Alexander Popov

Human mesenchymal stem cells (MSCs) show promise for musculoskeletal repair applications. Animal-derived serum is extensively used for MSC culture as a source of nutrients, extracellular matrix proteins and growth factors. However, the routine use of fetal calf serum (FCS) is not innocuous due to its animal antigens and ill-defined composition, driving the development of alternatives protocols. The present study sought to reduce exposure to FCS via the transient use of human serum. Transient exposure to animal serum had previously proved successful for the osteogenic differentiation of MSCs but had not yet been tested with alternative serum sources. Here, human serum was used to support the proliferation of MSCs, which retained surface marker expression and presented higher alkaline phosphatase activity than those in FCS-based medium. Addition of osteogenic supplements supported strong mineralisation over a 3-week treatment. When limiting serum exposure to the first five days of treatment, MSCs achieved higher differentiation with human serum than with FCS. Finally, human serum analysis revealed significantly higher levels of osteogenic components such as alkaline phosphatase and 25-Hydroxyvitamin D, consistent with the enhanced osteogenic effect. These results indicate that human serum used at the start of the culture offers an efficient replacement for continuous FCS treatment and could enable short-term exposure to patient-derived serum in the future.

This review focuses on developments in the field of bioprinting for musculoskeletal tissue engineering, along with discussion on the various approaches for bone, cartilage and connective tissue fabrication. All approaches (cell-laden, cell-free and a combination of both) aim to obtain complex, living tissues able to develop and mature, using the same fundamental technology. To date, co-printing of cell-laden and cell-free materials has been revealed to be the most promising approach for musculoskeletal applications because materials with good bioactivity and good mechanical strength can be combined within the same constructs. Bioprinting for musculoskeletal applications is a developing field, and detailed discussion on the current challenges and future perspectives is also presented in this review.

Human mesenchymal stem cells (MSCs), which can generate both osteoblasts and chondrocytes, represent an ideal resource for orthopaedic repair using tissue-engineering approaches. One major difficulty for the development of osteochondral constructs using undifferentiated MSCs is that serum is typically used in culture protocols to promote differentiation of the osteogenic component, whereas existing chondrogenic differentiation protocols rely on the use of serum-free conditions. In order to define conditions which could be compatible with both chondrogenic and osteogenic differentiation in a single bioreactor, we have analysed the efficiency of new biphasic differentiation regimes based on transient serum exposure followed by serum-free treatment. MSC differentiation was assessed either in serum-free medium or with a range of transient exposure to serum, and compared to continuous serum-containing treatment. Although osteogenic differentation was not supported in the complete absence of serum, marker expression and extensive mineralization analyses established that 5 days of transient exposure triggered a level of differentiation comparable to that observed when serum was present throughout. This initial phase of serum exposure was further shown to support the successful chondrogenic differentiation of MSCs, comparable to controls maintained in serum-free conditions throughout. This study indicates that a culture based on temporal serum exposure followed by serum-free treatment is compatible with both osteogenic and chondrogenic differentiation of MSCs. These results will allow the development of novel strategies for osteochondral tissue engineering approaches using MSCs for regenerative medicine. Copyright © 2012 John Wiley & Sons, Ltd.