Ming-Chieh Hsu
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Ming-Chieh Hsu has a total of 26 co-authors. Here are the top co-authors by number of shared publications:
- Chao-Hsin Wu
National Taiwan University
2 shared publications - Chi-En Chen
Graduate School of Advanced Technology and the Center for Quantum Science and Engineering, National Taiwan University, Taipei, Taiwan
2 shared publications - Hirofumi Sumi
University of Tokyo, Tokyo, Japan
2 shared publications - Jau Yang Wu
College of Industry-Academia Innovation, National Taiwan University of Science and Technology 3 , Taipei
2 shared publications Kazuya Kitamura
NHK Science and Technology Research Laboratories, Tokyo, Japan
2 shared publicationsSatoshi Aoyama
Brookman Technology, Inc., Hamamatsu, Japan
2 shared publications
Latest Publications
- Open Access
- 1 December 2025
- Published by AIP Publishing in APL Photonics
- Vol. 10 (12)
A novel full-chip afterpulsing evaluation technique for 116 × 160 Ge-on-Si SPAD array
This Letter presents a novel on-chip afterpulsing characterization method demonstrated using gated-mode short-wave infrared single photon avalanche diode arrays, effectively overcoming the measurement limitations of conventional methods. Through this approach, we first achieve a comprehensive evaluation of the full-chip afterpulsing effect by adjusting the ratio between gated-on time and gated-off time and employing a sampling window technique. Experimentally validated using a room-temperature-operated 160 × 116 Ge-on-Si single photon avalanche diode array, the approach clearly reveals the potential pixel-to-pixel variations in afterpulsing behavior across SWIR single-photon avalanche diode arrays, highlighting the critical importance of full-chip evaluation for designing and optimizing gating period.
- 1 December 2025
- Published by AIP Publishing in APL Photonics
- Vol. 10 (12)
Open AccessA novel full-chip afterpulsing evaluation technique for 116 × 160 Ge-on-Si SPAD array
This Letter presents a novel on-chip afterpulsing characterization method demonstrated using gated-mode short-wave infrared single photon avalanche diode arrays, effectively overcoming the measurement limitations of conventional methods. Through this approach, we first achieve a comprehensive evaluation of the full-chip afterpulsing effect by adjusting the ratio between gated-on time and gated-off time and employing a sampling window technique. Experimentally validated using a room-temperature-operated 160 × 116 Ge-on-Si single photon avalanche diode array, the approach clearly reveals the potential pixel-to-pixel variations in afterpulsing behavior across SWIR single-photon avalanche diode arrays, highlighting the critical importance of full-chip evaluation for designing and optimizing gating period.
- 18 June 2024
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Electron Device Letters
- Vol. 45 (8) , 1413-1416
High Temperature Tolerant Ge-on-Si Single Photon Avalanche Diode at the Communication Wavelength
We present a practical design concept to reduce the noise of Ge-on-Si single photon avalanche diodes to improve temperature operation. In this letter, three different values of barrier height design have been investigated, and all devices exhibit ultra-low leakage current (-1/2 ). A high photon detection efficiency of 24.7 % and effective suppression of the dark count rate enable photon response at high temperatures up to 330 K with low and high barrier height designs, respectively. With our proposed structure design, the initial progress made by Ge-on-Si SPADs in overcoming challenges associated with low temperatures is underscored, emphasizing its potential in light detection and ranging applications across ambient and elevated temperatures.
- 18 June 2024
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Electron Device Letters
- Vol. 45 (8) , 1413-1416
High Temperature Tolerant Ge-on-Si Single Photon Avalanche Diode at the Communication Wavelength
We present a practical design concept to reduce the noise of Ge-on-Si single photon avalanche diodes to improve temperature operation. In this letter, three different values of barrier height design have been investigated, and all devices exhibit ultra-low leakage current (-1/2 ). A high photon detection efficiency of 24.7 % and effective suppression of the dark count rate enable photon response at high temperatures up to 330 K with low and high barrier height designs, respectively. With our proposed structure design, the initial progress made by Ge-on-Si SPADs in overcoming challenges associated with low temperatures is underscored, emphasizing its potential in light detection and ranging applications across ambient and elevated temperatures.
- Open Access
- 8 November 2017
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Electron Devices
- Vol. 64 (12) , 4992-5000
A 1.1- $\mu \text{m}$ 33-Mpixel 240-fps 3-D-Stacked CMOS Image Sensor With Three-Stage Cyclic-Cyclic-SAR Analog-to-Digital ConvertersIn this paper, a 1.1-$\mu \text{m}$ -pitch 33-Mpixel 240-fps backside-illuminated 3-D-stacked CMOS image sensor with three-stage cyclic-cyclic-successive-approximation-register (SAR) analog-to-digital converters (ADCs) is developed. The narrow-pitch interconnection technology that connects the pixels and arrayed ADCs inside the pixel area is described. The 3-D-stacked architecture, constructed using the interconnection technology, makes it possible to place a$\textsf {1932} ~{(}\textsf {H}{)} \times \textsf {4}~ {(}\textsf {V}{)}$ correlated-double-sampling/ADC array underneath the pixel area. Furthermore, the pipelined and parallel operation of the three-stage cyclic-cyclic-SAR ADC architecture effectively reduces the conversion time period and power consumption and achieves 12-b precision within one horizontal scan time of$0.92~\mu \text{s}$ . As a result, the interconnection technology and ADC architecture achieved a high frame rate of 240 fps in 33 Mpixels. Random noise of 3.6$\text{e}^{-}$ and low power consumption of 3.0 W were attained at an extremely high pixel rate of 7.96 Gpixel/s. A good figure of merit is achieved compared with recently developed image sensors.- 8 November 2017
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Electron Devices
- Vol. 64 (12) , 4992-5000
Open AccessA 1.1- $\mu \text{m}$ 33-Mpixel 240-fps 3-D-Stacked CMOS Image Sensor With Three-Stage Cyclic-Cyclic-SAR Analog-to-Digital ConvertersIn this paper, a 1.1-$\mu \text{m}$ -pitch 33-Mpixel 240-fps backside-illuminated 3-D-stacked CMOS image sensor with three-stage cyclic-cyclic-successive-approximation-register (SAR) analog-to-digital converters (ADCs) is developed. The narrow-pitch interconnection technology that connects the pixels and arrayed ADCs inside the pixel area is described. The 3-D-stacked architecture, constructed using the interconnection technology, makes it possible to place a$\textsf {1932} ~{(}\textsf {H}{)} \times \textsf {4}~ {(}\textsf {V}{)}$ correlated-double-sampling/ADC array underneath the pixel area. Furthermore, the pipelined and parallel operation of the three-stage cyclic-cyclic-SAR ADC architecture effectively reduces the conversion time period and power consumption and achieves 12-b precision within one horizontal scan time of$0.92~\mu \text{s}$ . As a result, the interconnection technology and ADC architecture achieved a high frame rate of 240 fps in 33 Mpixels. Random noise of 3.6$\text{e}^{-}$ and low power consumption of 3.0 W were attained at an extremely high pixel rate of 7.96 Gpixel/s. A good figure of merit is achieved compared with recently developed image sensors. - 1 January 2016
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 126-128
6.9 A 1.1µm 33Mpixel 240fps 3D-stacked CMOS image sensor with 3-stage cyclic-based analog-to-digital converters
There is an increasing demand for high-reality video systems. The ITU-R has standardized video parameters for ultra-high-definition TV (UHDTV), and the full-specification video signal stated in this international standard is prescribed as having a 7,680 (H) × 4,320 (V) pixel count, 120Hz frame frequency with progressive scanning, 12b tone reproduction, and wide color gamut. A 33Mpixel 120fps CMOS image sensor with a 12b column-parallel analog-to-digital converter (ADC) is reported in [1]. In addition to standard operation, higher sensitivity, smaller pixels, and a higher frame rate of 240fps or more are required for CMOS image sensors. Backside-illuminated stacked CMOS image sensors [2] are effective for simultaneously achieving both high sensitivity for small pixels and high operation speed. However, these stacked structures are still insufficient for high-frame-rate UHDTV image sensors since the pixel wafer and the ASIC wafer are connected by through-silicon vias in the peripheral area.
- 1 January 2016
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 126-128
6.9 A 1.1µm 33Mpixel 240fps 3D-stacked CMOS image sensor with 3-stage cyclic-based analog-to-digital converters
There is an increasing demand for high-reality video systems. The ITU-R has standardized video parameters for ultra-high-definition TV (UHDTV), and the full-specification video signal stated in this international standard is prescribed as having a 7,680 (H) × 4,320 (V) pixel count, 120Hz frame frequency with progressive scanning, 12b tone reproduction, and wide color gamut. A 33Mpixel 120fps CMOS image sensor with a 12b column-parallel analog-to-digital converter (ADC) is reported in [1]. In addition to standard operation, higher sensitivity, smaller pixels, and a higher frame rate of 240fps or more are required for CMOS image sensors. Backside-illuminated stacked CMOS image sensors [2] are effective for simultaneously achieving both high sensitivity for small pixels and high operation speed. However, these stacked structures are still insufficient for high-frame-rate UHDTV image sensors since the pixel wafer and the ASIC wafer are connected by through-silicon vias in the peripheral area.