Roberto Yuji Tanaka
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Roberto Yuji Tanaka has a total of 38 co-authors. Here are the top co-authors by number of shared publications:
- Angelo Passaro
Instituto de Estudos Avanados, So Jos dos Campos, So Paulo, Brazil
12 shared publications Ademar Muraro
3 shared publicationsGustavo S. Vieira
3 shared publicationsGustavo Soares Vieira
Applied Physics Division, Instituto de Estudos Avançados - IEAv, São José dos Campos, Brazil
3 shared publicationsNancy M. Abe
3 shared publications- Carlos Alberto da Silva Junior
Universidade Federal de S ão Jo ão del-Rei -UFSJ Depertamento de Matem ática e Estatística -DEMAT S ão Jo ão del Rei -MG Brazil
2 shared publications
Latest Publications
- Open Access
- 1 January 2026
- Published by FapUNIFESP (SciELO) in Journal of Aerospace Technology and Management
- Vol. 18
Effects of Non-Uniform Data Coverage on Deep Neural Network-Based Scramjet Performance Prediction
The development of hypersonic vehicles increasingly relies on deep learning (DL) models; however, their reliability depends on the coverage of training data. When training datasets exhibit uneven coverage of the operational domain, predictions may retain high statistical accuracy while losing physical meaning. This study examines how a deep neural network (DNN) responds to such uneven coverage in predicting thrust for supersonic ramjets (scramjets), whose thrust computation is based on reliable physical models accounting for Mach number and flight altitude. Two datasets generated through computational optimization sampling of operating conditions using these models are considered; the datasets differ in the uniformity of data coverage across operating conditions. Holding the network architecture, loss function, and optimizer fixed, the DNN trained on the larger, non-uniform dataset achieved lower error but exhibited thrust trends inconsistent with the envelope defined by the physical model used in the optimization. In contrast, the DNN trained on the smaller, uniformly covered dataset yielded slightly higher error, but preserved coherent altitude-conditioned thrust trends across the Mach-altitude domain. These results underscore that adequate coverage is a methodological requirement for physically consistent DL models, indicating that reliable artificial intelligence-based tools in aerospace design depend on careful dataset construction rather than architectural complexity.
- 1 January 2026
- Published by FapUNIFESP (SciELO) in Journal of Aerospace Technology and Management
- Vol. 18
Open AccessEffects of Non-Uniform Data Coverage on Deep Neural Network-Based Scramjet Performance Prediction
The development of hypersonic vehicles increasingly relies on deep learning (DL) models; however, their reliability depends on the coverage of training data. When training datasets exhibit uneven coverage of the operational domain, predictions may retain high statistical accuracy while losing physical meaning. This study examines how a deep neural network (DNN) responds to such uneven coverage in predicting thrust for supersonic ramjets (scramjets), whose thrust computation is based on reliable physical models accounting for Mach number and flight altitude. Two datasets generated through computational optimization sampling of operating conditions using these models are considered; the datasets differ in the uniformity of data coverage across operating conditions. Holding the network architecture, loss function, and optimizer fixed, the DNN trained on the larger, non-uniform dataset achieved lower error but exhibited thrust trends inconsistent with the envelope defined by the physical model used in the optimization. In contrast, the DNN trained on the smaller, uniformly covered dataset yielded slightly higher error, but preserved coherent altitude-conditioned thrust trends across the Mach-altitude domain. These results underscore that adequate coverage is a methodological requirement for physically consistent DL models, indicating that reliable artificial intelligence-based tools in aerospace design depend on careful dataset construction rather than architectural complexity.
- Open Access
High-level hybridization of heuristics and metaheuristics to solve symmetric TSP: a comparative study
The Travelling Salesman Problem - TSP is one of the most explored problems in the scientific literature to solve real problems regarding the economy, transportation, and logistics, to cite a few cases. Adapting TSP to solve different problems has originated several variants of the optimization problem with more complex objectives and different restrictions. Metaheuristics have been used to solve the problem in polynomial time. Several studies have tried hybridising metaheuristics with specialised heuristics to improve the quality of the solutions. However, we have found no study to evaluate whether the searching mechanism of a particular metaheuristic is more adequate for exploring hybridization. This paper focuses on the solution of the classical TSP using high-level hybridisations, experimenting with eight metaheuristics and heuristics derived from k-OPT, SISR, and segment intersection search, resulting in twenty-four combinations. Some combinations allow more than one set of searching parameters. Problems with 50 to 280 cities are solved. Parameter tuning of the metaheuristics is not carried out, exploiting the different searching patterns of the eight metaheuristics instead. The solutions' quality is compared to those presented in the literature.
Open AccessHigh-level hybridization of heuristics and metaheuristics to solve symmetric TSP: a comparative study
The Travelling Salesman Problem - TSP is one of the most explored problems in the scientific literature to solve real problems regarding the economy, transportation, and logistics, to cite a few cases. Adapting TSP to solve different problems has originated several variants of the optimization problem with more complex objectives and different restrictions. Metaheuristics have been used to solve the problem in polynomial time. Several studies have tried hybridising metaheuristics with specialised heuristics to improve the quality of the solutions. However, we have found no study to evaluate whether the searching mechanism of a particular metaheuristic is more adequate for exploring hybridization. This paper focuses on the solution of the classical TSP using high-level hybridisations, experimenting with eight metaheuristics and heuristics derived from k-OPT, SISR, and segment intersection search, resulting in twenty-four combinations. Some combinations allow more than one set of searching parameters. Problems with 50 to 280 cities are solved. Parameter tuning of the metaheuristics is not carried out, exploiting the different searching patterns of the eight metaheuristics instead. The solutions' quality is compared to those presented in the literature.
- Open Access
- 1 February 2024
- Published by AIP Publishing in Physics of Fluids
- Vol. 36 (2)
Multi-objective optimization of a hypersonic airbreathing vehicle
Multi-objective optimization of a hypersonic airbreathing engine (scramjet technology) was carried out with the aim of maximizing thrust and minimizing drag while satisfying a series of design constraints, such as avoiding unstart (blockage of supersonic flow within the combustion chamber) by ensuring that the pressure ratio across the shock waves remains below the adverse pressure gradient given by the Korkegi limit, geometry correction to achieve shock on-lip condition, and temperature and pressure requirements at the inlet exit. Using the relations presented in the literature, pressure and viscous drag are estimated analytically. The analytical approach is verified against computational fluid dynamics data from Ansys Fluent to solve two-dimensional compressible Reynolds-averaged Navier–Stokes flow equations, with transition shear stress transport as the turbulence closure model. Comparing the total drag and the flow properties at the combustion chamber entrance shows the model's feasibility for the optimization approach. Three different approaches were conducted to formulate the multi-objective function to determine the one that can find the highest number of geometries satisfying the Korkegi limit with the highest net thrust. The best approach was the multi-objective function formulated with the uninstalled thrust, total pressure recovery, and pressure drag, concentrating the search in the region with greater uninstalled thrust and lower drag and nearly doubling the value of net thrust compared to the first formulation, which uses the uninstalled thrust, pressure drag, and viscous drag.
- 1 February 2024
- Published by AIP Publishing in Physics of Fluids
- Vol. 36 (2)
Open AccessMulti-objective optimization of a hypersonic airbreathing vehicle
Multi-objective optimization of a hypersonic airbreathing engine (scramjet technology) was carried out with the aim of maximizing thrust and minimizing drag while satisfying a series of design constraints, such as avoiding unstart (blockage of supersonic flow within the combustion chamber) by ensuring that the pressure ratio across the shock waves remains below the adverse pressure gradient given by the Korkegi limit, geometry correction to achieve shock on-lip condition, and temperature and pressure requirements at the inlet exit. Using the relations presented in the literature, pressure and viscous drag are estimated analytically. The analytical approach is verified against computational fluid dynamics data from Ansys Fluent to solve two-dimensional compressible Reynolds-averaged Navier–Stokes flow equations, with transition shear stress transport as the turbulence closure model. Comparing the total drag and the flow properties at the combustion chamber entrance shows the model's feasibility for the optimization approach. Three different approaches were conducted to formulate the multi-objective function to determine the one that can find the highest number of geometries satisfying the Korkegi limit with the highest net thrust. The best approach was the multi-objective function formulated with the uninstalled thrust, total pressure recovery, and pressure drag, concentrating the search in the region with greater uninstalled thrust and lower drag and nearly doubling the value of net thrust compared to the first formulation, which uses the uninstalled thrust, pressure drag, and viscous drag.
- 20 April 2016
- Published by IOP Publishing in Journal of Physics D: Applied Physics
- Vol. 49 (21) , 215101
Modeling the 3D In profile of InxGa1−xAs/GaAs quantum dots
An iterative procedure, based on the finite-elements method combined with a stochastic approach, was developed to calculate the energy levels of In x Ga1?x As/GaAs quantum dots grown by molecular-beam epitaxy. The vertical and radial In-composition profiles resulting from segregation and intermixing effects were taken into account. Two In profiles suggested in the literature were tested and compared to optical and structural data. One of them was shown to be compatible with the experimental data.
- 20 April 2016
- Published by IOP Publishing in Journal of Physics D: Applied Physics
- Vol. 49 (21) , 215101
Modeling the 3D In profile of InxGa1−xAs/GaAs quantum dots
An iterative procedure, based on the finite-elements method combined with a stochastic approach, was developed to calculate the energy levels of In x Ga1?x As/GaAs quantum dots grown by molecular-beam epitaxy. The vertical and radial In-composition profiles resulting from segregation and intermixing effects were taken into account. Two In profiles suggested in the literature were tested and compared to optical and structural data. One of them was shown to be compatible with the experimental data.
- 1 August 2013
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1-5
Computer program for analysis and design of nanostructured semiconductor devices
This work presents the recent improvements in a computer program created to assist the design and analysis of quantum well, wire, and dot nanostructured semiconductor-based devices. The list of added features includes the calculation of heavy hole, light hole and split-off energy bands, dark current, photocurrent, and absorption spectrum. Additionally, the computer program allows self-consistent computation and can take into account the energy band non-parabolic effects in the effective mass approximation.
- 1 August 2013
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1-5
Computer program for analysis and design of nanostructured semiconductor devices
This work presents the recent improvements in a computer program created to assist the design and analysis of quantum well, wire, and dot nanostructured semiconductor-based devices. The list of added features includes the calculation of heavy hole, light hole and split-off energy bands, dark current, photocurrent, and absorption spectrum. Additionally, the computer program allows self-consistent computation and can take into account the energy band non-parabolic effects in the effective mass approximation.
- 1 January 2011
- Published by AIP Publishing in AIP Conference Proceedings
- Vol. 1416 (1) , 161
Quantum Well Infrared Photodetectors (QWIPs) Optimization Based on Dark Current Models Evaluation
In this work we evaluate different dark current models applied in QWIPs. In order to avoid empirical parameters we calculate the sequential tunneling probability of the lowest energy state to reproduce the dark current properties. Using the same arguments, the photocurrent is replaced by the tunneling probability modulated by the optical matrix element. Considering the different tunneling models presented in literature we apply a genetic algorithm to evaluate the models role on the election of the optimized infrared sensor.
- 1 January 2011
- Published by AIP Publishing in AIP Conference Proceedings
- Vol. 1416 (1) , 161
Quantum Well Infrared Photodetectors (QWIPs) Optimization Based on Dark Current Models Evaluation
In this work we evaluate different dark current models applied in QWIPs. In order to avoid empirical parameters we calculate the sequential tunneling probability of the lowest energy state to reproduce the dark current properties. Using the same arguments, the photocurrent is replaced by the tunneling probability modulated by the optical matrix element. Considering the different tunneling models presented in literature we apply a genetic algorithm to evaluate the models role on the election of the optimized infrared sensor.
- 1 October 2010
- Published by The Electrochemical Society in ECS Transactions
- Vol. 31 (1) , 259-266
Optimization of Nanostructured Devices Using Self-consistent Calculations
In this work, self-consistent calculations of semiconductors band structure and genetic algorithm method are used to design semiconductor nanostructures. In special, we calculate the band structure of semiconductors nanostructures including contact layers, which are frequently neglected.
- 1 October 2010
- Published by The Electrochemical Society in ECS Transactions
- Vol. 31 (1) , 259-266
Optimization of Nanostructured Devices Using Self-consistent Calculations
In this work, self-consistent calculations of semiconductors band structure and genetic algorithm method are used to design semiconductor nanostructures. In special, we calculate the band structure of semiconductors nanostructures including contact layers, which are frequently neglected.
- 19 July 2010
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Magnetics
- Vol. 46 (8) , 2759-2762
Self-Consistent Optimization of Multi-Quantum Well Structures by a Genetic Algorithm
This work presents a self-consistent optimization of multi-quantum well based nanostructured semiconductors. A Genetic Algorithm is used for the search module. The simulation module is based on the self-consistent solution of the coupled Poisson and Schrödinger equations by using the finite-element method. The results of two case tests are presented and discussed.
- 19 July 2010
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Magnetics
- Vol. 46 (8) , 2759-2762
Self-Consistent Optimization of Multi-Quantum Well Structures by a Genetic Algorithm
This work presents a self-consistent optimization of multi-quantum well based nanostructured semiconductors. A Genetic Algorithm is used for the search module. The simulation module is based on the self-consistent solution of the coupled Poisson and Schrödinger equations by using the finite-element method. The results of two case tests are presented and discussed.
- 1 February 2010
- Published by SAGE Publications in International Journal of Applied Electromagnetics and Mechanics
- Vol. 33 (1-2) , 217-223
A self-consistent analysis of subband alignment in a superlattice with one larger well
Self-consistent calculations of multi-quantum well semiconductor structures based on a Finite-Element Method are presented. The self-consistent calculation is specially needed when wells of different width are present in the structure, generating a larger charge separation and affecting significantly the tunneling conditions. The object-oriented computer code used was implemented using a finite-element class library developed and used in previous works. Results for an asymmetric heterostructure with a larger well and contact layers are also presented.
- 1 February 2010
- Published by SAGE Publications in International Journal of Applied Electromagnetics and Mechanics
- Vol. 33 (1-2) , 217-223
A self-consistent analysis of subband alignment in a superlattice with one larger well
Self-consistent calculations of multi-quantum well semiconductor structures based on a Finite-Element Method are presented. The self-consistent calculation is specially needed when wells of different width are present in the structure, generating a larger charge separation and affecting significantly the tunneling conditions. The object-oriented computer code used was implemented using a finite-element class library developed and used in previous works. Results for an asymmetric heterostructure with a larger well and contact layers are also presented.