Wendi Dreesen
Wendi Dreesen has a total of 37 co-authors. Here are the top co-authors by number of shared publications:
David Schwellenbach
National Security Technologies, LLC, Los Alamos Operations, 2900 East Road, NM 87544 USA
3 shared publicationsJ. Andrew Green
National Security Technologies, LLC, Remote Sensing Laboratory, 4600 N. Hollywood Blvd., Las Vegas, NV 89191, USA
3 shared publicationsDave Schwellenbach
National Security Technologies
2 shared publications- Derek Aberle
Los Alamos National Laboratory 3 , Los Alamos, New Mexico 87545, USA
2 shared publications Mark Browder
Lockheed Martin, P.O. Box 650003, Dallas, TX 75265 USA
2 shared publicationsAlfred Meidinger
NSTec
1 shared publication
Latest Publications
- 24 March 2016
- Published by Society of Exploration Geophysicists
- Vol. 1, 401-404
Novel Environmental/NS Geophysics Methods
The individual abstracts for this session are available to read in the PDF.
- 24 March 2016
- Published by Society of Exploration Geophysicists
- Vol. 1, 401-404
Novel Environmental/NS Geophysics Methods
The individual abstracts for this session are available to read in the PDF.
- 1 November 2014
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1-5
Imaging shielded configurations using near-horizontal and near-vertical trajectory cosmic-ray muons
This work will describe the proof-of-concept research applying muon tomography technologies based on drift tube systems to create images using near-horizontal trajectory muons. To date, the majority of imaging studies using cosmic-ray muons have used near-vertical trajectory muons. This work compares imaging results using near-vertical trajectory muons with results using near-horizontal trajectory muons. The muon flux is much lower for the near-horizontal trajectory muons, requiring longer imaging times, but the average muon energy is higher, so the horizontal results are expected to better differentiate high-Z materials. The muon tracking system is easily configurable and can be oriented to capture near-vertical trajectory or near-horizontal trajectory cosmic-ray muons. The software can track each muon passing through the system, and generate 3D images of the scene. The experimental design and preliminary results will be presented, including the comparisons of detection efficiency, image resolution, and integration times.
- 1 November 2014
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1-5
Imaging shielded configurations using near-horizontal and near-vertical trajectory cosmic-ray muons
This work will describe the proof-of-concept research applying muon tomography technologies based on drift tube systems to create images using near-horizontal trajectory muons. To date, the majority of imaging studies using cosmic-ray muons have used near-vertical trajectory muons. This work compares imaging results using near-vertical trajectory muons with results using near-horizontal trajectory muons. The muon flux is much lower for the near-horizontal trajectory muons, requiring longer imaging times, but the average muon energy is higher, so the horizontal results are expected to better differentiate high-Z materials. The muon tracking system is easily configurable and can be oriented to capture near-vertical trajectory or near-horizontal trajectory cosmic-ray muons. The software can track each muon passing through the system, and generate 3D images of the scene. The experimental design and preliminary results will be presented, including the comparisons of detection efficiency, image resolution, and integration times.
- 1 November 2014
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1-6
Detection of petawatt laser-induced muon source for rapid high-Z material detection
A proof-of-concept investigation of a rapid detection system for shielded high-Z material using a petawatt laser-based muon source is presented. Unlike cosmic-ray muons, a laser-induced muon beam has unique characteristics that can be exploited for use in a rapid detection system. These characteristics include: (1) a near-point source of muons, (2) well-characterized muon energies, (3) directionality of the beam, and (4) well-defined timing of the muons. A detector system is being developed that combines multiple muon detection technologies to characterize an active muon source. This detection system and the associated data acquisition and analysis techniques are designed to search for deflections of the muon beam as it passes through high-Z materials. Additionally, the ability of the system to differentiate muons from the expected secondary particles, such as high-energy gammas and electrons, is being explored. The detector system's ability to differentiate muons from other particles, muon angular distribution, and measured muon flux will be discussed.
- 1 November 2014
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1-6
Detection of petawatt laser-induced muon source for rapid high-Z material detection
A proof-of-concept investigation of a rapid detection system for shielded high-Z material using a petawatt laser-based muon source is presented. Unlike cosmic-ray muons, a laser-induced muon beam has unique characteristics that can be exploited for use in a rapid detection system. These characteristics include: (1) a near-point source of muons, (2) well-characterized muon energies, (3) directionality of the beam, and (4) well-defined timing of the muons. A detector system is being developed that combines multiple muon detection technologies to characterize an active muon source. This detection system and the associated data acquisition and analysis techniques are designed to search for deflections of the muon beam as it passes through high-Z materials. Additionally, the ability of the system to differentiate muons from the expected secondary particles, such as high-energy gammas and electrons, is being explored. The detector system's ability to differentiate muons from other particles, muon angular distribution, and measured muon flux will be discussed.
- 1 November 2014
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1-6
X-ray radar imaging technique using a 2 MeV linear electron accelerator
X-ray radar imaging, patented in 2013 by James R. Wood, combines standard radar techniques with the penetration power of x-rays to image scenes. Our project strives to demonstrate the technique using a 2 MeV linear electron accelerator (linac) to generate the S-band-modulated x-ray signals. X-ray detectors such as photodiodes and scintillators are used to detect the signals in backscatter and transmission detection schemes. The S-band microstructure is imposed on the variable-width electron pulse, and this modulation carries over to the bremsstrahlung x-rays after the electron beam is incident upon a copper-tungsten alloy target. Using phase/distance calculations and a low-jitter timing system, we expect to detect different object distances by comparing the measured phase differences. The experimental setup, which meets strict jitter requirements, and preliminary experimental results are presented.
- 1 November 2014
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1-6
X-ray radar imaging technique using a 2 MeV linear electron accelerator
X-ray radar imaging, patented in 2013 by James R. Wood, combines standard radar techniques with the penetration power of x-rays to image scenes. Our project strives to demonstrate the technique using a 2 MeV linear electron accelerator (linac) to generate the S-band-modulated x-ray signals. X-ray detectors such as photodiodes and scintillators are used to detect the signals in backscatter and transmission detection schemes. The S-band microstructure is imposed on the variable-width electron pulse, and this modulation carries over to the bremsstrahlung x-rays after the electron beam is incident upon a copper-tungsten alloy target. Using phase/distance calculations and a low-jitter timing system, we expect to detect different object distances by comparing the measured phase differences. The experimental setup, which meets strict jitter requirements, and preliminary experimental results are presented.
- Open Access
- 9 November 2012
- Published by AIP Publishing in AIP Advances
- Vol. 2 (4) , 042128
Obtaining material identification with cosmic ray radiography
The passage of muons through matter is dominated by the Coulomb interaction with electrons and nuclei in the matter. The muon interaction with the electrons leads to continuous energy loss and stopping of the muons. The muon interaction with nuclei leads to angular diffusion. Using both stopped muons and angle diffusion interactions allows us to determine density and identify materials. Here we demonstrate material identification using data taken at Los Alamos with a particle tracker built from a set of sealed drift tubes with commercial electronics and software, the Mini Muon Tracker (MMT).
- 9 November 2012
- Published by AIP Publishing in AIP Advances
- Vol. 2 (4) , 042128
Open AccessObtaining material identification with cosmic ray radiography
The passage of muons through matter is dominated by the Coulomb interaction with electrons and nuclei in the matter. The muon interaction with the electrons leads to continuous energy loss and stopping of the muons. The muon interaction with nuclei leads to angular diffusion. Using both stopped muons and angle diffusion interactions allows us to determine density and identify materials. Here we demonstrate material identification using data taken at Los Alamos with a particle tracker built from a set of sealed drift tubes with commercial electronics and software, the Mini Muon Tracker (MMT).
- 31 August 2006
- Published by SPIE-Intl Soc Optical Eng
- Vol. 6289, 628916
Design considerations for a time-resolved tomographic diagnostic at DARHT
An instrument has been developed to acquire time-resolved tomographic data from the electron beam at the DARHT [Dual-Axis Radiographic Hydrodynamic Test] facility at Los Alamos National Laboratory. The instrument contains four optical lines of sight that view a single tilted object. The lens design optically integrates along one optical axis for each line of sight. These images are relayed via fiber optic arrays to streak cameras, and the recorded streaks are used to reconstruct the original two-dimensional data. Installation of this instrument into the facility requires automation of both the optomechanical adjustments and calibration of the instrument in a constrained space. Additional design considerations include compound tilts on the object and image planes.© (2006) COPYRIGHT SPIE--The International Society for Optical Engineering. Downloading of the abstract is permitted for personal use only.
- 31 August 2006
- Published by SPIE-Intl Soc Optical Eng
- Vol. 6289, 628916
Design considerations for a time-resolved tomographic diagnostic at DARHT
An instrument has been developed to acquire time-resolved tomographic data from the electron beam at the DARHT [Dual-Axis Radiographic Hydrodynamic Test] facility at Los Alamos National Laboratory. The instrument contains four optical lines of sight that view a single tilted object. The lens design optically integrates along one optical axis for each line of sight. These images are relayed via fiber optic arrays to streak cameras, and the recorded streaks are used to reconstruct the original two-dimensional data. Installation of this instrument into the facility requires automation of both the optomechanical adjustments and calibration of the instrument in a constrained space. Additional design considerations include compound tilts on the object and image planes.© (2006) COPYRIGHT SPIE--The International Society for Optical Engineering. Downloading of the abstract is permitted for personal use only.