GBGovindarajan Venkat Babu

Govindarajan Venkat Babu

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article

Previous Organizations / Institutes

The organizations / institutes from the scholar's other articles in the past ten years


Govindarajan Venkat Babu has a total of 30 co-authors. Here are the top co-authors by number of shared publications:

  • D. Rajesh Kumar

    Centre of Excellence in RF System Engineering, SASTRA Deemed to be University, Thanjavur, Tamilnadu, India

    2 shared publications
  • D. Rajesh Kumar

    Centre of Excellence in RF system Engineering, School of EEE, SASTRA Deemed to be University, Thanjavur, Tamilnadu, India

    2 shared publications
  • Harish Kumar

    Dept. of Electronics Engg. and Computer Engineering, Bhagwant Institute of Technology, Muzaffarnagar (Uttar Pradesh), India

    2 shared publications
  • Pushpneel Verma

    Dept. of Electronics Engg. and Computer Engineering, Bhagwant Institute of Technology, Muzaffarnagar (Uttar Pradesh), India

    2 shared publications
  • Arvind Kumar

    Sharda Univ, Greater Noida, India

    1 shared publication
  • Cristhian Figueroa

    Telematics Department, University of Cauca, Popayan,Colombia

    1 shared publication

Latest Publications

  • Open Access

    GlioSurvQNet: A DuelContextAttn DQN Framework for Brain Tumor Prognosis with Metaheuristic Optimization

    by M. Renugadevi, Venkateswarlu Gonuguntla, Ihssan S. Masad, G. Venkat Babu, K. Narasimhan

    Background/Objectives: Accurate classification of brain tumors and reliable prediction of patient survival are essential in neuro-oncology, guiding clinical decisions and enabling precision treatment planning. However, conventional machine learning and deep learning methods often struggle with challenges such as data scarcity, class imbalance, limited model interpretability, and poor generalization across diverse clinical settings. This study presents GlioSurvQNet, a novel reinforcement learning-based framework designed to address these limitations for both glioma grading and survival prediction. Methods: GlioSurvQNet is built upon a DuelContextAttn Deep Q-Network (DQN) architecture, tailored for binary classification of low-grade vs. high-grade gliomas and multi-class survival prediction (short-, medium-, and long-term categories). Radiomics features were extracted from multimodal MRI scans, including FLAIR, T1CE, and T2 sequences. Feature optimization was performed using a hybrid ensemble of metaheuristic algorithms, including Harris Hawks Optimization (HHO), Modified Gorilla Troops Optimization (mGTO), and Zebra Optimization Algorithm (ZOA). Subsequently, SHAP-based feature selection was applied to enhance model interpretability and robustness. Results: The classification module achieved the highest accuracy of 99.27% using the FLAIR + T1CE modality pair, while the survival prediction model attained an accuracy of 93.82% with the FLAIR + T2 + T1CE fusion. Comparative evaluations against established machine learning and deep learning models demonstrated that GlioSurvQNet consistently outperformed existing approaches in both tasks. Conclusions: GlioSurvQNet offers a powerful and interpretable AI-driven solution for brain tumor analysis. Its high accuracy and robustness make it a promising tool for clinical decision support in glioma diagnosis and prognosis.


  • Detection of Pathogens Using PET Based Microwave Assisted Irradiation to Extend Bread Shelf-life

    by Govindarajan Venkat Babu, Arvind Kumar, Kumareson Anish Pon Yamini, Kamatchi Govindaraj Sujanth Narayan, Dhandapani Rajeshkumar


  • A miniaturized CPW-fed CSRR-loaded quad-port MIMO antenna for 5.5/6.5 GHz wireless applications

    by D. Rajesh Kumar, T. Sangeetha, K. G. Sujanth Narayan, G. Venkat Babu, V. Prithivirajan, M. S. K. Manikandan

    For forthcoming wireless applications, a small and highly decoupled complementary split ring resonators (CSRR)–loaded co-planar waveguide (CPW)–fed antenna for dual-band applications is investigated. The low-profile antenna consists of a CSRR-loaded rectangular radiating element with a truncated bottom, giving a wideband performance over the frequency ranges of 5.28–5.52 GHz and 6–7.2 GHz. The antenna has been printed on a widely used FR4 substrate measuring 7.5 × 10.5 × 1.6 mm3 in volume. This research’s suggested antenna is turned into a 4 × 4 multi input multi output (MIMO) construction using a 25 × 25 mm2 printed circuit board. Individual antennas were isolated by nearly 20 dB without using a decoupling device. The antenna has been built, and the measured and simulated results correspond well. Computing envelope correlation coefficient (ECC), channel capacity (CC), and channel capacity loss (CCL) further validates the antenna’s performance (−). The antenna has an overall gain of around 2.54 dBi and a radiation efficiency of approximately 89% throughout the relevant spectral range, which is much better for wireless applications. The suggested antenna’s omnidirectional emission pattern makes it a potential contender for future wireless and cellular applications.


  • Efficient Six-Port MIMO Antenna System for 5G Mobile Handsets

    by D. Rajesh Kumar, G. Venkat Babu

    A six-port MIMO antenna system for forthcoming mobile applications (Sub 6 GHz) is presented in this paper. Four F-shaped antenna elements are placed at four extreme corners and two at the middle side edges of 0.8 mm thick FR4 substrate. An open-ended slot is carved into the ground plane to improve the impedance matching. The proposed antenna operates in the frequency range of 3.4–3.6 GHz (LTE Band 42), with a-10 dB (2:1 voltage standing wave ratio) impedance bandwidth of 200 MHz. The proposed antenna operates in the frequency range of 3.4–3.6 GHz (LTE Band 42), with a-10 dB (2:1 voltage standing wave ratio) impedance bandwidth of 200–MHz. The fabricated MIMO antenna is practically measured and compared with simulated results. The obtained isolation is lower than 20 dB without employing isolation enhancing procedures, making the antenna highly appropriate for 5G smartphone applications. High isolation results in lower values of Envelope Correlation Coefficient (ECC) below 0.01. The antenna’s diversity performance is validated by calculating Total Active Reflection Co-efficient (TARC) which is better than 40 dB. The calculated channel capacity of the six-port antenna array is 32.5 bps/Hz at 20 dB Signal to Noise Ratio (SNR). The six-antenna array’s reliability is evaluated by examining the influence of hand effects and Specific Absorption Rate (SAR). The measured results are consistent with simulated results which exhibit the antenna presented in this article is highly capable of mobile phone applications for future cellular communication.


  • Efficient and optimized six- port MIMO antenna system for 5G smartphones

    by Kumar D. Rajesh, Babu G. Venkat

    In this paper, six-port MIMO antenna is presented for 5G mobile handsets. The proposed six-port antenna array is designed by making four L shaped monopole slots at four corners and two at the middle side edges of the ground plane which is printed on the backside of 0.8 mm thick FR4 substrate. High isolation (>−18 dB) between any pair of antenna elements is achieved without deploying dedicated isolation enhancing mechanisms. The antenna is working from 3.4–3.6 GHz (LTE Band 42) with 200 MHz bandwidth in the 2:1 VSWR (−10 dB impedance bandwidth). The proposed six-port MIMO antenna array is fabricated and measured. Significant radiation efficiency is obtained from 70 to 74 % in desired band of operation. Further, the MIMO parameters such as Envelope Correlation Co-efficient (ECC), Channel Capacity, Channel Capacity Loss (CLL) and Total Active Reflection Co-Efficient (TARC) are calculated. The robustness of the antenna is estimated by analyzing the user hand effects and Specific Absorption Rate (SAR). The measured results are well agreed with the simulated results.


  • Investigation of 10-port coupled fed slotted MIMO antenna system for 5G mobile handset

    by D. Rajesh Kumar, G. Venkat Babu, K.G. Sujanth Narayan, N. Raju

    A dual-band 10-port multiple input multiple output (MIMO) antenna array for 5G smartphone is proposed. Each antenna in the MIMO system can work from 3.4 to 3.6 GHz and 5 to 6 GHz with 10 dB (2:1 VSWR) impedance bandwidth. Nevertheless, for a 3:1 VSWR, the antenna operates from 3.3 to 3.8 GHz and 4.67 to 6.24 GHz. The MIMO system is formed by making 10 seven-shaped coupled fed slot antenna elements excited at two different resonant modes and integrated into the system circuit board. By implementing the spatial and polarization diversity techniques, high isolation better than 28 dB between any pair of antenna elements is achieved. The proposed 10-port MIMO antenna array is fabricated and measured. Significant radiation efficiency is obtained, ranging from 65 to 82% for both bands. The antenna gain in the required operating band is substantial, around 3–3.8 dBi. Further, the MIMO parameters such as envelope correlation co-efficient, channel capacity, and total active reflection co-efficient are calculated. The antenna's robustness is estimated by analyzing the user hand effects and specific absorption rate (SAR). The measured results are well agreed with the simulated results.


  • Intelligent Antenna System for Medical Applications

    by D. Rajesh Kumar, G. Venkat Babu, N. Raju


  • Open Access

    Exploring DNS, HTTP, and ICMP Response Time Computations on Brain Signal/Image Databases using a Packet Sniffer Tool

    by V. Elamaran, N. Arunkumar, G. Venkat Babu, V. S. Balaji, Jorge Gomez, Cristhian Figueroa, Gustavo Ramirez-Gonzalez

    Neurological signal processing is of significance not only the physiologist doing research and the clinician investigating patients but also to the biomedical engineer who is needed to collect, process and interpret the physiological signals by prototyping systems and algorithms for their manipulations. While it is a fact that there does hold immense stuff (material) on the subject of digital neurological signal processing, however, it is dispersed in various scientific, technological and physiological journals, databases also in various international conference proceedings. Consequently, it is a quite hard, more time-consuming and often tiresome job, especially to the stranger to the domain. Hence, this study concentrates on how much time would require to access the databases belong to the brain signal/image collections, neurological signals, etc. The sixteen US-based Servers, ten UK-based Servers, and the five Servers from other countries are included in this study. Mainly, the domain name system (DNS), hyper text transfer protocol (HTTP), and the Internet control message protocol (ICMP) query/response times are analyzed using a popular packet sniffer called Wireshark.