FEFrederik Edler

Frederik Edler

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Frederik Edler has a total of 51 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Shaping single atomic junctions in ultra-thin Ag structures by electromigration

    by A. Chatterjee, T. Heidenblut, F. Edler, E. Olsen, J. P. Stöckmann, C. Tegenkamp, H. Pfnür

    By characterizing and manipulating the conductive properties of single Ag nano-grain boundaries with electromigration—originally considered only as a detrimental effect for metallic nanostructures—we show that atomic point contacts can be generated at well-defined locations with extreme reliability in ultra-thin (5 nm) and ultra-small (minimum width 16 nm) Ag nanostructures, deposited on hydrogen terminated low-doped Si(100) samples. Single contacts were always obtained once the smallest constriction of the structures was below the average grain size of the Ag films and competing thermal migration was suppressed. These ultra-thin and laterally open structures on Si provide complete accessibility for local characterisation of the molecular junction.


  • Electromigration and morphological changes in Ag nanostructures

    by Atasi Chatterjee, T. Bai, Frederik Edler, Christoph Tegenkamp, Kirsten Weide-Zaage, Herbert Pfnür

    Electromigration (EM) as a structuring tool was investigated in Ag nanowires (width 300 nm, thickness 25 nm) and partly in notched and bow-tie Ag structures on a Si(1 0 0) substrate in ultra-high vacuum using a four-tip scanning tunneling microscope in combination with a scanning electron microscope. From simulations of Ag nanowires we got estimates of temperature profiles, current density profiles, EM and thermal migration (TM) mass flux distributions within the nanowire induced by critical current densities of 10 8 A cm −2 . At room temperature, the electron wind force at these current densities by far dominates over thermal diffusion, and is responsible for formation of voids at the cathode and hillocks at the anode side. For current densities that exceed the critical current densities necessary for EM, a new type of wire-like structure formation was found both at room temperature and at 100 K for notched and bow-tie structures. This suggests that the simultaneous action of EM and TM is structure forming, but with a very small influence of TM at low temperature.


  • Tuning the conductivity along atomic chains by selective chemisorption

    by F. Edler, I. Miccoli, J. P. Stöckmann, H. Pfnür, C. Braun, S. Neufeld, S. Sanna, W. G. Schmidt, C. Tegenkamp

    Adsorption of Au on vicinal Si(111) surfaces results in growth of long-range ordered metallic quantum wires. In this paper, we utilized site-specific and selective adsorption of oxygen to modify chemically the transport via different channels in the systems Si(553)-Au and Si(557)-Au. They were analyzed by electron diffraction and four-tip STM-based transport experiments. Modeling of the adsorption process by density functional theory shows that the adatoms and rest atoms on Si(557)-Au provide energetically favored adsorption sites, which predominantly alter the transport along the wire direction. Since this structural motif is missing on Si(553)-Au, the transport channels remain almost unaffected by oxidation.


  • Atomic size effects studied by transport in single silicide nanowires

    by I. Miccoli, F. Edler, H. Pfnür, S. Appelfeller, M. Dähne, K. Holtgrewe, S. Sanna, W. G. Schmidt, C. Tegenkamp

    Ultrathin metallic silicide nanowires with extremely high aspect ratios can be easily grown, e.g., by deposition of rare earth elements on semiconducting surfaces. These wires play a pivotal role in fundamental research and open intriguing perspectives for CMOS applications. However, the electronic properties of these one-dimensional systems are extremely sensitive to atomic-sized defects, which easily alter the transport characteristics. In this study, we characterized comprehensively TbSi2 wires grown on Si(100) and correlated details of the atomic structure with their electrical resistivities. Scanning tunneling microscopy (STM) as well as all transport experiments were performed in situ using a four-tip STM system. The measurements are complemented by local spectroscopy and density functional theory revealing that the silicide wires are electronically decoupled from the Si template. On the basis of a quasiclassical transport model, the size effect found for the resistivity is quantitatively explained in terms of bulk and surface transport channels considering details of atomic-scale roughness. Regarding future applications the full wealth of these robust nanostructures will emerge only if wires with truly atomically sharp interfaces can be reliably grown.


  • Interwire coupling forIn(4×1)/Si(111) probed by surface transport

    by F. Edler, I. Miccoli, S. Demuth, H. Pfnür, S. Wippermann, A. Lücke, W. G. Schmidt, C. Tegenkamp

    The In/Si(111) system reveals an anisotropy in the electrical conductivity and is a prototype system for atomic wires on surfaces. We use this system to study and tune the interwire interaction by adsorption of oxygen. Through rotational square four-tip transport measurements, both the parallel (σ||) and perpendicular (σ⊥) components are measured separately. The analysis of the I(V) curves reveals that σ⊥ is also affected by adsorption of oxygen, showing clearly an effective interwire coupling, in agreement with density-functional-theory-based calculations of the transmittance. In addition to these surface-state mediated transport channels, we confirm the existence of conducting parasitic space-charge layer channels and address the importance of substrate steps by performing the transport measurements of In phases grown on Si(111) mesa structures.


  • Surface-mediated electrical transport in single GaAs nanowires

    by Ilio Miccoli, Frederik Edler, Herbert Pfnur, Christoph Tegenkamp, Paola Prete, Nico Lovergine

    III-V semiconductor compound based nanowires (NWs) are expected to impact the fields of nano-electronic, nano-photonic, and photovoltaic devices. Self-assembly of crystal-phase controlled and high optical quality III-V NWs has been demonstrated. However, important physical and technological issues, such as carrier transport properties and reproducible incorporation of high dopant concentrations in NW materials, remain to be addressed for enabling robust nano-devices fabrication. In this work, we show the use of a multi-probe scanning tunneling microscope for the rapid electrical characterization of free-standing GaAs NWs, without any need for post-growth sample processing and contact fabrication. In particular, 2-probe I-V measurements were performed along the axis of a single 60-nm diameter unpassivated GaAs NW, and its resistance profile determined, obtaining high (in the range of GΩ) resistance values. Due to its reduced radial dimension, the NW is expected to be completely depleted. Analysis of the NW resistance profile reveals instead, that carrier transport is mediated by the NW surface states. Finally, by using the substrate as a reference electrode and placing the other three STM-tips along the NWs, we demonstrate a 4-point probe geometry that can be used for the electrical characterization of highly doped NWs.


  • Top Cited Papers
    Open Access

    The 100th anniversary of the four-point probe technique: the role of probe geometries in isotropic and anisotropic systems

    by I Miccoli, F Edler, H Pfnür, C Tegenkamp

    The electrical conductivity of solid-state matter is a fundamental physical property and can be precisely derived from the resistance measured via the four-point probe technique excluding contributions from parasitic contact resistances. Over time, this method has become an interdisciplinary characterization tool in materials science, semiconductor industries, geology, physics, etc, and is employed for both fundamental and application-driven research. However, the correct derivation of the conductivity is a demanding task which faces several difficulties, e.g. the homogeneity of the sample or the isotropy of the phases. In addition, these sample-specific characteristics are intimately related to technical constraints such as the probe geometry and size of the sample. In particular, the latter is of importance for nanostructures which can now be probed technically on very small length scales. On the occasion of the 100th anniversary of the four-point probe technique, introduced by Frank Wenner, in this review we revisit and discuss various correction factors which are mandatory for an accurate derivation of the resistivity from the measured resistance. Among others, sample thickness, dimensionality, anisotropy, and the relative size and geometry of the sample with respect to the contact assembly are considered. We are also able to derive the correction factors for 2D anisotropic systems on circular finite areas with variable probe spacings. All these aspects are illustrated by state-of-the-art experiments carried out using a four-tip STM/SEM system. We are aware that this review article can only cover some of the most important topics. Regarding further aspects, e.g. technical realizations, the influence of inhomogeneities or different transport regimes, etc, we refer to other review articles in this field.


  • Surface-Dominated Transport on a Bulk Topological Insulator

    by Lucas Barreto, Lisa Kühnemund, Frederik Edler, Christoph Tegenkamp, Jianli Mi, Martin Bremholm, Bo Brummerstedt Iversen, Christian Frydendahl, Marco Bianchi, Philip Hofmann

    Topological insulators are guaranteed to support metallic surface states on an insulating bulk, and one should thus expect that the electronic transport in these materials is dominated by the surfaces states. Alas, due to the high remaining bulk conductivity, it is challenging to achieve surface-dominated transport. Here we use nanoscale four-point setups with a variable contact distance on an atomically clean surface of bulk-insulating Bi2Te2Se. We show that the transport at 30 K is two-dimensional rather than three-dimensional, that is, surface-dominated, and we find a surface state mobility of 390(30) cm2 V–1 s–1 at 30 K at a carrier concentration of 8.71(7) × 1012 cm–2.


  • Exceptional ballistic transport in epitaxial graphene nanoribbons

    by Jens Baringhaus, Ming Ruan, Frederik Edler, Antonio Tejeda, Muriel Sicot, Amina Taleb-Ibrahimi, An-Ping Li, Zhigang Jiang, Edward H. Conrad, Claire Berger, et al.

    Graphene nanoribbons will be essential components in future graphene nanoelectronics. However, in typical nanoribbons produced from lithographically patterned exfoliated graphene, the charge carriers travel only about ten nanometres between scattering events, resulting in minimum sheet resistances of about one kilohm per square. Here we show that 40-nanometre-wide graphene nanoribbons epitaxially grown on silicon carbide are single-channel room-temperature ballistic conductors on a length scale greater than ten micrometres, which is similar to the performance of metallic carbon nanotubes. This is equivalent to sheet resistances below 1 ohm per square, surpassing theoretical predictions for perfect graphene by at least an order of magnitude. In neutral graphene ribbons, we show that transport is dominated by two modes. One is ballistic and temperature independent; the other is thermally activated. Transport is protected from back-scattering, possibly reflecting ground-state properties of neutral graphene. At room temperature, the resistance of both modes is found to increase abruptly at a particular length--the ballistic mode at 16 micrometres and the other at 160 nanometres. Our epitaxial graphene nanoribbons will be important not only in fundamental science, but also--because they can be readily produced in thousands--in advanced nanoelectronics, which can make use of their room-temperature ballistic transport properties.


  • Local transport measurements on epitaxial graphene

    by J. Baringhaus, F. Edler, C. Neumann, C. Stampfer, S. Forti, U. Starke, C. Tegenkamp

    Growth of large-scale graphene is still accompanied by imperfections. By means of a four-tip scanning tunneling and electron microscope (4-tip STM/SEM), the local structure of graphene grown on SiC(0001) was correlated with scanning electron microscope images and spatially resolved transport measurements. The systematic variation of probe spacings and substrate temperature has clearly revealed two-dimensional transport regimes of Anderson localization as well as of diffusive transport. The detailed analysis of the temperature dependent data demonstrates that the local on-top nano-sized contacts do not induce significant strain to the epitaxial graphene films.