Luis Martinez-Alvarado
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Luis Martinez-Alvarado has a total of 13 co-authors. Here are the top co-authors by number of shared publications:
Daniel Fernandez
Baolab Microsystems, Institut Politècnic del Campus de Terrassa, Terrassa, Spain
2 shared publicationsDaniel Fernández
2 shared publicationsJordi Madrenas
Advanced Hardware Architectures group, Electronic Engineering Department, Universitat Politècnica de Catalunya (UPC), Barcelona, Spain
2 shared publications- Jordi Madrenas
Electronic Engineering Department, Universitat Politècnica de Catalunya (UPC), Jordi Girona 1-3, 08034 Barcelona, Spain
2 shared publications Amoldo Diaz-Ramirez
Department of Computer Systems, Instituto Tecnológico de Mexicali, Mexicali, Baja California, México
1 shared publicationEdgar Dominguez
Department of Computer Systems, Instituto Tecnológico de Mexicali, Mexicali, Baja California, México
1 shared publication
Latest Publications
- 1 November 2015
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1-6
A falls detection system for the elderly based on a WSN
Accidental falls are one of the main causes of deaths and severe injuries of people over 65 years old. For this reason, the development of fall detection systems for the elderly has been an important research topic. In this paper, a non-invasive fall detection system for older people, based on the use of a wireless sensor network (WSN), is proposed. It uses the acoustic signal sensed by a node of the WSN, as well as signal processing and pattern recognition techniques to detect a fall. The model uses a signal-processing algorithm based on the use of cross-correlation to measure the similarity between the sampled signal and a reference template signal, which represents a fall event. If these two signals are similar, then the Mel-frequency cepstral coefficients (MFCC) of the fall sound are extracted. Afterwards, the dynamic time warping (DTW) method is used for pattern recognition. The evaluation of the proposed system showed a very good detection rate.
- 1 November 2015
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1-6
A falls detection system for the elderly based on a WSN
Accidental falls are one of the main causes of deaths and severe injuries of people over 65 years old. For this reason, the development of fall detection systems for the elderly has been an important research topic. In this paper, a non-invasive fall detection system for older people, based on the use of a wireless sensor network (WSN), is proposed. It uses the acoustic signal sensed by a node of the WSN, as well as signal processing and pattern recognition techniques to detect a fall. The model uses a signal-processing algorithm based on the use of cross-correlation to measure the similarity between the sampled signal and a reference template signal, which represents a fall event. If these two signals are similar, then the Mel-frequency cepstral coefficients (MFCC) of the fall sound are extracted. Afterwards, the dynamic time warping (DTW) method is used for pattern recognition. The evaluation of the proposed system showed a very good detection rate.
- 7 November 2011
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Journal of Solid-State Circuits
- Vol. 47 (2) , 490-503
A Translinear, Log-Domain FPAA on Standard CMOS Technology
A field-programmable analog array (FPAA) using a standard-CMOS wide-dynamic-range translinear element (TE) is introduced. The FPAA configurable analog blocks (CABs) are based on a reconfigurable translinear cell (RTC), capable of implementing the basic circuit elements required by translinear and log-domain circuit design. The interfacing is provided by an I/O programmable cell, which allows for easier connectivity between the signal-processing core and the external circuitry. As a proof-of-concept, a 5 × 5 RTC FPAA testchip was implemented in 0.35- μm CMOS technology. A set of various circuit primitives, such as one- and four-quadrant multipliers, an Euclidean distance operator and a fourth-order log-domain filter, were mapped on the chip in order to demonstrate the versatility of the approach. FPAA bandwidth reaches 20 MHz with a power consumption of 30 μW/TE and precision errors below 3%.
- 7 November 2011
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Journal of Solid-State Circuits
- Vol. 47 (2) , 490-503
A Translinear, Log-Domain FPAA on Standard CMOS Technology
A field-programmable analog array (FPAA) using a standard-CMOS wide-dynamic-range translinear element (TE) is introduced. The FPAA configurable analog blocks (CABs) are based on a reconfigurable translinear cell (RTC), capable of implementing the basic circuit elements required by translinear and log-domain circuit design. The interfacing is provided by an I/O programmable cell, which allows for easier connectivity between the signal-processing core and the external circuitry. As a proof-of-concept, a 5 × 5 RTC FPAA testchip was implemented in 0.35- μm CMOS technology. A set of various circuit primitives, such as one- and four-quadrant multipliers, an Euclidean distance operator and a fourth-order log-domain filter, were mapped on the chip in order to demonstrate the versatility of the approach. FPAA bandwidth reaches 20 MHz with a power consumption of 30 μW/TE and precision errors below 3%.
- 1 January 2011
- Published by INSTICC
- p. 260-267
BIOINSPIRED SENSORY INTEGRATION FOR ENVIRONMENT PERCEPTION EMBEDDED SYSTEMS
- 1 January 2011
- Published by INSTICC
- p. 260-267
BIOINSPIRED SENSORY INTEGRATION FOR ENVIRONMENT PERCEPTION EMBEDDED SYSTEMS
- 1 December 2009
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 715-718
Translinear signal processing circuits in standard CMOS FPAA
In this paper, the implementation of signal processing circuits on a novel translinear Field-Programmable Analog Array (FPAA) testchip is reported. The FPAA testchip is based on a 0.35-micron, fully CMOS translinear element, which is the core block of a reconfigurable analog cell. The FPAA embeds a 5 × 5 cell array. As implementation examples, a four-quadrant multiplier with five decade dynamic range and a programmable fourth-order low-pass filter with up to 7 MHz bandwidth have been mapped on the translinear FPAA. 14 cells have been used for the four-quadrant multiplier while 18 cells were needed for the fourth-order low-pass filter.
- 1 December 2009
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 715-718
Translinear signal processing circuits in standard CMOS FPAA
In this paper, the implementation of signal processing circuits on a novel translinear Field-Programmable Analog Array (FPAA) testchip is reported. The FPAA testchip is based on a 0.35-micron, fully CMOS translinear element, which is the core block of a reconfigurable analog cell. The FPAA embeds a 5 × 5 cell array. As implementation examples, a four-quadrant multiplier with five decade dynamic range and a programmable fourth-order low-pass filter with up to 7 MHz bandwidth have been mapped on the translinear FPAA. 14 cells have been used for the four-quadrant multiplier while 18 cells were needed for the fourth-order low-pass filter.
- 1 October 2009
- Published by Elsevier in AEU - International Journal of Electronics and Communications
- Vol. 63 (10) , 871-876
Self-controlled 4-transistor low-power min–max current selector
- 1 October 2009
- Published by Elsevier in AEU - International Journal of Electronics and Communications
- Vol. 63 (10) , 871-876
Self-controlled 4-transistor low-power min–max current selector