Matthew R. Buck
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Matthew R. Buck has a total of 23 co-authors. Here are the top co-authors by number of shared publications:
- Austin E. Herzog
Chemistry Department Johns Hopkins University Baltimore MD 21218 USA
2 shared publications - Debra R. Rolison
U.S. Naval Research Laboratory
2 shared publications - Raymond E. Schaak
Pennsylvania State University
2 shared publications - Ryan Henry DeBlock
Former Member of Surface Chemistry Branch, Code 6170, U.S. Naval Research Laboratory, Washington, DC 20375, USA
2 shared publications - Travis G. Novak
U.S. Naval Research Laboratory, Washington, DC 20375, USA
2 shared publications Adam J. Biacchi
Department of Chemistry and Materials Research Institute, The Pennsylvania State University, University Park, Pennsylvania 16802, United States
1 shared publication
Latest Publications
- 3 February 2026
- Published by Royal Society of Chemistry (RSC) in Journal of Materials Chemistry A
- Vol. 14 (18) , 11000-11007
A dual-site approach in high-entropy oxide aerogels creates active and selective reverse water–gas shift catalysts
High-entropy oxides consist of 4 or more equimolar or near-equimolar elements stabilized in a crystalline phase. The inherently slow atomic diffusion in these materials holds promise for creating sinter-resistant high-temperature catalysts, but most reported synthetic methods create multi-metal materials with low surface area. Here, we introduce high-entropy rare-earth oxide aerogels (HERAs) as a route to unlock the nearly unlimited compositional versatility of high-entropy oxides in an architected nanostructure with high surface area (>130 m2 g-1). We demonstrate that a base oxide composition of (YZrCeHf)Ox readily hosts catalytically relevant transition metals (Ni, Co, Fe) to effectively catalyze the reverse water–gas shift (RWGS) reaction: CO2 + H2 → CO + H2O. A high-entropy composition comprising 2.5 at.% Ni and 20% Fe in (YZrCeHf)Ox aerogel is an exceptionally active, selective, and stable catalyst, with no loss of CO2 conversion over 90 h at 500°C and no CH4 byproduct detected.
- 3 February 2026
- Published by Royal Society of Chemistry (RSC) in Journal of Materials Chemistry A
- Vol. 14 (18) , 11000-11007
A dual-site approach in high-entropy oxide aerogels creates active and selective reverse water–gas shift catalysts
High-entropy oxides consist of 4 or more equimolar or near-equimolar elements stabilized in a crystalline phase. The inherently slow atomic diffusion in these materials holds promise for creating sinter-resistant high-temperature catalysts, but most reported synthetic methods create multi-metal materials with low surface area. Here, we introduce high-entropy rare-earth oxide aerogels (HERAs) as a route to unlock the nearly unlimited compositional versatility of high-entropy oxides in an architected nanostructure with high surface area (>130 m2 g-1). We demonstrate that a base oxide composition of (YZrCeHf)Ox readily hosts catalytically relevant transition metals (Ni, Co, Fe) to effectively catalyze the reverse water–gas shift (RWGS) reaction: CO2 + H2 → CO + H2O. A high-entropy composition comprising 2.5 at.% Ni and 20% Fe in (YZrCeHf)Ox aerogel is an exceptionally active, selective, and stable catalyst, with no loss of CO2 conversion over 90 h at 500°C and no CH4 byproduct detected.
- Open Access
- 22 November 2024
- Published by American Association for the Advancement of Science (AAAS) in Science Advances
- Vol. 10 (47) , eadr9120
Atomically dispersed nickel in CeO 2 aerogel catalysts completely suppresses methanation in the water-gas shift reaction
Nickel-based catalysts are widely studied for water-gas shift (WGS), a key intermediate step in hydrogen production from carbon-based feedstocks. Their viability under practical conditions is limited at high temperatures when Ni aggregates and converts CO to methane, an undesirable side product. Because experimental and computational studies identify undercoordinated Ni step sites as most active toward CH 4 formation, we eliminate Ni step sites by atomically dispersing Ni into networked, nanoparticulate CeO 2 aerogels. The mesoporous catalyst with 2.5 atomic % Ni in CeO 2 is highly active for WGS, converting near-equilibrium levels of CO at 350°C, while no CH 4 is detected at the limit of detection (2 aerogels leads to methanation. The CH 4 yield produced by the atomically dispersed Ni-substituted CeO 2 aerogel is over an order of magnitude lower than previously reported Ni-based catalysts claiming methane suppression, marking an important advance in the development of WGS catalysts.
- 22 November 2024
- Published by American Association for the Advancement of Science (AAAS) in Science Advances
- Vol. 10 (47) , eadr9120
Open AccessAtomically dispersed nickel in CeO 2 aerogel catalysts completely suppresses methanation in the water-gas shift reaction
Nickel-based catalysts are widely studied for water-gas shift (WGS), a key intermediate step in hydrogen production from carbon-based feedstocks. Their viability under practical conditions is limited at high temperatures when Ni aggregates and converts CO to methane, an undesirable side product. Because experimental and computational studies identify undercoordinated Ni step sites as most active toward CH 4 formation, we eliminate Ni step sites by atomically dispersing Ni into networked, nanoparticulate CeO 2 aerogels. The mesoporous catalyst with 2.5 atomic % Ni in CeO 2 is highly active for WGS, converting near-equilibrium levels of CO at 350°C, while no CH 4 is detected at the limit of detection (2 aerogels leads to methanation. The CH 4 yield produced by the atomically dispersed Ni-substituted CeO 2 aerogel is over an order of magnitude lower than previously reported Ni-based catalysts claiming methane suppression, marking an important advance in the development of WGS catalysts.
- 31 March 2022
- Published by American Chemical Society (ACS) in Chemistry of Materials
- Vol. 34 (7) , 2907-2918
Polyoxovanadates as Precursors for the Synthesis of Colloidal Multi-Metal Oxide Nanocrystals
- 31 March 2022
- Published by American Chemical Society (ACS) in Chemistry of Materials
- Vol. 34 (7) , 2907-2918
Polyoxovanadates as Precursors for the Synthesis of Colloidal Multi-Metal Oxide Nanocrystals
- 28 January 2014
- Published by American Chemical Society (ACS) in Chemistry of Materials
- Vol. 26 (3) , 1492-1499
Insights into the Thermal Decomposition of Co(II) Oleate for the Shape-Controlled Synthesis of Wurtzite-Type CoO Nanocrystals
- 28 January 2014
- Published by American Chemical Society (ACS) in Chemistry of Materials
- Vol. 26 (3) , 1492-1499
Insights into the Thermal Decomposition of Co(II) Oleate for the Shape-Controlled Synthesis of Wurtzite-Type CoO Nanocrystals
- 7 October 2008
- Published by American Chemical Society (ACS) in Journal of the American Chemical Society
- Vol. 130 (43) , 14042-14043
On-Wire Conversion Chemistry: Engineering Solid-State Complexity into Striped Metal Nanowires using Solution Chemistry Reactions
Multisegment template-grown metal nanowires have become important one-dimensional materials for a variety of applications in chemistry, physics, engineering, biology, and medicine. Segmented nanowires are traditionally fabricated in anodic alumina membranes using electrodeposition, and this technique is applicable to a range of metals, alloys, and semiconductors. Here we report an alternative and simple solution chemistry strategy for incorporating multimetal components of controllable length and composition into template-grown metal nanowires. By reacting membrane-confined nanowires with metal salt solutions under reducing conditions, site-specific diffusion occurs to convert one or both nanowire tips or the entire nanowire into a variety of multimetal phases. Platinum-based intermetallic compounds were chosen as targets for demonstrating the feasibility of the on-wire conversion chemistry.
- 7 October 2008
- Published by American Chemical Society (ACS) in Journal of the American Chemical Society
- Vol. 130 (43) , 14042-14043
On-Wire Conversion Chemistry: Engineering Solid-State Complexity into Striped Metal Nanowires using Solution Chemistry Reactions
Multisegment template-grown metal nanowires have become important one-dimensional materials for a variety of applications in chemistry, physics, engineering, biology, and medicine. Segmented nanowires are traditionally fabricated in anodic alumina membranes using electrodeposition, and this technique is applicable to a range of metals, alloys, and semiconductors. Here we report an alternative and simple solution chemistry strategy for incorporating multimetal components of controllable length and composition into template-grown metal nanowires. By reacting membrane-confined nanowires with metal salt solutions under reducing conditions, site-specific diffusion occurs to convert one or both nanowire tips or the entire nanowire into a variety of multimetal phases. Platinum-based intermetallic compounds were chosen as targets for demonstrating the feasibility of the on-wire conversion chemistry.