Nasreddine Nait-Said
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Nasreddine Nait-Said has a total of 39 co-authors. Here are the top co-authors by number of shared publications:
A. Benoudjit
Dept. of Electr. Eng., Univ. of Batna, Algeria
4 shared publicationsM.S. Nait-Said
4 shared publicationsAbdeldjalil Dahbi
3 shared publicationsB. Abdelhadi
Dept. of Electr. Eng., Univ. of Batna, Algeria
3 shared publications- Mohamed Said Nait Said
LSP-IE Laboratory, Electrical Engineering Department, Faculty of Technology, University of Batna 2, Batna, Algeria
3 shared publications Mohamed-Said Nait-Said
3 shared publications
Latest Publications
- 18 January 2022
- Published by Springer Nature in International Journal of System Assurance Engineering and Management
- Vol. 13 (5) , 2327-2337
System reconfiguration under open phase fault in a three-phase induction motor field-oriented controlled
- 18 January 2022
- Published by Springer Nature in International Journal of System Assurance Engineering and Management
- Vol. 13 (5) , 2327-2337
System reconfiguration under open phase fault in a three-phase induction motor field-oriented controlled
- Open Access
- 1 January 2021
- Published by Politehnica University Timisoara in Journal of Electrical Engineering
- Vol. 21 (3) , 165-171
Incipient short circuit fault impact on service continuity of an electric vehicle propelled by dual induction motors structure
The short circuit is among one of the most dangerous electrical faults in induction motor, which leads to serious implications on the motor operation and its performances. The present paper deals with the influence of the stator short circuit fault in its early stage in terms of performances and service continuity of an electric vehicle (EV) using dual induction motor’s structure piloted by Backstepping control. An equivalent induction motor model with turn-to-turn fault on one stator phase, without already assuming the temperature effect through an intrinsic model, is investigated and thereafter its impacts on electric vehicle performance using simulation tests are presented and discussed.
- 1 January 2021
- Published by Politehnica University Timisoara in Journal of Electrical Engineering
- Vol. 21 (3) , 165-171
Open AccessIncipient short circuit fault impact on service continuity of an electric vehicle propelled by dual induction motors structure
The short circuit is among one of the most dangerous electrical faults in induction motor, which leads to serious implications on the motor operation and its performances. The present paper deals with the influence of the stator short circuit fault in its early stage in terms of performances and service continuity of an electric vehicle (EV) using dual induction motor’s structure piloted by Backstepping control. An equivalent induction motor model with turn-to-turn fault on one stator phase, without already assuming the temperature effect through an intrinsic model, is investigated and thereafter its impacts on electric vehicle performance using simulation tests are presented and discussed.
- Open Access
- 2 September 2020
- Published by Polskie Towarzystwo Diagnostyki Technicznej in Diagnostyka
- Vol. 21 (3) , 41-47
Comparative study between propulsion control system failures of an electrical vehicle piloted by FOC and by DTC using dual-induction-motors structure
- 2 September 2020
- Published by Polskie Towarzystwo Diagnostyki Technicznej in Diagnostyka
- Vol. 21 (3) , 41-47
Open AccessComparative study between propulsion control system failures of an electrical vehicle piloted by FOC and by DTC using dual-induction-motors structure
- Open Access
- 2 April 2018
- Published by VSB - Technical University of Ostrava in Advances in Electrical and Electronic Engineering
- Vol. 16 (1) , 1 - 14-14
Novel Speed and Current Sensor FDI Schemes with an Improved AFTC for Induction Motor Drives
Novel Speed and Current Sensor FDI Schemes with an Improved AFTC for Induction Motor Drives
- 2 April 2018
- Published by VSB - Technical University of Ostrava in Advances in Electrical and Electronic Engineering
- Vol. 16 (1) , 1 - 14-14
Open AccessNovel Speed and Current Sensor FDI Schemes with an Improved AFTC for Induction Motor Drives
Novel Speed and Current Sensor FDI Schemes with an Improved AFTC for Induction Motor Drives
- Open Access
- 27 September 2016
- Published by VSB - Technical University of Ostrava in Advances in Electrical and Electronic Engineering
- Vol. 14 (3) , 247 - 253
On-Line Efficiency Improvement of Induction Motor Vector Controlled
Efficiency improvement is an important challenge for electric motor driven systems. For an induction motor, operation under rated conditions (at rated load with rated flux) is very efficient. However, in many situations, operation with rated flux causes low efficiency especially at light load ranges. In these applications, induction motor should operate at reduced flux which causes a balance between iron losses and copper losses leading to an improved efficiency. This paper concerns energy optimization, i.e. efficiency improvement is carried out via a controller designed on the basis of imposing the rated power factor, by finding a relationship between rotor flux and torque current component which can optimize the compromise between torque and efficiency in steady state as well as in transient state. Experimental results are presented to prove the effectiveness and validity of the proposed controller.
- 27 September 2016
- Published by VSB - Technical University of Ostrava in Advances in Electrical and Electronic Engineering
- Vol. 14 (3) , 247 - 253
Open AccessOn-Line Efficiency Improvement of Induction Motor Vector Controlled
Efficiency improvement is an important challenge for electric motor driven systems. For an induction motor, operation under rated conditions (at rated load with rated flux) is very efficient. However, in many situations, operation with rated flux causes low efficiency especially at light load ranges. In these applications, induction motor should operate at reduced flux which causes a balance between iron losses and copper losses leading to an improved efficiency. This paper concerns energy optimization, i.e. efficiency improvement is carried out via a controller designed on the basis of imposing the rated power factor, by finding a relationship between rotor flux and torque current component which can optimize the compromise between torque and efficiency in steady state as well as in transient state. Experimental results are presented to prove the effectiveness and validity of the proposed controller.
- 1 July 2016
- Published by Elsevier in Journal of Magnetism and Magnetic Materials
- Vol. 410, 137-143
Dynamic hysteresis modeling including skin effect using diffusion equation model
- 1 July 2016
- Published by Elsevier in Journal of Magnetism and Magnetic Materials
- Vol. 410, 137-143
Dynamic hysteresis modeling including skin effect using diffusion equation model
- 1 June 2016
- Published by Elsevier in International Journal of Hydrogen Energy
- Vol. 41 (22) , 9427-9442
A novel combined MPPT-pitch angle control for wide range variable speed wind turbine based on neural network
- 1 June 2016
- Published by Elsevier in International Journal of Hydrogen Energy
- Vol. 41 (22) , 9427-9442
A novel combined MPPT-pitch angle control for wide range variable speed wind turbine based on neural network
- 1 May 2016
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- Vol. 13, 365-370
A new flux rotor based MRAS for sensorless control of induction motor
A model reference adaptive system (MRAS) based speed estimator for sensorless induction motor (IM) drive is proposed in this paper. The MRAS is formed with flux rotor and the estimated stator current vector. The reference model utilizes measured current vector. On the other hand, the adjustable model uses the estimated stator current vector. The current is estimated through the solution of machine state equations. The performance of the estimator under regeneration is an important aspect, which is studied in this paper through the small signal analysis. In this paper, the principle and method of speed estimation and control set-up are described, as well as the results of an experiment that verified the effectiveness of the proposed method.
- 1 May 2016
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- Vol. 13, 365-370
A new flux rotor based MRAS for sensorless control of induction motor
A model reference adaptive system (MRAS) based speed estimator for sensorless induction motor (IM) drive is proposed in this paper. The MRAS is formed with flux rotor and the estimated stator current vector. The reference model utilizes measured current vector. On the other hand, the adjustable model uses the estimated stator current vector. The current is estimated through the solution of machine state equations. The performance of the estimator under regeneration is an important aspect, which is studied in this paper through the small signal analysis. In this paper, the principle and method of speed estimation and control set-up are described, as well as the results of an experiment that verified the effectiveness of the proposed method.
- 1 October 2014
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- No. 23807385,p. 352-359
Analysis of different converters used in wind energy conversion system
This paper studies performances of wind energy conversion system (WECS) using Permanent Magnet Synchronous Generator (PMSG). The big interest and requirements to high efficiency imposes the wind turbine to operate in variable speed mode, which inevitably requires power electronic converters to maximize the extracted power from the wind as well as decoupling generator dynamics from the grid or load. The aim of this paper is to present an analysis of the suitable topology among the most popular rectifier systems for the generator-side converter those are: the passive diode bridge rectifier and the active six-switch two level rectifier, another rectifier system considered in this study include combinations of a diode bridge rectifier and DC-DC converter, the half controlled rectifier topology is also discussed. This work provides a comparison study between performances of different rectifier systems to examine their performances in (WECSs) starting by modeling of the used converters in the rectifier system, then a comparison is made between the association of (PMSG-diode rectifier) and (PMSG- diode rectifier with DC-DC buck converter), then with fully controlled rectifier, in order to discover their influences on the performances of the PMSG and the wind turbine system. Simulation results using Matlab Similink are presented to support the conclusion.
- 1 October 2014
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- No. 23807385,p. 352-359
Analysis of different converters used in wind energy conversion system
This paper studies performances of wind energy conversion system (WECS) using Permanent Magnet Synchronous Generator (PMSG). The big interest and requirements to high efficiency imposes the wind turbine to operate in variable speed mode, which inevitably requires power electronic converters to maximize the extracted power from the wind as well as decoupling generator dynamics from the grid or load. The aim of this paper is to present an analysis of the suitable topology among the most popular rectifier systems for the generator-side converter those are: the passive diode bridge rectifier and the active six-switch two level rectifier, another rectifier system considered in this study include combinations of a diode bridge rectifier and DC-DC converter, the half controlled rectifier topology is also discussed. This work provides a comparison study between performances of different rectifier systems to examine their performances in (WECSs) starting by modeling of the used converters in the rectifier system, then a comparison is made between the association of (PMSG-diode rectifier) and (PMSG- diode rectifier with DC-DC buck converter), then with fully controlled rectifier, in order to discover their influences on the performances of the PMSG and the wind turbine system. Simulation results using Matlab Similink are presented to support the conclusion.
- 1 August 2014
- Published by Elsevier in Energy Conversion and Management
- Vol. 84, 346-353
Realization and control of a wind turbine connected to the grid by using PMSG
- 1 August 2014
- Published by Elsevier in Energy Conversion and Management
- Vol. 84, 346-353
Realization and control of a wind turbine connected to the grid by using PMSG