Ana Paula Pinto Correia
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Ana Paula Pinto Correia has a total of 6 co-authors. Here are the top co-authors by number of shared publications:
- Pedro Barquinha
CENIMAT|i3N, Department of Materials Science, School of Science and Technology, NOVA University Lisbon and CEMOP/UNINOVA, 2829-516 Caparica, Portugal
8 shared publications - Joao Goes
Department of Electrical and Computer Engineering, Faculty of Sciences and Technology, Universidade Nova de Lisboa, Caparica, Portugal
7 shared publications - Elvira Fortunato
CENIMAT|i3N, Department of Materials Science, School of Science and Technology, NOVA University Lisbon and CEMOP/UNINOVA, 2829-516 Caparica, Portugal
1 shared publication João Carlos da Palma Goes
1 shared publication- Rodrigo Martins
CENIMAT|i3N, Department of Materials Science, School of Science and Technology, NOVA University Lisbon and CEMOP/UNINOVA, 2829-516 Caparica, Portugal
1 shared publication - Vítor Grade Tavares
INESC TEC and Faculty of Engineering, University of Porto, Campus FEUP, Rua Dr. Roberto Frias, 378, 4200-465 Porto, Portugal
1 shared publication
Latest Publications
- Open Access
- 7 December 2022
- Published by MDPI AG in Journal of Low Power Electronics and Applications
- Vol. 12 (4) , 64
All-Standard-Cell-Based Analog-to-Digital Architectures Well-Suited for Internet of Things Applications
In this paper, the most suited analog-to-digital (A/D) converters (ADCs) for Internet of Things (IoT) applications are compared in terms of complexity, dynamic performance, and energy efficiency. Among them, an innovative hybrid topology, a digital–delta (Δ) modulator (ΔM) ADC employing noise shaping (NS), is proposed. To implement the active building blocks, several standard-cell-based synthesizable comparators and amplifiers are examined and compared in terms of their key performance parameters. The simulation results of a fully synthesizable Digital-ΔM with NS using passive and standard-cell-based circuitry show a peak of 72.5 dB in the signal-to-noise and distortion ratio (SNDR) for a 113 kHz input signal and 1 MHz bandwidth (BW). The estimated is close to 16.2 fJ/conv.-step.- 7 December 2022
- Published by MDPI AG in Journal of Low Power Electronics and Applications
- Vol. 12 (4) , 64
Open AccessAll-Standard-Cell-Based Analog-to-Digital Architectures Well-Suited for Internet of Things Applications
In this paper, the most suited analog-to-digital (A/D) converters (ADCs) for Internet of Things (IoT) applications are compared in terms of complexity, dynamic performance, and energy efficiency. Among them, an innovative hybrid topology, a digital–delta (Δ) modulator (ΔM) ADC employing noise shaping (NS), is proposed. To implement the active building blocks, several standard-cell-based synthesizable comparators and amplifiers are examined and compared in terms of their key performance parameters. The simulation results of a fully synthesizable Digital-ΔM with NS using passive and standard-cell-based circuitry show a peak of 72.5 dB in the signal-to-noise and distortion ratio (SNDR) for a 113 kHz input signal and 1 MHz bandwidth (BW). The estimated is close to 16.2 fJ/conv.-step. - Open Access
- 1 January 2016
- Published by Springer Nature
- p. 533-541
Oxide TFTs on Flexible Substrates for Designing and Fabricating Analog-to-Digital Converters
- 1 January 2016
- Published by Springer Nature
- p. 533-541
Open AccessOxide TFTs on Flexible Substrates for Designing and Fabricating Analog-to-Digital Converters
- 30 December 2015
- Published by Springer Nature
- p. 73-75
Conclusions and Future Perspectives
- 30 December 2015
- Published by Springer Nature
- p. 57-71
A Second-Order ΣΔ ADC with Oxide TFTs @ FCT-UNL
- 30 December 2015
- Published by Springer Nature
- p. 49-56
Analog-to-Digital Converters
- 30 December 2015
- Published by Springer Nature
- p. 17-47
Oxide TFTs @ FCT-UNL
- 1 May 2015
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- No. 02714302,p. 261-264
Design of a robust general-purpose low-offset comparator based on IGZO thin-film transistors
This paper presents a low-offset comparator based on n-type amorphous indium gallium zinc oxide thin-film transistors (TFTs). An a-Si:H TFT model was adapted to fit the electrical characterization data obtained for these devices. The proposed comparator comprises three pre-amplification stages, a positive-feedback analog latch and a fully dynamic digital latch. Simulation results show that the proposed circuit can work at several tens of kHz, with an accuracy of the order of 10 mV, considering a supply voltage of 10 V and a current consumption of 380 μA. Monte-Carlo simulations exhibit a 1-sigma random offset voltage smaller than 10 mV and 40 mV, respectively, with and without using autozeroing techniques.
- 1 May 2015
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- No. 02714302,p. 261-264
Design of a robust general-purpose low-offset comparator based on IGZO thin-film transistors
This paper presents a low-offset comparator based on n-type amorphous indium gallium zinc oxide thin-film transistors (TFTs). An a-Si:H TFT model was adapted to fit the electrical characterization data obtained for these devices. The proposed comparator comprises three pre-amplification stages, a positive-feedback analog latch and a fully dynamic digital latch. Simulation results show that the proposed circuit can work at several tens of kHz, with an accuracy of the order of 10 mV, considering a supply voltage of 10 V and a current consumption of 380 μA. Monte-Carlo simulations exhibit a 1-sigma random offset voltage smaller than 10 mV and 40 mV, respectively, with and without using autozeroing techniques.