Jeraime A. Griffith
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Jeraime A. Griffith has a total of 23 co-authors. Here are the top co-authors by number of shared publications:
- Tom Welton
Department of Chemistry, Imperial College London, White City Campus, London, W12 0BZ, UK
3 shared publications Gareth J. Rowlands
College of Sciences, Institute of Fundamental Sciences, Massey University, Private Bag 11-222, Palmerston North, New Zealand
2 shared publications- Olga Kuzmina
Department of Chemistry, Imperial College London, London, UK
2 shared publications Alastair J.S. McIntosh
1 shared publication- Antje Potthast
BOKU University Konrad-Lorenz-Strasse 24
1 shared publication - Cameron Charles Weber
School of Chemical Sciences University of Auckland Auckland New Zealand
1 shared publication
Latest Publications
- Open Access
- 23 November 2017
- Published by Royal Society of Chemistry (RSC) in Green Chemistry
- Vol. 19 (24) , 5949-5957
Superbase ionic liquids for effective cellulose processing from dissolution to carbonisation
A range of superbase derived ionic liquids (SILs) was synthesised and characterised. Their ability to dissolve cellulose and the characteristics of the produced fibres were correlated to their specific structural and solvent properties. 17 ionic liquids (ILs) (including 9 novel) were analysed and six ILs were selected to produce fibres: 1-ethyl-3-methylimidazolium acetate [C2C1im][OAc], 1-ethyl-3-methylimidazolium diethyl phosphate [C2C1im][DEP] and the SILs 1-ethyl-1,8-diazabicyclo[5.4.0]undec-7-enium diethylphosphate [DBUEt][DEP], 1,8-diazabicyclo[5.4.0]undec-7-enium acetate [DBUH][OAc], 1,5-diazabicyclo[4.3.0]non-5-enium acetate [DBNH][OAc] and 1-ethyl-1,5-diazabicyclo[4.3.0]non-5-enium diethylphsophate [DBNEt][DEP]. The mechanical properties of these fibres were investigated. The obtained fibres were then carbonised to explore possible application as carbon fibre precursors. The fibres obtained using a mixture of 1,5-diazabicyclo[4.3.0]non-5-enium based SILs with acetate and hexanoate anions (9 : 1), [DBNH][OAc][Hex], showed a promising combination of strength, stiffness and strain at failure values for applications in textiles and fibre reinforcement in renewable composites. Using Raman spectroscopy it is demonstrated that these fibres exhibit a relatively high degree of structural order, with fewer defects than the other materials. On the other hand, analogous fibres based on imidazolium cation with acetate and hexanoate anions (9 : 1), [C2C1im][OAc][Hex] showed a decline in the quality of the produced fibres compared to the fibres produced from [C2C1im][OAc], [C2C1im][DEP] or [DBNH][OAc][Hex].
- 23 November 2017
- Published by Royal Society of Chemistry (RSC) in Green Chemistry
- Vol. 19 (24) , 5949-5957
Open AccessSuperbase ionic liquids for effective cellulose processing from dissolution to carbonisation
A range of superbase derived ionic liquids (SILs) was synthesised and characterised. Their ability to dissolve cellulose and the characteristics of the produced fibres were correlated to their specific structural and solvent properties. 17 ionic liquids (ILs) (including 9 novel) were analysed and six ILs were selected to produce fibres: 1-ethyl-3-methylimidazolium acetate [C2C1im][OAc], 1-ethyl-3-methylimidazolium diethyl phosphate [C2C1im][DEP] and the SILs 1-ethyl-1,8-diazabicyclo[5.4.0]undec-7-enium diethylphosphate [DBUEt][DEP], 1,8-diazabicyclo[5.4.0]undec-7-enium acetate [DBUH][OAc], 1,5-diazabicyclo[4.3.0]non-5-enium acetate [DBNH][OAc] and 1-ethyl-1,5-diazabicyclo[4.3.0]non-5-enium diethylphsophate [DBNEt][DEP]. The mechanical properties of these fibres were investigated. The obtained fibres were then carbonised to explore possible application as carbon fibre precursors. The fibres obtained using a mixture of 1,5-diazabicyclo[4.3.0]non-5-enium based SILs with acetate and hexanoate anions (9 : 1), [DBNH][OAc][Hex], showed a promising combination of strength, stiffness and strain at failure values for applications in textiles and fibre reinforcement in renewable composites. Using Raman spectroscopy it is demonstrated that these fibres exhibit a relatively high degree of structural order, with fewer defects than the other materials. On the other hand, analogous fibres based on imidazolium cation with acetate and hexanoate anions (9 : 1), [C2C1im][OAc][Hex] showed a decline in the quality of the produced fibres compared to the fibres produced from [C2C1im][OAc], [C2C1im][DEP] or [DBNH][OAc][Hex].
- Open Access
- 4 April 2016
- Published by Royal Society of Chemistry (RSC) in Green Chemistry
- Vol. 18 (13) , 3758-3766
Enhancing the stability of ionic liquid media for cellulose processing: acetal protection or carbene suppression?
Although excellent candidate solvents for cellulose, capable of dissolving ≥20 wt% of the carbohydrate for electrospinning processes, dialkylimidazolium carboxylate ionic liquids undergo undesirable side reactions with the reducing end of saccharides, terminating in an equilibrium concentration of a 2-(hydroxymethyl)-substituted imidazolium ‘adduct’. The addition of small molar quantities of a benign, non-toxic and inexpensive co-solvent, e.g. glycerol, reduces the rate of adduct accumulation, thereby enhancing the long-term thermal stability and recyclability of the expensive ionic liquid component. NMR, UV-vis and mass spectrometry experiments reveal that the improved stability is likely attributable to suppression of the transient dialkylimidazol-2-ylidene carbene, via hydrogen-donation by the protic co-solvent, rather than by cyclic acetal protection of the carbohydrate. The incorporation of (up to) 10 wt% of glycerol into the solvent mixture does not exacerbate the rate of cellulose depolymerisation compared to in the neat ionic liquid, and high solubility of cellulose is maintained. Furthermore, a colourimetric comparison of the recovered solvents, following cellulose re-precipitation, demonstrates that glycerol does not increase the concentration of contaminant reducing sugars in the organic electrolyte.
- 4 April 2016
- Published by Royal Society of Chemistry (RSC) in Green Chemistry
- Vol. 18 (13) , 3758-3766
Open AccessEnhancing the stability of ionic liquid media for cellulose processing: acetal protection or carbene suppression?
Although excellent candidate solvents for cellulose, capable of dissolving ≥20 wt% of the carbohydrate for electrospinning processes, dialkylimidazolium carboxylate ionic liquids undergo undesirable side reactions with the reducing end of saccharides, terminating in an equilibrium concentration of a 2-(hydroxymethyl)-substituted imidazolium ‘adduct’. The addition of small molar quantities of a benign, non-toxic and inexpensive co-solvent, e.g. glycerol, reduces the rate of adduct accumulation, thereby enhancing the long-term thermal stability and recyclability of the expensive ionic liquid component. NMR, UV-vis and mass spectrometry experiments reveal that the improved stability is likely attributable to suppression of the transient dialkylimidazol-2-ylidene carbene, via hydrogen-donation by the protic co-solvent, rather than by cyclic acetal protection of the carbohydrate. The incorporation of (up to) 10 wt% of glycerol into the solvent mixture does not exacerbate the rate of cellulose depolymerisation compared to in the neat ionic liquid, and high solubility of cellulose is maintained. Furthermore, a colourimetric comparison of the recovered solvents, following cellulose re-precipitation, demonstrates that glycerol does not increase the concentration of contaminant reducing sugars in the organic electrolyte.
- Open Access
- 26 February 2016
- Published by Royal Society of Chemistry (RSC) in Physical Chemistry Chemical Physics
- Vol. 18 (12) , 8608-8624
A structural investigation of ionic liquid mixtures
The role of hydrogen bonding, π + –π + stacking and anion–π + interactions on the structure of ionic liquid mixtures has been elucidated through a combined theoretical and experimental approach.
- 26 February 2016
- Published by Royal Society of Chemistry (RSC) in Physical Chemistry Chemical Physics
- Vol. 18 (12) , 8608-8624
Open AccessA structural investigation of ionic liquid mixtures
The role of hydrogen bonding, π + –π + stacking and anion–π + interactions on the structure of ionic liquid mixtures has been elucidated through a combined theoretical and experimental approach.
- 1 January 2014
- Published by Elsevier in Sensors and Actuators B: Chemical
- Vol. 190, 818-821
A bio-inspired chemical sensor of gamma and neutron radiation
- 1 January 2014
- Published by Elsevier in Sensors and Actuators B: Chemical
- Vol. 190, 818-821
A bio-inspired chemical sensor of gamma and neutron radiation
- 30 April 2013
- Published by Royal Society of Chemistry (RSC) in RSC Advances
- Vol. 3 (24) , 9373-9380
Ligand assembly and chirality transfer guided by DNA modified with enantiomerically pure [2.2]paracyclophanes
Enantiomerically pure (Rp)- and (Sp)-4-azido[2.2]paracyclophane was incorporated into DNA using copper-catalysed azide–alkyne cycloaddition. While these modifications caused destabilisation of the duplexes, those that had the paracyclophane arrayed in a zipper-like motif were still stable at room temperature. The interactions of several modified duplexes with an achiral cationic perylenediimide were investigated. UV-VIS and CD data indicate that the transfer of chirality from paracylophane–DNA to the perylene is dependent on the arrangement of the chiral paracyclophanes in the preformed duplex. Significant thermal stabilisation of paracyclophane–DNA is observed upon addition of perylene (ΔTm = +8.0…19.0 °C), while no change in thermal stability is detected for the unmodified duplex. These findings pave the way for the design of DNAs with extended chiral properties which can further be translated into chemical transformations and into the design of chiral optical arrays.
- 30 April 2013
- Published by Royal Society of Chemistry (RSC) in RSC Advances
- Vol. 3 (24) , 9373-9380
Ligand assembly and chirality transfer guided by DNA modified with enantiomerically pure [2.2]paracyclophanes
Enantiomerically pure (Rp)- and (Sp)-4-azido[2.2]paracyclophane was incorporated into DNA using copper-catalysed azide–alkyne cycloaddition. While these modifications caused destabilisation of the duplexes, those that had the paracyclophane arrayed in a zipper-like motif were still stable at room temperature. The interactions of several modified duplexes with an achiral cationic perylenediimide were investigated. UV-VIS and CD data indicate that the transfer of chirality from paracylophane–DNA to the perylene is dependent on the arrangement of the chiral paracyclophanes in the preformed duplex. Significant thermal stabilisation of paracyclophane–DNA is observed upon addition of perylene (ΔTm = +8.0…19.0 °C), while no change in thermal stability is detected for the unmodified duplex. These findings pave the way for the design of DNAs with extended chiral properties which can further be translated into chemical transformations and into the design of chiral optical arrays.
- 14 November 2005
- Published by Georg Thieme Verlag KG in Synthesis
- Vol. 2005 (19) , 3446-3450
The Synthesis of Novel 4-(Aminomethyl)oxazoline Ligands
A practical route to 2,3-bis(amino)-1-alcohols has been developed and utilized in the synthesis of a number of novel bis(oxazoline) ligands.
- 14 November 2005
- Published by Georg Thieme Verlag KG in Synthesis
- Vol. 2005 (19) , 3446-3450
The Synthesis of Novel 4-(Aminomethyl)oxazoline Ligands
A practical route to 2,3-bis(amino)-1-alcohols has been developed and utilized in the synthesis of a number of novel bis(oxazoline) ligands.