Jan Prokupek
Research Subjects
Research Interests
Jan Prokupek has a total of 258 co-authors. Here are the top co-authors by number of shared publications:
- Andriy Velyhan
ELI Beamlines, FZU—Institute of Physics of the Czech Academy of Sciences, Za Radnicí 835, 25241 Dolní Břežany, Czech Republic
15 shared publications - Lorenzo Torrisi
MIFT Department University of Messina Messina Italy
10 shared publications B. Rus
IoP/PALS Center
8 shared publicationsD. Margarone
Institute of Physics of the AS CR, v. v. i., ELI-Beamlines Project, Na Slovance 2, 182 21 Prague 8, Czech Republic
8 shared publicationsG. Korn
Institute of Physics ASCR, FZU, ELI-Beamlines project, Prague 182 00, Czech Republic
8 shared publicationsJ. Ullschmied
Institute of Plasma Physics, CAS, Za Slovankou 1782/3, 182 00 Prague 8, Czech Republic
8 shared publications
Latest Publications
- 1 September 2019
- Published by Elsevier in Fusion Engineering and Design
- Vol. 146, 770-772
Monitoring and determination of Beryllium contamination at HELCZA
- 1 September 2019
- Published by Elsevier in Fusion Engineering and Design
- Vol. 146, 770-772
Monitoring and determination of Beryllium contamination at HELCZA
- 1 November 2017
- Published by Elsevier in Fusion Engineering and Design
- Vol. 124, 187-190
HELCZA—High heat flux test facility for testing ITER EU first wall components
- 1 November 2017
- Published by Elsevier in Fusion Engineering and Design
- Vol. 124, 187-190
HELCZA—High heat flux test facility for testing ITER EU first wall components
- 1 November 2017
- Published by Elsevier in Fusion Engineering and Design
- Vol. 124, 344-347
Commissioning phase of high heat flux test facility HELCZA
- 1 November 2017
- Published by Elsevier in Fusion Engineering and Design
- Vol. 124, 344-347
Commissioning phase of high heat flux test facility HELCZA
- 1 June 2017
- Published by IOP Publishing in Journal of Instrumentation
- Vol. 12 (06) , C06024
Efficient production and diagnostics of MeV proton beams from a cryogenic hydrogen ribbon
A solid hydrogen thin ribbon, produced by the cryogenic system ELISE (Experiments on Laser Interaction with Solid hydrogEn) target delivery system, was experimentally used at the PALS kJ-laser facility to generate intense proton beams with energies in the MeV range. This sophisticated target system operating at cryogenic temperature (~ 10 K) continuously producing a 62 μm thick target was combined with a 600 J sub-nanosecond laser pulse to generate a collimated proton stream. The accelerated proton beams were fully characterized by a number of diagnostics. High conversion efficiency of laser to energetic protons is of great interest for future potential applications in non-conventional proton therapy and fast ignition for inertial confinement fusion.
- 1 June 2017
- Published by IOP Publishing in Journal of Instrumentation
- Vol. 12 (06) , C06024
Efficient production and diagnostics of MeV proton beams from a cryogenic hydrogen ribbon
A solid hydrogen thin ribbon, produced by the cryogenic system ELISE (Experiments on Laser Interaction with Solid hydrogEn) target delivery system, was experimentally used at the PALS kJ-laser facility to generate intense proton beams with energies in the MeV range. This sophisticated target system operating at cryogenic temperature (~ 10 K) continuously producing a 62 μm thick target was combined with a 600 J sub-nanosecond laser pulse to generate a collimated proton stream. The accelerated proton beams were fully characterized by a number of diagnostics. High conversion efficiency of laser to energetic protons is of great interest for future potential applications in non-conventional proton therapy and fast ignition for inertial confinement fusion.
- Open Access
- 8 November 2016
- Published by American Physical Society (APS) in Physical Review X
- Vol. 6 (4) , 041030
Proton Acceleration Driven by a Nanosecond Laser from a Cryogenic Thin Solid-Hydrogen Ribbon
A high-power pulsed laser is focused onto a solid-hydrogen target to accelerate forward a collimated stream of protons in the range 0.1–1 MeV, carrying a very high energy of about 30 J ( laser-ion conversion efficiency) and extremely large charge of about per laser pulse. This result is achieved for the first time through the combination of a sophisticated target system ( thin ribbon) operating at cryogenic temperature () and a very hot H plasma ( “hot electron” temperature) generated by a subnanosecond laser with an intensity of . Both the H plasma and the accelerated proton beam are fully characterized by in situ and ex situ diagnostics. Results obtained using the ELISE (experiments on laser interaction with solid hydrogen) target delivery system at PALS (Prague) kJ-class laser facility are presented and discussed along with potential multidisciplinary applications.- 8 November 2016
- Published by American Physical Society (APS) in Physical Review X
- Vol. 6 (4) , 041030
Open AccessProton Acceleration Driven by a Nanosecond Laser from a Cryogenic Thin Solid-Hydrogen Ribbon
A high-power pulsed laser is focused onto a solid-hydrogen target to accelerate forward a collimated stream of protons in the range 0.1–1 MeV, carrying a very high energy of about 30 J ( laser-ion conversion efficiency) and extremely large charge of about per laser pulse. This result is achieved for the first time through the combination of a sophisticated target system ( thin ribbon) operating at cryogenic temperature () and a very hot H plasma ( “hot electron” temperature) generated by a subnanosecond laser with an intensity of . Both the H plasma and the accelerated proton beam are fully characterized by in situ and ex situ diagnostics. Results obtained using the ELISE (experiments on laser interaction with solid hydrogen) target delivery system at PALS (Prague) kJ-class laser facility are presented and discussed along with potential multidisciplinary applications. - Open Access
- 31 August 2014
- Published by Czech Technical University in Prague - Central Library in Acta Polytechnica
- Vol. 54 (4) , 285-289
ELIMED: MEDICAL APPLICATION AT ELI-BEAMLINES. STATUS OF THE COLLABORATION AND FIRST RESULTS
ELI-Beamlines is one of the four pillars of the ELI (Extreme Light Infrastructure) pan-European project. It will be an ultrahigh-intensity, high repetition-rate, femtosecond laser facility whose main goal is to generate and apply high-brightness X-ray sources and accelerated charged particles. In particular, medical applications are treated by the ELIMED task force, which has been launched by collaboration between ELI and INFN researchers. ELIMED aims to demonstrate the clinical applicability of laser accelerated ions. In this article, the state of the ELIMED project and the first scientific results are reported. The design and realisation of a preliminary beam handling system and of an advanced spectrometer for diagnostics of high energy (multi-MeV) laser-accelerated ion beams will also be briefly presented.
- 31 August 2014
- Published by Czech Technical University in Prague - Central Library in Acta Polytechnica
- Vol. 54 (4) , 285-289
Open AccessELIMED: MEDICAL APPLICATION AT ELI-BEAMLINES. STATUS OF THE COLLABORATION AND FIRST RESULTS
ELI-Beamlines is one of the four pillars of the ELI (Extreme Light Infrastructure) pan-European project. It will be an ultrahigh-intensity, high repetition-rate, femtosecond laser facility whose main goal is to generate and apply high-brightness X-ray sources and accelerated charged particles. In particular, medical applications are treated by the ELIMED task force, which has been launched by collaboration between ELI and INFN researchers. ELIMED aims to demonstrate the clinical applicability of laser accelerated ions. In this article, the state of the ELIMED project and the first scientific results are reported. The design and realisation of a preliminary beam handling system and of an advanced spectrometer for diagnostics of high energy (multi-MeV) laser-accelerated ion beams will also be briefly presented.
- Open Access
- 19 August 2014
- Published by American Physical Society (APS) in Physical Review X
- Vol. 4 (3) , 031030
Boron-Proton Nuclear-Fusion Enhancement Induced in Boron-Doped Silicon Targets by Low-Contrast Pulsed Laser
We show that a spatially well-defined layer of boron dopants in a hydrogen-enriched silicon target allows the production of a high yield of alpha particles of around per steradian using a nanosecond, low-contrast laser pulse with a nominal intensity of approximately . This result can be ascribed to the nature of the long laser-pulse interaction with the target and with the expanding plasma, as well as to the optimal target geometry and composition. The possibility of an impact on future applications such as nuclear fusion without production of neutron-induced radioactivity and compact ion accelerators is anticipated.- 19 August 2014
- Published by American Physical Society (APS) in Physical Review X
- Vol. 4 (3) , 031030
Open AccessBoron-Proton Nuclear-Fusion Enhancement Induced in Boron-Doped Silicon Targets by Low-Contrast Pulsed Laser
We show that a spatially well-defined layer of boron dopants in a hydrogen-enriched silicon target allows the production of a high yield of alpha particles of around per steradian using a nanosecond, low-contrast laser pulse with a nominal intensity of approximately . This result can be ascribed to the nature of the long laser-pulse interaction with the target and with the expanding plasma, as well as to the optimal target geometry and composition. The possibility of an impact on future applications such as nuclear fusion without production of neutron-induced radioactivity and compact ion accelerators is anticipated. - 1 August 2014
- Published by IOP Publishing in Journal of Instrumentation
- Vol. 9 (08) , T08001
A new Thomson Spectrometer for high energy laser-driven beams diagnostic
Thomson Spectrometers (TPs) are widely used for beam diagnostic as they provide simultaneous information on charge over mass ratio, energy and momentum of detected ions. A new TP design has been realized at INFN-LNS within the LILIA (Laser Induced Light Ion Acceleration) and ELIMED (MEDical application at ELI-Beamlines) projects. This paper reports on the construction details of the TP and on its experimental tests performed at PALS laboratory in Prague, with the ASTERIX IV laser system. Reported data are obtained with polyethylene and polyvinyl alcohol solid targets, they have been compared with data obtained from other detectors. Consistency among results confirms the correct functioning of the new TP. The main features, characterizing the design, are a wide acceptance of the deflection sector and a tunability of the, partially overlapping, magnetic and electric fields that allow to resolve ions with energy up to about 40 MeV for protons.
- 1 August 2014
- Published by IOP Publishing in Journal of Instrumentation
- Vol. 9 (08) , T08001
A new Thomson Spectrometer for high energy laser-driven beams diagnostic
Thomson Spectrometers (TPs) are widely used for beam diagnostic as they provide simultaneous information on charge over mass ratio, energy and momentum of detected ions. A new TP design has been realized at INFN-LNS within the LILIA (Laser Induced Light Ion Acceleration) and ELIMED (MEDical application at ELI-Beamlines) projects. This paper reports on the construction details of the TP and on its experimental tests performed at PALS laboratory in Prague, with the ASTERIX IV laser system. Reported data are obtained with polyethylene and polyvinyl alcohol solid targets, they have been compared with data obtained from other detectors. Consistency among results confirms the correct functioning of the new TP. The main features, characterizing the design, are a wide acceptance of the deflection sector and a tunability of the, partially overlapping, magnetic and electric fields that allow to resolve ions with energy up to about 40 MeV for protons.
- 1 January 2014
- Published by AIP Publishing in Review of Scientific Instruments
- Vol. 85 (1) , 013302
Development and first experimental tests of Faraday cup array
A new type of Faraday cup, capable of detecting high energy charged particles produced in a high intensity laser-matter interaction environment, has recently been developed and demonstrated as a real-time detector based on the time-of-flight technique. An array of these Faraday cups was designed and constructed to cover different observation angles with respect to the target normal direction. Thus, it allows reconstruction of the spatial distribution of ion current density in the subcritical plasma region and the ability to visualise its time evolution through time-of-flight measurements, which cannot be achieved with standard laser optical interferometry. This is a unique method for two-dimensional visualisation of ion currents from laser-generated plasmas. A technical description of the new type of Faraday cup is introduced along with an ad hoc data analysis procedure. Experimental results obtained during campaigns at the Petawatt High-Energy Laser for Heavy Ion Experiments (GSI, Darmstadt) and at the Prague Asterix Laser System (AS CR) are presented. Advantages and limitations of the used diagnostic system are discussed.
- 1 January 2014
- Published by AIP Publishing in Review of Scientific Instruments
- Vol. 85 (1) , 013302
Development and first experimental tests of Faraday cup array
A new type of Faraday cup, capable of detecting high energy charged particles produced in a high intensity laser-matter interaction environment, has recently been developed and demonstrated as a real-time detector based on the time-of-flight technique. An array of these Faraday cups was designed and constructed to cover different observation angles with respect to the target normal direction. Thus, it allows reconstruction of the spatial distribution of ion current density in the subcritical plasma region and the ability to visualise its time evolution through time-of-flight measurements, which cannot be achieved with standard laser optical interferometry. This is a unique method for two-dimensional visualisation of ion currents from laser-generated plasmas. A technical description of the new type of Faraday cup is introduced along with an ad hoc data analysis procedure. Experimental results obtained during campaigns at the Petawatt High-Energy Laser for Heavy Ion Experiments (GSI, Darmstadt) and at the Prague Asterix Laser System (AS CR) are presented. Advantages and limitations of the used diagnostic system are discussed.
- 1 January 2014
- Published by Springer Nature
- p. 239-242
Critical Components for XUV Probing of Laser Driven Shocks
- 1 January 2014
- Published by Springer Nature
- p. 239-242
Critical Components for XUV Probing of Laser Driven Shocks