Zongyan Lv

Limited knowledge exists regarding gasoline and diesel exhaust effects on lipid metabolism. This study collected gasoline and diesel exhaust under actual driving conditions and conducted inhalation exposure on male young and middle-aged C57BL/6J mice for 4 h/day for 5 days to simulate commuting exposure intensity. Additionally, PM_2.5 from actual roadways, representing gasoline and diesel vehicles, was generated for exposure to human umbilical vein endothelial cells (HUVECs) and normal liver cells (LO2) for 24, 48, and 72 h to further investigate exhaust particle toxicity. Results showed that diesel exhaust reduced total cholesterol and low-density lipoprotein cholesterol levels in young mice, indicating disrupted lipid metabolism. Aspartate aminotransferase and alanine aminotransferase levels increased by 53.7% and 21.7%, respectively, suggesting potential liver injury. Diesel exhaust exposure decreased superoxide dismutase and increased glutathione peroxidase levels. Cell viability decreased, and reactive oxygen species levels increased in HUVECs and LO2 following exposure to exhaust particles, with dose- and time-dependent effects. Diesel exhaust particles exhibited more severe inhibition of cell proliferation and oxidative damage compared to gasoline exhaust particles. These findings provide novel evidence of the risk of disrupted lipid metabolism due to gasoline and diesel exhaust, emphasizing the toxicity of diesel exhaust.

Vehicle exhaust emissions have seriously affected air quality and human health, and understanding the emission characteristics of vehicle pollutants can promote emission reductions. In this study, a chassis dynamometer was used to study the emission characteristics of the pollutants of two gasoline vehicles (Euro 5 and Euro 6) when using six kinds of fuels. The results show that the two tested vehicles had different engine performance under the same test conditions, which led to a significant difference in their emission characteristics. The fuel consumption and pollutant emission factors of the WLTC cycle were higher than those of the NEDC. The research octane number (RON) and ethanol content of fuels have significant effects on pollutant emissions. For the Euro 5 vehicle, CO and particle number (PN) emissions decreased under the WLTC cycle, and NOx emissions decreased with increasing RONs. For the Euro 6 vehicle, CO and NOx emissions decreased and PN emissions increased with increasing RONs. Compared with traditional gasoline, ethanol gasoline (E10) led to decreases in NOx and PN emissions, and increased CO emissions for the Euro 5 vehicle, while it led to higher PN and NOx emissions and lower CO emissions for the Euro 6 vehicle. In addition, the particulate matter emitted was mainly nucleation-mode particulate matter, accounting for more than 70%. There were two peaks in the particle size distribution, which were about 18 nm and 40 nm, respectively. Finally, compared with ethanol–gasoline, gasoline vehicles with high emission standards (Euro 6) are more suitable for the use of traditional gasoline with a high RON.

Previous works on real-world vehicle emission characteristics have mainly focused on the influences of fuel, speed, vehicle type, elevation, and other factors on vehicle emission quantity and components. However, few studies have investigated the transient trend of automotive exhaust emissions through on-road measurements. The key objective of the present paper was to examine the transient characteristics of exhaust emissions from different vehicle types on the roads of Tianjin. To achieve the goal, a portable emission measurement system (PEMS) was employed to monitor emissions from selected test vehicles—private cars, passenger vehicles, and cargo vehicles. It was found that the high-emission points of test vehicles were mainly distributed in two regions: the high-speed region (speed > 70–90 km/h, vehicle-specific power (VSP) > 0 kW/t) and the medium-speed–acceleration region (20–30 km/h < speed < 60–90 km/h, 0 kW/t <VSP < 12 kW/t). The CO, hydrocarbon (HC), NOx, and particulate number (PN) average emission rates in the high-emission points could be 3.15–14.93 times, 1.93–24.89 times, 3.23–6.03 times, and 3.22–30.27 times of those of average emission rates. The HC, NOx, and PN average emission rates of China IV vehicles in the high-emission points were 2.46–4.92 times, 3.56–6.03 times, and 3.22–13.21 times of those of average emission rates, not less than those of China III (1.93–2.52 times, 2.75–3.90 times, and 9.98–22.34 times). Test vehicles mainly emitted nucleation-mode and Aitken-mode particles, and the increase of the PN concentration emission rate in low-speed and high-speed regions was higher than that in the medium-speed region. The exhaust gas recirculation (EGR) + diesel particulate filter (DPF) could effectively inhibit the Aitken output caused by turbocharged intercooler (CIC). The selective catalytic reduction (SCR) might cause more nucleation-mode particles.