Gabriela Kratošová

Although the nanoparticle (NP) utilization in agronomy is currently orientated to intensify crop yield, the potential negative effects on soil and plant reproductive organs, including effects on pollen are largely absent in the literature. For this reason, our study was set to evaluate the impact of ZnO nanoparticles (ZnO-NPs) on the selective properties of Fluvisol, on the direct microbial activity and zinc (Zn) phytoavailability, and crop yield after their foliar application on soybean [Glycine max (L.) Merril] under field conditions. Additionally, the potential hazardous impact to plant reproductive structures was evaluated, focusing on the agronomically and environmentally sensitive biomarker – pollen viability. The soil biological activity was evaluated through microbial respiration while Zn phytoavailability was determined using reaction agents with nutrients analysis conducted through flame atomic absorption spectroscopy (F-AAS). Pollen viability was evaluated using the iodine potassium iodide (IPI) test. The experiments were carried out at an experimental site of the Faculty of Agrobiology and Food Resources (FAFR) at the Slovak University of Agriculture (SUA) in Nitra, located in Central Europe, during the 2023 vegetation season. Depending on increasing concentrations of ZnO-NPs through order of 1.4, 14, and 140 mg∙L–1, revealed no harmful effect on soil microbial activity or hazardous Zn accumulation in the context of its Fluvisol-phytoavailable distribution compared to NPs-free control. A positive impact on soybean pollen viability was observed at all applied ZnO-NP concentrations compared to the NP-free control. The highest pollen viability, reaching up to 97.04%, was achieved at a concentration of 1.4 mg∙L–1, and, subsequently, it slightly decreased with increasing concentrations of ZnO-NPs. Moreover, the application of ZnO-NPs had a positive impact on soybean weight of thousand seeds and seed yield, where it’s the highest concentration was the most effective. Thus, our results directly demonstrate the positive efficiency on selective properties of soil and reproductive structure – pollen, where ZnO-NP spray application acted positively and stimulatingly. Additionally, ZnO-NPs had positive impact on weight of thousand seeds (TSW) and seed yield. Therefore, the use of nanoparticles in foliar applications could be considered as kind of novelty in precision and sustainable agriculture.

Our previous studies have shown physiological and yield intensification of selected crops with the application of nanoparticles (NPs). However, the impact on the quantitative, qualitative, and yield parameters of maize (Zea mays L.) in field conditions remains highly debated. This study aimed to evaluate the effects of zinc oxide (ZnO-NPs), gold NPs anchored to meso-biosilica (Au-NP-bioSi), and titanium dioxide (TiO₂-NPs) as biological stimulants under field conditions during the vegetation season of 2021 in the Central European region. The study assessed the effects on the number of plants, yield, yield components, and nutritional quality, including mineral nutrients, starch, and crude protein levels. The potential translocation of these chemically–physically stable NPs, which could pose a hazard, was also investigated. The results indicate that Au-NP-bioSi and ZnO-NPs-treatments were the most beneficial for yield and yield components at a statistically significant level. Mineral nutrient outcomes were varied, with the NP-free variant performing the best for phosphorus-levels, while Au-NP-bioSi and ZnO-NPs were optimal for crude protein. Starch content was comparable across the TiO₂-NPs, Au-NP-bioSi, and control variants. Importantly, we observed no hazardous translocation of NPs or negative impacts on maize grain quality. This supports the hypothesis that NPs can serve as an effective tool for precise and sustainable agriculture.

Even though the biodegradability of polycaprolactone (PCL) and its nanocomposites is lower compared to other biodegradable polyesters, this property and good biocompatibility are used for development of materials for drug delivery with a long‐term effect. We prepared novel PCL/clay nanocomposite films with antimicrobials chlorhexidine (CH) or octenidine (OCT) combined with ZnO anchored on vermiculite (VER). The intercalation of CH and OCT into the interlayer of VER/ZnOVER was confirmed by XRD, FTIR and SEM. The organically modified nanofillers compared to VER (−46.0 mV) or ZnOVER (−34.9 mV) showed a positive ζ‐potential (+30.7 mV (VER_CH), +21.9 mV (VER_OCT), +24.6 mV (ZnOVER_CH)) indicating a relatively stable materials, except ZnOVER_OCT (+8.6 mV), which strongly agglomerated.Thin PCL/clay films were prepared by solvent casting method and the effect of used nanofillers on structural, thermal, mechanical and antimicrobial properties followed by degradation under hydrolytic conditions was studied. The results showed that presence of ZnO significantly decreases thermal and mechanical stability. The nanofillers with the higher hydrophilic character are responsible for the fastest degradation of PCL matrix. Films possessed high antimicrobial efficiency in long time intervals, hence these nanocomposites open new avenues for the possible application of such materials for the drug delivery with a long‐term effect.Highlights: Antimicrobial active PCL/clay nanocomposites were prepared. Nanofillers influenced the structure and properties of prepared thin PCL films. ZnO caused lower thermal stability and worse mechanical properties of PCL films. PCL/clay nanocomposite films degraded slowly by a hydrolytic mechanism. High potential as medical materials with long‐lasting antimicrobial efficacy.

On a daily basis, a wide range of materials including inorganic nanoparticles (NPs) inadvertently find their way into the environment. Meanwhile, intentionally used NPs, such as the new generation of nanofertilizers (NFs) are designed to enhance agronomic production. However, their physicochemical properties and not-so-well understood effects raise potential risks to the plant reproductive cycle, specifically pollen development, a subject largely absent in academic research. Even slight contamination, deformation, or aberration of pollen could have enormous impacts on the ecosystem. Thus, our objective was to evaluate the influence of various metal-based NPs on sunflower pollen morphology and its yield. Nano-formulations were applied during the 2019–2021 agronomic seasons on two sunflower hybrids, Neostar and Edison, in Dolná Malanta, near Nitra, Slovak Republic. Pollen morphology findings indicated that conventional ZnSO₄ had the most positive impact on the size of pollen grains compared to ZnO-NPs, Fe₃O₄-NPs, and the NP-free control. Gold-NPs on SiO₂ mesoporous silica (AuSi-NPs) showed a statistically insignificant impact, while the use of TiO₂-NPs in agriculture remained a topic of debate. Surprisingly, pollen characteristics did not fully correspond to crop yields. Despite causing a reduction in pollen grain size, the TiO₂-NPs consistently showed the highest yield compared to other variants. Employing low concentrations of NFs did not notably alter pollen morphology, reinforcing our commitment to eco-friendly, precise, and sustainable agriculture.

One of the challenges in agriculture practices is guaranteeing an adequate and bioavailable phosphorus supply for plants on phosphorus-deficient soils. A promising alternative lies in the utilization of phosphate nano-fertilizers (NFs) through spray applications. Therefore, this short-term study aimed to investigate the yet undetermined widespread impact of P-NFs on crops characterized by broad leaves, an intensive rate of photosynthesis, and belonging to the oilseed plant, sunflower (Helianthus annuus L.). To achieve this, NFs were applied at lower concentrations of various phosphate-based NFs, including (i) nano-hydroxylapatite (nano-Hap) and (ii) a mixture of nano-calcium zinc phosphate and macro-sized parascholzite (nano/macro-ZnPhos), in comparison to the NF-free control. The study was carried out under authentic field conditions during the 2022 vegetation season at the Dolná Malanta site within the Central European Region. The empirical evidence presented herein indicates that the utilization of biocompatible and bioactive nano-Hap, initially engineered for biomedical applications, and nano/macro-ZnPhos, now foliarly applied at reduced concentrations, elicited a statistically significant elevation in quantitative parameters and seasonal physiological responses. The parameters analyzed included head diameter, dry head weight, seed yield per hectare, nutritional seed oiliness, etc. as well as the physiological normalized difference vegetation index (NDVI), stomatal conductance index (Ig), and crop water stress index (CWSI). In terms of agro-ecological terrestrial bio/diversity, it was evident that the nano/macro-ZnPhos was the most hospitable variant for the terrestric insect community, but surprisingly, the agronomically more popular nano-Hap showed only statistically insignificant changes in the diversity of the detected communities. However, the relevance of outcomes highlighted using nano-fertilizers, supporting the concept of precision and sustainable agriculture under field conditions.

In environmental and agronomic settings, even minor imbalances can trigger a range of unpredicted responses. Despite the widespread use of metal-based nanoparticles (NPs) and new bio-nanofertilizers, their impact on crop production is absent in the literature. Therefore, our research is focused on the agronomic effect of spray application of gold nanoparticles anchored to SiO₂ mesoporous silica (AuSi-NPs), zinc oxide nanoparticles (ZnO-NPs), and iron oxide nanoparticles (Fe₃O₄-NPs) on sunflowers under real-world environments. Our findings revealed that the biosynthetically prepared AuSi-NPs and ZnO-NPs were highly effective in enhancing sunflower seasonal physiology, e.g., the value of the NDVI index increased from 0.012 to 0.025 after AuSi-NPs application. The distribution of leaf trichomes improved and the grain yield increased from 2.47 t ha⁻¹ to 3.29 t ha⁻¹ after ZnO-NPs application. AuSi-NPs treatment resulted in a higher content of essential linoleic acid (54.37%) when compared to the NPs-free control (51.57%), which had a higher determined oleic acid. No NPs or residual translocated metals were detected in the fully ripe sunflower seeds, except for slightly higher silica content after the AuSi-NPs treatment. Additionally, AuSi-NPs and NPs-free control showed wide insect biodiversity while ZnO-NPs treatment had the lowest value of phosphorus as anti-nutrient. Contradictory but insignificant effect on physiology, yield, and insect biodiversity was observed in Fe₃O₄-NPs treatment. Therefore, further studies are needed to fully understand the long-term environmental and agricultural sustainability of NPs applications.

Today, Ni-Cr steel is used for advanced applications in the high-temperature and electrical industries, medical equipment, food industry, agriculture and is applied in food and beverage packaging and kitchenware, automotive or mesh. A study of input steel powder from various stages of the recycling process intended for 3D printing was conducted. In addition to the precise evaluation of the morphology, particle size and composition of the powders used for laser 3D printing, special testing and evaluation of the heat-treated powders were carried out. Heat treatment up to 950 °C in an air atmosphere revealed the properties of powders that can appear during laser sintering. The powders in the oxidizing atmosphere change the phase composition and the original FeNiCr stainless steel changes to a two-phase system of Fe₃Ni and Cr₂O₃, as evaluated by X-ray diffraction analysis. Observation of the morphology showed the separation of the oxidic phase in the sense of a brittle shell. The inner part of the powder particle is a porous compact core. The particle size is generally reduced due to the peeling of the oxide shell. This effect can be critical to 3D printing processing, causing defects on the printed parts, as well as reducing the usability of the precursor powder and can also change the properties of the printed part.

The alumina and zirconia surfaces were pretreated with chemical etching using alkaline mixtures of ammonia, hydrogen peroxide and sodium hydroxide, and followed with application of the powder layer of Ca-deficient hydroxyapatite (CDH). The influence of etching bath conditions time and concentration on surface development, chemical composition and morphology of medicinal ceramic powders were studied. The following analyses were performed: morphology (scanning electron microscopy), phase composition (X-ray diffraction analysis), changes in binding interactions and chemical composition (FT-Infrared and Energy dispersive spectroscopies). Both types of etchants did not expose the original phase composition changes or newly created phases for both types of ceramics. Subsequent decoration of the surface with hydroxyapatite revealed differences in the morphological appearance of the layer on both ceramic surfaces. The treated zirconia surface accepted CDH as a flowing layer on the surface, while the alumina was decorated with individual CDH aggregates. The goal of this study was to focus further on the ceramic fillers for polymer-ceramic composites used as a biomaterial in dental prosthetics.

Nanotechnology offers new opportunities for the development of novel materials and strategies that improve technology and industry. This applies especially to agriculture, and our previous field studies have indicated that zinc oxide nanoparticles provide promising nano-fertilizer dispersion in sustainable agriculture. However, little is known about the precise ZnO-NP effects on legumes. Herein, 1 mg·L⁻¹ ZnO-NP spray was dispersed on lentil plants to establish the direct NP effects on lentil production, seed nutritional quality, and stress response under field conditions. Although ZnO-NP exposure positively affected yield, thousand-seed weight and the number of pods per plant, there was no statistically significant difference in nutrient and anti-nutrient content in treated and untreated plant seeds. In contrast, the lentil water stress level was affected, and the stress response resulted in statistically significant changes in stomatal conductance, crop water stress index, and plant temperature. Foliar application of low ZnO-NP concentrations therefore proved promising in increasing crop production under field conditions, and this confirms ZnO-NP use as a viable strategy for sustainable agriculture.