Osmín Avilés-García
Research Subjects
Osmín Avilés-García has a total of 12 co-authors. Here are the top co-authors by number of shared publications:
- Jaime Espino-Valencia
Facultad de Ingeniería Química, Universidad Michoacana de San Nicolás de Hidalgo, Morelia 58060, Mexico
3 shared publications - Rubi Romero
Chemical Engineering Laboratory, Centro Conjunto de Investigación en Química Sustentable, UAEM-UNAM, Universidad Autónoma del Estado de México, Km 14.5 Toluca-Atlacomulco Road, Toluca 50200, Mexico
3 shared publications José Luis Rico-Cerda
2 shared publicationsA. de Lucas-Consuegra
1 shared publicationA.R. de la Osa
1 shared publication- Amaya Romero
Department of Chemical Engineering, University of Castilla-La Mancha, Avda. Camilo José Cela 12, Ciudad Real 13071, Spain
1 shared publication
Latest Publications
- Open Access
- 2 February 2022
- Published by Elsevier in Sustainable Chemistry and Pharmacy
- Vol. 25
New catalysts based on reduced graphene oxide for hydrogen production from ammonia decomposition
- 2 February 2022
- Published by Elsevier in Sustainable Chemistry and Pharmacy
- Vol. 25
Open AccessNew catalysts based on reduced graphene oxide for hydrogen production from ammonia decomposition
- Open Access
- 23 September 2018
- Published by Wiley in International Journal of Photoenergy
- Vol. 2018, 1-8
Synthesis and Characterization of TiO2/SiO2 Monoliths as Photocatalysts on Methanol Oxidation
Photocatalytic materials based on silica-titania (SiO2-TiO2) were synthesized by sol-gel and dip-coating method. TEOS and titanium butoxide were used as precursors of the silica-titania, respectively. A thin film with anatase phase was obtained on the surface of the support. The effect of variables as dispersion mechanism, immersion time, and number of treatment cycles were studied. The materials were characterized using X-ray diffraction, scanning electron microscopy, energy dispersion scanning, and N2 adsorption-desorption. The highest crystallinity of TiO2 on silica, high specific surface area in TiO2-SiO2 materials, and thin film formation were obtained by using a stirring plate and minimum immersion time. The so synthesized catalyst allowed the production of formaldehyde from the photocatalyzed methanol oxidation in a packed-bed reactor.
- 23 September 2018
- Published by Wiley in International Journal of Photoenergy
- Vol. 2018, 1-8
Open AccessSynthesis and Characterization of TiO2/SiO2 Monoliths as Photocatalysts on Methanol Oxidation
Photocatalytic materials based on silica-titania (SiO2-TiO2) were synthesized by sol-gel and dip-coating method. TEOS and titanium butoxide were used as precursors of the silica-titania, respectively. A thin film with anatase phase was obtained on the surface of the support. The effect of variables as dispersion mechanism, immersion time, and number of treatment cycles were studied. The materials were characterized using X-ray diffraction, scanning electron microscopy, energy dispersion scanning, and N2 adsorption-desorption. The highest crystallinity of TiO2 on silica, high specific surface area in TiO2-SiO2 materials, and thin film formation were obtained by using a stirring plate and minimum immersion time. The so synthesized catalyst allowed the production of formaldehyde from the photocatalyzed methanol oxidation in a packed-bed reactor.
- Open Access
- 27 April 2014
- Published by Wiley in International Journal of Photoenergy
- Vol. 2014, 1-10
Oxidation of 4-Chlorophenol by Mesoporous Titania: Effect of Surface Morphological Characteristics
Mesoporous nanocrystalline anatase was prepared via EISA employing CTAB as structure directing agent. The drying rate was used as a key synthesis parameter to increase the average pore diameter. The resultant mesoporous crystalline phases exhibited specific surface areas between 55 and 150 m2 g−1, average unimodal pore sizes of about 3.4 to 5.6 nm, and average crystallite size of around 7 to 13 nm. These mesophases were used as photocatalysts for the degradation of 4-chlorophenol (4CP) with UV light. Under the studied conditions, the mesoporous anatase degraded 100% 4CP. This was twice faster than Degussa P-25. 57% reduction of chemical oxygen demand (COD) value was achieved.
- 27 April 2014
- Published by Wiley in International Journal of Photoenergy
- Vol. 2014, 1-10
Open AccessOxidation of 4-Chlorophenol by Mesoporous Titania: Effect of Surface Morphological Characteristics
Mesoporous nanocrystalline anatase was prepared via EISA employing CTAB as structure directing agent. The drying rate was used as a key synthesis parameter to increase the average pore diameter. The resultant mesoporous crystalline phases exhibited specific surface areas between 55 and 150 m2 g−1, average unimodal pore sizes of about 3.4 to 5.6 nm, and average crystallite size of around 7 to 13 nm. These mesophases were used as photocatalysts for the degradation of 4-chlorophenol (4CP) with UV light. Under the studied conditions, the mesoporous anatase degraded 100% 4CP. This was twice faster than Degussa P-25. 57% reduction of chemical oxygen demand (COD) value was achieved.