SKShadeepa Karunarathne

Shadeepa Karunarathne

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article

Previous Organizations / Institutes

The organizations / institutes from the scholar's other articles in the past ten years


Shadeepa Karunarathne has a total of 35 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Optimizing discharge product morphology with hetero-nanostructured NiCoP/NiCo 2 O 4 for enhanced sustainability in Li–O 2 battery performance

    by Shadeepa Karunarathne, Gabriel E. Pérez, W. P. S. L. Wijesinghe, François Orange, Yasun Y. Kannangara, Chirag R. Ratwani, Chanaka Sandaruwan, Alice Mija, Ali Reza Kamali, Amr M. Abdelkader

    Dual-phase electrocatalysts help to enhance Li–O 2 battery performances with a sheet-like Li 2 O 2 morphology.


  • Open Access

    Hetero-nanostructured NiCoP/NiCo2O4 for sustainable Li-O2 battery operation through optimised discharged product morphology

    by Shadeepa Karunarathne, Gabriel Pérez, W.P.S.L. Wijesinghe, Francois Orange, Yasun Kannangara, Chirag Ratwani, Chanaka Sandaruwan, Alice Mija, Ali Kamali, Amor Abdelkader

    Progress in Li-O2 battery (LOB) research is pivotal for achieving the ambitious goal of full electrification of transport. However, difficulties in promptly catalysing the sluggish oxygen kinetics remain the long outstanding challenge hindering the progress in LOB technology. Herein, the groundsel flower-like hierarchical microsphere network of NiCoP/NiCo2O4 (NCP@NCO/Ni) is synthesised in situ grafting on nickel foam as a high-performing oxygen cathode for LOBs. Both oxygen reduction and evolution reactions are kinetically enhanced by the presence of heterogeneous NiCoP and NiCo2O4 promoting surface electron transfer. The assembled LOB cells demonstrate an exceptional lifespan, withstanding over 400 cycles under a very high charge rate of 800 mAg-1 while achieving the highest discharge/ charging capacities of 15710/ 14632 mAh g-1 at 100 mAg-1 with low charging overpotentials, owing to unique catalytic support and fast charge transfer occurred across the interface in the heterostructure. Interestingly, the discharge capacity is only reduced by 10% to 14092 mAh g-1 even after the charge rate increases by 6 times, where the capacities of the pure metal phosphide and metal oxide cathodes fade substantially. The facile decomposition of sheet-like Li₂O₂ well-attached to the cathode surface enhances the cell’s reversibility and performance, overcoming the drawbacks of alternative Li₂O₂ morphologies.

  • Influence of graphene nanoplatelets on the thermal conductivity of heat transfer oils based on the developed hotwire method

    by A Karalasingam, Shadeepa Karunarathne, W P S L Wijesinghe, S A L Sameera, M G S De Silva, G A Amaratunga

    The thermal conductivity measurements of graphene nanoplatelets (GNP) loaded mineral oil suspensions are obtained using an unconventional custom-made Transient Hot-Wire setup using tungsten. The presence of a few layers of graphene in the prepared GNP using a single-step ultrasonication of graphite microparticles without the use of a surfactant is verified by AFM, TEM, Raman Spectroscopy, XRD, and XPS techniques. We measured the thermal conductivity and the specific heat capacity ( C p ) of GNP-loaded mineral oil suspensions. The experimental result shows a maximum of 45.5% increment in the thermal conductivity of the mineral oil with 1 mg ml−1 (11.481 × 10 − 4 weight fraction) loading of GNP at 30 °C. Despite thermal conductivity enhancements, the results indicate that the C p is not compromised, since a low concentration of nanoplatelets was used. The experimental results agree with the Maxwell-Garnett effective medium approach (MGEMA) model for the thermal conductivity of nanofluids which we found to be suitable for lower loading of nanoparticles. We propose GNP incorporated mineral oil suspensions are effective when it comes to heat transfer fluids even with the lower volume and mass fractions.


  • Open Access

    Stoichiometrically optimized e g orbital occupancy of Ni–Co oxide catalysts for Li–air batteries

    by Shadeepa Karunarathne, Yasun Y. Kannangara, Chirag R. Ratwani, Chanaka Sandaruwan, W. P. S. L. Wijesinghe, Ali Reza Kamali, Amr M. Abdelkader

    Lithium–air battery performance enhancement by optimizing the surface e g occupancy via adjusting the stoichiometric ratios of transition metal-based spinel structures.


  • Open Access

    Enhanced Wide Spectrum Photocatalytic Activity by in-Situ Magnetite-Graphite Nanoplatelets Heterostructure

    by S. A. L. Sameera, N. P. Edirisinghe, Yasun. Y. Kannangara, Shadeepa Karunarathne, K. R. Koswattage, H. C. S. Perera, G. Das, M. M. M. G. P. G. Mantilaka, W. P. S. L. Wijesinghe

    A UV, visible and NIR range irradiation responsive magnetite/graphite nanoplatelets composite was successfully synthesised via a single-step facile in-situ electrochemical exfoliation method using natural vein graphite. The spectral analysis revealed that as-synthesised photocatalytic could rapidly degrade the organic dyes with 96.1, 78.0 and 82.6 % efficiency in 120 minutes under respective UV, Visible, and NIR ranges of the electromagnetic spectrum. The formation of the magnetite-graphite nanoplatelet (GNP) nanocomposite was verified with X-ray diffraction (XRD), Fourier transform infrared absorption spectroscopy (FTIR), Raman spectroscopy, X-ray photoelectron spectroscopy (XPS), scanning electron microscopy (SEM), transmission electron microscopy (TEM), and atomic force microscopy (AFM) analysis. The scaffold of highly electrically conductive GNP helps magnetite nanoparticles for the efficient distribution of photoinduced electrons generated by the photocatalytic activity to participate in the photodegradation of organic dyes, through rapid superoxide radical formation. The current work presents a hypothesized mechanism for the photocatalyst composite synthesis, while a thorough discussion was made on the improvements in photocatalytic degradation kinetics under multiple irradiation conditions through the synergy of the magnetite and GNP. High efficiency, low-cost facile synthesis, easy up scalability, and the easy removal of the catalyst as needed via an external magnetic field can be identified as major benefits of as-synthesised green catalyst, which can be readily used in dye pollutant removal and wastewater treatment applications.


  • Development of universal fabric dyeing and adhesion through RF glow discharge plasma treatment

    by T.S.E.F. Karunarathne, Chanaka Sandaruwan, W.P.S.L. Wijesinghe, Anushanth Karalasignham, Amr.M. Abdelkader, G.A.J. Amaratunga, S.G.M. de Silva


  • Open Access

    Synthesis of a hydroxyapatite/poly(methyl methacrylate) nanocomposite using dolomite

    by W. P. S. L. Wijesinghe, M. M. M. G. P. G. Mantilaka, T. S. E. F. Karunarathne, R. M. G. Rajapakse

    Hydroxyapatite/poly(methyl methacrylate) (HA–PMMA) nanocomposites are extensively used in biomedical fields.


  • Open Access

    Polyaniline/palladium nanohybrids for moisture and hydrogen detection

    by Chanaka Sandaruwan, H. M. P. C. K. Herath, T. S. E. F. Karunarathne, S. P. Ratnayake, G. A. J. Amaratunga, D. P. Dissanayake

    Palladium nanoparticles display fascinating electronic, optical and catalytic properties, thus they can be used for various applications such as sensor fabrication. Conducting polymers such as polyaniline have also been widely used in sensor technology due to its cost effectiveness, versatility, and ease of synthesis. In this research, attention was given to unify the exceptional properties of these two materials and construct palladium nanoparticle coated polyaniline films to detect hydrogen and moisture. Electrochemical polymerization of aniline was carried out on gold sputtered epoxy resin boards. Polyaniline film was generated across a gap of 0.2 mm created by a scratch made on the gold coating prior to electrochemical polymerization. A palladium nanoparticle dispersion was prepared using sonochemical reduction method and coated on to polyaniline film using drop-drying technique. Polyaniline only films were also fabricated for comparative analysis. Sensitivity of films towards humidity and hydrogen was evaluated using impedance spectroscopy in the presence of the respective species. According to the results, polyaniline films exhibited an impedance drop in the presence of humidity and the response was significantly improved once palladium nanoparticles were incorporated. Interestingly, polyaniline only films did not respond to hydrogen. Nevertheless, palladium nanoparticle coated polyaniline films exhibited remarkable response towards hydrogen.