MMMaryna Mikhalieva

Maryna Mikhalieva

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article

Previous Organizations / Institutes

The organizations / institutes from the scholar's other articles in the past ten years


Maryna Mikhalieva has a total of 48 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Research of the possibilities of controlling the composition of mixtures of organic and inorganic substances in a cyber-physical measurement system

    by Maryna Mikhalieva, Liubomyra Odosii, Krzysztof Przystupa, Artūras KILIKEVIČIUS, Yuryi Shabatura, Oleksandr Protsanin

    The article examines experimental results in which new dependences of electrical parameters on the composition and viscosity of liquids mixtures of liquids of different chemical nature were obtained. A new method of comparing the value of the complex conductivity of the measured system with the experimentally established value for the standard composition of the liquid brand allows it to be used for the cyber-physical control system during the operation of the equipment. The obtained results confirm the theory of dielectric properties of organic substances and the theory of atomic electronic polarization with relaxation effects on capacitor energy losses. The proposed method has positive theoretical and practical significance for improving the process of diagnosing automotive systems using various types of technical fluids.

  • Research of dependences of engine oil viscosity on electrical parameters for quality control in a cyber-physical measurement system

    by Maryna Mikhalieva, Liubomyra Odosii, Volodymyr Hera, Krzysztof Przystupa, Liliya Kropuvnutcka, Andriy Shandrivskyy

    The article presents an improved method for monitoring the viscosity of motor oil by its electrical parameters. This dependence is based on laboratory studies of the spectra of the dependences of the values of the complex conductivity of the measuring system on the frequency of the test signal. The method is based on a new calibration dependence of viscosity on the measured value of complex conductivity. The obtained dependences allow their use in cyber-physical systems for oil quality control.

  • Open Access

    Improving a methodology for estimating the cross-country ability of all-wheel-drive vehicles

    by Mykhailo Hrubel, Lubomir Kraynyk, Maryna Mikhalieva, Vasyl Zalypka, Mykhailo Manziak, Vitalii Khoma, Olena Lanets, Dmytro Ruban, Anatolii Andriienko, Vasyl Kokhan

    The object of this study is the cross-country ability of four-wheel drive vehicles under off-road conditions. Based on the results of analysis of known studies, it was determined that the procedures of experimental assessment of the load-bearing capacity of bearing surfaces (BS), based on the use of the cone index, are used in NATO member countries. They take into account the characteristics of the surface of the theater of operations and make it possible to determine the approximate speeds of all-wheel drive vehicles with the help of standardized computer software. In the procedures for assessing the load-bearing capacity of BSs, which use the soil deformation module E, there is no possibility for calculating the speed of the car with known axle loads. In addition, they provide for the determination of a number of parameters of the bearing surface, such as the coefficient of adhesion, the angle of internal friction in the soil, and the shear modulus during the formation of a track. This makes them much more difficult compared to the procedures used by NATO. Therefore, the problem that is solved in this work is to improve the methodology for assessing the reference cross-country ability of four-wheel drive vehicles. Based on the results of scientific research, motion modeling was carried out in the MATLAB Simulink environment to determine parameters of reference cross-country ability of four-wheel drive vehicles. In order to determine the cross-country ability of samples of wheeled military vehicles (WMV) based on the indicator of the maximum pressure value (mean measure pressure – MMP), the conducted experimental studies were analyzed. They showed a difference in the speed modes of vehicles of the same gross weight but different layout schemes, within 11–12 %. Therefore, the methodology for assessing the cross-country ability based on MMP has been improved to take into account the features of the layout of WMV samples. Specifically, taking into account the different values of loads on the front axle of vehicles with hoodless and hood layouts at the same gross weight. In general, the improved procedure makes it possible to give a quantitative assessment of the movement mobility of WMV samples with various layout schemes and an assessment of their potential cross-country ability on the basis of the proposed refinement of MMP calculation


  • Opportunities of electrical technologies for control of the quality parameters of light sensitive materials

    by Maryna Mikhalieva, Lubomyra Odosii, Krzysztof Przystupa, Yuryi Shabatura, Volodymyr Romanchuk, Lidiya Parashchuk

    Based on the obtained experimental results, an algorithm of the information and measurement system for operational control of the efficiency of photocells during their operation is proposed. The subject of the research was solar radiation energy converters into electric current energy - photocells from the wide-band semiconductor titanium oxide and polymethine dyes - sensitizers, which are sensitive to the action of light in the visible and near-infrared bands of the solar spectrum. Using the method of immittance spectroscopy, information on transport and recombination electronic processes was obtained, which was used to assess the potential for the construction and use of the investigated quality systems of solar cells. The object of the study is the dependence of the quality control parameter of the photocell - the titanium oxide content - on the value of the measured electrical parameter - admittance. Control of the efficiency of photocells is offered by the sign (positive or negative) of the value of the measured electrical parameter - complex conductivity.


  • Improvement of electrical methods of control and evaluation of impact of military activity on surface waters

    by Maryna Mikhalieva, Lubomyra Odosii, Krzysztof Przystupa, Yuryi Shabatura, Mykhailo Hrubel, Nataliya Hots

    The article argues and describes a new approach to the technical assessment of the impact of military activity on surface water sources, which is based on new electrical indicators: Red-Ox, admittance; this will improve the processes of monitoring and responding to threats to the environment.


  • Simulation of the influence of wind power plants on the compartments of the complex landscape system

    by Mariia Ruda, Taras Boyko, Oksana Chayka, Maryna Mikhalieva, Olena Holodovska

    The impact of wind power plants on the environmental components is assessed taking into account a number of their parameters, in particular the technical characteristics of wind turbines, the characteristics of networks, engineering and other structures. To do this the life cycle of the wind power plants is described taking into account (by way of inventory) all the necessary materials and resources. Waste management scenarios have been developed, the use of which will make it possible to reduce the harmful impact on the environment. Based on the inventory and input data on the wind farm under study, a diagram is generated – a tree of life cycle processes of the wind power plant – to determine the potential environmental impacts. A list of impact categories that represent the load on the environment caused by the wind power plant is defined; also, the relative contribution of harmful factors is determined for each category, taking into account possible scenarios of waste management. Ecological profiles have been built for all potential impacts on the environment. After normalisation and determination of significance, individual estimates of all indicators and their distribution in three categories of lesions were obtained: human health, ecosystem quality and resources, as well as four stages of the wind farm life cycle: production, dismantling and disposal, operation, transportation and installation. The obtained profiles made it possible to determine individual indicators and eco-indicators, expressed in eco-points that characterise the wind farm under study.


  • Simulation of the influence of multiple reflections of background radiation on the thermography results

    by Nataliya Hots, Krzysztof Przystupa, Maryna Mikhalewa, Berestov Ruslan

    W artykule przeprowadzono analizę wpływu promieniowania tła na dokładność pomiaru temperatury promieniowaniem podczerwonym. Zdefiniowano wymagania dotyczące możliwości pominięcia wielokrotnych odbić promieniowania. Analizę teoretyczną potwierdzono wynikami modelowania błędów radiacyjnych pomiaru temperatury. (Symulacja wpływu wielokrotnych odbić promieniowania tła na wyniki pomiarów termowizyjnych)

  • Electrical method for a water control after an osmosis process for the standard unit of ultrasound power in the aquatic environment

    by Maryna Mikhalieva, Vasyl Parakuda, Yuryi Shabatura, Lubomyra Odosii, Krzysztof Przystupa

    The article discusses the issue of water quality improved by the metrological characteristics of the standard unit of ultrasound power in the aquatic environment by an automated control of the purification process. The received experimental results demonstrate that this new electric method of control is highly efficient


  • Open Access

    Obtaining stable characteristics description of signals scattered by complex objects through frequency averaging

    by V. V. Atamaniuk, Y. M. Kosovtsov, A. M. Zubkov, Y. V. Shabatura, M. S. Mikhalieva

    Частотне усереднення як спосіб отримання стійкого опису характеристик сигналів, розсіяних складними об’єктами

  • Electrical method for intelligent cooling liquid control system

    by Maryna Mikhalieva, Liubomyra Odosii, Bohdan Seredyuk, Vasyl Zalypka, Lidiya Parashchuk, Hanna Lunkova

    The ability to determine and control the normalized concentrations has been established using the experimentally obtained dependencies of the active and reactive constituents of conductivity in the wide frequency range of the electromagnetic field on the composition of the multicomponent fluid and the impurity concentrations. For high-aqueous substances dissolved in water (cooling liquids), a method for controlling the qualitative and quantitative composition is developed. It is based on the comparison of the measured and experimentally established active conductivity component and the comparison of the corresponding dependencies in the frequency field of the reactive component of conductivity. The developed electric method allows quantitative and qualitative estimation of the composition of the coolant on the contents of controlled components in the short time (up to 2 seconds) in a non-laboratory environment and to ensure uninterrupted operation of the equipment.