Iulia Dan
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Iulia Dan has a total of 17 co-authors. Here are the top co-authors by number of shared publications:
- Ingmar Kallfass
University of Stuttgart
4 shared publications Guillaume Ducournau
IEMN, Université de Lille, Lille, France
2 shared publications- Guillaume Ducournau
Université Lille, CNRS, Centrale Lille, Université Polytechnique Hauts-de-France, UMR 8520 - IEMN - Institut d'Électronique de Microélectronique et de Nanotechnologie
2 shared publications Pascal Szriftgiser
Laboratoire PhLAM, Université de Lille, Lille, France
2 shared publications- Pascal Szriftgiser
CNRS UMR 8523 – PhLAM Laboratoire De Physique Des Lasers Atomes et Molécules Université De Lille Lille France
2 shared publications Ralf-Peter Braun
Deutsche Telekom AG, Berlin, Germany
2 shared publications
Latest Publications
- 1 March 2021
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Terahertz Science and Technology
- Vol. 11 (2) , 231-239
A Compact 281–319 GHz Low-Power Downconverter MMIC for Superheterodyne Communication Receivers
This paper presents a fully-integrated first downconversion stage for a superheterodyne receiver for high data rate communication at 300 GHz. It comprises a frequency multiplier-by-three, an active dual-gate downconverter and an LNA. The chip was fabricated in a 35nm InGaAs-based metamorphic high electron mobility transistor technology. The down-converter was designed to be used for different LO frequencies between 70 and 80 GHz and IF frequencies from 65 to 95 GHz, to create multiple channels for real-time full-duplex communication in the terahertz region. It achieves a conversion gain of 14 dB without IF amplification and a 3-dB bandwidth of 25 GHz in the desired upper sideband from 288 to 313 GHz and an estimated noise figure of 6.6 dB. Without the LNA the conversion gain of the circuit is -10 dB and it shows a 3-dB bandwidth of 38 GHz in a frequency range from 281 to 319 GHz. Finally, the MMIC will be compared in detail to a similar state-of-the-art down-converter using a resistive mixer and a necessary additional LO buffer stage in the same technology targeting the identical application. While exhibiting a better conversion gain and bandwidth and occupying only 40% of chip area, the presented down-converter consumes 70% less DC power than the MMIC with a resistive mixer.
- 1 March 2021
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Terahertz Science and Technology
- Vol. 11 (2) , 231-239
A Compact 281–319 GHz Low-Power Downconverter MMIC for Superheterodyne Communication Receivers
This paper presents a fully-integrated first downconversion stage for a superheterodyne receiver for high data rate communication at 300 GHz. It comprises a frequency multiplier-by-three, an active dual-gate downconverter and an LNA. The chip was fabricated in a 35nm InGaAs-based metamorphic high electron mobility transistor technology. The down-converter was designed to be used for different LO frequencies between 70 and 80 GHz and IF frequencies from 65 to 95 GHz, to create multiple channels for real-time full-duplex communication in the terahertz region. It achieves a conversion gain of 14 dB without IF amplification and a 3-dB bandwidth of 25 GHz in the desired upper sideband from 288 to 313 GHz and an estimated noise figure of 6.6 dB. Without the LNA the conversion gain of the circuit is -10 dB and it shows a 3-dB bandwidth of 38 GHz in a frequency range from 281 to 319 GHz. Finally, the MMIC will be compared in detail to a similar state-of-the-art down-converter using a resistive mixer and a necessary additional LO buffer stage in the same technology targeting the identical application. While exhibiting a better conversion gain and bandwidth and occupying only 40% of chip area, the presented down-converter consumes 70% less DC power than the MMIC with a resistive mixer.
- Open Access
- 19 May 2020
- Published by Cambridge University Press (CUP) in International Journal of Microwave and Wireless Technologies
- Vol. 12 (7) , 578-587
A superheterodyne 300 GHz wireless link for ultra-fast terahertz communication systems
A superheterodyne transmission scheme is adopted and analyzed in a 300 GHz wireless point-to-point link. This was realized using two different intermediate frequency (IF) systems. The first uses fast digital synthesis which provides an IF signal centered around a carrier frequency of 10 GHz. The second involves the usage of commercially available mixers, which work as direct up- and down-converters, to generate the IF input and output. The radio frequency components are based on millimeterwave monolithic integrated circuits at a center frequency of 300 GHz. Transmission experiments over distances up to 10 m are carried out. Data rates of up to 60 Gbps using the first IF option and up to 24 Gbps using the second IF option are achieved. Modulation formats up to 32QAM are successfully transmitted. The linearity of this link and of its components is analyzed in detail. Two local oscillators (LOs), a photonics-based source and a commercially available electronic source are employed and compared. This work validates the concept of superheterodyne architecture for integration in a beyond-5G network, supplying important guidelines that have to be taken into account in the design steps of a future wireless system.
- 19 May 2020
- Published by Cambridge University Press (CUP) in International Journal of Microwave and Wireless Technologies
- Vol. 12 (7) , 578-587
Open AccessA superheterodyne 300 GHz wireless link for ultra-fast terahertz communication systems
A superheterodyne transmission scheme is adopted and analyzed in a 300 GHz wireless point-to-point link. This was realized using two different intermediate frequency (IF) systems. The first uses fast digital synthesis which provides an IF signal centered around a carrier frequency of 10 GHz. The second involves the usage of commercially available mixers, which work as direct up- and down-converters, to generate the IF input and output. The radio frequency components are based on millimeterwave monolithic integrated circuits at a center frequency of 300 GHz. Transmission experiments over distances up to 10 m are carried out. Data rates of up to 60 Gbps using the first IF option and up to 24 Gbps using the second IF option are achieved. Modulation formats up to 32QAM are successfully transmitted. The linearity of this link and of its components is analyzed in detail. Two local oscillators (LOs), a photonics-based source and a commercially available electronic source are employed and compared. This work validates the concept of superheterodyne architecture for integration in a beyond-5G network, supplying important guidelines that have to be taken into account in the design steps of a future wireless system.
- 2 March 2020
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Terahertz Science and Technology
- Vol. 10 (3) , 271-281
A 300-GHz Wireless Link Employing a Photonic Transmitter and an Active Electronic Receiver With a Transmission Bandwidth of 54 GHz
In this paper, we present a 300 GHz wireless link composed of a photonic uni-traveling-carrier diode transmitter and an active electronic receiver based on millimeterwave integrated circuits fabricated in an InGaAs metamorphic high electron mobility transistor technology. The input pseudo-random binary sequence is transmitted and analyzed offline using fast analog to digital converters. The data transmission reaches 100 Gbps over a distance of 15 meters. Complex modulation formats, like 32-Quadrature Amplitude Modulation and 64-Quadrature Amplitude Modulation, are successfully transmitted up to a symbol rate of 8 GBd. The system presents not only a high linearity but is also capable of transmitting high symbol rates, up to 40 GBd To the best of the authors' knowledge, this represents the highest ever reported transmission bandwidth as well as the highest spectral density symbol rate product for transmissions with center frequency in the terahertz band. Thus, the usage of such links in future bandwidth-hungry applications like data centers, data showers, front- and backhaul is proven feasible.
- 2 March 2020
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Terahertz Science and Technology
- Vol. 10 (3) , 271-281
A 300-GHz Wireless Link Employing a Photonic Transmitter and an Active Electronic Receiver With a Transmission Bandwidth of 54 GHz
In this paper, we present a 300 GHz wireless link composed of a photonic uni-traveling-carrier diode transmitter and an active electronic receiver based on millimeterwave integrated circuits fabricated in an InGaAs metamorphic high electron mobility transistor technology. The input pseudo-random binary sequence is transmitted and analyzed offline using fast analog to digital converters. The data transmission reaches 100 Gbps over a distance of 15 meters. Complex modulation formats, like 32-Quadrature Amplitude Modulation and 64-Quadrature Amplitude Modulation, are successfully transmitted up to a symbol rate of 8 GBd. The system presents not only a high linearity but is also capable of transmitting high symbol rates, up to 40 GBd To the best of the authors' knowledge, this represents the highest ever reported transmission bandwidth as well as the highest spectral density symbol rate product for transmissions with center frequency in the terahertz band. Thus, the usage of such links in future bandwidth-hungry applications like data centers, data showers, front- and backhaul is proven feasible.
- 1 January 2020
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Terahertz Science and Technology
- Vol. 10 (1) , 32-43
A Terahertz Wireless Communication Link Using a Superheterodyne Approach
- 1 January 2020
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Terahertz Science and Technology
- Vol. 10 (1) , 32-43
A Terahertz Wireless Communication Link Using a Superheterodyne Approach
- 1 September 2019
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1-2
Towards super-heterodyne THz links pumped by photonic local oscillators
We present in this paper wireless data transmission experiments in a superheterodyne wireless system based on millimeterwave monolithic integrated circuits at a center frequency of 300 GHz, driven by photonic local oscillator (LO). Superheterodyne operation is attractive for compliance with the recent IEEE802.15.3d frequency standard. The super-heterodyne transmission with two channels is realized using an AWG and a photonic-based LO. The paper presents initial transmission experiments realized using two channels in the 300 GHz band.
- 1 September 2019
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1-2
Towards super-heterodyne THz links pumped by photonic local oscillators
We present in this paper wireless data transmission experiments in a superheterodyne wireless system based on millimeterwave monolithic integrated circuits at a center frequency of 300 GHz, driven by photonic local oscillator (LO). Superheterodyne operation is attractive for compliance with the recent IEEE802.15.3d frequency standard. The super-heterodyne transmission with two channels is realized using an AWG and a photonic-based LO. The paper presents initial transmission experiments realized using two channels in the 300 GHz band.