Jil Sutaria
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Jil Sutaria has a total of 17 co-authors. Here are the top co-authors by number of shared publications:
Sarah Rönnberg
3 shared publicationsÁngela Espín-Delgado
3 shared publications- Sarah Karolina Ronnberg
Department of Engineering Sciences and Mathematics, Electric Power Engineering, Lule University of Technology, Skellefte, Sweden
2 shared publications - Angela Espin Delgado
Department of Engineering Sciences and Mathematics, Luleå University of Technology, 97187 Skellefteå, Sweden
1 shared publication - Angela Espin-Delgado
Department of Electrical and Electronic Engineering, Universidad de los Andes, Bogotá D.C., Colombia
1 shared publication Chirag Chauhan
R&D Department, Suvik Electronics Pvt. Ltd., Gandhinagar, India
1 shared publication
Latest Publications
- Open Access
- 26 July 2023
- Published by Elsevier in Electric Power Systems Research
- Vol. 224
Factors influencing the induced primary emission and induced secondary emission in the frequency range of 2 to 150 kHz
- 26 July 2023
- Published by Elsevier in Electric Power Systems Research
- Vol. 224
Open AccessFactors influencing the induced primary emission and induced secondary emission in the frequency range of 2 to 150 kHz
- Open Access
Power Quality Issues of Electro-Mobility on Distribution Network—An Overview
The journey towards sustainable transportation has significantly increased the grid penetration of electric vehicles (EV) around the world. The connection of EVs to the power grid poses a series of new challenges for network operators, such as network loading, voltage profile perturbation, voltage unbalance, and other power quality issues. This paper presents a coalescence of knowledge on the impact that electro-mobility can impose on the grid, and identifies gaps for further research. Further, the study investigates the impact of electric vehicle charging on the medium-voltage network and low-voltage distribution network, keeping in mind the role of network operators, utilities, and customers. From this, the impacts, challenges, and recommendations are summarized. This paper will be a valuable resource to research entities, industry professionals, and network operators, as a ready reference of all possible power quality challenges posed by electro-mobility on the distribution network.
Open AccessPower Quality Issues of Electro-Mobility on Distribution Network—An Overview
The journey towards sustainable transportation has significantly increased the grid penetration of electric vehicles (EV) around the world. The connection of EVs to the power grid poses a series of new challenges for network operators, such as network loading, voltage profile perturbation, voltage unbalance, and other power quality issues. This paper presents a coalescence of knowledge on the impact that electro-mobility can impose on the grid, and identifies gaps for further research. Further, the study investigates the impact of electric vehicle charging on the medium-voltage network and low-voltage distribution network, keeping in mind the role of network operators, utilities, and customers. From this, the impacts, challenges, and recommendations are summarized. This paper will be a valuable resource to research entities, industry professionals, and network operators, as a ready reference of all possible power quality challenges posed by electro-mobility on the distribution network.
- Open Access
- 10 April 2023
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Access
- Vol. 11, 36823-36833
Propagation of Supraharmonics in a Data Center With Different Operating Modes of UPS
A data center is a major hub of different converters ensuring continuous power to the server loads. The pulse width modulation switching techniques with frequency emission from 2 to 150 kHz (i.e., supraharmonics) in these converters call for a study of the magnitude and propagation of this emission within data centers where UPS is one of the main contributors of supraharmonics. The paper shows, with measurements and model, the change in magnitude and propagation of supraharmonics with the change in the operating mode of the UPS. The magnitude of supraharmonics shows a non-linear dependency on the power consumed in the online mode. In bypass mode, the magnitude of supraharmonics shows a dependency on the type of load connected. The filter connected between PE-N at the input side of the UPS can cause resonance in the phase conductors. The results show that to study the emission, immunity, and electromagnetic compatibility of supraharmonics for UPS, the factors such as operating mode, the type of load connected, and the input and output impedance need to be considered.
- 10 April 2023
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Access
- Vol. 11, 36823-36833
Open AccessPropagation of Supraharmonics in a Data Center With Different Operating Modes of UPS
A data center is a major hub of different converters ensuring continuous power to the server loads. The pulse width modulation switching techniques with frequency emission from 2 to 150 kHz (i.e., supraharmonics) in these converters call for a study of the magnitude and propagation of this emission within data centers where UPS is one of the main contributors of supraharmonics. The paper shows, with measurements and model, the change in magnitude and propagation of supraharmonics with the change in the operating mode of the UPS. The magnitude of supraharmonics shows a non-linear dependency on the power consumed in the online mode. In bypass mode, the magnitude of supraharmonics shows a dependency on the type of load connected. The filter connected between PE-N at the input side of the UPS can cause resonance in the phase conductors. The results show that to study the emission, immunity, and electromagnetic compatibility of supraharmonics for UPS, the factors such as operating mode, the type of load connected, and the input and output impedance need to be considered.
- Open Access
- 4 May 2022
- Published by Elsevier in Electric Power Systems Research
- Vol. 209
Measurements and modeling of the frequency behavior of residual current devices- from 4 Hz to 40 kHz
- 4 May 2022
- Published by Elsevier in Electric Power Systems Research
- Vol. 209
Open AccessMeasurements and modeling of the frequency behavior of residual current devices- from 4 Hz to 40 kHz
- Open Access
- 1 February 2022
- Published by Elsevier in Electric Power Systems Research
- Vol. 203
Analysis of supraharmonics in a three-phase frame
- 1 February 2022
- Published by Elsevier in Electric Power Systems Research
- Vol. 203
Open AccessAnalysis of supraharmonics in a three-phase frame
- Open Access
- 28 September 2020
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Open Journal of Industry Applications
- Vol. 1, 148-156
Summation of Supraharmonics in Neutral for Three-Phase Four-Wire System
Due to the increase in electronic loads such as LED lamps, power supply units for computing loads, voltage frequency drives in industries; high-frequency distortion is introduced into the power system. These high-frequency components appear due to the switching components of different power electronic converters present in the mentioned loads. The switching frequency components are most often in the range of 2 kHz to 150 kHz referred to as supraharmonics. The paper aims to show, with simulations and measurements, how supraharmonics sum in neutral and to quantify the neutral supraharmonic current as a ratio of single-phase current. This paper defines characteristics of supraharmonic emission that influence their summation in the neutral conductor through studies of devices connected in a balanced three-phase four-wire system. The paper further defines the relation of the supraharmonics emission with the number of devices connected at each phase. A mathematical model to predict the supraharmonics in a neutral conductor based on single-phase current and the number of devices is further proposed.
- 28 September 2020
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Open Journal of Industry Applications
- Vol. 1, 148-156
Open AccessSummation of Supraharmonics in Neutral for Three-Phase Four-Wire System
Due to the increase in electronic loads such as LED lamps, power supply units for computing loads, voltage frequency drives in industries; high-frequency distortion is introduced into the power system. These high-frequency components appear due to the switching components of different power electronic converters present in the mentioned loads. The switching frequency components are most often in the range of 2 kHz to 150 kHz referred to as supraharmonics. The paper aims to show, with simulations and measurements, how supraharmonics sum in neutral and to quantify the neutral supraharmonic current as a ratio of single-phase current. This paper defines characteristics of supraharmonic emission that influence their summation in the neutral conductor through studies of devices connected in a balanced three-phase four-wire system. The paper further defines the relation of the supraharmonics emission with the number of devices connected at each phase. A mathematical model to predict the supraharmonics in a neutral conductor based on single-phase current and the number of devices is further proposed.
- 24 November 2016
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- Vol. 5, 1234-1240
Implementation in arm microcontroller to maximize the power output of solar panel using Hill Climbing Algorithm
The objective of the paper is to discuss about the hardware implementation of a Maximum power point tracking (MPPT) unit which comprises of a 10W Photo Voltaic Panel, a Boost dc-dc converter and load, using ARM Cortex M3 32 bit Microcontroller in which the Hill Climbing Algorithm for maximum power point tracking with respect to insolation and load variations is executed. The ideal coupling of Photovoltaic (PV) Panel to the load is done through a controlled Boost type dc-dc converter. The boosted output voltage of the converter at MPPT can be coupled directly with grid synchronized inverter to supply power to local utility grid. The microcontroller instantaneously senses voltage and current output of solar panel with the help of 12 bit ADC of sampling frequency 200 KHz. It adjusts the duty cycle of the PWM signal given to the converter gate drive circuit. Generated PWM signal results in impedance matching of the panel with the load and hence deliver maximum power at customer side. ARM Cortex M3 32 bit Microcontroller allows greater performance efficiency, easy system modifications, low power consumption, critical tasks and interrupts are serviced as quickly as possible & improved code density.
- 24 November 2016
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- Vol. 5, 1234-1240
Implementation in arm microcontroller to maximize the power output of solar panel using Hill Climbing Algorithm
The objective of the paper is to discuss about the hardware implementation of a Maximum power point tracking (MPPT) unit which comprises of a 10W Photo Voltaic Panel, a Boost dc-dc converter and load, using ARM Cortex M3 32 bit Microcontroller in which the Hill Climbing Algorithm for maximum power point tracking with respect to insolation and load variations is executed. The ideal coupling of Photovoltaic (PV) Panel to the load is done through a controlled Boost type dc-dc converter. The boosted output voltage of the converter at MPPT can be coupled directly with grid synchronized inverter to supply power to local utility grid. The microcontroller instantaneously senses voltage and current output of solar panel with the help of 12 bit ADC of sampling frequency 200 KHz. It adjusts the duty cycle of the PWM signal given to the converter gate drive circuit. Generated PWM signal results in impedance matching of the panel with the load and hence deliver maximum power at customer side. ARM Cortex M3 32 bit Microcontroller allows greater performance efficiency, easy system modifications, low power consumption, critical tasks and interrupts are serviced as quickly as possible & improved code density.
- 1 January 2015
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1-6
Design, simulation and implementation of two phase interleaved bi-directional DC-DC converter
Removed.
- 1 January 2015
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1-6
Design, simulation and implementation of two phase interleaved bi-directional DC-DC converter
Removed.