Hamid A.ABd El-Rahman
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Hamid A.ABd El-Rahman has a total of 36 co-authors. Here are the top co-authors by number of shared publications:
A. G. Gad-Allah
Chemistry Department, Faculty of Science, Cairo University, Giza, Egypt
9 shared publicationsM. M. Abou-Romia
Cairo University
5 shared publicationsA.G. Gad-Allah
Department of Chemistry, Faculty of Science, Cairo University, Giza, Egypt
3 shared publicationsH. H. Rehan
Cairo University
3 shared publicationsM. Abd El-Galil
Chloride, Egypt Company for Batteries, Giza, Egypt
3 shared publicationsW.A. Badawy
Department of Chemistry, Faculty of Science, Cairo University, Giza, Egypt
3 shared publications
Latest Publications
- 1 January 2014
- Published by The Scientific and Technological Research Council of Turkey (TUBITAK-ULAKBIM) - DIGITAL COMMONS JOURNALS in TURKISH JOURNAL OF CHEMISTRY
- Vol. 38 (2) , 260-274
Effect of boric acid on corrosion and electrochemical performance of Pb-0.08{\%} Ca-1.1{\%} Sn alloys containing Cu, As, and Sb impurities for manufacture of grids of lead-acid batteries
- 1 January 2014
- Published by The Scientific and Technological Research Council of Turkey (TUBITAK-ULAKBIM) - DIGITAL COMMONS JOURNALS in TURKISH JOURNAL OF CHEMISTRY
- Vol. 38 (2) , 260-274
Effect of boric acid on corrosion and electrochemical performance of Pb-0.08{\%} Ca-1.1{\%} Sn alloys containing Cu, As, and Sb impurities for manufacture of grids of lead-acid batteries
- 23 October 2013
- Published by Wiley in Materialwissenschaft und Werkstofftechnik
- Vol. 44 (10) , 832-838
Effect of As, Cu and Sb impurities on performance of Pb‐Ca‐Sn grids of lead‐acid batteries
The performance of Pb‐Ca‐Sn grids of lead‐acid batteries made from recycled lead in 4 M H2SO4 in the absence and presence of traces of Cu, As and Sb, as potential impurities in the recycling process at 0.1% level, is investigated by electrochemical methods. The study includes the effect of each impurity and impurities combined on the alloy corrodibility, the efficiency of PbO2 formation, the rate of the self‐discharge and the hydrogen evolution reaction (HER) and the oxygen evolution reaction (OER). The results show that individual impurity enhances the corrosion resistance but increases the anode corrosion and the self‐discharge rate. Impurities play opposite effects on hydrogen evolution reaction and oxygen evolution reaction either individually or combined. Concerning water loss problem, the harmful effect of individual impurity on increasing oxygen evolution reaction is compensated by their suppression of hydrogen evolution reaction. The impurities combined suppress effectively both hydrogen evolution reaction and oxygen evolution reaction relative to alloy without any impurity. Sb has the highest harmful effects on oxygen evolution reaction and the self‐discharge but it is the best in the suppression of hydrogen evolution reaction. The impurities combined relatively improve the general corrosion resistance, the anode corrosion resistance and the self‐discharge. The study supports higher tolerance levels of Cu, As and Sb in Pb‐Ca‐Sn grids, especially when present combined, than the recommended levels in the industry standards.
- 23 October 2013
- Published by Wiley in Materialwissenschaft und Werkstofftechnik
- Vol. 44 (10) , 832-838
Effect of As, Cu and Sb impurities on performance of Pb‐Ca‐Sn grids of lead‐acid batteries
The performance of Pb‐Ca‐Sn grids of lead‐acid batteries made from recycled lead in 4 M H2SO4 in the absence and presence of traces of Cu, As and Sb, as potential impurities in the recycling process at 0.1% level, is investigated by electrochemical methods. The study includes the effect of each impurity and impurities combined on the alloy corrodibility, the efficiency of PbO2 formation, the rate of the self‐discharge and the hydrogen evolution reaction (HER) and the oxygen evolution reaction (OER). The results show that individual impurity enhances the corrosion resistance but increases the anode corrosion and the self‐discharge rate. Impurities play opposite effects on hydrogen evolution reaction and oxygen evolution reaction either individually or combined. Concerning water loss problem, the harmful effect of individual impurity on increasing oxygen evolution reaction is compensated by their suppression of hydrogen evolution reaction. The impurities combined suppress effectively both hydrogen evolution reaction and oxygen evolution reaction relative to alloy without any impurity. Sb has the highest harmful effects on oxygen evolution reaction and the self‐discharge but it is the best in the suppression of hydrogen evolution reaction. The impurities combined relatively improve the general corrosion resistance, the anode corrosion resistance and the self‐discharge. The study supports higher tolerance levels of Cu, As and Sb in Pb‐Ca‐Sn grids, especially when present combined, than the recommended levels in the industry standards.
- 8 September 2011
- Published by Wiley in Materialwissenschaft und Werkstofftechnik
- Vol. 42 (9) , 784-791
Effect of phosphoric acid on the performance of low antimony grid of Pb‐acid cell under constant current charging and discharging
Effect of phosphoric acid on the performance of Pb‐1.7%Sb grid of lead‐acid cell is studied in 5 M H2SO4 by cyclic galvanostatic polarization and impedance spectroscopy. An increase in capacitance to a maximum is recorded during the initial stages of the electro‐reduction of PbO2 into Pb(II) compounds and attributed to concurrent compositional and dimensional changes. These changes include removal of O2 bubbles, insertion of large amounts of H2SO4 and H2O. Efficiency of PbO2 formation decreases, while its rate of self‐discharge increases with increasing the charging current and in the presence of H3PO4. The charge capacity increases with increasing the discharging current due to the decrease in the self‐discharge. The charge capacity is lower in the presence of H3PO4. On increasing the cycle number, the corrodibility of the grid increases, because more layers of the surface Pb are involved in the self‐discharge. H3PO4 significantly retards the effect of cycle number.
- 8 September 2011
- Published by Wiley in Materialwissenschaft und Werkstofftechnik
- Vol. 42 (9) , 784-791
Effect of phosphoric acid on the performance of low antimony grid of Pb‐acid cell under constant current charging and discharging
Effect of phosphoric acid on the performance of Pb‐1.7%Sb grid of lead‐acid cell is studied in 5 M H2SO4 by cyclic galvanostatic polarization and impedance spectroscopy. An increase in capacitance to a maximum is recorded during the initial stages of the electro‐reduction of PbO2 into Pb(II) compounds and attributed to concurrent compositional and dimensional changes. These changes include removal of O2 bubbles, insertion of large amounts of H2SO4 and H2O. Efficiency of PbO2 formation decreases, while its rate of self‐discharge increases with increasing the charging current and in the presence of H3PO4. The charge capacity increases with increasing the discharging current due to the decrease in the self‐discharge. The charge capacity is lower in the presence of H3PO4. On increasing the cycle number, the corrodibility of the grid increases, because more layers of the surface Pb are involved in the self‐discharge. H3PO4 significantly retards the effect of cycle number.
- 1 April 2002
- Published by Association for Materials Protection and Performance (AMPP) in Corrosion
- Vol. 58 (4) , 299-302
Technical Note: Synergetic Effect of 8-Quinolinol and Benzotriazole on Preventing Dezincification of α-Brass (35.9% Zn) in Acid Chloride Solutions
Corrosion and dezincification of α-brass (35.9% Zn) in acid chloride solutions in the absence and presence of 8-quinolinol (C9H6NOH) (0.1 mM to 5.0 mM) were studied after 1-week immersion by mass loss and solution analysis. The severe dezincification was found to decrease substantially in the presence of 8-quinolinol, and complete prevention of dezincification was attained in the concentration range of 0.5 mM to 2.0 mM. The presence of 8-quinolinol, however, caused a pronounced increase in the corrosion rate. This disadvantage was completely overcome by adding 5 mM benzotriazole (C6H5N3). The following complementary action occurred: 8-quinolinol accelerated the dissolution of copper in the alloy more than that of zinc (dezincification was suppressed) while benzotriazole inhibited the dissolution of copper and zinc equally (general corrosion suppression).
- 1 April 2002
- Published by Association for Materials Protection and Performance (AMPP) in Corrosion
- Vol. 58 (4) , 299-302
Technical Note: Synergetic Effect of 8-Quinolinol and Benzotriazole on Preventing Dezincification of α-Brass (35.9% Zn) in Acid Chloride Solutions
Corrosion and dezincification of α-brass (35.9% Zn) in acid chloride solutions in the absence and presence of 8-quinolinol (C9H6NOH) (0.1 mM to 5.0 mM) were studied after 1-week immersion by mass loss and solution analysis. The severe dezincification was found to decrease substantially in the presence of 8-quinolinol, and complete prevention of dezincification was attained in the concentration range of 0.5 mM to 2.0 mM. The presence of 8-quinolinol, however, caused a pronounced increase in the corrosion rate. This disadvantage was completely overcome by adding 5 mM benzotriazole (C6H5N3). The following complementary action occurred: 8-quinolinol accelerated the dissolution of copper in the alloy more than that of zinc (dezincification was suppressed) while benzotriazole inhibited the dissolution of copper and zinc equally (general corrosion suppression).
- 1 January 2000
- Published by The Electrochemical Society in Journal of the Electrochemical Society
- Vol. 147 (1) , 242-247
Electroactive Polymer Films Formed from the Schiff Base Product of 1,8-Diaminonaphthalene and Dehydroacetic Acid. I. Preparation and Characterization
We report on the preliminary synthesis and characterization of an electroactive, conducting polymer that should readily bind metal cation. Anodic polymerization of the Schiff base resulting from the condensation reaction between 1,8‐diaminonaphthalene and dehydroacetic acid, 8‐(3‐acetylimino‐6‐methyl‐2,4‐dioxopyran)‐1‐aminonaphthalene, on platinum electrode in acetonitrile was found to yield thin, electroactive polymeric films. The films were found electroactive in acetonitrile and aqueous sulfuric acid solution and the electroacity is attributed to the electron transformation of the amino/imine sites in the polymer as in aromatic amine polymers. Electrochemical studies of electron‐transfer reactions on the polymer‐covered platinum electrodes indicated that the polymer films are highly porous and semiconducting. © 2000 The Electrochemical Society. All rights reserved.
- 1 January 2000
- Published by The Electrochemical Society in Journal of the Electrochemical Society
- Vol. 147 (1) , 242-247
Electroactive Polymer Films Formed from the Schiff Base Product of 1,8-Diaminonaphthalene and Dehydroacetic Acid. I. Preparation and Characterization
We report on the preliminary synthesis and characterization of an electroactive, conducting polymer that should readily bind metal cation. Anodic polymerization of the Schiff base resulting from the condensation reaction between 1,8‐diaminonaphthalene and dehydroacetic acid, 8‐(3‐acetylimino‐6‐methyl‐2,4‐dioxopyran)‐1‐aminonaphthalene, on platinum electrode in acetonitrile was found to yield thin, electroactive polymeric films. The films were found electroactive in acetonitrile and aqueous sulfuric acid solution and the electroacity is attributed to the electron transformation of the amino/imine sites in the polymer as in aromatic amine polymers. Electrochemical studies of electron‐transfer reactions on the polymer‐covered platinum electrodes indicated that the polymer films are highly porous and semiconducting. © 2000 The Electrochemical Society. All rights reserved.
- 1 October 1999
- Published by Springer Nature in Journal of Applied Electrochemistry
- Vol. 29 (10) , 1205-1210
Effect of oxide ion donors on the corrosion and dechromization of stainless steels in KCl–NaCl–BaCl2 melt
- 1 October 1999
- Published by Springer Nature in Journal of Applied Electrochemistry
- Vol. 29 (10) , 1205-1210
Effect of oxide ion donors on the corrosion and dechromization of stainless steels in KCl–NaCl–BaCl2 melt
- 1 April 1999
- Published by Springer Nature in Journal of Radioanalytical and Nuclear Chemistry
- Vol. 240 (1) , 141-146
Physico-chemical studies on polymethyl methacrylate alite composite
- 1 April 1999
- Published by Springer Nature in Journal of Radioanalytical and Nuclear Chemistry
- Vol. 240 (1) , 141-146
Physico-chemical studies on polymethyl methacrylate alite composite
- 1 April 1998
- Published by Wiley in Materialwissenschaft und Werkstofftechnik
- Vol. 29 (5) , 263-269
Corrosion of Zinc in acetic acid derivatives: Glycollic, mercaptoacetic and cyanoacetic acids and glycine
- 1 April 1998
- Published by Wiley in Materialwissenschaft und Werkstofftechnik
- Vol. 29 (5) , 263-269
Corrosion of Zinc in acetic acid derivatives: Glycollic, mercaptoacetic and cyanoacetic acids and glycine
- 1 November 1996
- Published by Elsevier in Journal of Electroanalytical Chemistry
- Vol. 416 (1-2) , 67-74
New quaternized aminoquinoline polymer films: electropolymerization and characterization
- 1 November 1996
- Published by Elsevier in Journal of Electroanalytical Chemistry
- Vol. 416 (1-2) , 67-74
New quaternized aminoquinoline polymer films: electropolymerization and characterization
- 1 September 1996
- Published by Elsevier in Journal of Power Sources
- Vol. 62 (1) , 51-57
Role of minor alloying elements on the performance of lead/acid battery grids. Part 2. Corrosion of lead-arsenic alloys
- 1 September 1996
- Published by Elsevier in Journal of Power Sources
- Vol. 62 (1) , 51-57
Role of minor alloying elements on the performance of lead/acid battery grids. Part 2. Corrosion of lead-arsenic alloys