Henryk Wrzosek
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Henryk Wrzosek has a total of 40 co-authors. Here are the top co-authors by number of shared publications:
- Wieslawa Urbaniak-Domagala
Poland, Łódź, Lodz University of Technology, Faculty of Material Technologies and Textile Design, Department of Material and Commodity Sciencs and Textile Metrology
5 shared publications - Beata Gutarowska
Department of Environmental Biotechnology, Faculty of Biotechnology and Food Sciences, Lodz University of Technology, Wolczanska 171/173, 90-530 Lodz, Poland
4 shared publications - Waldemar Machnowski
Textile Institute, Lodz University of Technology, 116 Żeromskiego Street, 90-924 Lodz, Poland
3 shared publications A. Jeziorny
Institute of Fiber Physics and Textile Finishing, Technical University of Lodz, 36 Zwirki Street, 90–924 Lodz, Poland
2 shared publicationsB. Lipp-Symonowicz
Institute of Fiber Physics and Textile Finishing, Technical University of Lodz, 36 Zwirki Street, 90–924 Lodz, Poland
2 shared publications- Michał Puchalski
Textile Institute, Lodz University of Technology, 116 Zeromskiego Street, 90-543 Lodz, Poland
2 shared publications
Latest Publications
- 1 July 2018
- Published by Elsevier in International Biodeterioration & Biodegradation
- Vol. 131, 88-96
Application of Cinnamomum zeylanicum essential oil in vapour phase for heritage textiles disinfection
- 1 July 2018
- Published by Elsevier in International Biodeterioration & Biodegradation
- Vol. 131, 88-96
Application of Cinnamomum zeylanicum essential oil in vapour phase for heritage textiles disinfection
- 1 July 2018
- Published by Elsevier in International Biodeterioration & Biodegradation
- Vol. 131, 97-106
Low temperature plasma for textiles disinfection
- 1 July 2018
- Published by Elsevier in International Biodeterioration & Biodegradation
- Vol. 131, 97-106
Low temperature plasma for textiles disinfection
- 17 August 2017
- Published by Taylor & Francis in Nanomedicine
- Vol. 12 (18) , 2161-2182
Carbon Nanotubes Functionalized With Folic Acid Attached Via Biomimetic Peptide Linker
Aim: Anchoring folic acid (FA) with a biomimetic peptidic linker resistant to proteolytic degradation to act as a homing device on functionalized carbon nanotubes. Materials & methods: Ethylenediamine was attached to oxidized multiwalled carbon nanotubes (MWNTs) using 4-(4,6-dimethoxy-[1,3,5]triazin-2-yl)-4-methylmorpholinium tetrafluoroborate. FA was coupled with 6-aminohexanoic acid and derivatives of β-alanine, affording four intermediates, which connected to the MWNTs via peptidic linkers of various lengths. Results: Biomimetic nanomaterials were produced with FA as a homing molecule. The structure and properties of the nanomaterials were analyzed, confirming the versatility of the peptides used as linkers. Conclusion: Conjugates of FA attached to MWNTs via peptide linkers prepared from β-alanine residues are resistant to proteolytic degradation. Viability in colon cancer cells and normal colonocytes confirmed their lack of cytotoxicity.
- 17 August 2017
- Published by Taylor & Francis in Nanomedicine
- Vol. 12 (18) , 2161-2182
Carbon Nanotubes Functionalized With Folic Acid Attached Via Biomimetic Peptide Linker
Aim: Anchoring folic acid (FA) with a biomimetic peptidic linker resistant to proteolytic degradation to act as a homing device on functionalized carbon nanotubes. Materials & methods: Ethylenediamine was attached to oxidized multiwalled carbon nanotubes (MWNTs) using 4-(4,6-dimethoxy-[1,3,5]triazin-2-yl)-4-methylmorpholinium tetrafluoroborate. FA was coupled with 6-aminohexanoic acid and derivatives of β-alanine, affording four intermediates, which connected to the MWNTs via peptidic linkers of various lengths. Results: Biomimetic nanomaterials were produced with FA as a homing molecule. The structure and properties of the nanomaterials were analyzed, confirming the versatility of the peptides used as linkers. Conclusion: Conjugates of FA attached to MWNTs via peptide linkers prepared from β-alanine residues are resistant to proteolytic degradation. Viability in colon cancer cells and normal colonocytes confirmed their lack of cytotoxicity.
- 1 January 2017
- Published by Elsevier in Journal of Cultural Heritage
- Vol. 23, 138-147
Microbial diversity of pre-Columbian archaeological textiles and the effect of silver nanoparticles misting disinfection
- 1 January 2017
- Published by Elsevier in Journal of Cultural Heritage
- Vol. 23, 138-147
Microbial diversity of pre-Columbian archaeological textiles and the effect of silver nanoparticles misting disinfection
- Open Access
- 20 April 2015
- Published by SAGE Publications in Textile Research Journal
- Vol. 86 (1) , 72-85
Plasma modification of polylactide nonwovens for dressing and sanitary applications
Polylactide (PLA) non-woven surfaces were modified with Radio Frequency plasma (RF) under reduced pressure with the use of two media, air and C6F14 vapor. The effectiveness of the plasma modification of nonwovens was analyzed by examining the fiber surface layer with ATR-FTIR absorption spectroscopy, SEM/EDX microanalysis of atomic composition, SEM surface morphology, wettability tests, susceptibility to water, and physiological liquid absorption tests and air permeability tests. The type of plasma used determines the effect obtained. Air plasma improves sorption properties of nonwovens and does not significantly affect air permeability. C6F14 vapor plasma significantly reduces the absorption of liquids by the fabric and increases its hydrophobicity. The effects obtained from the plasma are stable for six months of fabrics storage after treatment. PLA fabrics modified with plasma can be used for various applications such as dressing and sanitary materials.
- 20 April 2015
- Published by SAGE Publications in Textile Research Journal
- Vol. 86 (1) , 72-85
Open AccessPlasma modification of polylactide nonwovens for dressing and sanitary applications
Polylactide (PLA) non-woven surfaces were modified with Radio Frequency plasma (RF) under reduced pressure with the use of two media, air and C6F14 vapor. The effectiveness of the plasma modification of nonwovens was analyzed by examining the fiber surface layer with ATR-FTIR absorption spectroscopy, SEM/EDX microanalysis of atomic composition, SEM surface morphology, wettability tests, susceptibility to water, and physiological liquid absorption tests and air permeability tests. The type of plasma used determines the effect obtained. Air plasma improves sorption properties of nonwovens and does not significantly affect air permeability. C6F14 vapor plasma significantly reduces the absorption of liquids by the fabric and increases its hydrophobicity. The effects obtained from the plasma are stable for six months of fabrics storage after treatment. PLA fabrics modified with plasma can be used for various applications such as dressing and sanitary materials.
- 8 March 2013
- Published by SAGE Publications in Textile Research Journal
- Vol. 83 (17) , 1775-1785
Influence of the calender temperature on the crystallization behaviors of polylactide spun-bonded non-woven fabrics
In this paper the influence of calender temperature on the crystallization behavior of polylactide (PLA) non-woven fabrics during their manufacturing by the spun-bonding technique is described. Non-woven samples were studied by wide-angle X-ray diffraction, differential scanning calorimetry and birefringence. In addition, physical–mechanical properties of the non-woven fabrics were determined. The results are discussed in terms of structural changes of PLA and meso-phase content during the calendering process in the temperature range 70–130℃. The rebuilding of the supermolecular structure of the investigated samples of PLA fabrics under the influence of increasing calender temperature is observed in terms of the disorder-to-order phase transition (ά to α form) during heating around 110℃, and increased degree of crystallinity up to 100℃. The presented structural rebuild of PLA explains observed changes of physical–mechanical properties of the non-woven fabrics obtained at different calendering temperatures. During calendering above 100℃, thermal degradation of PLA occurs at the point of contact between the non-woven fabrics and the calender rollers.
- 8 March 2013
- Published by SAGE Publications in Textile Research Journal
- Vol. 83 (17) , 1775-1785
Influence of the calender temperature on the crystallization behaviors of polylactide spun-bonded non-woven fabrics
In this paper the influence of calender temperature on the crystallization behavior of polylactide (PLA) non-woven fabrics during their manufacturing by the spun-bonding technique is described. Non-woven samples were studied by wide-angle X-ray diffraction, differential scanning calorimetry and birefringence. In addition, physical–mechanical properties of the non-woven fabrics were determined. The results are discussed in terms of structural changes of PLA and meso-phase content during the calendering process in the temperature range 70–130℃. The rebuilding of the supermolecular structure of the investigated samples of PLA fabrics under the influence of increasing calender temperature is observed in terms of the disorder-to-order phase transition (ά to α form) during heating around 110℃, and increased degree of crystallinity up to 100℃. The presented structural rebuild of PLA explains observed changes of physical–mechanical properties of the non-woven fabrics obtained at different calendering temperatures. During calendering above 100℃, thermal degradation of PLA occurs at the point of contact between the non-woven fabrics and the calender rollers.
- 26 June 2012
- Published by SAGE Publications in Textile Research Journal
- Vol. 83 (1) , 44-55
Effects of gamma radiation on the mechanical properties of and susceptibility to biodegradation of natural fibers
The effect of gamma radiation on the mechanical properties and surface structure of woven fabrics made of cotton, flax, and silk fibers was investigated. It was found that small radiation doses (up to 15 kGy), sufficient for effective disinfection of textiles, caused only insignificant changes in the fiber parameters tested. However, it was found that doses increased to 100 kGy bring about a considerable weakening of the tested fabrics——their tensile strength decreases by 26–33%. Microbiological examination has shown that preradiation of cotton and linen fabric samples with a dose of 100 kGy does not affect the susceptibility of these fabrics to fungal biodegradation. A silk fabric irradiated under the same conditions shows clear susceptibility to bacterial biodegradation.
- 26 June 2012
- Published by SAGE Publications in Textile Research Journal
- Vol. 83 (1) , 44-55
Effects of gamma radiation on the mechanical properties of and susceptibility to biodegradation of natural fibers
The effect of gamma radiation on the mechanical properties and surface structure of woven fabrics made of cotton, flax, and silk fibers was investigated. It was found that small radiation doses (up to 15 kGy), sufficient for effective disinfection of textiles, caused only insignificant changes in the fiber parameters tested. However, it was found that doses increased to 100 kGy bring about a considerable weakening of the tested fabrics——their tensile strength decreases by 26–33%. Microbiological examination has shown that preradiation of cotton and linen fabric samples with a dose of 100 kGy does not affect the susceptibility of these fabrics to fungal biodegradation. A silk fabric irradiated under the same conditions shows clear susceptibility to bacterial biodegradation.
- 1 March 2009
- Published by Taylor & Francis in Materials Technology
- Vol. 24 (1) , 24-28
Deposition of polypyrrole insulating layer on copper monofilaments using low temperature plasma technique
Polypyrrole is a material with growing application in technique and medicine. It characterises with thermal durability, environmental resistance, and biocompatibility, electric conductivity regulated in wide range by using of dopants. In the following research plasma RF 13·56 MHz type H was used to obtained electroinsulating polypyrrole layers covering the surface of metallic (Cu) monofilament. The developed multilayer monofilaments can be used as the initial material in wearable electronics. Influence of polymerisation conditions such as deposition time and the pressure of monomer vapours on morphological structure of plasma polypyrrole was analysed by using SEM technique. The results of research show, that plasma polymer layers deposited on the Cu cylindrical substrates are uniform, with thickness dependent on the time deposition and resistant to action of dynamic loads on a loom.
- 1 March 2009
- Published by Taylor & Francis in Materials Technology
- Vol. 24 (1) , 24-28
Deposition of polypyrrole insulating layer on copper monofilaments using low temperature plasma technique
Polypyrrole is a material with growing application in technique and medicine. It characterises with thermal durability, environmental resistance, and biocompatibility, electric conductivity regulated in wide range by using of dopants. In the following research plasma RF 13·56 MHz type H was used to obtained electroinsulating polypyrrole layers covering the surface of metallic (Cu) monofilament. The developed multilayer monofilaments can be used as the initial material in wearable electronics. Influence of polymerisation conditions such as deposition time and the pressure of monomer vapours on morphological structure of plasma polypyrrole was analysed by using SEM technique. The results of research show, that plasma polymer layers deposited on the Cu cylindrical substrates are uniform, with thickness dependent on the time deposition and resistant to action of dynamic loads on a loom.
- Open Access
- 25 July 1997
- Published by Wiley in Journal of Applied Polymer Science
- Vol. 65 (4) , 807-819
Chitin filaments from dibutyrylchitin precursor: Fine structure and physical and physicochemical properties
- 25 July 1997
- Published by Wiley in Journal of Applied Polymer Science
- Vol. 65 (4) , 807-819
Open AccessChitin filaments from dibutyrylchitin precursor: Fine structure and physical and physicochemical properties
- 5 December 1994
- Published by Wiley in Journal of Applied Polymer Science
- Vol. 54 (10) , 1469-1482
Studies upon the fine structure and selected physical and physicochemical properties of butrylchitin membranes
- 5 December 1994
- Published by Wiley in Journal of Applied Polymer Science
- Vol. 54 (10) , 1469-1482
Studies upon the fine structure and selected physical and physicochemical properties of butrylchitin membranes