Szymon Goderski
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Szymon Goderski has a total of 23 co-authors. Here are the top co-authors by number of shared publications:
- Stefan Lis
Adam Mickiewicz University, Faculty of Chemistry, Uniwersytetu Poznańskiego 8, 61-614 Poznan, Poland
7 shared publications - Marcin Runowski
Faculty of Chemistry Adam Mickiewicz University Poznań Poland
6 shared publications - Natalia Stopikowska
Adam Mickiewicz University , Faculty of Chemistry, Department of Rare Earths , Umultowska 89b , 61-614 Poznań , Poland
3 shared publications Małgorzata Skwierczyńska
Adam Mickiewicz University , Faculty of Chemistry, Department of Rare Earths , Umultowska 89b , 61-614 Poznań , Poland
2 shared publications- Anna Ekner-Grzyb
Zakład Biologii Komórki, Wydział Biologii, Uniwersytet im. Adama Mickiewicza w Poznaniu
1 shared publication - Ayumi Ishii
Waseda University
1 shared publication
Latest Publications
- Open Access
- 16 December 2020
- Published by American Chemical Society (ACS) in ACS Omega
- Vol. 5 (51) , 32930-32938
Lanthanide Luminescence Enhancement of Core–Shell Magnetite–SiO2 Nanoparticles Covered with Chain-Structured Helical Eu/Tb Complexes
Oligomeric-brush chains of helical lanthanide (Ln) complexes retain their structural and luminescent behavior after coating onto magnetic nanoparticles (MNPs) consisting of Fe3O4 covered with silicate. It is one of the type of bifunctional NPs exhibiting luminescence of Ln and superparamagnetism of Fe3O4. In comparison to a simple monolayer of complexes adsorbed on a modified surface, a layer made of luminescent chains allowed us to obtain a more intensive red/green luminescence originating from Eu3+/Tb3+ ions, and at the same time, no visible increase in particle size (compared to Fe3O4@silica particles) was observed. The luminescent properties of the Tb3+ complex were altered by MNPs; the decrease of the luminescence was not as large as expected, the excitation spectrum changed significantly, and the average luminescence lifetime was much longer at room temperature. Surprisingly, this phenomenon was not observed at 77 K and also did not occur for the Eu3+ complexes. The possibility to stack building blocks in a chain using complexes of different lanthanide ions can be used to design novel multifunctional nanosystems.
- 16 December 2020
- Published by American Chemical Society (ACS) in ACS Omega
- Vol. 5 (51) , 32930-32938
Open AccessLanthanide Luminescence Enhancement of Core–Shell Magnetite–SiO2 Nanoparticles Covered with Chain-Structured Helical Eu/Tb Complexes
Oligomeric-brush chains of helical lanthanide (Ln) complexes retain their structural and luminescent behavior after coating onto magnetic nanoparticles (MNPs) consisting of Fe3O4 covered with silicate. It is one of the type of bifunctional NPs exhibiting luminescence of Ln and superparamagnetism of Fe3O4. In comparison to a simple monolayer of complexes adsorbed on a modified surface, a layer made of luminescent chains allowed us to obtain a more intensive red/green luminescence originating from Eu3+/Tb3+ ions, and at the same time, no visible increase in particle size (compared to Fe3O4@silica particles) was observed. The luminescent properties of the Tb3+ complex were altered by MNPs; the decrease of the luminescence was not as large as expected, the excitation spectrum changed significantly, and the average luminescence lifetime was much longer at room temperature. Surprisingly, this phenomenon was not observed at 77 K and also did not occur for the Eu3+ complexes. The possibility to stack building blocks in a chain using complexes of different lanthanide ions can be used to design novel multifunctional nanosystems.
- 21 March 2019
- Published by American Chemical Society (ACS) in ACS Applied Materials & Interfaces
- Vol. 11 (14) , 13389-13396
Upconverting Lanthanide Fluoride Core@Shell Nanorods for Luminescent Thermometry in the First and Second Biological Windows: β-NaYF4:Yb3+– Er3+@SiO2 Temperature Sensor
Up-converting core@shell type β-NaYF4:Yb3+-Er3+@SiO2 nanorods have been obtained by a two-step synthesis process, which encompasses hydrothermal and microemulsion routes. The synthesized nanomaterial forms stable aqueous colloids and exhibits a bright dual-center emission (λex= 975 nm), i.e. up-conversion luminescence of Er3+ and down-shifting emission of Yb3+, located in the first (I-BW) and the second (II-BW) biological windows of the spectral range. The intensity ratios of the emission bands of Er3+ and Yb3+ observed in the Vis-NIR range monotonously change with temperature, i.e. the thermalized Er3+ levels (2H11/2→4I15/2/4S3/2→4I15/2) and the non-thermally coupled Yb3+/Er3+ levels (2F5/2→2F7/2/4I9/2→4I15/2 or 4F9/2→4I15/2). Hence, their thermal evolutions have been correlated with temperature using the Boltzmann type distribution and 2-th order polynomial fits for temperature sensing purposes, i.e. Er3+ 525/545 nm (max Sr = 1.31 %K-1) and Yb3+/Er3+ 1010/810 nm (1.64 %K-1) or 1010/660 nm (0.96 %K-1). Additionally, a fresh chicken breast was used as a tissue imitation in the performed ex vivo experiment, showing the advantage of the use of NIR Yb3+/Er3+ bands, vs. the typically used Er3+ 525/545 nm band ratio, i.e. better penetration of the luminescence signal through the tissue in the I-BW and II-BW. Such nanomaterials can be utilized as accurate and effective, broad-range Vis-NIR optical, contactless sensors of temperature.
- 21 March 2019
- Published by American Chemical Society (ACS) in ACS Applied Materials & Interfaces
- Vol. 11 (14) , 13389-13396
Upconverting Lanthanide Fluoride Core@Shell Nanorods for Luminescent Thermometry in the First and Second Biological Windows: β-NaYF4:Yb3+– Er3+@SiO2 Temperature Sensor
Up-converting core@shell type β-NaYF4:Yb3+-Er3+@SiO2 nanorods have been obtained by a two-step synthesis process, which encompasses hydrothermal and microemulsion routes. The synthesized nanomaterial forms stable aqueous colloids and exhibits a bright dual-center emission (λex= 975 nm), i.e. up-conversion luminescence of Er3+ and down-shifting emission of Yb3+, located in the first (I-BW) and the second (II-BW) biological windows of the spectral range. The intensity ratios of the emission bands of Er3+ and Yb3+ observed in the Vis-NIR range monotonously change with temperature, i.e. the thermalized Er3+ levels (2H11/2→4I15/2/4S3/2→4I15/2) and the non-thermally coupled Yb3+/Er3+ levels (2F5/2→2F7/2/4I9/2→4I15/2 or 4F9/2→4I15/2). Hence, their thermal evolutions have been correlated with temperature using the Boltzmann type distribution and 2-th order polynomial fits for temperature sensing purposes, i.e. Er3+ 525/545 nm (max Sr = 1.31 %K-1) and Yb3+/Er3+ 1010/810 nm (1.64 %K-1) or 1010/660 nm (0.96 %K-1). Additionally, a fresh chicken breast was used as a tissue imitation in the performed ex vivo experiment, showing the advantage of the use of NIR Yb3+/Er3+ bands, vs. the typically used Er3+ 525/545 nm band ratio, i.e. better penetration of the luminescence signal through the tissue in the I-BW and II-BW. Such nanomaterials can be utilized as accurate and effective, broad-range Vis-NIR optical, contactless sensors of temperature.
- Open Access
- 31 August 2018
- Published by American Chemical Society (ACS) in ACS Omega
- Vol. 3 (8) , 10383-10390
Luminescent–Magnetic Cellulose Fibers, Modified with Lanthanide-Doped Core/Shell Nanostructures
Novel luminescent–magnetic cellulose microfibers were prepared by a dry–wet spinning method with the use of N-methylmorpholine-N-oxide. The synthesized luminescent–magnetic core/shell type nanostructures, based on the lanthanide-doped fluorides and magnetite nanoparticles (NPs)—Fe3O4/SiO2/NH2/PAA/LnF3, were used as nanomodifiers of the fibers. Thanks to the successful incorporation of the bifunctional nanomodifiers into the cellulose structure, the functionalized fibers exhibited superior properties, that is, bright multicolor emission under UV light and strong magnetic response. By the use of the as-prepared fibers, the luminescent–magnetic thread was fabricated and used to sew and make a unique pattern in the glove material, as a proof of concept for advanced, multimodal cloths’/materials’ protection against counterfeiting. The presence and uniform distribution of the modifier NPs in the polymer matrix were confirmed by X-ray diffraction, scanning electron microscopy, and energy-dispersive X-ray analysis (EDX). The concentration of the modifier NPs in the fibers was determined by inductively coupled plasma mass spectrometry, EDX, and magnetic measurements. The luminescence characteristics of the materials were examined by photoluminescence spectroscopy, and their magnetic field-responsive behavior was investigated by a superconducting quantum interference device.
- 31 August 2018
- Published by American Chemical Society (ACS) in ACS Omega
- Vol. 3 (8) , 10383-10390
Open AccessLuminescent–Magnetic Cellulose Fibers, Modified with Lanthanide-Doped Core/Shell Nanostructures
Novel luminescent–magnetic cellulose microfibers were prepared by a dry–wet spinning method with the use of N-methylmorpholine-N-oxide. The synthesized luminescent–magnetic core/shell type nanostructures, based on the lanthanide-doped fluorides and magnetite nanoparticles (NPs)—Fe3O4/SiO2/NH2/PAA/LnF3, were used as nanomodifiers of the fibers. Thanks to the successful incorporation of the bifunctional nanomodifiers into the cellulose structure, the functionalized fibers exhibited superior properties, that is, bright multicolor emission under UV light and strong magnetic response. By the use of the as-prepared fibers, the luminescent–magnetic thread was fabricated and used to sew and make a unique pattern in the glove material, as a proof of concept for advanced, multimodal cloths’/materials’ protection against counterfeiting. The presence and uniform distribution of the modifier NPs in the polymer matrix were confirmed by X-ray diffraction, scanning electron microscopy, and energy-dispersive X-ray analysis (EDX). The concentration of the modifier NPs in the fibers was determined by inductively coupled plasma mass spectrometry, EDX, and magnetic measurements. The luminescence characteristics of the materials were examined by photoluminescence spectroscopy, and their magnetic field-responsive behavior was investigated by a superconducting quantum interference device.
- 1 August 2017
- Published by Elsevier in Journal of Luminescence
- Vol. 188, 24-30
Luminescent-plasmonic effects in GdPO 4 :Eu 3+ nanorods covered with silver nanoparticles
- 1 August 2017
- Published by Elsevier in Journal of Luminescence
- Vol. 188, 24-30
Luminescent-plasmonic effects in GdPO 4 :Eu 3+ nanorods covered with silver nanoparticles
- 10 October 2016
- Published by American Chemical Society (ACS) in The Journal of Physical Chemistry C
- Vol. 120 (41) , 23788-23798
Preparation of Biocompatible, Luminescent-Plasmonic Core/Shell Nanomaterials Based on Lanthanide and Gold Nanoparticles Exhibiting SERS Effects
- 10 October 2016
- Published by American Chemical Society (ACS) in The Journal of Physical Chemistry C
- Vol. 120 (41) , 23788-23798
Preparation of Biocompatible, Luminescent-Plasmonic Core/Shell Nanomaterials Based on Lanthanide and Gold Nanoparticles Exhibiting SERS Effects
- 1 August 2016
- Published by Elsevier in Journal of Rare Earths
- Vol. 34 (8) , 808-813
Synthesis of luminescent KY3F10 nanopowder multi-doped with lanthanide ions by a co-precipitation method
- 1 August 2016
- Published by Elsevier in Journal of Rare Earths
- Vol. 34 (8) , 808-813
Synthesis of luminescent KY3F10 nanopowder multi-doped with lanthanide ions by a co-precipitation method