Roger Gadiou
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Research Interests
Roger Gadiou has a total of 226 co-authors. Here are the top co-authors by number of shared publications:
- Joseph Dentzer
Institut de Science des Matériaux de Mulhouse (IS2M), CNRS UMR7361, Université de Haute-Alsace, 15, rue Jean Starcky, BP 2488, 68057 Mulhouse, France
19 shared publications Cathie Vix-Guterl
16 shared publicationsC. Vix-Guterl
12 shared publications- Camélia Matei Ghimbeu
Université de Haute-Alsace, Institut de Science des Matériaux de Mulhouse (IS2 M), CNRS, UMR 7361, F-68100 Mulhouse, France
8 shared publications - Eric Leroy
UR1268 Biopolymères Interactions Assemblages, INRA, F-44316 Nantes, France
7 shared publications - Fermin Cuevas
Univ Paris-Est Creteil, CNRS, ICMPE (UMR 7182), 2 rue Henri Dunant, F-94320 Thiais, France
7 shared publications
Latest Publications
- Open Access
- 26 October 2021
- Published by American Chemical Society (ACS) in Energy & Fuels
- Vol. 35 (21) , 17769-17783
Depolymerization of Technical Lignins in Supercritical Ethanol: Effects of Lignin Structure and Catalyst
- 26 October 2021
- Published by American Chemical Society (ACS) in Energy & Fuels
- Vol. 35 (21) , 17769-17783
Open AccessDepolymerization of Technical Lignins in Supercritical Ethanol: Effects of Lignin Structure and Catalyst
- Open Access
Mechanical Desensitization of an Al/WO3 Nanothermite by Means of Carbonaceous Coatings Derived from Carbohydrates
Nanothermites show great developmental promise in the near future in civilian, military and aerospace applications due to their tuneable reactive properties (ignition delay time, combustion velocity and pressure release). However, the high mechanical sensitivities of some of these energetic nanocomposites can make transportation and handling of them hazardous. Here, a mechanical desensitization (shock and friction) of an Al/WO3 nanothermite is successfully obtained by means of carbon adding through the pyrolysis of naturally occurring molecules (carbohydrates). The combustion behaviour of the carbon-based energetic mixtures were also evaluated and a respectable reactivity has been evidenced.
Open AccessMechanical Desensitization of an Al/WO3 Nanothermite by Means of Carbonaceous Coatings Derived from Carbohydrates
Nanothermites show great developmental promise in the near future in civilian, military and aerospace applications due to their tuneable reactive properties (ignition delay time, combustion velocity and pressure release). However, the high mechanical sensitivities of some of these energetic nanocomposites can make transportation and handling of them hazardous. Here, a mechanical desensitization (shock and friction) of an Al/WO3 nanothermite is successfully obtained by means of carbon adding through the pyrolysis of naturally occurring molecules (carbohydrates). The combustion behaviour of the carbon-based energetic mixtures were also evaluated and a respectable reactivity has been evidenced.
- 16 February 2019
- Published by Springer Nature
- p. 1195-1203
How to Appreciate the Coal Tar Pitch Impregnation on Coke Material?
- 16 February 2019
- Published by Springer Nature
- p. 1195-1203
How to Appreciate the Coal Tar Pitch Impregnation on Coke Material?
- 1 September 2018
- Published by Elsevier in Electrochimica Acta
- Vol. 283, 88-96
Direct electron transfer of bilirubin oxidase at a carbon flow-through electrode
- 1 September 2018
- Published by Elsevier in Electrochimica Acta
- Vol. 283, 88-96
Direct electron transfer of bilirubin oxidase at a carbon flow-through electrode
- 5 May 2017
- Published by American Chemical Society (ACS) in ACS Catalysis
- Vol. 7 (6) , 3916-3923
Mechanism of Chloride Inhibition of Bilirubin Oxidases and Its Dependence on Potential and pH
Bilirubin oxidases (BODs) belong to the multicopper oxidase (MCO) family and efficiently reduce O2 at neutral pH and under physiological conditions where chloride concentrations are >100 mM. BODs were consequently considered to be Cl– resistant, as opposed to laccases. However, there has not been a detailed study of the related effect of chloride and pH on the redox state of immobilized BODs. Here, we investigate by electrochemistry the catalytic mechanism of O2 reduction by the thermostable Bacillus pumilus BOD immobilized on carbon nanofibers in the presence of NaCl. The addition of chloride results in the formation of a redox state of the enzyme, previously observed for different BODs and laccases, which is active only after a reductive step. This behavior has not been previously investigated. We show that the kinetics of formation of this state is strongly dependent on pH, temperature, Cl– concentration, and applied redox potential. Ultraviolet–visible spectroscopy allows us to correlate the inhibition by chloride with the formation of the alternative resting form of the enzyme. We demonstrate that O2 is not required for its formation and show that the application of an oxidative potential is sufficient. In addition, our results suggest that reactivation may proceed through T3β.
- 5 May 2017
- Published by American Chemical Society (ACS) in ACS Catalysis
- Vol. 7 (6) , 3916-3923
Mechanism of Chloride Inhibition of Bilirubin Oxidases and Its Dependence on Potential and pH
Bilirubin oxidases (BODs) belong to the multicopper oxidase (MCO) family and efficiently reduce O2 at neutral pH and under physiological conditions where chloride concentrations are >100 mM. BODs were consequently considered to be Cl– resistant, as opposed to laccases. However, there has not been a detailed study of the related effect of chloride and pH on the redox state of immobilized BODs. Here, we investigate by electrochemistry the catalytic mechanism of O2 reduction by the thermostable Bacillus pumilus BOD immobilized on carbon nanofibers in the presence of NaCl. The addition of chloride results in the formation of a redox state of the enzyme, previously observed for different BODs and laccases, which is active only after a reductive step. This behavior has not been previously investigated. We show that the kinetics of formation of this state is strongly dependent on pH, temperature, Cl– concentration, and applied redox potential. Ultraviolet–visible spectroscopy allows us to correlate the inhibition by chloride with the formation of the alternative resting form of the enzyme. We demonstrate that O2 is not required for its formation and show that the application of an oxidative potential is sufficient. In addition, our results suggest that reactivation may proceed through T3β.
- 1 March 2017
- Published by Elsevier in International Journal of Hydrogen Energy
- Vol. 42 (13) , 8712-8720
Evaluation of activated carbons based on olive stones as catalysts during hydrogen production by thermocatalytic decomposition of methane
- 1 March 2017
- Published by Elsevier in International Journal of Hydrogen Energy
- Vol. 42 (13) , 8712-8720
Evaluation of activated carbons based on olive stones as catalysts during hydrogen production by thermocatalytic decomposition of methane
- 1 March 2017
- Published by Elsevier in Thermochimica Acta
- Vol. 649, 13-21
Oxidation behavior at moderate temperature under dry and wet air of phenolic resin-derived carbon
- 1 March 2017
- Published by Elsevier in Thermochimica Acta
- Vol. 649, 13-21
Oxidation behavior at moderate temperature under dry and wet air of phenolic resin-derived carbon
- 2 October 2016
- Published by Springer Nature in Environmental Science and Pollution Research
- Vol. 24 (11) , 10005-10017
Thermodynamic study of seven micropollutants adsorption onto an activated carbon cloth: Van’t Hoff method, calorimetry, and COSMO-RS simulations
The thermodynamic of the adsorption of seven organic pollutants, namely benzotriazol, bisphenol A, caffeine, carbamazepine, diclofenac, ofloxacin, and pentachlorophenol, was studied on a microporous-activated carbon fabric. The isosteric adsorption quantities (Gibbs energy, enthalpy, and entropy variations) at high coverage ratio (around 1 mmol/g) have been determined from the adsorption isotherms at three temperatures (13, 25, and 40 °C). The adsorption heats at very low coverage (about 10−5 mmol/g) have been measured by flow micro calorimetry. The experimental adsorption energies were correlated to the adsorbate-adsorbent and the adsorbate-solvent interaction energies calculated by simulations using the COSMO-RS model. The main role of the van der Waals forces in the adsorption of the studied molecules was established. The bulkier the adsorbate is, the lower the adsorption Gibbs energy variation at high coverage deduced from the isotherms. The heterogeneity of the adsorption sites was brought out by calorimetric measurements. At high coverage, a physisorption phenomenon was observed. At very low coverage, high values of the adsorption heats were found (ranging from −58 to −110 kJ/mol), except for pentachlorophenol characterized by an athermal adsorption controlled by Pi-anions interactions.
- 2 October 2016
- Published by Springer Nature in Environmental Science and Pollution Research
- Vol. 24 (11) , 10005-10017
Thermodynamic study of seven micropollutants adsorption onto an activated carbon cloth: Van’t Hoff method, calorimetry, and COSMO-RS simulations
The thermodynamic of the adsorption of seven organic pollutants, namely benzotriazol, bisphenol A, caffeine, carbamazepine, diclofenac, ofloxacin, and pentachlorophenol, was studied on a microporous-activated carbon fabric. The isosteric adsorption quantities (Gibbs energy, enthalpy, and entropy variations) at high coverage ratio (around 1 mmol/g) have been determined from the adsorption isotherms at three temperatures (13, 25, and 40 °C). The adsorption heats at very low coverage (about 10−5 mmol/g) have been measured by flow micro calorimetry. The experimental adsorption energies were correlated to the adsorbate-adsorbent and the adsorbate-solvent interaction energies calculated by simulations using the COSMO-RS model. The main role of the van der Waals forces in the adsorption of the studied molecules was established. The bulkier the adsorbate is, the lower the adsorption Gibbs energy variation at high coverage deduced from the isotherms. The heterogeneity of the adsorption sites was brought out by calorimetric measurements. At high coverage, a physisorption phenomenon was observed. At very low coverage, high values of the adsorption heats were found (ranging from −58 to −110 kJ/mol), except for pentachlorophenol characterized by an athermal adsorption controlled by Pi-anions interactions.