Hyunkyung Choi
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Hyunkyung Choi has a total of 35 co-authors. Here are the top co-authors by number of shared publications:
- Chul Sung Kim
Department of Physics, Kookmin University, Seoul, Republic of Korea
11 shared publications - Young Rang Uhm
HANARO Utilization Division, Korea Atomic Energy Research Institute, Daejeon, Republic of Korea
4 shared publications Jae Yeon Seo
Department of Physics, Kookmin University 1 , Seoul 02707, South Korea
3 shared publicationsYoung Rang Uhm
3 shared publicationsGwang Min Sun
HANARO Operation and Utilization, Korea Atomic Energy Research Institute 2 , Daejeon 34057, South Korea
2 shared publications- Jae Yeon Seo
Department of Physics, Kookmin University, Seoul 02707, South Korea
2 shared publications
Latest Publications
- 11 October 2025
- Published by Springer Nature in Research on Chemical Intermediates
- Vol. 52 (1) , 211-226
Enhanced oxygen reduction catalysis in electron beam derived 57Fe–N–C: impact of precursor coordination and iron speciation
- 11 October 2025
- Published by Springer Nature in Research on Chemical Intermediates
- Vol. 52 (1) , 211-226
Enhanced oxygen reduction catalysis in electron beam derived 57Fe–N–C: impact of precursor coordination and iron speciation
- Open Access
- 7 January 2025
- Published by Elsevier in Chemical Engineering Journal
- Vol. 505
Gas-solid reaction-based selective lithium leaching strategy for efficient LiFePO4 recycling
- 7 January 2025
- Published by Elsevier in Chemical Engineering Journal
- Vol. 505
Open AccessGas-solid reaction-based selective lithium leaching strategy for efficient LiFePO4 recycling
- Open Access
Structural, Magnetic, and Mössbauer Study on Nb and Heat Treatment of Fe-Si-B-P-Cu-Nb Ribbons
This study aims to enhance the amorphous formation ability and magnetic properties that are crucial for the production of high-quality nanocrystalline alloys. The structural, thermal, and magnetic characteristics of the alloy ribbons were analyzed through a systematic adjustment of Nb content, and, including Nb, significantly improved the amorphous formation ability and thermal stability of the alloy, which is vital for nanocrystalline production. By varying the Nb content within Fe85-xSi2B8P4Cu1Nbx (x = 0.0, 0.5, 1.0, and 1.5), we explored finer adjustments to achieve homogeneous amorphousness during the melt spinning process. Careful control over the Nb content facilitated the production of amorphous ribbons with consistent homogeneity, which was critical for the subsequent fabrication of nanocrystalline structures through heat treatment. As a result, the amorphous ribbon of Fe85.5Si2B8P4Cu1Nb0.5 showed a low coercivity of 7 A/m. The heat treatment showed a remarkably high saturation magnetic flux density of 1.94 T. Additionally, the grain size (D) decreased as the Nb content increased, with D values ranging from 25.09 nm to 24.29 nm, as calculated by the Scherrer formula. Mössbauer spectroscopy confirmed the formation of nanocrystalline and residual amorphous phases. The hyperfine magnetic field values (Beff) decreased from 25.7 T to 24.7 T in the amorphous samples and reached 33.0 T in the nanocrystalline phases. This study highlights Nb’s positive impact on thermal stability and amorphous formation capacity in Fe-Si-B-P-Cu alloys, culminating in the successful fabrication of nanocrystalline ribbons with superior structural and magnetic properties.
Open AccessStructural, Magnetic, and Mössbauer Study on Nb and Heat Treatment of Fe-Si-B-P-Cu-Nb Ribbons
This study aims to enhance the amorphous formation ability and magnetic properties that are crucial for the production of high-quality nanocrystalline alloys. The structural, thermal, and magnetic characteristics of the alloy ribbons were analyzed through a systematic adjustment of Nb content, and, including Nb, significantly improved the amorphous formation ability and thermal stability of the alloy, which is vital for nanocrystalline production. By varying the Nb content within Fe85-xSi2B8P4Cu1Nbx (x = 0.0, 0.5, 1.0, and 1.5), we explored finer adjustments to achieve homogeneous amorphousness during the melt spinning process. Careful control over the Nb content facilitated the production of amorphous ribbons with consistent homogeneity, which was critical for the subsequent fabrication of nanocrystalline structures through heat treatment. As a result, the amorphous ribbon of Fe85.5Si2B8P4Cu1Nb0.5 showed a low coercivity of 7 A/m. The heat treatment showed a remarkably high saturation magnetic flux density of 1.94 T. Additionally, the grain size (D) decreased as the Nb content increased, with D values ranging from 25.09 nm to 24.29 nm, as calculated by the Scherrer formula. Mössbauer spectroscopy confirmed the formation of nanocrystalline and residual amorphous phases. The hyperfine magnetic field values (Beff) decreased from 25.7 T to 24.7 T in the amorphous samples and reached 33.0 T in the nanocrystalline phases. This study highlights Nb’s positive impact on thermal stability and amorphous formation capacity in Fe-Si-B-P-Cu alloys, culminating in the successful fabrication of nanocrystalline ribbons with superior structural and magnetic properties.
- 12 May 2023
- Published by Springer Nature in Journal of Radioanalytical and Nuclear Chemistry
- Vol. 332 (12) , 5119-5126
Analysis of red pottery bodies from South Korea using Mössbauer spectroscopy
- 12 May 2023
- Published by Springer Nature in Journal of Radioanalytical and Nuclear Chemistry
- Vol. 332 (12) , 5119-5126
Analysis of red pottery bodies from South Korea using Mössbauer spectroscopy
- 29 November 2022
- Published by Springer Nature in Journal of the Korean Physical Society
- Vol. 81 (12) , 1257-1261
Magnetic property-based provenance investigation of Hokkaido (Japan) archaeological obsidian tools
- 29 November 2022
- Published by Springer Nature in Journal of the Korean Physical Society
- Vol. 81 (12) , 1257-1261
Magnetic property-based provenance investigation of Hokkaido (Japan) archaeological obsidian tools
- Open Access
- 21 October 2022
- Published by MDPI AG in Nanomaterials
- Vol. 12 (20) , 3704
Effects of Silica Shell Encapsulated Nanocrystals on Active χ-Fe5C2 Phase and Fischer–Tropsch Synthesis
Among various iron carbide phases, χ-Fe5C2, a highly active phase in Fischer–Tropsch synthesis, was directly synthesized using a wet-chemical route, which makes a pre-activation step unnecessary. In addition, χ-Fe5C2 nanoparticles were encapsulated with mesoporous silica for protection from deactivation. Further structural analysis showed that the protective silica shell had a partially ordered mesoporous structure with a short range. According to the XRD result, the sintering of χ-Fe5C2 crystals did not seem to be significant, which was believed to be the beneficial effect of the protective shell providing restrictive geometrical space for nanoparticles. More interestingly, the protective silica shell was also found to be effective in maintaining the phase of χ-Fe5C2 against re-oxidation and transformation to other iron carbide phases. Fischer–Tropsch activity of χ-Fe5C2 in this study was comparable to or higher than those from previous reports. In addition, CO2 selectivity was found to be very low after stabilization.
- 21 October 2022
- Published by MDPI AG in Nanomaterials
- Vol. 12 (20) , 3704
Open AccessEffects of Silica Shell Encapsulated Nanocrystals on Active χ-Fe5C2 Phase and Fischer–Tropsch Synthesis
Among various iron carbide phases, χ-Fe5C2, a highly active phase in Fischer–Tropsch synthesis, was directly synthesized using a wet-chemical route, which makes a pre-activation step unnecessary. In addition, χ-Fe5C2 nanoparticles were encapsulated with mesoporous silica for protection from deactivation. Further structural analysis showed that the protective silica shell had a partially ordered mesoporous structure with a short range. According to the XRD result, the sintering of χ-Fe5C2 crystals did not seem to be significant, which was believed to be the beneficial effect of the protective shell providing restrictive geometrical space for nanoparticles. More interestingly, the protective silica shell was also found to be effective in maintaining the phase of χ-Fe5C2 against re-oxidation and transformation to other iron carbide phases. Fischer–Tropsch activity of χ-Fe5C2 in this study was comparable to or higher than those from previous reports. In addition, CO2 selectivity was found to be very low after stabilization.
- 12 May 2022
- Published by Springer Nature in Journal of the Korean Physical Society
- Vol. 80 (12) , 1153-1158
Synthesis and Mössbauer studies of tavorite-structured LiFePO4F
- 12 May 2022
- Published by Springer Nature in Journal of the Korean Physical Society
- Vol. 80 (12) , 1153-1158
Synthesis and Mössbauer studies of tavorite-structured LiFePO4F
- 12 May 2022
- Published by Springer Nature in Journal of the Korean Physical Society
- Vol. 80 (12) , 1148-1152
Mössbauer studies and inductive thermal properties of Mgx-doped maghemite nanoparticles
- 12 May 2022
- Published by Springer Nature in Journal of the Korean Physical Society
- Vol. 80 (12) , 1148-1152
Mössbauer studies and inductive thermal properties of Mgx-doped maghemite nanoparticles
- 21 June 2021
- Published by Springer Nature in Journal of Radioanalytical and Nuclear Chemistry
- Vol. 330 (2) , 445-454
Mn–Zn ferrite nanoparticles for application in magnetic hyperthermia
- 21 June 2021
- Published by Springer Nature in Journal of Radioanalytical and Nuclear Chemistry
- Vol. 330 (2) , 445-454
Mn–Zn ferrite nanoparticles for application in magnetic hyperthermia
- Open Access
- 1 January 2021
- Published by AIP Publishing in AIP Advances
- Vol. 11 (1) , 015131
Crystalline structure and magnetic properties of pyrite FeS2
Iron pyrite (FeS2) has attracted significant attention as a promising inorganic material in various applications, such as electrode materials for high-energy batteries, medical diagnostics, semiconductor materials, and photovoltaic solar cells. In this study, we characterized the crystalline structure and magnetic properties of FeS2 using X-ray diffraction (XRD), vibrating sample magnetometry, and Mössbauer spectroscopy. The refined XRD patterns confirmed that the crystalline structure of FeS2 was cubic (Pa-3 space group) with lattice constant a0 = 5.417 Å. The temperature dependence of the zero-field-cooled and field-cooled curves and the hysteresis loops were measured at various temperatures between 4.2 and 295 K. The Mössbauer spectra collected in the temperature range of 4.2–500 K were fitted with one doublet. The ΔEQ values increased slightly with decreasing temperature owing to changes in the Fe–S distance. The charge state was determined to be Fe2+ based on the isomer shift (δ).
- 1 January 2021
- Published by AIP Publishing in AIP Advances
- Vol. 11 (1) , 015131
Open AccessCrystalline structure and magnetic properties of pyrite FeS2
Iron pyrite (FeS2) has attracted significant attention as a promising inorganic material in various applications, such as electrode materials for high-energy batteries, medical diagnostics, semiconductor materials, and photovoltaic solar cells. In this study, we characterized the crystalline structure and magnetic properties of FeS2 using X-ray diffraction (XRD), vibrating sample magnetometry, and Mössbauer spectroscopy. The refined XRD patterns confirmed that the crystalline structure of FeS2 was cubic (Pa-3 space group) with lattice constant a0 = 5.417 Å. The temperature dependence of the zero-field-cooled and field-cooled curves and the hysteresis loops were measured at various temperatures between 4.2 and 295 K. The Mössbauer spectra collected in the temperature range of 4.2–500 K were fitted with one doublet. The ΔEQ values increased slightly with decreasing temperature owing to changes in the Fe–S distance. The charge state was determined to be Fe2+ based on the isomer shift (δ).