Taha A. Khalaf
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Taha A. Khalaf has a total of 17 co-authors. Here are the top co-authors by number of shared publications:
- Mohammed Younis Abdelsadek
Department of Systems and Computer Engineering, Non-Terrestrial Networks Lab, Carleton University, ON K1S 5B6, Ottawa, Canada
2 shared publications - Ahmed Tohamy
Electrical Engineering Department, Faculty of Engineering, Assiut University, Assiut, Egypt
1 shared publication - Anas Aljohani
University of Tabuk
1 shared publication Hazem Mohammed
Department of Electrical Engineering, Assiut University, Assiut, 71516, Egypt
1 shared publication- Kasra Ghasemi
School of Engineering, University of Guelph
1 shared publication - Khalid Alshahrani
University of Tabuk
1 shared publication
Latest Publications
- 10 February 2026
- Published by Taylor & Francis in Heat Transfer Engineering
- p. 1-20
Advanced Thermal Management for Electric Vehicle Batteries Using High Thermal Capacity Slurry
- 10 February 2026
- Published by Taylor & Francis in Heat Transfer Engineering
- p. 1-20
Advanced Thermal Management for Electric Vehicle Batteries Using High Thermal Capacity Slurry
- Open Access
- 1 March 2023
- Published by Institute of Advanced Engineering and Science in Indonesian Journal of Electrical Engineering and Computer Science
- Vol. 29 (3) , 1412-1422
Smart fuzzy logic control of photovoltaic system: case study Kingdom of Saudi Arabia
Robust controls of photovoltaic (PV) system applications that include modular multilevel inverter (MMI) for interfacing stand-alone and gridconnected operating modes are investigated in this paper to overcome interfacing problems of two-level and three-level inverters. The MMI provides high-quality voltage, current, and power signals without additional filters, which reduces complexity and cost of interface circuits. A new control method of active and reactive power has been introduced for PV systems to get maximum power point (MPP) in various climatic circumstances. The steady-state and dynamic performances of MMI are investigated using MATLAB/Simulink. A fuzzy logic control is proposed to track the MPP utilizing the perturb and observe (P&O) technique. A fair comparison between fuzzy logic control and proportional integral (PI) control was conducted using MATLAB/Simulink. The fuzzy logic controller for obtaining MPPT by P&O method is proposed to get fast and accurate results. The obtained results obvioused that the fuzzy logic controller is quick accessing MPP than PI controller. A simple LC filter can achieve minimum harmonics provided by total harmonic distortion (THD) of MMI within IEEE limit. The PV system for standalone and grid-connected modes is being tested under climatic conditions in the city of Tabuk, Kingdom of Saudi Arabia (KSA).
- 1 March 2023
- Published by Institute of Advanced Engineering and Science in Indonesian Journal of Electrical Engineering and Computer Science
- Vol. 29 (3) , 1412-1422
Open AccessSmart fuzzy logic control of photovoltaic system: case study Kingdom of Saudi Arabia
Robust controls of photovoltaic (PV) system applications that include modular multilevel inverter (MMI) for interfacing stand-alone and gridconnected operating modes are investigated in this paper to overcome interfacing problems of two-level and three-level inverters. The MMI provides high-quality voltage, current, and power signals without additional filters, which reduces complexity and cost of interface circuits. A new control method of active and reactive power has been introduced for PV systems to get maximum power point (MPP) in various climatic circumstances. The steady-state and dynamic performances of MMI are investigated using MATLAB/Simulink. A fuzzy logic control is proposed to track the MPP utilizing the perturb and observe (P&O) technique. A fair comparison between fuzzy logic control and proportional integral (PI) control was conducted using MATLAB/Simulink. The fuzzy logic controller for obtaining MPPT by P&O method is proposed to get fast and accurate results. The obtained results obvioused that the fuzzy logic controller is quick accessing MPP than PI controller. A simple LC filter can achieve minimum harmonics provided by total harmonic distortion (THD) of MMI within IEEE limit. The PV system for standalone and grid-connected modes is being tested under climatic conditions in the city of Tabuk, Kingdom of Saudi Arabia (KSA).
- Open Access
- 24 August 2020
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Access
- Vol. 8, 156408-156421
Cooperative Spectrum Sensing Using Maximum a Posteriori as a Detection Technique for Dynamic Spectrum Access Networks
Over the past few years, dynamic spectrum access has been gaining an increasing attention as a solution to the spectrum scarcity problem. In this paper, a primary user detection technique based on Maximum A Posteriori estimation is proposed for dynamic spectrum access networks. In the proposed technique, a set of secondary users acting as sensing nodes send their individual decisions about the existence of the primary user to a central fusion center. The fusion center uses the received data to form a codeword then, applies the maximum a posteriori estimation rule to make a final decision regarding the presence of the primary user. The proposed technique takes into consideration the accuracy of the local decisions provided by the secondary users when making a final decision. In this paper, we analyze the performance of the proposed scheme and derive closed-form expressions for the upper bounds of the false alarm and misdetection probabilities. The results show that the proposed technique outperforms other combining techniques in terms of its ability to detect the primary user and, accordingly, minimizes the harmful interference to the licensed network. Moreover, the proposed technique achieves better performance at a lower number of reporting secondary users which compensates for the complexity of the maximum a posteriori estimation.
- 24 August 2020
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Access
- Vol. 8, 156408-156421
Open AccessCooperative Spectrum Sensing Using Maximum a Posteriori as a Detection Technique for Dynamic Spectrum Access Networks
Over the past few years, dynamic spectrum access has been gaining an increasing attention as a solution to the spectrum scarcity problem. In this paper, a primary user detection technique based on Maximum A Posteriori estimation is proposed for dynamic spectrum access networks. In the proposed technique, a set of secondary users acting as sensing nodes send their individual decisions about the existence of the primary user to a central fusion center. The fusion center uses the received data to form a codeword then, applies the maximum a posteriori estimation rule to make a final decision regarding the presence of the primary user. The proposed technique takes into consideration the accuracy of the local decisions provided by the secondary users when making a final decision. In this paper, we analyze the performance of the proposed scheme and derive closed-form expressions for the upper bounds of the false alarm and misdetection probabilities. The results show that the proposed technique outperforms other combining techniques in terms of its ability to detect the primary user and, accordingly, minimizes the harmful interference to the licensed network. Moreover, the proposed technique achieves better performance at a lower number of reporting secondary users which compensates for the complexity of the maximum a posteriori estimation.
- Open Access
- 9 January 2020
- Published by Springer Nature in EURASIP Journal on Wireless Communications and Networking
- Vol. 2020 (1) , 1-13
Bit error rate performance analysis of AC-MAP in multiple input single output wireless relay network
In this paper, we propose a joint decoding scheme called AC-MAP decoder for multiple input single output (MISO) wireless cooperative communication network that consists of single source, single relay, and single destination. The proposed scheme is based on both Alamouti combining (AC) scheme and maximum a posteriori (MAP) decoder and is used to estimate the data at the destination. The AC-MAP decoder is optimal in the sense that it minimizes the end-to-end bit error rate (BER). In order to analyze performance of the proposed decoder, we derive a closed form expression for the upper bound (UB) on the end-to-end error probability. Distances between system nodes, transmit energy, and channel noise and fading effects are considered in the derivation of the UB. Numerical results show that the closed form UB is very tight and it almost coincides with the exact BER results obtained from simulations. Therefore, we use the derived UB expression to study the effects of the relay position on the BER performance and to find the optimal location of the relay node.
- 9 January 2020
- Published by Springer Nature in EURASIP Journal on Wireless Communications and Networking
- Vol. 2020 (1) , 1-13
Open AccessBit error rate performance analysis of AC-MAP in multiple input single output wireless relay network
In this paper, we propose a joint decoding scheme called AC-MAP decoder for multiple input single output (MISO) wireless cooperative communication network that consists of single source, single relay, and single destination. The proposed scheme is based on both Alamouti combining (AC) scheme and maximum a posteriori (MAP) decoder and is used to estimate the data at the destination. The AC-MAP decoder is optimal in the sense that it minimizes the end-to-end bit error rate (BER). In order to analyze performance of the proposed decoder, we derive a closed form expression for the upper bound (UB) on the end-to-end error probability. Distances between system nodes, transmit energy, and channel noise and fading effects are considered in the derivation of the UB. Numerical results show that the closed form UB is very tight and it almost coincides with the exact BER results obtained from simulations. Therefore, we use the derived UB expression to study the effects of the relay position on the BER performance and to find the optimal location of the relay node.
- Open Access
- 30 December 2015
- Published by Wiley in International Journal of Antennas and Propagation
- Vol. 2015, 1-7
Compressed Measurements Based Spectrum Sensing for Wideband Cognitive Radio Systems
Spectrum sensing is the most important component in the cognitive radio (CR) technology. Spectrum sensing has considerable technical challenges, especially in wideband systems where higher sampling rates are required which increases the complexity and the power consumption of the hardware circuits. Compressive sensing (CS) is successfully deployed to solve this problem. Although CS solves the higher sampling rate problem, it does not reduce complexity to a large extent. Spectrum sensing via CS technique is performed in three steps: sensing compressed measurements, reconstructing the Nyquist rate signal, and performing spectrum sensing on the reconstructed signal. Compressed detectors perform spectrum sensing from the compressed measurements skipping the reconstruction step which is the most complex step in CS. In this paper, we propose a novel compressed detector using energy detection technique on compressed measurements sensed by the discrete cosine transform (DCT) matrix. The proposed algorithm not only reduces the computational complexity but also provides a better performance than the traditional energy detector and the traditional compressed detector in terms of the receiver operating characteristics. We also derive closed form expressions for the false alarm and detection probabilities. Numerical results show that the analytical expressions coincide with the exact probabilities obtained from simulations.
- 30 December 2015
- Published by Wiley in International Journal of Antennas and Propagation
- Vol. 2015, 1-7
Open AccessCompressed Measurements Based Spectrum Sensing for Wideband Cognitive Radio Systems
Spectrum sensing is the most important component in the cognitive radio (CR) technology. Spectrum sensing has considerable technical challenges, especially in wideband systems where higher sampling rates are required which increases the complexity and the power consumption of the hardware circuits. Compressive sensing (CS) is successfully deployed to solve this problem. Although CS solves the higher sampling rate problem, it does not reduce complexity to a large extent. Spectrum sensing via CS technique is performed in three steps: sensing compressed measurements, reconstructing the Nyquist rate signal, and performing spectrum sensing on the reconstructed signal. Compressed detectors perform spectrum sensing from the compressed measurements skipping the reconstruction step which is the most complex step in CS. In this paper, we propose a novel compressed detector using energy detection technique on compressed measurements sensed by the discrete cosine transform (DCT) matrix. The proposed algorithm not only reduces the computational complexity but also provides a better performance than the traditional energy detector and the traditional compressed detector in terms of the receiver operating characteristics. We also derive closed form expressions for the false alarm and detection probabilities. Numerical results show that the analytical expressions coincide with the exact probabilities obtained from simulations.
- Open Access
- 1 May 2014
- Published by Egyptian Knowledge Bank in JES. Journal of Engineering Sciences
- Vol. 42 (3) , 746-755
COMPRESSED MEASUREMENTS BASED CYCLOSTATIONARY DETECTOR FOR WIDEBAND COGNITIVE RADIOS
Cyclostationary feature detection is one of the most powerful spectrum sensing techniquesused for cognitive radio (CR) systems. This is because of its robustness against noiseuncertainties. However, this technique needs high sampling rates, which is limited by thestate-of the-art analog to digital converters (ADCs), especially in wideband regime.Comressive sensing (CS) was used by many researchers for solving this problem viasub-Nyquist sampling rates. However CS solves the high sampling rate problem, but it doesnot reduce complexity considerably. This is because spectrum sensing is performed in threesteps: sensing compressed measurements, then reconstructing the Nyquist rate signal, andfinally performing cyclostationary detection (CD) on the reconstructed signal. In this paperwe suggest performing CD directly on the compressed measurements skipping thereconstruction step which is the most complex step in CS. This can be realized by designingthe sensing matrix with constraints different from those used in the conventional CS. Resultsshow that performance is improved relative to applying CD on the Nyquist rate signal. Thisis in addition to reduction in receiver complexity resulting from reducing sampling rates. Adetection probability of 78.7% can be achieved with only 7% of samples used by theconventional cyclostationary detection technique that achieves a detection probability of32.7%.
- 1 May 2014
- Published by Egyptian Knowledge Bank in JES. Journal of Engineering Sciences
- Vol. 42 (3) , 746-755
Open AccessCOMPRESSED MEASUREMENTS BASED CYCLOSTATIONARY DETECTOR FOR WIDEBAND COGNITIVE RADIOS
Cyclostationary feature detection is one of the most powerful spectrum sensing techniquesused for cognitive radio (CR) systems. This is because of its robustness against noiseuncertainties. However, this technique needs high sampling rates, which is limited by thestate-of the-art analog to digital converters (ADCs), especially in wideband regime.Comressive sensing (CS) was used by many researchers for solving this problem viasub-Nyquist sampling rates. However CS solves the high sampling rate problem, but it doesnot reduce complexity considerably. This is because spectrum sensing is performed in threesteps: sensing compressed measurements, then reconstructing the Nyquist rate signal, andfinally performing cyclostationary detection (CD) on the reconstructed signal. In this paperwe suggest performing CD directly on the compressed measurements skipping thereconstruction step which is the most complex step in CS. This can be realized by designingthe sensing matrix with constraints different from those used in the conventional CS. Resultsshow that performance is improved relative to applying CD on the Nyquist rate signal. Thisis in addition to reduction in receiver complexity resulting from reducing sampling rates. Adetection probability of 78.7% can be achieved with only 7% of samples used by theconventional cyclostationary detection technique that achieves a detection probability of32.7%.