Current Organizations / Institutes

The organizations/institutes from the scholar's latest article

Previous Organizations / Institutes

The organizations / institutes from the scholar's other articles in the past ten years


Yuri Nishikawa has a total of 63 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Identification of Stress Location During Low-Speed Mobility Travel Using Environmental Data

    by Narumon Jadram, Yuri Nishikawa, Midori Sugaya

    This study proposes an exploratory framework for identifying stress locations during travel with low-speed mobility devices (LMDs), such as electric wheelchairs. In this framework, stress factors perceived during LMD travel were identified through a post-ride questionnaire, and the travel route was divided into 100 m segments to enable location-specific stress evaluation. The identified factors were quantified using environmental data to construct an environment-based stress estimation index. Based on these quantified factors, a Composite Stress Score (CSS) was calculated to estimate stress levels along the route. Experiments with healthy adult participants were conducted to examine the feasibility of the proposed method. The results identified poor road surface conditions and vibrations, encounters with other road users, and narrow sidewalks as key stress factors during LMD travel. To examine whether the proposed method captures stress-related responses, correlations between CSS-based stress estimates and heart rate variability (HRV) indices were analyzed. The results showed that CSS calculated from poor road surface/vibrations, encounters with other road users, and narrow sidewalks exhibited moderate negative correlations with SDNN, suggesting that higher CSS values may correspond to increased physiological stress responses. These findings provide preliminary support for the exploratory feasibility of estimating potential stress locations during LMD travel using environmental data. However, the generalizability of the results is limited due to the specific experimental route and the use of healthy adult participants.

  • Open Access

    Identify Stress Location during Low-Speed Mobility Travel Using Environmental Data

    by Narumon Jadram, Yuri Nishikawa, Midori Sugaya

    In Japan, low-speed mobility devices (LMDs), such as electric wheelchairs and mobility scooters, are increasingly used to support mobility for older adults and individuals with mobility difficulties. However, during outdoor travel, environmental factors including uneven road surfaces, crowded pedestrian spaces, and narrow sidewalks can impose psychological stress on users and hinder continued LMD use. Identifying locations where stress is likely to occur is therefore important for improving travel comfort and safety. This study proposes a method for identifying stress locations based on environmental data during LMD travel by introducing a Composite Stress Score (CSS) that integrates multiple LMD-specific stress factors. Post-ride questionnaires identified three primary stress factors: poor road surface/vibrations, encounters with others, and narrow sidewalks. These factors were quantified using vertical acceleration, encounter counts derived from onboard video recordings, and sidewalk width, respectively, and stress levels were estimated for 100-m route segments. The relationship between CSS-based stress estimation and physiological stress responses was evaluated using heart rate variability (HRV) indexes. The results show that combining multiple environmental stress factors yields stronger associations with physiological stress responses, and segments classified as high-stress exhibited significantly lower SDNN values. These findings demonstrate the potential of the proposed method to identify stress locations during LMD travel using environmental data.

  • Open Access

    Designing a Digital Service System for Sustainable Social Value Creation: A Holistic Design Method Based on Socio-Cyber-Physical System Perspectives

    by Fumiya Akasaka, Yuya Mitake, Kentaro Watanabe, Yuri Nishikawa, Jun Ozawa, Yoshiki Shimomura

    Recently, data utilisation and digital service offerings are becoming primary methods of value creation. In this context, designing and offering ‘digital service systems’ (DSSs) that integrate physical elements (e.g., products, facilities, and physical infrastructure) and digital service elements (e.g., digital services, data, apps, and cloud systems) are important to create sustainable social values and achieve the United Nations’ Sustainable Development Goals 9 and 11. In this study, we propose a novel method for designing a DSS that simultaneously consider three system domains, namely social, physical, and digital domains. Specifically, we developed design models and a design process to support the DSS design. The proposed method was applied to an actual DSS design case. The results revealed that the proposed method could effectively consider components in the social system domain in addition to those in the digital and physical system domains in the DSS design. In particular, we identified that the proposed design models were useful for enabling the systematic management of a long-term collaborative design process among various stakeholders. They also enabled value-oriented thinking in DSS design and encouraged designers to consider different types of value in the DSS.


  • Lifestyle analysis with IoT data acquired from coffee roaster for service development

    by Masaaki Terano, Ayaka Kimura, Jun Ozawa, Yuri Nishikawa, Takeshi Takenaka, Fuko Oura

    This paper presents the lifestyle analyses of users via the appliance logs of our IoT coffee roasting service combined with a questionnaire survey on their lifestyles. We found that there is a difference in lifestyle trends between subscribed and non-subscribed users of the service. We also found that users showing a certain lifestyle have specific usage patterns of the roaster. In addition, we confirmed differences between the lifestyles of some users who quit the service and those who did not. Finally, we defined a service continuity index and discussed examples of measures to enhance service continuity by lifestyle analysis.

  • Mobility Optimization on Cyber Physical System via Multiple Object Tracking and Mathematical Programming

    by Nozomi Hata, Takashi Nakayama, Akira Tanaka, Takashi Wakamatsu, Akihiro Yoshida, Nariaki Tateiwa, Yuri Nishikawa, Jun Ozawa, Katsuki Fujisawa

    Cyber-Physical Systems (CPSs) are attracting significant attention from a number of industries, including social infrastructure, manufacturing, retail, among others. We can easily gather big datasets of people and transportation movements by utilizing camera and sensor technologies, and create new industrial applications by optimizing and simulating social mobility in the cyberspace. In this paper, we develop the system which automatically performs a series of processes, including object detection, multiple object tracking, and mobility optimization. The mobility of humans and objects is one of the essential components in the real world. Therefore, our system can be widely applied to various application fields. Our major contributions to this paper are remarkable performance improvement of multiple object tracking and building the new mobility optimization engine. In the former, we improve the multiple object tracker using K-Shortest Paths (KSP), which achieves significant data reduction and acceleration by specifying and deleting unnecessary nodes. Numerical experiments show that our proposed tracker is over three times faster than the original KSP tracker while keeping the accuracy. We formulate the mobility optimization problem as the SATisfiability problem (SAT) and the Integer Programming problem (IP) in the latter. Numerical experiments demonstrate that the total transit time can be reduced from 30 s to 10 s. We discuss the characteristics of solutions obtained by the two formulations. We can finally select the appropriate optimization method according to the constraints of calculation time and accuracy for real applications.

  • OpenMP and GPGPU Implementations of Probabilistic Occupancy Map for Multiple Human Position Estimation

    by Yuri Nishikawa, Hitoshi Sato, Jun Ozawa

    Probabilistic Occupancy Map (POM) is a method to estimate a location of multiple people, given images taken by multiple cameras from different angles set at a head level. It is useful even in the case of significant occlusion and can derive a location of people without an appearance model and prerequisite knowledge about the number of people in a detection space. However, the computation time of POM increases according to the area of detection space and number of cameras, which limits its performance. In this paper, we report performance enhancement of POM by applying OpenMP and GPGPU. As a result of evaluating test videos with different area size and cameras, we confirm that OpenMP implementation marks 1.8 to 2.7 times speedup compared to single CPU core implementation for all videos, whereas GPU implementation provides speedup in case of large grid size by a maximum of 7.6 times.

  • Multiple sports player tracking system based on graph optimization using low-cost cameras

    by Yuri Nishikawa, Hitoshi Sato, Jun Ozawa

    Multiplayer tracking is a key technology for strategic analysis in team sports. Since existing solutions use high-resolution cameras and are also expensive to install, they are primarily for professionals and there are almost no solutions that consumers can easily obtain. We focused on K-Shortest Paths which performs well with low-end cameras located at a tripod-level height, where occasional detection failure may occur. We implemented a prototype that can generate visual tracking results based on the algorithm, investigated factors that influences tracking performance and computation time using multi-camera video sequences, and estimated computation time for tracking multiplayer in several team sports.


  • Performance evaluation of multiple sports player tracking system based on graph optimization

    by Yuri Nishikawa, Hitoshi Sato, Jun Ozawa

    Multiplayer tracking is one of the essential technologies in team sports analysis, but there are few commercial solutions that consumers can quickly obtain and install. We focused on multiple object tracking method using graph optimization algorithm called K-Shortest Paths (KSP), which performs well with cameras located at a tripod-level height where occasional detection failure may occur. We evaluated end-to-end execution time and accuracy to verify the feasibility of KSP as a multiplayer tracking method. As a result, using a high-performance computing environment equipped with 8 NVIDIA Tesla P100 GPUs, we found that tracking a basketball video of 1 hour is expected to be completed in about 2 1/2 hours. On the other hand, nearly 30 ID switches (replacement of individual trajectory) appeared in 60 seconds. We found that about 75% of the case was either due to the system tracking one person as multiple persons or when people were in contact with each other.


  • Vegeta: An Implementation and Evaluation of Development-Support Middleware on Multiple OpenCL Platform

    by Akihiro Shitara, Tetsuya Nakahama, Masahiro Yamada, Toshiaki Kamata, Yuri Nishikawa, Masato Yoshimi, Hideharu Amano

    Programming on the cluster with accelerators like GP-GPU tends to be a mixture of intra-node parallel library based on CUDA or OpenCL and inter-node communication library including MPI. In this work, we proposed, implemented and evaluated VEGETA, a middleware that can inject OpenCL program tasks written for multiple OpenCL accelerators in a single chassis to multiple OpenCL accelerators equipped in multiple chassis. Furthermore, we add a new feature called Virtual Direct Memory Access (VDMA) scheme, which supports direct data transfer to other node without writing back to the memory region on user application. In execution of a matrix multiplication benchmark on two, three and four nodes each provided performance improvement of 1.9, 2.8 and 3.8 times. Furthermore, as the result of executing advection term computation based on Cartesian grid method, 78% of the performance compared to that of MPI version was obtained even without use of VDMA, and moreover, 96% of that was achieved the system with VDMA.


  • A datapath classification method for FPGA-based scientific application accelerator systems

    by Yui Ogawa, Tomonori Ooya, Yasunori Osana, Masato Yoshimi, Yuri Nishikawa, Akira Funahashi, Noriko Hiroi, Hideharu Amano, Yuichiro Shibata, Kiyoshi Oguri

    Resource reduction design techniques play an important role to implement large-scale FPGA-based accelerator systems in floating point applications since available resources on FPGAs are limited. This paper proposes a dataflow graph classification method which makes groups of graphs based on their similarity in order to bring out efficient graph combining. Aiming at finding effective parameters for the k-means algorithm, various parameter combinations are evaluated and compared in terms of resource reduction effects and performance. The experimental results using an FPGA-based biochemical simulator reveal that the graph clustering that uses information on the maximum common subgraphs achieve 73.3% of resource reduction rate while alleviating the performance degradation.