Khashayar Sharifi
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Research Interests
Khashayar Sharifi has a total of 22 co-authors. Here are the top co-authors by number of shared publications:
- Ahmad Tavana
Department of Environment Pollution, Tonekabon Branch, Islamic Azad University, Tonekabon, Iran
1 shared publication Ali Akbar Miranbeigi
Research Institute of Petroleum Industry (RIPI)
1 shared publicationAli Ghaffari
Petroleum Refining Division, Research Institute of Petroleum Industry, Tehran, Iran
1 shared publication- Amir Hossein Mohammadi
Department of Mathematics, University of California, Berkeley, CA 94720, USA
1 shared publication - Aptin Rahnavard
Department of Environment, Tonekabon Branch Islamic Azad University Tonekabon Iran
1 shared publication - Farid Gholamreza Fahimi
Department of Environment Pollution, Tonekabon Branch, Islamic Azad University, Tonekabon, Iran
1 shared publication
Latest Publications
- 31 March 2022
- Published by Taylor & Francis in Soil and Sediment Contamination: An International Journal
- Vol. 32 (1) , 51-84
Ability of Urtica dioica L. to adsorb heavy metals (Pb, Cd, As, and Ni) from contaminated soils
Landfill leachate contains heavy metals that contaminate water and soil near the landfill site. Phytoremediation is a process of decontaminating soil or water by using native plants to adsorb and accumulate or break down pollutants. This study aimed to evaluate absorption and accumulation of heavy metals from simulated landfill soil by nettle. Nettle seeds were collected from the Tonekabon landfill site and planted in 243 pots. After reaching the 6-leaf stage, the plants were exposed to three concentrations of four heavy metals (Pb, Cd, As, and Ni) during the growing season. An atomic absorption spectrometer was used to measure the concentrations of the heavy metals in nettle plants and the morphological features of nettle fibers. The results showed that increases in the concentrations of the heavy metals in the soils led to their higher concentrations in all organs of the nettle plants (Pb> Ni> Cd> Ar), and larger quantities of the heavy metals were accumulated in the aerial parts of the plants. In parallel with this result, the dry weights of stem, leaf and root, and leaf area index also decreased. Values of TF> 1 and BAC <1 in plant organs showed the ability of nettle to accumulate more heavy metals when they were present at higher concentrations in the soil. Bioremediation using native plants for removal of heavy metals from soil and their accumulation in these plants is a low-cost and environmentally friendly technology. Nettle is a plant that grows wild in the landfills in northern Iran and, due to its ability to accumulative heavy metals in its organs, is a suitable plant species for their removal from soil.
- 31 March 2022
- Published by Taylor & Francis in Soil and Sediment Contamination: An International Journal
- Vol. 32 (1) , 51-84
Ability of Urtica dioica L. to adsorb heavy metals (Pb, Cd, As, and Ni) from contaminated soils
Landfill leachate contains heavy metals that contaminate water and soil near the landfill site. Phytoremediation is a process of decontaminating soil or water by using native plants to adsorb and accumulate or break down pollutants. This study aimed to evaluate absorption and accumulation of heavy metals from simulated landfill soil by nettle. Nettle seeds were collected from the Tonekabon landfill site and planted in 243 pots. After reaching the 6-leaf stage, the plants were exposed to three concentrations of four heavy metals (Pb, Cd, As, and Ni) during the growing season. An atomic absorption spectrometer was used to measure the concentrations of the heavy metals in nettle plants and the morphological features of nettle fibers. The results showed that increases in the concentrations of the heavy metals in the soils led to their higher concentrations in all organs of the nettle plants (Pb> Ni> Cd> Ar), and larger quantities of the heavy metals were accumulated in the aerial parts of the plants. In parallel with this result, the dry weights of stem, leaf and root, and leaf area index also decreased. Values of TF> 1 and BAC <1 in plant organs showed the ability of nettle to accumulate more heavy metals when they were present at higher concentrations in the soil. Bioremediation using native plants for removal of heavy metals from soil and their accumulation in these plants is a low-cost and environmentally friendly technology. Nettle is a plant that grows wild in the landfills in northern Iran and, due to its ability to accumulative heavy metals in its organs, is a suitable plant species for their removal from soil.
- 1 January 2018
- Published by Elsevier in Applied Thermal Engineering
- Vol. 128, 898-910
Computational fluid dynamics (CFD) technique to study the effects of helical wire inserts on heat transfer and pressure drop in a double pipe heat exchanger
- 1 January 2018
- Published by Elsevier in Applied Thermal Engineering
- Vol. 128, 898-910
Computational fluid dynamics (CFD) technique to study the effects of helical wire inserts on heat transfer and pressure drop in a double pipe heat exchanger
- 1 January 2018
- Published by Elsevier in Journal of Petroleum Science and Engineering
- Vol. 160, 393-400
Development of a Log-Log scaling law approach for prediction of asphaltene precipitation from crude oil by n-alkane titration
- 1 January 2018
- Published by Elsevier in Journal of Petroleum Science and Engineering
- Vol. 160, 393-400
Development of a Log-Log scaling law approach for prediction of asphaltene precipitation from crude oil by n-alkane titration
- 23 September 2017
- Published by Pleiades Publishing Ltd in Petroleum Chemistry
- Vol. 57 (10) , 874-880
A new experimental investigation on upgrading of waxy crude oils by methacrylate polymers
Several methods have been used to reduce problems caused by wax precipitation during the production and/or transportation of waxy crude oil. Polymers are used to improve pour point and rheological behavior of waxy crude oils. In this work, the influence of the polymer inhibitors such as methacrylate polymers, as wax inhibitor, with different range of molecular weight and alkyl side chain carbons on the rheological behavior and pour point of two Iranian waxy crude oils were evaluated. Two Iranian waxy crude oils were selected on the basis of wax and asphaltene contents. The rheological behavior of these crude oils in absence and in presence of methacrylate polymer was studied. The rheological data cover the temperature range of–1 to 12°C. The results indicated that the performance of methacrylate polymer was dependent on the molecular weight, alkyl side chain carbons and the asphaltene content of crude oil. Methacrylate polymers with longer alkyl side chains than 18 carbons would perform best as wax inhibitors in two cases. Also, for crude oil with low asphaltene, higher molecular weight methacrylate polymer is the best flow improver and lower molecular weight methacrylate polymer showed good efficiency for crude oil with high asphaltene content.
- 23 September 2017
- Published by Pleiades Publishing Ltd in Petroleum Chemistry
- Vol. 57 (10) , 874-880
A new experimental investigation on upgrading of waxy crude oils by methacrylate polymers
Several methods have been used to reduce problems caused by wax precipitation during the production and/or transportation of waxy crude oil. Polymers are used to improve pour point and rheological behavior of waxy crude oils. In this work, the influence of the polymer inhibitors such as methacrylate polymers, as wax inhibitor, with different range of molecular weight and alkyl side chain carbons on the rheological behavior and pour point of two Iranian waxy crude oils were evaluated. Two Iranian waxy crude oils were selected on the basis of wax and asphaltene contents. The rheological behavior of these crude oils in absence and in presence of methacrylate polymer was studied. The rheological data cover the temperature range of–1 to 12°C. The results indicated that the performance of methacrylate polymer was dependent on the molecular weight, alkyl side chain carbons and the asphaltene content of crude oil. Methacrylate polymers with longer alkyl side chains than 18 carbons would perform best as wax inhibitors in two cases. Also, for crude oil with low asphaltene, higher molecular weight methacrylate polymer is the best flow improver and lower molecular weight methacrylate polymer showed good efficiency for crude oil with high asphaltene content.
- 3 August 2017
- Published by Taylor & Francis in Petroleum Science and Technology
- Vol. 35 (15) , 1583-1587
Effect of the addition of oligo ester on the rheological properties of bitumen grade 80–100
Many problems have emerged in road construction due to insufficient adhesion and elasticity of asphalt layers as road surface. Adding polymer to bitumen can improve and modify asphalt properties. Oligo ester can be used as an additive to improve bitumen properties. Through reaction of recycled polyethylene terephthalate with dipropyleneglycol, oligo ester was produced during the glycolysis process. In this research, oligo ester was fabricated through glycolysis reaction. Then it was added to the bitumen grade 80–100 in 2 and 5 wt%. The end product was evaluated by standard test methods for ductility, softening point, penetration, and thermal behavior was measured by Thermal Gravimetric, Differential Thermal Gravimetric, and Differential Thermal Analysis. The results revealed that the addition of the above polymers to bitumen reduced penetration property and increased softening point and ductility. Also, thermal behavior of bitumen was modified.
- 3 August 2017
- Published by Taylor & Francis in Petroleum Science and Technology
- Vol. 35 (15) , 1583-1587
Effect of the addition of oligo ester on the rheological properties of bitumen grade 80–100
Many problems have emerged in road construction due to insufficient adhesion and elasticity of asphalt layers as road surface. Adding polymer to bitumen can improve and modify asphalt properties. Oligo ester can be used as an additive to improve bitumen properties. Through reaction of recycled polyethylene terephthalate with dipropyleneglycol, oligo ester was produced during the glycolysis process. In this research, oligo ester was fabricated through glycolysis reaction. Then it was added to the bitumen grade 80–100 in 2 and 5 wt%. The end product was evaluated by standard test methods for ductility, softening point, penetration, and thermal behavior was measured by Thermal Gravimetric, Differential Thermal Gravimetric, and Differential Thermal Analysis. The results revealed that the addition of the above polymers to bitumen reduced penetration property and increased softening point and ductility. Also, thermal behavior of bitumen was modified.
- 18 April 2017
- Published by Taylor & Francis in Petroleum Science and Technology
- Vol. 35 (8) , 768-774
An experimental study on the effects of temperature and asphaltene content on the rheological behavior of vacuum residues
- 18 April 2017
- Published by Taylor & Francis in Petroleum Science and Technology
- Vol. 35 (8) , 768-774
An experimental study on the effects of temperature and asphaltene content on the rheological behavior of vacuum residues
- 1 December 2012
- Published by Elsevier in Energy Conversion and Management
- Vol. 64, 344-350
CFD modeling of fouling in crude oil pre-heaters
- 1 December 2012
- Published by Elsevier in Energy Conversion and Management
- Vol. 64, 344-350
CFD modeling of fouling in crude oil pre-heaters