Ribhu Gautam
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Ribhu Gautam has a total of 97 co-authors. Here are the top co-authors by number of shared publications:
- Ravikrishnan Vinu
Department of Chemical Engineering, Indian Institute of Technology Madras, Chennai, India
9 shared publications - Subram Mani Sarathy
Clean Energy Research Platform, Physical Sciences and Engineering (PSE) Division, King Abdullah University of Science and Technology (KAUST), Thuwal 23955-6900, Saudi Arabia
7 shared publications - Ramanujam Sarathi
Department of Electrical Engineering Indian Institute of Technology Chennai India
6 shared publications S. Mani Sarathy
6 shared publications- Mohammed AlAbbad
Clean Combustion Research Center, Physical Sciences and Engineering Division, King Abdullah University of Science and Technology (KAUST), Thuwal, Saudi Arabia
5 shared publications Jeffrey W. Kloosterman
Air Prod & Chem Inc, Allentown, PA USA
4 shared publications
Latest Publications
- Open Access
- 10 October 2026
- Published by Elsevier in SSRN Electronic Journal
Multi-Stage Isothermal Fractionation of a Type II-S Oil Shale: Decoupling Mineral-Matrix Kinetics, H2S Evolution, and Steam-Intensified Syngas Production
Type II-S oil shale carries sulfur in thermolytically weak C–S and S–S linkages, causing H2S co-evolution that complicates conventional non-isothermal retorting. This work applies a four-stage (multi-stage) isothermal fractionation (MS-IF) protocol (100, 350, 550 and 850 °C) to a Jordanian Al-Lajjun oil shale under dry and steam-intensified atmospheres, benchmarked against single-stage pyrolysis coupled to real-time gas speciation with solid- and liquid-phase characterization. Thermogravimetric analyses of fresh, demineralized, Fe-spiked demineralized and Ca-spiked demineralized matrices were performed at multiple heating rates. When resolved by constrained Fraser-Suzuki deconvolution and validated by dual isoconversional methods (Friedman, Starink). Two organic devolatilization events (mass-weighted activation energy 170.6 kJ mol−1) were isolated from a diffusion-controlled carbonate-decomposition event that dominates the bulk mass-loss profile. The native mineral matrix lowers the organic activation energy by 20–30 kJ mol−1, while independently obtained (Ea, ln A) pairs reveal a kinetic compensation effect (isokinetic temperature ≈ 296 °C) explaining why calcium carbonate addition raises, rather than lowers, peak decomposition temperature despite reducing the barrier. Dry MS-IF achieves 8.7% more mass loss than single-stage pyrolysis at equal peak temperature, and resolves two mechanistically distinct H2S release windows around 380 °C and 450 °C. Steam co-feeding advances sulfur mobilization to lower temperature and drives a strong water-gas shift, increasing H2 yield up to 16-fold at high temperatures. Liquid condensates remain organosulfur-dominated (47–63%), with the 350 °C stage identified as sulfur-selective. These findings establish MS-IF as a mechanistic and process framework for decoupling volatile sulfur evolution and liquid organosulfur partitioning from hydrocarbon and syngas generation in high-sulfur oil shale valorization.
- 10 October 2026
- Published by Elsevier in SSRN Electronic Journal
Open AccessMulti-Stage Isothermal Fractionation of a Type II-S Oil Shale: Decoupling Mineral-Matrix Kinetics, H2S Evolution, and Steam-Intensified Syngas Production
Type II-S oil shale carries sulfur in thermolytically weak C–S and S–S linkages, causing H2S co-evolution that complicates conventional non-isothermal retorting. This work applies a four-stage (multi-stage) isothermal fractionation (MS-IF) protocol (100, 350, 550 and 850 °C) to a Jordanian Al-Lajjun oil shale under dry and steam-intensified atmospheres, benchmarked against single-stage pyrolysis coupled to real-time gas speciation with solid- and liquid-phase characterization. Thermogravimetric analyses of fresh, demineralized, Fe-spiked demineralized and Ca-spiked demineralized matrices were performed at multiple heating rates. When resolved by constrained Fraser-Suzuki deconvolution and validated by dual isoconversional methods (Friedman, Starink). Two organic devolatilization events (mass-weighted activation energy 170.6 kJ mol−1) were isolated from a diffusion-controlled carbonate-decomposition event that dominates the bulk mass-loss profile. The native mineral matrix lowers the organic activation energy by 20–30 kJ mol−1, while independently obtained (Ea, ln A) pairs reveal a kinetic compensation effect (isokinetic temperature ≈ 296 °C) explaining why calcium carbonate addition raises, rather than lowers, peak decomposition temperature despite reducing the barrier. Dry MS-IF achieves 8.7% more mass loss than single-stage pyrolysis at equal peak temperature, and resolves two mechanistically distinct H2S release windows around 380 °C and 450 °C. Steam co-feeding advances sulfur mobilization to lower temperature and drives a strong water-gas shift, increasing H2 yield up to 16-fold at high temperatures. Liquid condensates remain organosulfur-dominated (47–63%), with the 350 °C stage identified as sulfur-selective. These findings establish MS-IF as a mechanistic and process framework for decoupling volatile sulfur evolution and liquid organosulfur partitioning from hydrocarbon and syngas generation in high-sulfur oil shale valorization.
- Open Access
- 18 March 2026
- Published by Elsevier in Applications in Energy and Combustion Science
- Vol. 26
A study on the products from co-pyrolysis of fruit waste with high density polyethylene
- 18 March 2026
- Published by Elsevier in Applications in Energy and Combustion Science
- Vol. 26
Open AccessA study on the products from co-pyrolysis of fruit waste with high density polyethylene
- Open Access
- 31 October 2025
- Published by American Chemical Society (ACS) in ACS Omega
- Vol. 10 (44) , 52783-52793
Valorization of Cyanidioschyzon merolae via Mixed Air/Steam/CO 2 Gasification: Syngas Evolution and Tar Molecular Insights
The accelerated research and scale-up of microalgal processesespecially those involving genetically modified (GM) strainsfor producing high-value specialty chemicals will generate biomass residues with limited disposal routes. To extract value from these GM waste streams, thermochemical conversion can transform them into useful energy products. In particular, gasification is a promising destructive pathway for the generation of biosyngas. However, several aspects remain underexplored, including the effect of introducing steam and CO2 in the gasifying agent on the evolution and characteristics of syngas and tar. This study explored the gasification of dried GM Cyanidioschyzon merolae biomass under mixed air/steam/CO2 atmospheres in a fixed-bed tubular reactor at 850–1000 °C. In addition to analyzing the syngas yields and composition, the resulting tar was comprehensively characterized by GC–MS and FT-ICR-MS to elucidate its molecular structure. It was found that steam injection significantly enhanced syngas quality, increasing the H2/CO ratio up to 1.5 at 1000 °C; however, it also led to higher tar yields. In contrast, introducing CO2 in the gasifying medium reduced syngas yields. Across all conditions, tar samples predominantly featured condensed aromatic structures (350–450 Da, DBE/C > 0.7). Higher temperatures strongly influenced tar chemistry by promoting the formation of single nitrogen-containing aromatics and pure aromatic hydrocarbons. However, across the gasifying atmospheres tested, tar composition remained similar. These findings offer molecular-level insights into how steam and CO2 influence product distribution and tar chemistry during microalgae gasification, informing future strategies for tar mitigation and process optimization.
- 31 October 2025
- Published by American Chemical Society (ACS) in ACS Omega
- Vol. 10 (44) , 52783-52793
Open AccessValorization of Cyanidioschyzon merolae via Mixed Air/Steam/CO 2 Gasification: Syngas Evolution and Tar Molecular Insights
The accelerated research and scale-up of microalgal processesespecially those involving genetically modified (GM) strainsfor producing high-value specialty chemicals will generate biomass residues with limited disposal routes. To extract value from these GM waste streams, thermochemical conversion can transform them into useful energy products. In particular, gasification is a promising destructive pathway for the generation of biosyngas. However, several aspects remain underexplored, including the effect of introducing steam and CO2 in the gasifying agent on the evolution and characteristics of syngas and tar. This study explored the gasification of dried GM Cyanidioschyzon merolae biomass under mixed air/steam/CO2 atmospheres in a fixed-bed tubular reactor at 850–1000 °C. In addition to analyzing the syngas yields and composition, the resulting tar was comprehensively characterized by GC–MS and FT-ICR-MS to elucidate its molecular structure. It was found that steam injection significantly enhanced syngas quality, increasing the H2/CO ratio up to 1.5 at 1000 °C; however, it also led to higher tar yields. In contrast, introducing CO2 in the gasifying medium reduced syngas yields. Across all conditions, tar samples predominantly featured condensed aromatic structures (350–450 Da, DBE/C > 0.7). Higher temperatures strongly influenced tar chemistry by promoting the formation of single nitrogen-containing aromatics and pure aromatic hydrocarbons. However, across the gasifying atmospheres tested, tar composition remained similar. These findings offer molecular-level insights into how steam and CO2 influence product distribution and tar chemistry during microalgae gasification, informing future strategies for tar mitigation and process optimization.
- 11 May 2025
- Published by Elsevier in Journal of Analytical and Applied Pyrolysis
- Vol. 191
Linking microalgae characteristics with their fast pyrolysis products
- 11 May 2025
- Published by Elsevier in Journal of Analytical and Applied Pyrolysis
- Vol. 191
Linking microalgae characteristics with their fast pyrolysis products
- 17 January 2024
- Published by Elsevier in Thermal Science and Engineering Progress
- Vol. 48
Effect of water vapor on the oxidation of heavy fuel and vacuum residue oil in a TGA
- 17 January 2024
- Published by Elsevier in Thermal Science and Engineering Progress
- Vol. 48
Effect of water vapor on the oxidation of heavy fuel and vacuum residue oil in a TGA
- 25 July 2023
- Published by Taylor & Francis in Combustion Science and Technology
- Vol. 195 (14) , 3372-3384
Effect of Biphenyl, Acetylene and Carbon Dioxide on Benzene Pyrolysis at Intermediate Temperatures
- 25 July 2023
- Published by Taylor & Francis in Combustion Science and Technology
- Vol. 195 (14) , 3372-3384
Effect of Biphenyl, Acetylene and Carbon Dioxide on Benzene Pyrolysis at Intermediate Temperatures
- Open Access
- 24 July 2023
- Published by Royal Society of Chemistry (RSC) in Sustainable Energy & Fuels
- Vol. 7 (17) , 4213-4228
Interactions in co-pyrolysis of Salicornia bigelovii and heavy fuel oil
The interactions in the co-pyrolysis of biomass from Salicornia bigelovii (SB) with heavy fuel oil (HFO) were studied through an investigation of the yields, kinetics, and the quality of bio-oil and biochar produced.
- 24 July 2023
- Published by Royal Society of Chemistry (RSC) in Sustainable Energy & Fuels
- Vol. 7 (17) , 4213-4228
Open AccessInteractions in co-pyrolysis of Salicornia bigelovii and heavy fuel oil
The interactions in the co-pyrolysis of biomass from Salicornia bigelovii (SB) with heavy fuel oil (HFO) were studied through an investigation of the yields, kinetics, and the quality of bio-oil and biochar produced.