems and diversity of weather are the two main concerns for Hybrid Energy Systems (HES) optimisation in the face of energy scarcity. Many techniques for sizing and optimisation of such systems have been developed. However, these techniques are developed independently of each other and require end-users to know a priori the techniques to use as well as data inputs of each. There is no sharing of data between the various techniques although they can use the same data. The novelty of this study is to develop an ontology-based system that offers the end-user an optimal design solution without having to know in advance the optimisation techniques. To that effect, we present an ontology-based generic tool that includes most used energy sources for optimising HES. The proposed tool has been applied and tested on an isolated wind-photovoltaic hybrid power system with battery storage.
- 1 January 2017
- Published by IGI Global Scientific Publishing
- p. 1695-1718
A New Robust H∞ Control Power
Attention has been paid by many researchers to address the various challenges of grid connection of DFIG-based Wind Energy Conversion Systems (WECS). This chapter focuses on the design of a robust H8 controller for the power flow between the stator of the Doubly-Fed Induction Generator (DFIG) and the grid. The robust H8 controller design is formulated as a mixed-sensitivity problem. A mathematical model of the DFIG written in an appropriate d-q reference frame is established to carry out simulations. The proposed power control scheme is elaborated and compared with a conventional Proportional-Integral (PI) controller based on vector control technique. The results show interesting performance of the controlled system in terms of the power reference tracking (the active and reactive power) and robustness against parameter variations compared with the conventional PI controller.
- 1 January 2017
- Published by IGI Global Scientific Publishing
- p. 1695-1718
A New Robust H∞ Control Power
Attention has been paid by many researchers to address the various challenges of grid connection of DFIG-based Wind Energy Conversion Systems (WECS). This chapter focuses on the design of a robust H8 controller for the power flow between the stator of the Doubly-Fed Induction Generator (DFIG) and the grid. The robust H8 controller design is formulated as a mixed-sensitivity problem. A mathematical model of the DFIG written in an appropriate d-q reference frame is established to carry out simulations. The proposed power control scheme is elaborated and compared with a conventional Proportional-Integral (PI) controller based on vector control technique. The results show interesting performance of the controlled system in terms of the power reference tracking (the active and reactive power) and robustness against parameter variations compared with the conventional PI controller.