Farida Ashraf Ali
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Farida Ashraf Ali has a total of 35 co-authors. Here are the top co-authors by number of shared publications:
Gouranga Bose
5 shared publicationsS. K. Kamilla
3 shared publicationsSushanta K. Kamilla
3 shared publications- Dilip Kumar Mishra
Department of Physics, Faculty of Engineering and Technology (ITER), Siksha ‘O’ Anusandhan Deemed to be University, Bhubaneswar 751 030, Odisha, India
2 shared publications Gayatri Pradhan
Dept. of EIE, ITER, S ‘O’ A University, Bhubaneswar, India
2 shared publicationsA. K. Panda
1 shared publication
Latest Publications
- 11 August 2026
- Published by Taylor & Francis
- p. 306-320
Advanced All-Solid-State Organic Batteries for Sustainable Energy Storage
Recent innovations like the all-solid-state organic battery offer long-term, efficient energy storage. These batteries outperform standard batteries in safety, performance, and environmental effect. Recent improvements and issues with all-solid-state organic batteries are examined in this chapter. Solid-state electrolytes (SSEs), synthesis, characterization, applications, and environmental impacts are comprehensively explored. SSEs need ion conductivity and interface compatibility, which are covered in this chapter. Different methods for manufacturing and characterizing these electrolytes for battery components are also discussed. This study examines all-solid-state organic batteries in consumer devices, electric cars, and grid storage to determine their efficacy and impact. We also assess all-solid-state organic batteries’ sustainability and environmental effect by considering resource availability, recycling possibilities, and life cycle analysis. The chapter discusses how all-solid-state organic batteries might increase energy storage efficiency and sustainability, including research approaches and difficulties.
- 11 August 2026
- Published by Taylor & Francis
- p. 306-320
Advanced All-Solid-State Organic Batteries for Sustainable Energy Storage
Recent innovations like the all-solid-state organic battery offer long-term, efficient energy storage. These batteries outperform standard batteries in safety, performance, and environmental effect. Recent improvements and issues with all-solid-state organic batteries are examined in this chapter. Solid-state electrolytes (SSEs), synthesis, characterization, applications, and environmental impacts are comprehensively explored. SSEs need ion conductivity and interface compatibility, which are covered in this chapter. Different methods for manufacturing and characterizing these electrolytes for battery components are also discussed. This study examines all-solid-state organic batteries in consumer devices, electric cars, and grid storage to determine their efficacy and impact. We also assess all-solid-state organic batteries’ sustainability and environmental effect by considering resource availability, recycling possibilities, and life cycle analysis. The chapter discusses how all-solid-state organic batteries might increase energy storage efficiency and sustainability, including research approaches and difficulties.
- 4 January 2022
- Published by Springer Nature in Bulletin of Materials Science
- Vol. 45 (1) , 1-22
Solid-state gas sensors: sensing mechanisms and materials
- 4 January 2022
- Published by Springer Nature in Bulletin of Materials Science
- Vol. 45 (1) , 1-22
Solid-state gas sensors: sensing mechanisms and materials
- 1 December 2018
- Published by Elsevier in Inorganic Chemistry Communications
- Vol. 98, 11-28
Conducting polymer nanocomposite based temperature sensors: A review
- 1 December 2018
- Published by Elsevier in Inorganic Chemistry Communications
- Vol. 98, 11-28
Conducting polymer nanocomposite based temperature sensors: A review
- 1 February 2016
- Published by American Scientific Publishers in Advanced Science Letters
- Vol. 22 (2) , 430-433
Structural and Electrical Properties of Fe Doped ZnO/GaSb Heterostructure Thin Film for Device Application
- 1 February 2016
- Published by American Scientific Publishers in Advanced Science Letters
- Vol. 22 (2) , 430-433
Structural and Electrical Properties of Fe Doped ZnO/GaSb Heterostructure Thin Film for Device Application
- 1 February 2016
- Published by American Scientific Publishers in Advanced Science Letters
- Vol. 22 (2) , 381-383
Study of 65 nm n-MOSFET Using SILVACO TCAD
The electrical characterization of 65 nm NMOS transistor structure is simulated by the ATLAS simulator software and then it is compared with the reported experimental results. The input and output characteristics of the structure was studied. The simulated threshold voltage was found to be 0.2 V which matches well with the experimental value. Furthermore, various short channel effects like punch through, velocity saturation and hot electron effects are studied. From the study it was found that for higher drain voltage, the amount of gate voltage which the device will be able to sustain before giving rise to gate current is less.
- 1 February 2016
- Published by American Scientific Publishers in Advanced Science Letters
- Vol. 22 (2) , 381-383
Study of 65 nm n-MOSFET Using SILVACO TCAD
The electrical characterization of 65 nm NMOS transistor structure is simulated by the ATLAS simulator software and then it is compared with the reported experimental results. The input and output characteristics of the structure was studied. The simulated threshold voltage was found to be 0.2 V which matches well with the experimental value. Furthermore, various short channel effects like punch through, velocity saturation and hot electron effects are studied. From the study it was found that for higher drain voltage, the amount of gate voltage which the device will be able to sustain before giving rise to gate current is less.
- 1 January 2016
- Published by Institution of Engineering and Technology (IET)
Comparison study of GaSb and strained silicon p-mosfets
To keep pace with the projected International Technology Roadmap for Semiconductors (ITRS) mainly in terms of low cost, low power and high speed; hole mobility is one of the roadblocks. Hence, many researchers are intensively looking to enhance the hole mobility either by modifying the surface of silicon substrate or by exploring new materials in place of silicon. Thus, in this paper, the electrical properties of strained silicon substrate based MOSFET and Gallium-Antimony (GaSb) based MOSFET are simulated using SILVACO-ATLAS and compared. The band misalignment and occurrence of undesired buried channel in the strained silicon limits the hole mobility, which does not occur in GaSb MOS devices. In spite of retardation of hole mobility in the strained silicon substrate, it is more than the GaSb substrate. Moreover, the GaSb MOSFET turns on at low voltage (-0.1 Volts) and its trans-conductance increases at lower gate voltage range and thereafter it gets saturated. On the other hand, the strained silicon MOSFET turns on at -0.4volts and its trans-conductance saturates at higher voltage range compared to GaSb substrate and its trans-conductance is found to be approximately 4 times than the GaSb MOSFET. Hence, GaSb substrate may work better at low power applications; whereas, the S-Si substrate may be suitable for high hole mobility devices.
- 1 January 2016
- Published by Institution of Engineering and Technology (IET)
Comparison study of GaSb and strained silicon p-mosfets
To keep pace with the projected International Technology Roadmap for Semiconductors (ITRS) mainly in terms of low cost, low power and high speed; hole mobility is one of the roadblocks. Hence, many researchers are intensively looking to enhance the hole mobility either by modifying the surface of silicon substrate or by exploring new materials in place of silicon. Thus, in this paper, the electrical properties of strained silicon substrate based MOSFET and Gallium-Antimony (GaSb) based MOSFET are simulated using SILVACO-ATLAS and compared. The band misalignment and occurrence of undesired buried channel in the strained silicon limits the hole mobility, which does not occur in GaSb MOS devices. In spite of retardation of hole mobility in the strained silicon substrate, it is more than the GaSb substrate. Moreover, the GaSb MOSFET turns on at low voltage (-0.1 Volts) and its trans-conductance increases at lower gate voltage range and thereafter it gets saturated. On the other hand, the strained silicon MOSFET turns on at -0.4volts and its trans-conductance saturates at higher voltage range compared to GaSb substrate and its trans-conductance is found to be approximately 4 times than the GaSb MOSFET. Hence, GaSb substrate may work better at low power applications; whereas, the S-Si substrate may be suitable for high hole mobility devices.
- 1 January 2015
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1-4
Interface study of high-k/InAs/n-GaSb MOSCAP structures
Removed.
- 1 January 2015
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1-4
Interface study of high-k/InAs/n-GaSb MOSCAP structures
Removed.
- 26 August 2014
- Published by Springer Nature
- p. 499-507
Interface Study of Individual and Stacked High-k/P-Si MOSCAPs by CV Technique
- 26 August 2014
- Published by Springer Nature
- p. 499-507
Interface Study of Individual and Stacked High-k/P-Si MOSCAPs by CV Technique
- 1 March 2014
- Published by American Scientific Publishers in Advanced Science Letters
- Vol. 20 (3) , 784-787
Crystal Growth of Bulk Ga1−xNixSb Ternary Alloy and It's Characterization Between 78 K to 300 K
In this work ingot of Ga1−x Ni x Sb (x = 0.04), a new III–V material was grown by the vertical Bridgman method. The ampoule containing the material was pulled downward at very slow rate (0.7 cm/hour). X-ray diffraction analysis revealed the polycrystalline composition of Ga0.96Ni0.04Sb. Also the X-ray photoemission spectroscopy (XPS) and Vickers microhardness analyses were done to determine the composition and mechanical properties of Ga0.96Ni0.04Sb. The semiconductor properties like resistivity, type of conductivity, free carrier density and free carrier mobility were experimentally determined by resistivity and Hall Effect measurements using van der Pauw configuration within temperature range 78 K to 300 K. From the sign of Hall co-efficient the samples were found to be p-type. All these electrical properties of Ga0.96Ni0.04Sb were compared with undoped GaSb which was grown by same Bridgeman method and also with nickel doped GaSb model developed using TCAD simulation. In case of undoped GaSb sample mobility of holes was found 440 cm2/V sec at 300 K and maximum mobility was observed 1050 cm2/V·sec at 140 K.
- 1 March 2014
- Published by American Scientific Publishers in Advanced Science Letters
- Vol. 20 (3) , 784-787
Crystal Growth of Bulk Ga1−xNixSb Ternary Alloy and It's Characterization Between 78 K to 300 K
In this work ingot of Ga1−x Ni x Sb (x = 0.04), a new III–V material was grown by the vertical Bridgman method. The ampoule containing the material was pulled downward at very slow rate (0.7 cm/hour). X-ray diffraction analysis revealed the polycrystalline composition of Ga0.96Ni0.04Sb. Also the X-ray photoemission spectroscopy (XPS) and Vickers microhardness analyses were done to determine the composition and mechanical properties of Ga0.96Ni0.04Sb. The semiconductor properties like resistivity, type of conductivity, free carrier density and free carrier mobility were experimentally determined by resistivity and Hall Effect measurements using van der Pauw configuration within temperature range 78 K to 300 K. From the sign of Hall co-efficient the samples were found to be p-type. All these electrical properties of Ga0.96Ni0.04Sb were compared with undoped GaSb which was grown by same Bridgeman method and also with nickel doped GaSb model developed using TCAD simulation. In case of undoped GaSb sample mobility of holes was found 440 cm2/V sec at 300 K and maximum mobility was observed 1050 cm2/V·sec at 140 K.
- 1 March 2014
- Published by American Scientific Publishers in Advanced Science Letters
- Vol. 20 (3) , 635-637
Impact of InxAlyGa1−x−yN Layer on GaSb/AlGaAs High Electron Mobility Transistor
The high electron mobility transistor (HEMT) is promising device for high power and high frequency application due to narrow band gap and low ohmic contact. In this paper, antimony (Sb) based multilayer HEMT is designed and optimized. The high electron mobility compound semiconductor materials used in the proposed device are Gallium Antimonide (GaSb), Aluminum Gallium Arsenide (AlGaAs), Indium Aluminum Gallium Nitride (InAlGaN) etc. stacked in layer of different electron affinity and work function. Here Ni metal was taken as gate contact of length 0.1 μm. The two dimensional electron gas (2DEG) is formed at the interface region due to discontinuity of hetero junction. The performance of the device is obtained from the simulation with TCAD software and is compared with theoretical result. The optimized structure of proposed GaSb based HEMT has been discussed. The device produced excellent Id –V ds characteristics, from which the maximum current found to be 4.6 A/mm for the composition of x = 0.1 and y = 0.5 in In x Al y Ga1−x−y N.
- 1 March 2014
- Published by American Scientific Publishers in Advanced Science Letters
- Vol. 20 (3) , 635-637
Impact of InxAlyGa1−x−yN Layer on GaSb/AlGaAs High Electron Mobility Transistor
The high electron mobility transistor (HEMT) is promising device for high power and high frequency application due to narrow band gap and low ohmic contact. In this paper, antimony (Sb) based multilayer HEMT is designed and optimized. The high electron mobility compound semiconductor materials used in the proposed device are Gallium Antimonide (GaSb), Aluminum Gallium Arsenide (AlGaAs), Indium Aluminum Gallium Nitride (InAlGaN) etc. stacked in layer of different electron affinity and work function. Here Ni metal was taken as gate contact of length 0.1 μm. The two dimensional electron gas (2DEG) is formed at the interface region due to discontinuity of hetero junction. The performance of the device is obtained from the simulation with TCAD software and is compared with theoretical result. The optimized structure of proposed GaSb based HEMT has been discussed. The device produced excellent Id –V ds characteristics, from which the maximum current found to be 4.6 A/mm for the composition of x = 0.1 and y = 0.5 in In x Al y Ga1−x−y N.