PDPaul M. Danehy

Paul M. Danehy

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Paul M. Danehy has a total of 432 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Wake Visualization of the LOFTID Model at Mach 10 Using Planar Laser-Induced Fluorescence

    by Neil S. Rodrigues, Olivia K. Tyrrell, Elizabeth F. Rieken, Brian R. Hollis, Paul M. Danehy

    An experimental investigation of the hypersonic wake behind the Low-Earth Orbit Flight Test of an Inflatable Decelerator (LOFTID) wind tunnel model in a Mach 10 freestream is discussed. Wake visualization was performed using planar laser-induced fluorescence (PLIF) of nitric oxide (NO), which was locally seeded into the wake through the aft body of the model. PLIF measurements are reported at all three of the typical freestream Reynolds numbers of the NASA Langley 31-inch Mach 10 wind tunnel at an [ ] angle of attack for two different NO seed gas flow rates. At the lowest Reynolds number, additional data are reported at [ ] and also with the model rolled to [ ]. Unsteady wake boundaries and large-scale unsteady flow structures were clearly seen in the wake at these test conditions. The upper wake boundary was identified using a custom edge-tracking algorithm. Changing the mass flow rate of the NO seed gas by [ ] and varying the Reynolds number did not have a significant effect on the average wake boundary, while notable changes in the wake boundary were observed based on the α variation. Data acquired with the model rolled to [ ] provided insight into sting effects.

  • Planar Investigation of CobraMRV Flowfields Using Pulse-Burst, Cross-Correlation Doppler Global Velocimetry

    by Ross A. Burns, Timothy W. Fahringer, Paul M. Danehy

    Flowfields around a model reentry vehicle, a scaled version of a CobraMRV, are investigated with a combination of high-speed planar laser Mie scattering and planar pulse-burst, cross-correlation, Doppler global velocimetry for scalar visualization and streamwise velocity measurements, respectively. Tests were conducted in the NASA Langley 4-Foot Supersonic Unitary Plan Wind Tunnel over a range of different tunnel operating conditions and model configurations and focused on the shock/boundary-layer interaction under the model. Pseudotomographic reconstructions of these flowfields were assessed for mean flow structure. Mach- and Reynolds-number-dependent effects were examined, including changes in bow-shock angle and standoff distance with Mach number along with global changes to the interaction topology with Reynolds number. Measurement uncertainties ranged from 50 to [Formula: see text] throughout the region of interest, driven largely by angular uncertainties. The mean measurement accuracy assessed in the tunnel freestream was 5.2% of tunnel-predicted values, while larger deviations were found in the immediate postshock regions due to assumptions made to assess velocity. Minor velocity and structural differences were also observed between repeated test cases. A series of recommendations to improve the fidelity of the velocimetry for future experiments by roughly a factor of 4 is given.

  • KHz-rate velocity measurements using pulse-burst, cross-correlation Doppler global velocimetry

    by Ross A Burns, Timothy W Fahringer Jr, Paul M Danehy

    Pulse-burst, cross-correlation Doppler global velocimetry was used to perform kHz-rate velocity measurements in the NASA Langley 4-Foot Supersonic Unitary Plan Wind Tunnel. Planar, one component (2D-1C) velocity measurements were made at rates up to 6 kHz in a canonical, oblique shockwave flowfield, generated by a full-span splitter plate in a Mach 2.4 flow. Assessment of the velocimetric accuracy indicates agreement with theoretical velocity values to within 1-percent on average for all measurements tested. The spatial velocity precision is measured to be between 0.3 and 0.5% (1 σ ) for all tested frequencies, while the ensemble (1σ) precision of the measurements was within 2.3% of the measured velocities. Measurement uncertainties that were estimated using Monte Carlo simulations exhibit values similar to the precision (2%) and also indicate the potential for biases in the velocity results as a result of periodic or modal behavior in flows. While these results are promising, the technique also shows great potential for expansion, both in measurement rates and applicability to other techniques.

  • Applications of single-beam 100 kHz krypton tagging velocimetry in high-pressure N2 flows

    by Jincheng Wang, Naibo Jiang, Paul S. Hsu, Neil Rodrigues, Paul M. Danehy, Sukesh Roy, Hui Hu

    High-repetition-rate krypton tagging velocimetry (KTV) has recently gained increased attention in high-speed flow diagnostics due to the nontoxic and nonreacting characteristics of krypton. We report the recent progress in developing a single-beam 100 kHz KTV system to characterize transonic/supersonic gaseous flows, focusing on high-pressure nitrogen environments. This technique has potential applications in various aerospace-related operations of nitrogen flows, including large-scale transonic/supersonic wind tunnel facilities and next-generation propulsion systems for space exploration. The performance of the single-beam KTV system is assessed in terms of relevant aspects commonly encountered in large-scale, high-speed wind tunnel facilities, including long focal length, high pressure, low krypton seeding, and wall effects. The effectiveness of the single-beam 100 kHz KTV system was demonstrated by conducting quantitative flow velocity measurements in the shear layers of a supersonic-free jet with high velocity gradients and a transonic boundary flow near a solid wall. The uncertainty of the KTV measurements is estimated to be about 4.0% at the center of the supersonic jet flow based on the standard deviation (i.e., 2σ) of the measurement data, with the corresponding standard error of the mean (i.e., 2σ/N) being 0.7%.


  • Frequency-scanning burst-mode filtered Rayleigh scattering for kHz-rate, multi-parameter, gas-phase measurements

    by Amanda M. Braun, Neil S. Rodrigues, Paul M. Danehy, Alexander R. Suppiah, James Braun, Mikhail N. Slipchenko, Terrence R. Meyer

    Molecular Rayleigh scattering (RS) is sensitive to the pressure, temperature, velocity, and number density of the gaseous flow. Filtered Rayleigh scattering (FRS) utilizes a narrowband molecular filter to remove stray scattering and deconvolve the effect of flow conditions on the signal intensity. As single-frequency, intensity-based FRS techniques can typically only deconvolve a single parameter per detector angle, frequency-scanning (FS) FRS has been used to semi-spectrally resolve the signal and quantify multiple parameters using a single detector. In this work, the FS-FRS data rate was increased by a factor of 105 using a rapid wavelength-tunable burst-mode laser operated at 20 kHz. The technique is demonstrated for simultaneous, spatially resolved temperature, pressure, and radial velocity measurements time-averaged across 1 ms in an underexpanded jet, yielding a measurement rate of 1 kHz for potential use in high-speed flow test facilities.


  • Open Access

    Fluorescence imaging of plume-surface interaction in large-scale reduced pressure environments

    by N. S. Rodrigues, O. K. Tyrrell, P. M. Danehy

    Planar laser-induced fluorescence (PLIF) was applied for the first time in the 20-ft vacuum chamber at the Marshall Space Flight Center to visualize the plume-surface interaction (PSI) of a nitrogen jet seeded with nitric oxide (NO). A Mach 5.3 nozzle was used to simulate the exhaust of a landing spacecraft for two different jet stagnation pressures and one jet stagnation temperature. A flat plate was used to simulate the landing surface, and two different dimensionless altitudes were investigated. The chamber pressure was reduced such that both lunar-relevant environments at 0.01–28 Pa and Martian-relevant environments at ∼600 Pa were investigated. PLIF flow visualization was performed using a pulsed, tunable, ultraviolet laser, which entered the vacuum chamber through a window, and was directed to the test article using remote-controlled mirrors. Fluorescence at ultraviolet wavelengths was imaged using an intensified camera, which was placed inside a pressurized enclosure located inside the vacuum chamber. For the Martian-relevant condition, a Mach disk and stagnation bubble were observed at h/De = 10, whereas a pair of oblique stagnation shocks were observed at h/De = 3. Significantly complex flows, such as different stagnation shock behaviors, were observed for the lunar-relevant conditions based on the h/De and Reynolds number. The results presented here are the first NO-PLIF measurements of the PSI flowfield within rarefied environments. The unique information on jet expansion and plume structure will be useful to aid researchers in validating complex computational simulations and to inform engineering designs of extraterrestrial landing systems.


  • Long-lived nitric oxide molecular tagging velocimetry with 1 + 1 REMPI

    by Naibo Jiang, Paul S. Hsu, Sukesh Roy, Jincheng Wang, Hui Hu, Neil Rodrigues, Paul M. Danehy

    The successful demonstration of long-lived nitric oxide (NO) fluorescence for molecular tagging velocimetry (MTV) measurements is described in this Letter. Using 1 + 1 resonance-enhanced multiphoton ionization (REMPI) of NO at a wavelength near 226 nm, targeting the overlapping Q1(7) and Q21(7) lines of the A–X (0, 0) electronic system, the lifetime of the NO MTV signal was observed to be approximately 8.6 µs within a 100-Torr cell containing 2% NO in nitrogen. This is in stark contrast to the commonly reported single photon NO fluorescence, which has a much shorter calculated lifetime of approximately 43 ns at this pressure and NO volume fraction. While the shorter lifetime fluorescence can be useful for molecular tagging velocimetry with single laser excitation within very high-speed flows at some thermodynamic conditions, the longer lived fluorescence shows the potential for an order of magnitude more accurate and precise velocimetry, particularly within lower speed regions of hypersonic flow fields such as wakes and boundary layers. The physical mechanism responsible for the generation of this long-lived signal is detailed. Furthermore, the effectiveness of this technique is showcased in a high-speed jet flow, where it is employed for precise flow velocity measurements.


  • Multiline molecular tagging velocimetry of nitric oxide at 100 kHz using an injection-seeded burst-mode OPO

    by Neil S. Rodrigues, Naibo Jiang, Paul Hsu, Sukesh Roy, Paul M. Danehy

    An injection-seeded, burst-mode optical parametric oscillator (OPO) operating at a repetition rate of 100 kHz is used to demonstrate the multiline molecular tagging velocimetry of an underexpanded jet using nitric oxide fluorescence. The very narrow linewidth of the OPO system, along with the relatively high pulse energies of the burst-mode system, enables efficient single-photon excitation of nitric oxide along multiple laser beam lines at a high repetition rate. Simultaneous one-dimensional velocity profile measurements were obtained of an underexpanded jet system at six different locations using a reference initial image and single-shot delayed images. A methodology for calculating the uncertainty of single-shot velocity is also described. Mean and root-mean-square velocity profiles are obtained at multiple locations simultaneously over a sampling time of 1 ms. The high-repetition-rate velocity measurements also appear to capture the onset of velocity oscillations and has the potential to reveal velocity frequency content occurring in the tens of kHz. The demonstrated velocimetry technique could be paired with other emerging burst-mode laser capabilities for a quantitative multiparameter gas property or multicomponent gas velocity measurements for supersonic and hypersonic flows, especially within ground test facilities that are limited to very short run durations.


  • Methods to improve burst-mode laser spectral purity for high-speed gas-phase filtered Rayleigh scattering

    by Amanda M. Braun, Mikhail N. Slipchenko, Jason Leicht, Terrence R. Meyer, Paul M. Danehy, Sukesh Roy

    In the filtered Rayleigh scattering (FRS) technique, Doppler or homogeneously broadened light from weak molecular scattering is separated from orders-of-magnitude stronger elastic scattering from surfaces, windows, particles, and/or droplets using a narrowband filter. In this work, high-speed detection of such weak molecular scattering is enabled by a burst-mode laser system that can achieve a spectral purity of ∼0.999999. This allows for an additional two orders of magnitude of attenuation from a narrowband iodine molecular filter for high-speed detection of gas-phase FRS in the presence of direct surface scattering at 532 nm. The methodology, system characterization, and feasibility of single-shot gas-phase FRS at 100 kHz or higher are presented and discussed.