YLYanpeng Liu

Yanpeng Liu

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Yanpeng Liu has a total of 22 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Aerodynamics of autorotating samaras in Ventilago leiocarpa

    by Huimin Li, Chujiang Cai, Laibing Jia, Yanpeng Liu

    The samaras exhibit diverse autorotational descent behaviors that enhance their likelihood of colonizing new and more favorable environments. Among them, Ventilago leiocarpa represents a large dual-axis autorotating species, whose aerodynamic force mechanisms remain poorly understood. In this study, experimental measurements and three-dimensional numerical simulations were conducted to investigate the kinematic characteristics and aerodynamic force mechanisms of a Ventilago leiocarpa seed. Results indicate that the descent velocity Vd, the pitch angle φ, the yaw angular velocity θ̇, and the roll angular velocity ψ̇ all exhibit small-amplitude, nearly sinusoidal variations during stable autorotational descent. The horizontal force coefficients and all moment coefficients remain close to zero. The vertical force coefficient CZ exhibits a nearly sinusoidal variation, with a time-averaged value of C¯Z=1.23, indicating that the time-averaged vertical force closely balances the seed's weight. This study reveals that the wakes shed in the previous cycle exert only a minimal influence on the aerodynamic force and flow field near the wing. The leading-edge vortex and the trailing-edge vortex near the wing play dominant roles in the aerodynamic force generation. The rate of change in the first moment of vorticity, or the vertical force coefficient, is primarily driven by the growth rate of the leading-edge vortex and the trailing-edge vortex. These findings provide important insights into the understanding of biological dispersal strategies and offer practical implications for the design of miniature aerial vehicles.

  • Open Access

    Hydrodynamic characteristics of the blue whale in unbounded and density-stratified flow environments

    by Jingshu Luo, Yanpeng Liu

    Based on the realizable k-epsilon turbulence model and the Volume of Fluid (VOF) method, this article investigates the hydrodynamic characteristics of blue whales in both unbounded and density-stratified flow environments. The results demonstrate that in unbounded flow, the drag coefficient of a blue whale fin is most significantly influenced by fluid velocity, and it decreases by 17.27% as the velocity increases. In density-stratified flow, the amplitude of the internal wave increases with the Froude number while its angle decreases. Wave-making drag rises with the whale’s proximity to the interface. The wave-making drag coefficient is highly sensitive to density variations; when the lower layer density increases from 1020 kg/m3 to 1040 kg/m3, the wave-making drag coefficient increases by 154.36%. This study provides important insights into the hydrodynamic characteristics of underwater creatures in a density-stratified flow environment, offering valuable references for the development of biomimetic designs and technologies.

  • Aerodynamics and power consumption of near-hovering lacewings (Chrysoperla nipponensis)

    by Yuzhu Lyu, Haojie Zhu, Gang Du, Mao Sun, Yanpeng Liu

    To investigate the flight characteristics and the aerodynamic interactions of a kind of four-winged insect, lacewings (Chrysoperla nipponensis), we experimentally measured the morphological and kinematic parameters in a near-hovering state and numerically calculated the aerodynamic forces and power consumption. It was found that lacewings flap their forewings and hindwings at the same frequency with a constant phase difference (∼30°). Both wings rely on the leading-edge vortex mechanism to produce most of their aerodynamic force during mid-stroke. Comparative analyses of aerodynamic interactions reveal that body motion and contralateral wings have minimal impact on overall aerodynamic performance. However, ipsilateral wings reduce total vertical force by 6%, primarily due to an 18% decrease in hindwing force caused by forewing downwash. Under real-world conditions, hindwings generate approximately 20% less vertical force, leading to a net 6% reduction in total vertical force. All tested specimens satisfied force equilibrium criteria, validating both numerical and experimental approaches. Notably, no kinematic or aerodynamic evidence supports the presence of the clap and fling mechanism. Green lacewings exhibit efficient flight with relatively low power consumption, maintaining near-hovering flight at an energy cost of ∼14 W/kg. The reduced aerodynamic efficiency of the hindwings only slightly increases the total power consumption.


  • Experimental study of bubble growth and detachment behavior under different constraint strengths in a von Kármán swirling flow

    by Shuai Qiao, Chujiang Cai, Chong Pan, Yanpeng Liu

    This work advances the systematic study of the mechanism by which a circular wettability dividing line (WDL) constrains the three-phase contact line of a growing bubble on a surface. This provides critical insights for improving the stability of air layers on superhydrophobic surfaces by discretization, which is essential for improving the application of superhydrophobic surfaces in drag reduction. The effects of two constraint parameters—the radius of the WDL and the size of the surface microstructures—on the growth and detachment behavior of bubbles in a von Kármán swirling flow were experimentally analyzed. The results show that as the WDL radius is increased from 2 to 8 mm, the additional constraint force it generates is weakened, leading to increases in the coefficient of variation of the bubble detachment volume, tilt angle, and asymmetry ratio, and a decrease in its maximum contact width. As the microstructure period is increased from 50 to 100 μm, the number of pinning points provided by the WDL for the three-phase contact line decreases, weakening the constraint force. Consequently, the coefficient of variation of the bubble detachment volume and the asymmetry ratio increase, while the tilt angle and maximum contact width decrease. Finally, as both the radius of the WDL and the size of the microstructures increase, the inertial force grows more rapidly than the buoyancy force at the moment of bubble detachment, resulting in a higher ratio of horizontal to vertical bubble displacement.


  • The interaction between water droplets and superhydrophobic holes: Detachment and penetration

    by Yunqi Tang, Chujiang Cai, Xin Zhou, Shuai Qiao, Chong Pan, Yanpeng Liu

    Water droplets of varying volumes exhibit distinct behaviors at the tip of a needle under the influence of gravitational force: larger droplets fall from the needle tip, while smaller droplets adhere to the needle tip. By integrating a superhydrophobic hole, which allows the needle to pass through but hinders droplets' passage, a method to allow smaller droplets to fall from the needle was evaluated. The interaction between water droplets and a superhydrophobic hole was studied experimentally, and two phenomena were observed: either the droplet detached from the needle tip or the needle pulled it through the superhydrophobic hole. A critical detachment volume Vcrid0,D, dependent on the needle diameter d0 and the superhydrophobic hole diameter D, determines droplet behavior. When the volume of the droplet Vdroplet>Vcrid0,D, the droplet detaches from the needle tip. When the Vdroplet<Vcrid0,D, the droplet penetrates through the superhydrophobic hole. The results show that the critical detachment volume Vcrid0,D increases with an increase in d0 for a given superhydrophobic hole and with an increase in D for a given needle. To enable a 0.25 μl droplet to fall from a 32G needle, a superhydrophobic hole of 0.48 mm diameter was employed. Furthermore, a mechanical model based on force equilibrium was developed to describe the interaction between water droplets and a superhydrophobic hole.

  • Aerodynamics and power requirements of climbing flight in fruit fly model

    by Yanpeng Liu, Mao Sun

    This study presents a novel numerical investigation, concentrating on the force generation and power consumption associated with climbing flight in fruit flies (Drosophila virilis) across varied climbing angles and advance ratios. The selection of fruit flies as the focal species stems from the availability of comprehensive data on their hovering, ascending, and forward flight. The idealized wing motion employed in the study is completely defined by previously established kinematic parameters, utilizing reasonable assumptions. To address heightened force requirements and counteract negative effects induced by the “downwash flow” inherent in climbing flight, insects must adjust their flapping wing motion. Two potential strategies, involving the augmentation of stroke amplitude and/or elevation of the angle of attack, as observed in experimental studies, were considered. Corresponding simulation cases were subsequently solved using a three-dimensional incompressible Navier–Stokes solver. The study identifies key flow structures and the predominant high lift mechanism, specifically the “delayed stall” of the leading-edge vortex. Analysis of power consumption reveals that insects can only attain a specific range of flight speeds under particular climbing angles, with the maximum speed exhibiting a negative correlation with the climbing angle. Furthermore, power consumption exhibits a gradual increase in the slow speed region, irrespective of the climbing angle. Subsequently, power requirements experience a notable surge upon reaching a climbing-angle-dependent speed threshold. Therefore, the maximum achievable advance ratios are approximately 0.66, 0.49, 0.40, and 0.31 for climbing angles of 0.0°, 22.5°, 45.0°, and 90.0°, respectively.


  • Effects of blood-feeding on mosquitoes hovering kinematics and aerodynamics

    by Yanpeng Liu, Gang Du

    Mosquitoes exhibit a distinctive and remarkable flight pattern, flapping their wings at a high frequency with relatively small stroke amplitude. However, until recently, the underlying aerodynamic mechanisms have remained unclear. Furthermore, there is a lack of understanding about their flight behaviors after blood-feeding and the corresponding aerodynamic characteristics. This study aims to explore this uncharted area, conducts experiments to acquire kinematic and morphological data and numerical simulations to obtain three-dimensional flow characteristic. Further analysis uncovers several key findings. Both before and after blood-feeding hovering exhibit a similar flapping wing pattern, characterized by downstroke and upstroke with three stages of each half stroke. After blood-feeding, there are significant increases in stroke amplitude, mid-downstroke duration, velocity, and flip angles. Additionally, body pitch, stroke plane tilt, and Reynolds number experience increments. In hovering, mosquitoes balance vertical force with weight, with substantial peaks observed in each stage, particularly during the mid-stroke. After blood-feeding, the vertical force experiences a 3.3-fold increase, with the majority of the increase occurring during the mid-downstroke. The study identifies three unsteady mechanisms for aerodynamic force generation without blood-feeding hovering, namely, added-mass force, delayed stall, and fast-pitching-up rotation. These mechanisms persist after blood-feeding, with a greater reliance on delayed stall to support increased weight.


  • Open Access

    Power requirements in hovering flight of mosquitoes

    by Yanpeng Liu, Longgui Liu, Mao Sun

    Mosquitoes exhibit distinctive flight characteristics, utilizing a combination of very small stroke amplitudes and high stroke frequencies. This study focuses on assessing the power requirements for hovering mosquitoes through numerical simulation of wing flow and aerodynamic power, coupled with analytical computation of wing inertial power. Our findings reveal that, despite the elevated stroke frequency, the primary contributor to power expenditure is the aerodynamic power, with wing inertial power being relatively negligible due to the diminutive wing mass. The specific power necessary for hovering is approximately 35 W/kg, comparable to the requirements of various other insects such as bees, flies, and moths (ranging from 20 to –60 W/kg). Moreover, the incorporation of a 100% elastic storage system yields only marginal power savings, approximately 3.5%. Consequently, while an elastic system proves somewhat beneficial, it is not indispensable for mosquito flight. Notably, altering stroke amplitude and frequency for hovering could potentially reduce power demands compared to real-case scenarios, suggesting that the conventional small stroke amplitude and high stroke frequency utilized in mosquito flight may not be the optimal choice in terms of power efficiency. The adoption of these flight characteristics in mosquitoes may be attributed to other factors, such as providing flexibility to increase amplitude in cases of substantial weight gain due to blood-feeding or conferring a selective advantage in acoustic communication through high stroke frequency.


  • Open Access

    Influence of the wettability dividing line on bubble growth and detachment behavior in a von Kármán swirling flow field

    by Shuai Qiao, Chujiang Cai, Chong Pan, Yanpeng Liu

    The contact-angle (CA) hysteresis generated by the difference between the advancing and receding CAs of a droplet on an inclined surface generates an adhesion force that can hold the droplet on the surface. Similarly, the CA hysteresis generated by a wettability dividing line (WDL) between the superhydrophobic and superhydrophilic regions can improve the anti-shear stability of bubbles in water, with a maximum range of more than 150° for the difference between the advancing and receding CAs. Based on this mechanism, the influence of a WDL on the growth and detachment behavior of bubbles at different Reynolds numbers (Re) in a von Kármán swirling flow field was experimentally studied. The results show that the WDL significantly improves the anti-shear stability of bubbles when compared to uniform superhydrophobic and hydrophilic surfaces. Furthermore, the detachment volume and maximum contact width decrease with increasing Re, while the tilt angle and asymmetry ratio increase significantly. The fluctuation amplitudes of these parameters gradually increase with rising Re. Based on variations in these parameters, bubbles' growth behavior can be classified into three modes: stabilization, transition, and oscillation. Additionally, the constraint mechanism of a WDL on a bubble was analyzed based on variations in the CA hysteresis generated by the WDL and the maximum contact width. Finally, the detachment dynamics of bubbles in the three modes were analyzed based on a force–balance model.