Emmanuel Lapebie
Research Subjects
Research Interests
Emmanuel Lapebie has a total of 67 co-authors. Here are the top co-authors by number of shared publications:
- Richard Saurel
Institut Universitaire des Systèmes Thermiques Industriels
6 shared publications Laurent Munier
CEA-DAM GRAMAT 3 , 46500 Gramat, France
5 shared publications- Frédéric Heymes
GARANCe, IMT Mines Alès
4 shared publications Gilles Dusserre
Ecole des Mines d'Ales (France)
3 shared publications- Pierre Slangen
EuroMov Digital Health in Motion, Univ Montpellier, IMT Mines Alès
3 shared publications R. Saurel
3 shared publications
Latest Publications
- 25 September 2025
- Published by Springer Nature in Shock Waves
- Vol. 35 (5) , 577-594
Shock wave propagation along a straight street
- 25 September 2025
- Published by Springer Nature in Shock Waves
- Vol. 35 (5) , 577-594
Shock wave propagation along a straight street
- 1 April 2022
- Published by Springer Nature in Shock Waves
- Vol. 32 (3) , 273-282
Analysis of 3D interaction of a blast wave with a finite wall
- 1 April 2022
- Published by Springer Nature in Shock Waves
- Vol. 32 (3) , 273-282
Analysis of 3D interaction of a blast wave with a finite wall
- Open Access
Modeling Heavy-Gas Dispersion in Air with Two-Layer Shallow Water Equations
Computation of gas dispersal in urban places or hilly grounds requires a large amount of computer time when addressed with conventional multidimensional models. Those are usually based on two-phase flow or Navier-Stokes equations. Different classes of simplified models exist. Among them, two-layer shallow water models are interesting to address large-scale dispersion. Indeed, compared to conventional multidimensional approaches, 2D simulations are carried out to mimic 3D effects. The computational gain in CPU time is consequently expected to be tremendous. However, such models involve at least three fundamental difficulties. The first one is related to the lack of hyperbolicity of most existing formulations, yielding serious consequences regarding wave propagation. The second is related to the non-conservative terms in the momentum equations. Those terms account for interactions between fluid layers. Recently, these two difficulties have been addressed in Chiapolino and Saurel (2018) and an unconditional hyperbolic model has been proposed along with a Harten-Lax-van Leer (HLL) type Riemann solver dealing with the non-conservative terms. In the same reference, numerical experiments showed robustness and accuracy of the formulation. In the present paper, a third difficulty is addressed. It consists of the determination of appropriate drag effect formulation. Such effects also account for interactions between fluid layers and become of particular importance when dealing with heavy-gas dispersion. With this aim, the model is compared to laboratory experiments in the context of heavy gas dispersal in quiescent air. It is shown that the model accurately reproduces experimental results thanks to an appropriate drag force correlation. This function expresses drag effects between the heavy and light gas layers. It is determined thanks to various experimental configurations of dam-break test problems.
Open AccessModeling Heavy-Gas Dispersion in Air with Two-Layer Shallow Water Equations
Computation of gas dispersal in urban places or hilly grounds requires a large amount of computer time when addressed with conventional multidimensional models. Those are usually based on two-phase flow or Navier-Stokes equations. Different classes of simplified models exist. Among them, two-layer shallow water models are interesting to address large-scale dispersion. Indeed, compared to conventional multidimensional approaches, 2D simulations are carried out to mimic 3D effects. The computational gain in CPU time is consequently expected to be tremendous. However, such models involve at least three fundamental difficulties. The first one is related to the lack of hyperbolicity of most existing formulations, yielding serious consequences regarding wave propagation. The second is related to the non-conservative terms in the momentum equations. Those terms account for interactions between fluid layers. Recently, these two difficulties have been addressed in Chiapolino and Saurel (2018) and an unconditional hyperbolic model has been proposed along with a Harten-Lax-van Leer (HLL) type Riemann solver dealing with the non-conservative terms. In the same reference, numerical experiments showed robustness and accuracy of the formulation. In the present paper, a third difficulty is addressed. It consists of the determination of appropriate drag effect formulation. Such effects also account for interactions between fluid layers and become of particular importance when dealing with heavy-gas dispersion. With this aim, the model is compared to laboratory experiments in the context of heavy gas dispersal in quiescent air. It is shown that the model accurately reproduces experimental results thanks to an appropriate drag force correlation. This function expresses drag effects between the heavy and light gas layers. It is determined thanks to various experimental configurations of dam-break test problems.
- 1 June 2018
- Published by Elsevier in Computers & Fluids
- Vol. 169, 213-229
Reprint of: Multiscale multiphase modeling of detonations in condensed energetic materials
- 1 June 2018
- Published by Elsevier in Computers & Fluids
- Vol. 169, 213-229
Reprint of: Multiscale multiphase modeling of detonations in condensed energetic materials
- 1 December 2017
- Published by Elsevier in Computers & Fluids
- Vol. 159, 95-111
Multiscale multiphase modeling of detonations in condensed energetic materials
- 1 December 2017
- Published by Elsevier in Computers & Fluids
- Vol. 159, 95-111
Multiscale multiphase modeling of detonations in condensed energetic materials
- 1 September 2017
- Published by Elsevier in Journal of Loss Prevention in the Process Industries
- Vol. 49, 248-265
Experimental investigation of blast wave propagation in an urban environment
- 1 September 2017
- Published by Elsevier in Journal of Loss Prevention in the Process Industries
- Vol. 49, 248-265
Experimental investigation of blast wave propagation in an urban environment
- 1 January 2017
- Published by AIP Publishing in AIP Conference Proceedings
- Vol. 1793, 040029
Experiments and modeling of dynamic powder compaction in the scope of deflagration to detonation transition studies
- 1 January 2017
- Published by AIP Publishing in AIP Conference Proceedings
- Vol. 1793, 040029
Experiments and modeling of dynamic powder compaction in the scope of deflagration to detonation transition studies
- 1 December 2016
- Published by AIP Publishing in Physics of Fluids
- Vol. 28 (12)
Phase diagram of crushed powders
Compression of monodisperse powder samples in quasistatic conditions is addressed in a pressure range such that particles fragmentation occurs while the solid remains incompressible (typical pressure range of 1–300 MPa for glass powders). For a granular bed made of particles of given size, the existence of three stages is observed during compression and crush up. First, classical compression occurs and the pressure of the granular bed increases along a characteristic curve as the volume decreases. Then, a critical pressure is reached for which fragmentation begins. During the fragmentation process, the granular pressure stays constant in a given volume range. At the end of this second stage, 20%–50% of initial grains are reduced to finer particles, depending on the initial size. Then the compression undergoes the third stage and the pressure increases along another characteristic curve, in the absence of extra fragmentation. The present paper analyses the analogies between the phase transition in liquid-vapour systems and powder compression with crush-up. Fragmentation diagram for a soda lime glass is determined by experimental means. The analogues of the saturation pressure and latent heat of phase change are determined. Two thermodynamic models are then examined to represent the crush-up diagram. The first one uses piecewise functions while the second one is of van der Waals type. Both equations of state relate granular pressure, solid volume fraction, and initial particle diameter. The piecewise functions approach provides reasonable representations of the phase diagram while the van der Waals one fails.
- 1 December 2016
- Published by AIP Publishing in Physics of Fluids
- Vol. 28 (12)
Phase diagram of crushed powders
Compression of monodisperse powder samples in quasistatic conditions is addressed in a pressure range such that particles fragmentation occurs while the solid remains incompressible (typical pressure range of 1–300 MPa for glass powders). For a granular bed made of particles of given size, the existence of three stages is observed during compression and crush up. First, classical compression occurs and the pressure of the granular bed increases along a characteristic curve as the volume decreases. Then, a critical pressure is reached for which fragmentation begins. During the fragmentation process, the granular pressure stays constant in a given volume range. At the end of this second stage, 20%–50% of initial grains are reduced to finer particles, depending on the initial size. Then the compression undergoes the third stage and the pressure increases along another characteristic curve, in the absence of extra fragmentation. The present paper analyses the analogies between the phase transition in liquid-vapour systems and powder compression with crush-up. Fragmentation diagram for a soda lime glass is determined by experimental means. The analogues of the saturation pressure and latent heat of phase change are determined. Two thermodynamic models are then examined to represent the crush-up diagram. The first one uses piecewise functions while the second one is of van der Waals type. Both equations of state relate granular pressure, solid volume fraction, and initial particle diameter. The piecewise functions approach provides reasonable representations of the phase diagram while the van der Waals one fails.
- Open Access
Phase diagram of crushed powders
Compression of monodisperse powder samples in quasistatic conditions is addressed in a pressure range such that particles fragmentation occurs while the solid remains incompressible (typical pressure range of 1-300 MPa for glass powders). For a granular bed made of particles of given size, the existence of three stages is observed during compression and crush up. First, classical compression occurs and the pressure of the granular bed increases along a characteristic curve as the volume decreases. Then, a critical pressure is reached for which fragmentation begins. During the fragmentation process, the granular pressure stays constant in a given volume range. At the end of this second stage, 20% to 50% of initial grains are reduced to finer particles, depending on the initial size. Then compression undergoes the third stage and the pressure increases along another characteristic curve, in the absence of extra fragmentation. The present paper analyses the analogies between phase transition in liquid-vapour systems and powder compression with crush-up. Fragmentation diagram of soda lime glass granular beds is determined by experimental means. The analogues of the saturation pressure and latent heat of phase change are determined. Two thermodynamic models are then examined to represent the crush-up diagram. The first one uses piecewise functions while the second one is of van der Waals type. Both equations of state relate granular pressure, solid volume fraction and initial particle diameter. The piecewise functions approach provides reasonable representations of the phase diagram while the van der Waals one fails.
Open AccessPhase diagram of crushed powders
Compression of monodisperse powder samples in quasistatic conditions is addressed in a pressure range such that particles fragmentation occurs while the solid remains incompressible (typical pressure range of 1-300 MPa for glass powders). For a granular bed made of particles of given size, the existence of three stages is observed during compression and crush up. First, classical compression occurs and the pressure of the granular bed increases along a characteristic curve as the volume decreases. Then, a critical pressure is reached for which fragmentation begins. During the fragmentation process, the granular pressure stays constant in a given volume range. At the end of this second stage, 20% to 50% of initial grains are reduced to finer particles, depending on the initial size. Then compression undergoes the third stage and the pressure increases along another characteristic curve, in the absence of extra fragmentation. The present paper analyses the analogies between phase transition in liquid-vapour systems and powder compression with crush-up. Fragmentation diagram of soda lime glass granular beds is determined by experimental means. The analogues of the saturation pressure and latent heat of phase change are determined. Two thermodynamic models are then examined to represent the crush-up diagram. The first one uses piecewise functions while the second one is of van der Waals type. Both equations of state relate granular pressure, solid volume fraction and initial particle diameter. The piecewise functions approach provides reasonable representations of the phase diagram while the van der Waals one fails.
- 1 July 2016
- Published by IGI Global Scientific Publishing in International Journal of Information Systems for Crisis Response and Management
- Vol. 8 (3) , 51-63
Mapping of Areas Presenting Specific Risks to Firefighters Due to Buried Technical Networks
Vehicles or freight cars on fire below a bridge or inside a tunnel are exceptional events and imply difficult intervention conditions for firefighters. A buried technical network like high voltage electricity line, gas or steam pipeline around such a fire causes additional specifics risks. Vulnerability areas for firefighters are zones where both factors exist: a difficult incident area together with a specific risk like buried networks. They require intervention teams with specific emergency response capabilities. The paper proposes a method developed for the Paris Fire Brigade for vulnerability mapping. Results aim at improving the mobilization in allocating directly the specific responses capabilities intervention teams. Results are debated from an operational point of view. Cutting off several network lines during firefighters' interventions may strongly affect the society. In case of simultaneous incidents in vulnerable areas, firefighters could be an early warning system and inform authorities of the risk of services disruption.
- 1 July 2016
- Published by IGI Global Scientific Publishing in International Journal of Information Systems for Crisis Response and Management
- Vol. 8 (3) , 51-63
Mapping of Areas Presenting Specific Risks to Firefighters Due to Buried Technical Networks
Vehicles or freight cars on fire below a bridge or inside a tunnel are exceptional events and imply difficult intervention conditions for firefighters. A buried technical network like high voltage electricity line, gas or steam pipeline around such a fire causes additional specifics risks. Vulnerability areas for firefighters are zones where both factors exist: a difficult incident area together with a specific risk like buried networks. They require intervention teams with specific emergency response capabilities. The paper proposes a method developed for the Paris Fire Brigade for vulnerability mapping. Results aim at improving the mobilization in allocating directly the specific responses capabilities intervention teams. Results are debated from an operational point of view. Cutting off several network lines during firefighters' interventions may strongly affect the society. In case of simultaneous incidents in vulnerable areas, firefighters could be an early warning system and inform authorities of the risk of services disruption.