K. A. Filippov
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
K. A. Filippov has a total of 84 co-authors. Here are the top co-authors by number of shared publications:
- Peter E. Teterin
Kovrov State Technol Acad, Phys Dept, Kovrov, Vladimir Region, Russia
8 shared publications - Vladimir.O Tikhomirov
CERN
8 shared publications A Romaniouk
National Research Nuclear University MEPhI (Moscow Engineering Physics Institute), Kashirskoe highway 31, Moscow, 115409, Russia
5 shared publications- S. Yu. Smirnov
CERN
5 shared publications D Shchukin
National Research Nuclear University MEPhI (Moscow Engineering Physics Institute), Kashirskoe highway 31, Moscow, 115409, Russia
3 shared publications- Daniil Ponomarenko
Indiana University
3 shared publications
Latest Publications
- 1 August 2019
- Published by Elsevier in Nuclear Instruments and Methods in Physics Research Section A: Accelerators, Spectrometers, Detectors and Associated Equipment
- Vol. 936, 523-526
First measurements of the spectral and angular distribution of transition radiation using a silicon pixel sensor on a Timepix3 chip
- 1 August 2019
- Published by Elsevier in Nuclear Instruments and Methods in Physics Research Section A: Accelerators, Spectrometers, Detectors and Associated Equipment
- Vol. 936, 523-526
First measurements of the spectral and angular distribution of transition radiation using a silicon pixel sensor on a Timepix3 chip
- 1 May 2019
- Published by Elsevier in Nuclear Instruments and Methods in Physics Research Section A: Accelerators, Spectrometers, Detectors and Associated Equipment
- Vol. 927, 1-13
Identification of particles with Lorentz factor up to with Transition Radiation Detectors based on micro-strip silicon detectors- 1 May 2019
- Published by Elsevier in Nuclear Instruments and Methods in Physics Research Section A: Accelerators, Spectrometers, Detectors and Associated Equipment
- Vol. 927, 1-13
Identification of particles with Lorentz factor up to with Transition Radiation Detectors based on micro-strip silicon detectors- 27 September 2018
- Published by Pleiades Publishing Ltd in Instruments and Experimental Techniques
- Vol. 61 (5) , 658-664
Computer Simulation of a Transition-Radiation Detector Prototype Based on Straw Proportional Chambers
A prototype of a transition radiation detector based on straw proportional chambers has been tested at the CERN SPS accelerator beams. A detailed Monte Carlo simulation program has been developed to...
- 27 September 2018
- Published by Pleiades Publishing Ltd in Instruments and Experimental Techniques
- Vol. 61 (5) , 658-664
Computer Simulation of a Transition-Radiation Detector Prototype Based on Straw Proportional Chambers
A prototype of a transition radiation detector based on straw proportional chambers has been tested at the CERN SPS accelerator beams. A detailed Monte Carlo simulation program has been developed to...
- Open Access
- 20 December 2017
- Published by IOP Publishing in Journal of Physics: Conference Series
- Vol. 934 (1) , 012053
Test beam studies of possibilities to separate particles with gamma factors above 103with straw based Transition Radiation Detector
Measurements of hadron production in the TeV energy range are one of the tasks of the future studies at the Large Hadron Collider (LHC). The main goal of these experiments is a study of the fundamental QCD processes at this energy range, which is very important not only for probing of the Standard Model but also for ultrahigh-energy cosmic particle physics. One of the key elements of these experiments measurements are hadron identification. The only detector technology which has a potential ability to separate hadrons in this energy range is Transition Radiation Detector (TRD) technology. TRD prototype based on straw proportional chambers combined with a specially assembled radiator has been tested at the CERN SPS accelerator beam. The test beam results and comparison with detailed Monte Carlo simulations are presented here.
- 20 December 2017
- Published by IOP Publishing in Journal of Physics: Conference Series
- Vol. 934 (1) , 012053
Open AccessTest beam studies of possibilities to separate particles with gamma factors above 103with straw based Transition Radiation Detector
Measurements of hadron production in the TeV energy range are one of the tasks of the future studies at the Large Hadron Collider (LHC). The main goal of these experiments is a study of the fundamental QCD processes at this energy range, which is very important not only for probing of the Standard Model but also for ultrahigh-energy cosmic particle physics. One of the key elements of these experiments measurements are hadron identification. The only detector technology which has a potential ability to separate hadrons in this energy range is Transition Radiation Detector (TRD) technology. TRD prototype based on straw proportional chambers combined with a specially assembled radiator has been tested at the CERN SPS accelerator beam. The test beam results and comparison with detailed Monte Carlo simulations are presented here.
- Open Access
- 20 December 2017
- Published by IOP Publishing in Journal of Physics: Conference Series
- Vol. 934 (1) , 012049
Measurements of angular distribution and spectrum of transition radiation with a GridPix detector
In recent years, developments of gaseous detectors based on a combination of electron multiplication gap in the gas and pixel readout chips as a part of the anode plane (GasPixel detectors) reached a level where they can offer unique opportunities for particle detection. Transition radiation (TR) detectors based on this technology can be one of the possible applications. In this work, measurements of energy spectra and angular distributions of transition radiation photons produced by particles with different gamma factors made with a GridPix detector prototype are presented. The observed results are compared with theoretical predictions.
- 20 December 2017
- Published by IOP Publishing in Journal of Physics: Conference Series
- Vol. 934 (1) , 012049
Open AccessMeasurements of angular distribution and spectrum of transition radiation with a GridPix detector
In recent years, developments of gaseous detectors based on a combination of electron multiplication gap in the gas and pixel readout chips as a part of the anode plane (GasPixel detectors) reached a level where they can offer unique opportunities for particle detection. Transition radiation (TR) detectors based on this technology can be one of the possible applications. In this work, measurements of energy spectra and angular distributions of transition radiation photons produced by particles with different gamma factors made with a GridPix detector prototype are presented. The observed results are compared with theoretical predictions.
- Open Access
- 5 February 2016
- Published by IOP Publishing in Journal of Physics: Conference Series
- Vol. 675 (1) , 012024
Gas mixtures for quality control of the sTGC chambers
STGC chambers are designed to operate at super-LHC conditions and will be installed in place during Phase-I upgrade of the ATLAS muon spectrometer. These chambers will provide precise coordinate measurements of the charged particle tracks and level 1 trigger for high pT muons. It is critical for the ATLAS detector to ensure a robust operation of these chambers during entire sLHC period. A quality control procedure based on X-ray scanner is being developed. Choice of the active gas for these tests is a very important issue. On one hand it should allow to find different types of chamber production defects, on the other hand one has to be sure that found problems are essential for the detector operation in future. Studies of the operation of the sTGC chamber prototype under X-ray irradiation with two gas mixtures (n- pentane/CO2 and CO2) were performed. The prototype was irradiated by X-rays with energy up to 50 keV. Particular attention was paid to the study of the "hot" chamber regions.
- 5 February 2016
- Published by IOP Publishing in Journal of Physics: Conference Series
- Vol. 675 (1) , 012024
Open AccessGas mixtures for quality control of the sTGC chambers
STGC chambers are designed to operate at super-LHC conditions and will be installed in place during Phase-I upgrade of the ATLAS muon spectrometer. These chambers will provide precise coordinate measurements of the charged particle tracks and level 1 trigger for high pT muons. It is critical for the ATLAS detector to ensure a robust operation of these chambers during entire sLHC period. A quality control procedure based on X-ray scanner is being developed. Choice of the active gas for these tests is a very important issue. On one hand it should allow to find different types of chamber production defects, on the other hand one has to be sure that found problems are essential for the detector operation in future. Studies of the operation of the sTGC chamber prototype under X-ray irradiation with two gas mixtures (n- pentane/CO2 and CO2) were performed. The prototype was irradiated by X-rays with energy up to 50 keV. Particular attention was paid to the study of the "hot" chamber regions.
- Open Access
- 5 February 2016
- Published by IOP Publishing in Journal of Physics: Conference Series
- Vol. 675 (1) , 012018
Visualization tool for X-ray scanner for sTGC detector production quality control
The ATLAS experiment at the Large Hadron Collider has an ambitious program of the detector upgrade to meet an expected rise of accelerator luminosity. The first large system which supposed to be installed in 2019 is the New Small Wheel (NSW) for ATLAS muon spectrometer. In order to ensure high quality and reliability of NSW chambers an X-ray scanning technique is being developed. One of the main components of the X-ray scanner is a special software visualization tool which would allow a fast and clear representation of scanning results and an identification of possible chamber defects.
- 5 February 2016
- Published by IOP Publishing in Journal of Physics: Conference Series
- Vol. 675 (1) , 012018
Open AccessVisualization tool for X-ray scanner for sTGC detector production quality control
The ATLAS experiment at the Large Hadron Collider has an ambitious program of the detector upgrade to meet an expected rise of accelerator luminosity. The first large system which supposed to be installed in 2019 is the New Small Wheel (NSW) for ATLAS muon spectrometer. In order to ensure high quality and reliability of NSW chambers an X-ray scanning technique is being developed. One of the main components of the X-ray scanner is a special software visualization tool which would allow a fast and clear representation of scanning results and an identification of possible chamber defects.
- Open Access
- 5 February 2016
- Published by IOP Publishing in Journal of Physics: Conference Series
- Vol. 675 (1) , 012015
Development of scanning technique for sTGC detectors production quality control
The innermost station of the ATLAS muon end-cap system will be replaced during the forthcoming Phase-I upgrade of the ATLAS detector. The small-strip Thin Gap Chambers (sTGC) are supposed to operate at harsh radiation conditions of super LHC. X-ray scanning technique for production quality control is proposed to ensure long-term reliability of these chambers. It allows to reveal different types of technological defects critical for sTGC chambers operation.
- 5 February 2016
- Published by IOP Publishing in Journal of Physics: Conference Series
- Vol. 675 (1) , 012015
Open AccessDevelopment of scanning technique for sTGC detectors production quality control
The innermost station of the ATLAS muon end-cap system will be replaced during the forthcoming Phase-I upgrade of the ATLAS detector. The small-strip Thin Gap Chambers (sTGC) are supposed to operate at harsh radiation conditions of super LHC. X-ray scanning technique for production quality control is proposed to ensure long-term reliability of these chambers. It allows to reveal different types of technological defects critical for sTGC chambers operation.