G. S. Kamali Kannangara
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
G. S. Kamali Kannangara has a total of 83 co-authors. Here are the top co-authors by number of shared publications:
Michael A. Wilson
11 shared publicationsAdriyan Milev
5 shared publications- Adriyan S. Milev
University of Western Sydney
5 shared publications - Herbert Volk
CSIRO Wealth from Oceans Flagship
4 shared publications Michael Wilson
CSIRO, Petroleum, North Ryde NSW 2113, Australia
4 shared publicationsNguyen H. Tran
4 shared publications
Latest Publications
- 1 August 2016
- Published by Elsevier in Electrochimica Acta
- Vol. 209, 565-573
Li-ion kinetics in LiFePO 4 /carbon nanocomposite prepared by a two-step process: The role of phase composition
- 1 August 2016
- Published by Elsevier in Electrochimica Acta
- Vol. 209, 565-573
Li-ion kinetics in LiFePO 4 /carbon nanocomposite prepared by a two-step process: The role of phase composition
- 1 April 2014
- Published by Elsevier in Chemical Engineering Science
- Vol. 107, 302-310
Developing saponite supported cobalt–molybdenum catalysts for upgrading squalene, a hydrocarbon from the microalgae Botryococcus braunii
- 1 April 2014
- Published by Elsevier in Chemical Engineering Science
- Vol. 107, 302-310
Developing saponite supported cobalt–molybdenum catalysts for upgrading squalene, a hydrocarbon from the microalgae Botryococcus braunii
- 9 August 2013
- Published by Royal Society of Chemistry (RSC) in Physical Chemistry Chemical Physics
- Vol. 15 (38) , 16294-16302
Defect induced electronic states and magnetism in ball-milled graphite
The electronic structure and magnetism of nanocrystalline graphite prepared by ball milling of graphite in an inert atmosphere have been investigated using valence band spectroscopy (VB), core level near-edge X-ray absorption fine structure (NEXAFS) spectroscopy and magnetic measurements as a function of the milling time. The NEXAFS spectroscopy of graphite milled for 30 hours shows simultaneous evolution of new states at ∼284.0 eV and at ∼290.5 eV superimposed upon the characteristic transitions at 285.4 eV and 291.6 eV, respectively. The modulation of the density of states is explained by evolution of discontinuities within the sheets and along the fracture lines in the milled graphite. The magnetic measurements in the temperature interval 2–300–2 K at constant magnetic field strength show a correlation between magnetic properties and evolution of the new electronic states. With the reduction of the crystallite sizes of the graphite fragments, the milled material progressively changes its magnetic properties from diamagnetic to paramagnetic with contributions from both Pauli and Curie paramagnetism due to the evolution of new states at ∼284 and ∼290.5 eV, respectively. These results indicate that the magnetic behaviour of ball-milled graphite can be manipulated by changing the milling conditions.
- 9 August 2013
- Published by Royal Society of Chemistry (RSC) in Physical Chemistry Chemical Physics
- Vol. 15 (38) , 16294-16302
Defect induced electronic states and magnetism in ball-milled graphite
The electronic structure and magnetism of nanocrystalline graphite prepared by ball milling of graphite in an inert atmosphere have been investigated using valence band spectroscopy (VB), core level near-edge X-ray absorption fine structure (NEXAFS) spectroscopy and magnetic measurements as a function of the milling time. The NEXAFS spectroscopy of graphite milled for 30 hours shows simultaneous evolution of new states at ∼284.0 eV and at ∼290.5 eV superimposed upon the characteristic transitions at 285.4 eV and 291.6 eV, respectively. The modulation of the density of states is explained by evolution of discontinuities within the sheets and along the fracture lines in the milled graphite. The magnetic measurements in the temperature interval 2–300–2 K at constant magnetic field strength show a correlation between magnetic properties and evolution of the new electronic states. With the reduction of the crystallite sizes of the graphite fragments, the milled material progressively changes its magnetic properties from diamagnetic to paramagnetic with contributions from both Pauli and Curie paramagnetism due to the evolution of new states at ∼284 and ∼290.5 eV, respectively. These results indicate that the magnetic behaviour of ball-milled graphite can be manipulated by changing the milling conditions.
- 18 September 2012
- Published by Springer Nature in Reaction Kinetics, Mechanisms and Catalysis
- Vol. 108 (1) , 127-138
Development of Raney cobalt catalysts for the hydrogenation of squalene type compounds
- 18 September 2012
- Published by Springer Nature in Reaction Kinetics, Mechanisms and Catalysis
- Vol. 108 (1) , 127-138
Development of Raney cobalt catalysts for the hydrogenation of squalene type compounds
- Open Access
- 1 June 2012
- Published by Elsevier in Soil Biology and Biochemistry
- Vol. 49, 4-10
Rapid incorporation of carbon from ectomycorrhizal mycelial necromass into soil fungal communities
- 1 June 2012
- Published by Elsevier in Soil Biology and Biochemistry
- Vol. 49, 4-10
Open AccessRapid incorporation of carbon from ectomycorrhizal mycelial necromass into soil fungal communities
- 30 May 2012
- Published by American Chemical Society (ACS) in Energy & Fuels
- Vol. 26 (6) , 3874-3881
Pyrolysis of a Naturally Dried Botryococcus braunii Residue
- 30 May 2012
- Published by American Chemical Society (ACS) in Energy & Fuels
- Vol. 26 (6) , 3874-3881
Pyrolysis of a Naturally Dried Botryococcus braunii Residue
- 20 December 2011
- Published by American Chemical Society (ACS) in The Journal of Physical Chemistry A
- Vol. 116 (1) , 150-157
Isothermal Evaporation of Ethanol in a Dynamic Gas Atmosphere
Optimization of evaporation and pyrolysis conditions for ethanol are important in carbon nanotube (CNT) synthesis. The activation enthalpy (ΔH⧧), the activation entropy (ΔS⧧), and the free energy barrier (ΔG⧧) to evaporation have been determined by measuring the molar coefficient of evaporation, kevap, at nine different temperatures (30–70 °C) and four gas flow rates (25–200 mL/min) using nitrogen and argon as carrier gases. At 70 °C in argon, the effect of the gas flow rate on kevap and ΔG⧧ is small. However, this is not true at temperatures as low as 30 °C, where the increase of the gas flow rate from 25 to 200 mL/min results in a nearly 6 times increase of kevap and decrease of ΔG⧧ by ∼5 kJ/mol. Therefore, at 30 °C, the effect of the gas flow rate on the ethanol evaporation rate is attributed to interactions of ethanol with argon molecules. This is supported by simultaneous infrared spectroscopic analysis of the evolved vapors, which demonstrates the presence of different amounts of linear and cyclic hydrogen bonded ethanol aggregates. While the amount of these aggregates at 30 °C depends upon the gas flow rate, no such dependence was observed during evaporation at 70 °C. When the evaporation was carried out in nitrogen, ΔG⧧ was almost independent of the evaporation temperature (30–70 °C) and the gas flow rate (25–200 mL/min). Thus the evaporation of ethanol in a dynamic gas atmosphere at different temperatures may go via different mechanisms depending on the nature of the carrier gas.
- 20 December 2011
- Published by American Chemical Society (ACS) in The Journal of Physical Chemistry A
- Vol. 116 (1) , 150-157
Isothermal Evaporation of Ethanol in a Dynamic Gas Atmosphere
Optimization of evaporation and pyrolysis conditions for ethanol are important in carbon nanotube (CNT) synthesis. The activation enthalpy (ΔH⧧), the activation entropy (ΔS⧧), and the free energy barrier (ΔG⧧) to evaporation have been determined by measuring the molar coefficient of evaporation, kevap, at nine different temperatures (30–70 °C) and four gas flow rates (25–200 mL/min) using nitrogen and argon as carrier gases. At 70 °C in argon, the effect of the gas flow rate on kevap and ΔG⧧ is small. However, this is not true at temperatures as low as 30 °C, where the increase of the gas flow rate from 25 to 200 mL/min results in a nearly 6 times increase of kevap and decrease of ΔG⧧ by ∼5 kJ/mol. Therefore, at 30 °C, the effect of the gas flow rate on the ethanol evaporation rate is attributed to interactions of ethanol with argon molecules. This is supported by simultaneous infrared spectroscopic analysis of the evolved vapors, which demonstrates the presence of different amounts of linear and cyclic hydrogen bonded ethanol aggregates. While the amount of these aggregates at 30 °C depends upon the gas flow rate, no such dependence was observed during evaporation at 70 °C. When the evaporation was carried out in nitrogen, ΔG⧧ was almost independent of the evaporation temperature (30–70 °C) and the gas flow rate (25–200 mL/min). Thus the evaporation of ethanol in a dynamic gas atmosphere at different temperatures may go via different mechanisms depending on the nature of the carrier gas.
- 1 January 2011
- Published by Elsevier
- p. 621-653
Toxicity and regulatory perspectives of carbon nanotubes
- 1 January 2011
- Published by Elsevier
- p. 621-653
Toxicity and regulatory perspectives of carbon nanotubes
- 23 April 2010
- Published by Royal Society of Chemistry (RSC) in Physical Chemistry Chemical Physics
- Vol. 12 (25) , 6685-6691
Unoccupied electronic structure of ball-milled graphite
Changes in electronic and vibrational structure of well characterised macrocrystalline graphite milled by a planetary ball-mill are investigated by Raman spectroscopy and Near Edge X-ray Absorption Fine structure (NEXAFS) measurements at the C K-edge. The electronic structure changes at the surface and in the sub-surface of the particles are examined by comparing two-different NEXAFS detection modes: total fluorescence yield (TFY) and partial electron yield (PEY) respectively. When the in-plane crystallite sizes of graphite are decreased to nanosized (from ∼160 nm to ∼9 nm), a new spectral structure appears in TFY at 284.1 eV which is not present in the macrocrystalline graphite. This feature is assigned to electronic states associated with zigzag edges. Further the TFY shows a shift of the main graphite π* band from 285.5 to 285.9 eV, attributed to breaking the conjugation and hence the electron localization effect during milling, The TFY spectra also show strong spectral features at 287.5 and 288.6 eV, which suggest that the local environment of carbon atoms changes from sp2 to more sp3 due to physical damage of the graphite sheets and formation of structures other than aromatic hexagons. Complementary Raman spectroscopic measurements demonstrate an up-shift of the graphite G band from 1575 to 1583 cm−1en route to nanosize. The changes in TFY NEXAFS and Raman spectra are attributed to modification of the sub-surface electronic structure due to the presence of defects in the graphite crystal produced during milling. The discovery of the strong spectral feature at 284.1 eV in nanographite and the 0.4 eV up-shift of the π* band may open up possibilities to influence the electronic transport properties of graphite by manipulation of defects during the preparation of the nanographite.
- 23 April 2010
- Published by Royal Society of Chemistry (RSC) in Physical Chemistry Chemical Physics
- Vol. 12 (25) , 6685-6691
Unoccupied electronic structure of ball-milled graphite
Changes in electronic and vibrational structure of well characterised macrocrystalline graphite milled by a planetary ball-mill are investigated by Raman spectroscopy and Near Edge X-ray Absorption Fine structure (NEXAFS) measurements at the C K-edge. The electronic structure changes at the surface and in the sub-surface of the particles are examined by comparing two-different NEXAFS detection modes: total fluorescence yield (TFY) and partial electron yield (PEY) respectively. When the in-plane crystallite sizes of graphite are decreased to nanosized (from ∼160 nm to ∼9 nm), a new spectral structure appears in TFY at 284.1 eV which is not present in the macrocrystalline graphite. This feature is assigned to electronic states associated with zigzag edges. Further the TFY shows a shift of the main graphite π* band from 285.5 to 285.9 eV, attributed to breaking the conjugation and hence the electron localization effect during milling, The TFY spectra also show strong spectral features at 287.5 and 288.6 eV, which suggest that the local environment of carbon atoms changes from sp2 to more sp3 due to physical damage of the graphite sheets and formation of structures other than aromatic hexagons. Complementary Raman spectroscopic measurements demonstrate an up-shift of the graphite G band from 1575 to 1583 cm−1en route to nanosize. The changes in TFY NEXAFS and Raman spectra are attributed to modification of the sub-surface electronic structure due to the presence of defects in the graphite crystal produced during milling. The discovery of the strong spectral feature at 284.1 eV in nanographite and the 0.4 eV up-shift of the π* band may open up possibilities to influence the electronic transport properties of graphite by manipulation of defects during the preparation of the nanographite.
- 30 March 2010
- Published by Wiley in Journal of Applied Polymer Science
- Vol. 117 (1) , 24-32
The effect of carbon nanotube hydrophobicity on the mechanical properties of carbon nanotube‐reinforced thermoplastic polyurethane nanocomposites
- 30 March 2010
- Published by Wiley in Journal of Applied Polymer Science
- Vol. 117 (1) , 24-32
The effect of carbon nanotube hydrophobicity on the mechanical properties of carbon nanotube‐reinforced thermoplastic polyurethane nanocomposites