Luz Sanguansri

Summary: Broccoli stems and leaves examined were rich in protein (23.2%, dry weight), fibre (36.5%, dry weight) and polyphenols (11.4 mg gallic acid equivalents g⁻¹). Chlorogenic acid, neochlorogenic acid and quinic acid were the major phenolics found. Broccoli by‐products have potential to be developed as differentiated food ingredients by separation. On a dry basis, the pomace and washed pomace fractions were enriched in fibre and had higher water‐holding but lower water solubility and emulsifying capacity compared to juice and supernatant from washed pomace, which were enriched in protein. The juice and supernatant had higher polyphenol content and higher antioxidant activity, suggesting that polyphenols were the major contributors to antioxidant activity. For convenience of use, the products may be supplied as packaged powdered ingredients, but this was practical only for broccoli stems and leaves and pomaces as these powders had higher glass transition temperatures than the juice and supernatant fractions.

Apple pomace, a by-product of juice production, is a high-fibre, high-polyphenol functional food ingredient. Extrusion (barrel moisture 15%, 20% or 30%) of apple pomace, followed by drying, allows it to be supplied in a convenient form. Extrusion caused degradation of the apple pomace cell wall structure. Water solubility was significantly increased by extrusion but oil holding capacity was reduced. Total extractable polyphenols, measured as gallic acid equivalents, were reduced by extrusion (barrel moisture 30%) but were not affected by extrusion at lower barrel moisture contents (15% or 20%). However, individual sub-groups of extractable flavanols, flavonols, phenolic acids and dihydrochalcones were increased by extrusion. There was little effect of extrusion on the release of total polyphenols from the matrix into the supernatant, as measured by total extractable polyphenols (measured as gallic acid equivalents) released during in vitro digestion. There was a marked increase in total flavanols, phenolic acids and dihydrochalones released into the supernatant during the gastric phase but changes in flavonoids were less obvious. The changes in the bioaccessibility of individual polyphenols released during intestinal digestion were dependent on the type of polyphenol and extrusion conditions. The antioxidant activity, as measured using oxygen radical absorbance capacity (ORAC) of the bioaccessible nutrients released upon in vitro intestinal digestion, was significantly enhanced by extrusion (from 78.2 to 400–500 μmol Trolox equivalents per mL at the ileal phase). The increased ORAC may be attributed in part to the increased release of individual polyphenols.

Extruded snack products were made from an oat fiber‐corn flour matrix fortified with 1.5% (w/w) curcuminoids (750 mg curcuminoids/100 g) to improve the solubility and stability of curcuminoids. The effects of extruder feed moisture content (21%, 28%, and 35%) and screw speed (200 and 300 rpm) on the extrusion parameters and physical properties of final snacks were investigated. Curcuminoids lost during extrusion and curcuminoids loss during subsequent drying of extrudates were analyzed, to separate the losses occurring in each unit process. Drying post extrusion (at 50 °C for 4 hr) was essential to obtain a crunchy shelf stable product (5% moisture). Curcuminoids loss during extrusion was from 17% to 84%, with high loss for the extrusion with low feed moisture content (21%). A further curcuminoids loss of 4% to 44% occurred during drying, with much higher loss for the extrudate with high moisture content. Total curcuminoids retained after extrusion and drying was 12% to 41% (59% to 88% loss), equivalent to 180 to 616 mg curcuminoids retained per 100 g snack, levels within recommended daily dose. Curcuminoids retained after drying was stable during 80 days of storage at 25 °C. The results highlighted the importance of understanding the impact of each unit process separately (for example, extrusion and drying) on the stability of curcuminoids for the development of healthier extruded snacks. Practical Application: Extruded snacks products were developed by fortifying the snacks with oat fiber and curcuminoids in order to address the need for a healthy ready to eat food products. Some extrusion characteristics were selected to produce snack products which have favorable properties in terms of consumer acceptance.