JSJamieson H Steidl

Jamieson H Steidl

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article

Previous Organizations / Institutes

The organizations / institutes from the scholar's other articles in the past ten years


Jamieson H Steidl has a total of 114 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Near-Surface Material and Topography Generate Anomalous High-Frequency Ground-Motion Amplification in Chugiak, Alaska

    by Te-Yang Yeh, Kim B. Olsen, Jamison H. Steidl, Peter J. Haeussler

    An ∼3 km long nodal array oriented approximately east–west was deployed in Chugiak, Alaska, by the U.S. Geological Survey during 2021. The array intersects with the permanent NetQuakes station NP.ARTY, where peak ground acceleration (PGA) value of 1.98g was recorded during the 2018 Mw 7.1 Anchorage, Alaska, earthquake, in sharp contrast to the PGA of ∼0.3g at a site just 4 km to the west. Seismic data for ML 1.8–4.3 aftershocks from the Mw 7.1 event recorded by the nodal array confirm the anomalously large ground motions obtained at NP.ARTY as well as similar amplifications at nodes within ∼1 km to the east. Here, we performed 0–10 Hz 3D finite-difference simulations, including high-resolution surface topography, to explore the cause of the unexpectedly large amplification. As expected, the simulations computed with a regional 3D tomography velocity model severely underpredict the 0–10 Hz acceleration records at almost all sites. Adding a near-surface low-velocity taper to 300 m depth amplifies the accelerations by up to a factor of 5 and enables a reasonable match between the nodal data and simulations at sites to the west of NP.ARTY. However, this model still underpredicts the spectral energy in the area covered by glacial sediments by up to an order of magnitude. The addition of a till layer using a depth-dependent shear-wave velocity (VS) profile along with a homogeneous, 8 m thick low-velocity layer with VS=250 m/s representing the kame terraces improves the fit to data to within a factor of 2 at nodes located on top of the glacial sediments. Our study shows that the anomalously large high-frequency amplification recorded at and near NP.ARTY can be explained by a combination of topographic effects and near-surface low-velocity material with amplification effects on the high-frequency ground motion by up to about 40% and an order of magnitude, respectively.


  • Open Access

    Monitoring Seasonal Shear Wave Velocity Changes in the Top 6 m at Garner Valley in Southern California With Borehole Data

    by Lei Qin, Jamison H. Steidl, Hongrui Qiu, Nori Nakata, Yehuda Ben‐Zion

    Subsurface structures play important roles in seismic ground motion, crustal hydrology, stability of the built environment, and more. Constraining temporal changes of subsurface shear wave velocity ( V S ) can provide useful information to all these topics and the growing field of hydrological monitoring with seismic velocity. Using borehole records at Garner Valley, CA, we estimate seasonal subsurface V S variations from impulse response functions (IRFs) of earthquake data (2005–2018) along with IRFs and cross‐correlation of cross‐hole experiment data (2015–2018). The inferred V S variations are up to ∼25% in the top 6 m and ∼10% at 2–5 m in depth. The V S variations correlate strongly with the water table depth changes, suggesting that the changes are mostly due to fluctuations of pore pressure in the shallow material. The shallow velocity changes alter the near‐surface conditions, can affect seismic hazard estimation, and may be improperly attributed to deeper processes without careful analysis.


  • Open Access

    Seismic Imaging of the Mw 7.1 Ridgecrest Earthquake Rupture Zone From Data Recorded by Dense Linear Arrays

    by Hongrui Qiu, Yehuda Ben‐Zion, Rufus Catchings, Mark R. Goldman, Amir A. Allam, Jamison Steidl

    We analyze seismograms recorded by four arrays (B1–B4) with 100 m station spacing and apertures of 4–8 km that cross the surface rupture of the 2019 Mw 7.1 Ridgecrest earthquake. The arrays extend from B1 in the northwest to B4 in the southeast of the surface rupture. Delay times between P wave arrivals associated with ∼1,200 local earthquakes and four teleseismic events are used to estimate local velocity variations beneath the arrays. Both teleseismic and local P waves travel faster on the northeast than the southwest side of the fault beneath arrays B1 and B4, but the velocity contrast is less reliably resolved at arrays B2 and B3. We identify several 1–2 km wide low‐velocity zones with much slower inner cores that amplify S waveforms, inferred as damage zones, beneath each array. The damage zones at arrays B2 and B4 also generate fault‐zone head and trapped waves. An automated detector, based on peak ground velocities and durations of high‐amplitude waves, identifies candidate fault‐zone trapped waves (FZTWs) in a localized zone for ∼600 earthquakes at array B4. Synthetic waveform modeling of averaged FZTWs, generated by ∼30 events with high‐quality signals, indicates that the trapping structure at array B4 has a width of ∼300 m, depth of 3–5 km, S wave velocity reduction of ∼20% with respect to the surrounding rock, Q‐value of ∼30, and S wave velocity contrast of ∼4% across the fault (faster on the northeast side). The results show complex fault‐zone internal structures (velocity contrasts and low‐velocity zones) that vary along fault strike.


  • A Pilot Experiment on Infrasonic Lahar Detection at Mount Adams, Cascades: Ambient Infrasound and Wind-Noise Characterization at a Quiescent Stratovolcano

    by Richard W. Sanderson, Robin S. Matoza, Rachel M. Haymon, Jamison H. Steidl

    Erosion, hydrothermal activity, and magmatism at volcanoes can cause large and unexpected mass wasting events. Large fluidized debris flows have occurred within the past 6000 yr at Mount Adams, Washington, and present a hazard to communities downstream. In August 2017, we began a pilot experiment to investigate the potential of infrasound arrays for detecting and tracking debris flows at Mount Adams. We deployed a telemetered four‐element infrasound array (BEAR, 85 m aperture), ~11 km from a geologically unstable area where mass wasting has repeatedly originated. We present a preliminary analysis of BEAR data, representing a survey of the ambient infrasound and noise environment at this quiescent stratovolcano. Array processing reveals near continuous and persistent infrasound signals arriving from the direction of Mount Adams, which we hypothesize are fluvial sounds from the steep drainages on the southwest flank. We interpret observed fluctuations in the detectability of these signals as resulting from a combination of (1) wind‐noise variations at the array, (2) changes in local infrasound propagation conditions associated with atmospheric boundary layer variability, and (3) changing water flow speeds and volumes in the channels due to freezing, thawing, and precipitation events. Suspected mass movement events during the study period are small (volumes <105  m3 and durations <2 min⁠), with one of five visually confirmed events detected infrasonically at BEAR. We locate this small event, which satellite imagery suggests was a glacial avalanche, using three additional temporary arrays operating for five days in August 2018. Events large enough to threaten downstream communities would likely produce stronger infrasonic signals detectable at BEAR. In complement to recent literature demonstrating the potential for infrasonic detection of volcano mass movements (Allstadt et al., 2018), this study highlights the practical and computational challenges involved in identifying signals of interest in the expected noisy background environment of volcanic topography and drainages.


  • Open Access

    Detailed seismic imaging of the Mw 7.1 Ridgecrest earthquake rupture zone from data recorded by dense linear arrays

    by Hongrui Qiu, Yehuda Ben-Zion, R. D. Catchings, Mark R Goldman, Amir Allam, Jamison Steidl

    We analyze seismograms recorded by four arrays (B1-B4) with 100-m station spacing and apertures of 4-8 km that cross the surface rupture of the 2019 Mw7.1 Ridgecrest earthquake. The arrays extend from B1 in the northwest to B4 in the southeast of the surface rupture. Delay times between P -wave arrivals associated with ∼1200 local earthquakes and four teleseismic events are used to estimate local velocity variations beneath the arrays. Both teleseismic and local P waves travel faster on the northeast than the southwest side of the fault for ~4.6% and ~7.5% beneath arrays B1 and B4, but the velocity contrast is less significant at arrays B2 and B3. We identify several 1- to 2-km-wide low-velocity zones with more intensely damaged inner cores beneath each array. The damage zone at array B4 generates fault-zone head, reflected, and trapped waves. An automated detector, based on peak ground velocities and durations of high-amplitude waves, identifies candidate fault-zone trapped waves (FZTWs) in a localized zone for ~600 earthquakes. Synthetic waveform modeling of averaged FZTWs, generated by ~30 events with high-quality signals, indicate that the trapping structure at array B4 has a width of ∼300 m, depth of 3-5 km, S -wave velocity reduction of ∼20% with respect to the surrounding rock, Q -value of ∼30, and S -wave velocity contrast of ~4% across the fault (faster on the northeast side). The results show complex fault-zone internal structures that vary along fault strike, in agreement the surface geology (alternating playa and igneous rocks).


  • Field and Experimental Evidence on the Effect of Preshaking History on the Liquefaction Resistance of Silty Sand Deposits

    by W. El-Sekelly, T. Abdou, R. Dobry, J. H. Steidl

    The paper discusses the effect of seismic preshaking history on liquefaction of silty sand soils using case histories in California, as well as experimental data. The case histories are: (a) the response of the Wildlife site in the Imperial Valley to the 2010 El-Mayor Cucapah earthquake (Mw = 7.2, amax = 0.15g); and (b) the response of the Treasure Island Fire Station (F.S.) site in the San Francisco Bay area to the 1989 Loma Prieta earthquake (Mw = 6.9, amax = 0.16g). Both sites are similar in almost every respect except for their seismic history. The magnitude and intensity of the corresponding earthquakes were also very similar at both locations. While Treasure Island F.S. did liquefy during the shaking, Wildlife did not and was far from liquefaction as indicated by piezometers at the site. The experiments conducted in this research were a crude simulation of the seismic history of the sites. From the results of the experimental simulation as well as the field case histories, it is concluded that preshaking by previous earthquakes is the most probable explanation of the higher liquefaction resistance exhibited by the Wildlife site and other sites in the Imperial Valley of Southern California.


  • Two Case Histories Demonstrating the Effect of Past Earthquakes on Liquefaction Resistance of Silty Sand

    by W. El-Sekelly, R. Dobry, T. Abdoun, J. H. Steidl

    The paper compares two liquefaction case histories in California: (1) the response of the Wildlife site in the Imperial Valley to the 2010 El-Mayor Cucapah earthquake (Mw=7.2 , amax=0.15  g ); and (2) the response of the Treasure Island Fire Station (F.S.) site in the San Francisco Bay area to the 1989 Loma Prieta earthquake (Mw=6.9 , amax=0.16  g ). Both histories involve silty sand critical layers with nonplastic fines contents, FC=24–27% , similar normalized shear wave velocities, Vs1=145–155  m/s , low cone penetration test (CPT) cone penetration resistances, and groundwater tables at essentially the same depth. The corresponding data points plot almost on top of each other on the shear wave velocity field liquefaction charts, which predict liquefaction at both sites. While Treasure Island F.S. did liquefy during the shaking, Wildlife did not and was far from liquefaction as indicated by piezometers at the site. This paper constitutes an attempt to understand the reason for these very different pore pressure responses through a detailed analysis of similarities and differences between the two histories. It is concluded that preshaking by previous earthquakes is the most probable explanation of the higher liquefaction resistance exhibited by the Wildlife site and other sites in the Imperial Valley. While the Wildlife critical layer was subjected to about 60–70 earthquakes capable of generating significant excess pore pressures between its estimated 1907 deposition and the 2010 earthquake, the Treasure Island F.S. layer was subjected to only about two earthquakes capable of doing so between deposition in the 1930’s and the 1989 earthquake. This difference is due to the very high seismic activity in the last 100-plus years in the Imperial Valley compared with a seismically quiet San Francisco Bay Area after the 1906 earthquake. The significance of the prior seismic history is corroborated by recent results from centrifuge and large-scale experiments. These results as well as the methodology developed in the paper may be helpful when analyzing the observed high liquefaction resistance of sandy sites located in other seismic regions.


  • Open Access

    U.S. Geological Survey National Strong-Motion Project strategic plan, 2017–22

    by Brad T. Aagaard, Mehmet Celebi, Lind Gee, Robert Graves, Kishor Jaiswal, Erol Kalkan, Keith L. Knudsen, Nicolas Luco, James Smith, Jamison Steidl, et al.

    The mission of the National Strong-Motion Project is to provide measurements of how the ground and built environment behave during earthquake shaking to the earthquake engineering community, the scientific community, emergency managers, public agencies, industry, media, and other users for the following purposes: Improving engineering evaluations and design methods for facilities and systems;Providing timely information for earthquake early warning, damage assessment, and emergency response action; andContributing to a greater understanding of the mechanics of earthquake rupture, groundmotion characteristics, and earthquake effects.


  • Centrifuge Modeling of the Effect of Preshaking on the Liquefaction Resistance of Silty Sand Deposits

    by W. El-Sekelly, R. Dobry, T. Abdoun, J. H. Steidl

    Field observations suggest that preshaken natural sands in some seismic regions have high liquefaction resistance as a result of geologic aging and/or preshaking. This paper focuses on the young silty sand deposits located in the Imperial Valley of California. Recent deposition and intense seismic activity in the Valley suggest that preshaking is the main cause of their increased liquefaction resistance. The first part of the paper examines the liquefiable layer at the Wildlife site, which may have been deposited by flooding approximately between 1905–1907. The site was instrumented with accelerometers and piezometers in 2005, providing data over the last 10 years. The following conclusions are reached from this and from the catalog information on earthquakes before 2005: (1) Since 1907, the Wildlife layer has been subjected to approximately 60–70 earthquakes having amax≥0.1 g at the site, which caused pore pressure buildup in the layer; (2) most of these earthquakes generated excess pore pressur...