Malgorzata Pilawska
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Research Interests
Malgorzata Pilawska has a total of 27 co-authors. Here are the top co-authors by number of shared publications:
- Witold Żukowski
Faculty of Chemical Engineering and Technology, Cracow University of Technology, Warszawska 24, 31-155 Cracow, Poland
6 shared publications - Jerzy Baron
Faculty of Chemical Engineering and Technology , Cracow University of Technology , ul. Warszawska 24, 31-155 Kraków , Poland , phone +48 12 628 27 66
5 shared publications S. Kandefer
3 shared publicationsE.M. Bulewicz
2 shared publicationsG. X. Yue
Tsinghua University
2 shared publicationsJ. F. Lu
Tsinghua University
2 shared publications
Latest Publications
- 1 May 2009
- Published by Elsevier in Combustion and Flame
- Vol. 156 (5) , 975-984
Combustion of hydrogen in a bubbling fluidized bed
- 1 May 2009
- Published by Elsevier in Combustion and Flame
- Vol. 156 (5) , 975-984
Combustion of hydrogen in a bubbling fluidized bed
- 1 January 2009
- Published by Springer Nature
- p. 953-959
Destruction of N2O over Different Bed Materials
- 1 September 2006
- Published by Taylor & Francis in Journal of the Energy Institute
- Vol. 79 (3) , 139-144
Combustion characteristics of refuse derived fuels in circulating fluidised bed combustor
Fluidised bed combustion (FBC) is a technology which can use waste materials and low quality fuels along with coal. Mixed with wastes, coal can burn more efficiently. The present study aimed at the co-combustion of refuse derived fuels (RDF) with coal in a bench scale circulating fluidised bed combustor (CFBC). Tests were carried out at different ratios of RDF/coal at temperatures from 830 to 960°C. Compared with coal alone, RDF–coal mixtures gave a more uniform temperature distribution in the combustor and the emissions were lower when burning. Improved efficiency and stability of co-combustion were attributed to the higher volatile matter content in RDF. However, the advantages could be lessened if a too high secondary air ratio was used. NOx and SO2 emissions were due to the presence of S (mainly in the coal) and fuel N (more than S) in both fuels. The SO2 concentration decreased with increasing RDF rich in Ca in the fuel. It was shown that CFBC units could burn RDF efficiently and cleanly.
- 1 September 2006
- Published by Taylor & Francis in Journal of the Energy Institute
- Vol. 79 (3) , 139-144
Combustion characteristics of refuse derived fuels in circulating fluidised bed combustor
Fluidised bed combustion (FBC) is a technology which can use waste materials and low quality fuels along with coal. Mixed with wastes, coal can burn more efficiently. The present study aimed at the co-combustion of refuse derived fuels (RDF) with coal in a bench scale circulating fluidised bed combustor (CFBC). Tests were carried out at different ratios of RDF/coal at temperatures from 830 to 960°C. Compared with coal alone, RDF–coal mixtures gave a more uniform temperature distribution in the combustor and the emissions were lower when burning. Improved efficiency and stability of co-combustion were attributed to the higher volatile matter content in RDF. However, the advantages could be lessened if a too high secondary air ratio was used. NOx and SO2 emissions were due to the presence of S (mainly in the coal) and fuel N (more than S) in both fuels. The SO2 concentration decreased with increasing RDF rich in Ca in the fuel. It was shown that CFBC units could burn RDF efficiently and cleanly.
- 1 January 2005
- Published by ASME International
- Vol. 2005, 101-108
FBC: Laboratory Scale Research to Small Scale Practical Operation
Working with a small, bubbling laboratory scale fluidised bed combustor for many years, helped to gain some insights into the fundamental physicochemical processes taking place in fluidised bed combustors in general, irrespective of size. For example, it has been demonstrated that during coal combustion as a rule the gases leaving the bed cannot be assumed to be at full thermal equilibrium and that when gases are burned the associated acoustic and visual phenomena can be explained in terms of bubbles of the combustible gases exploding within the bed. Much of the experience gained in running the laboratory system has been used in small scale practice, in designing and controlling small, but successful fluidised bed combustors up to about 3 MW. Several 1MW units have now been in operation for over 10 years. It has also been demonstrated that small bubbling bed combustors can be used for disposing of certain biomass and other wastes.
- 1 January 2005
- Published by ASME International
- Vol. 2005, 101-108
FBC: Laboratory Scale Research to Small Scale Practical Operation
Working with a small, bubbling laboratory scale fluidised bed combustor for many years, helped to gain some insights into the fundamental physicochemical processes taking place in fluidised bed combustors in general, irrespective of size. For example, it has been demonstrated that during coal combustion as a rule the gases leaving the bed cannot be assumed to be at full thermal equilibrium and that when gases are burned the associated acoustic and visual phenomena can be explained in terms of bubbles of the combustible gases exploding within the bed. Much of the experience gained in running the laboratory system has been used in small scale practice, in designing and controlling small, but successful fluidised bed combustors up to about 3 MW. Several 1MW units have now been in operation for over 10 years. It has also been demonstrated that small bubbling bed combustors can be used for disposing of certain biomass and other wastes.
- 1 January 2005
- Published by Begell House Inc. Publishers in International Journal of Energy for a Clean Environment
- Vol. 6 (2) , 113-123
COMBUSTION OF AROMATICS AND ESTERS IN AN ATMOSPHERIC BUBBLING FLUIDIZED BED COMBUSTOR, IN COMPARISON WITH THAT OF NATURAL GAS
The gas mixture was prepared by vaporization of liquids in hot air and burned in a laboratory-sized fluidized bed reactor. The test fuels were benzene, toluene, m-xylene, methyl acetate, ethyl acetate, and ethyl formate. Fuel conversion degree was assessed in terms of CO and VOCs concentrations; [NO] and [NO2] were also measured. Pollutants were highest when used. Liquid organic substances can be effectively burned in fluidized beds and the flue gases can in most cases be cleaner than with the methane. The best results are obtained if the combustion is flameless, i.e., takes place entirely inside the bed.
- 1 January 2005
- Published by Begell House Inc. Publishers in International Journal of Energy for a Clean Environment
- Vol. 6 (2) , 113-123
COMBUSTION OF AROMATICS AND ESTERS IN AN ATMOSPHERIC BUBBLING FLUIDIZED BED COMBUSTOR, IN COMPARISON WITH THAT OF NATURAL GAS
The gas mixture was prepared by vaporization of liquids in hot air and burned in a laboratory-sized fluidized bed reactor. The test fuels were benzene, toluene, m-xylene, methyl acetate, ethyl acetate, and ethyl formate. Fuel conversion degree was assessed in terms of CO and VOCs concentrations; [NO] and [NO2] were also measured. Pollutants were highest when used. Liquid organic substances can be effectively burned in fluidized beds and the flue gases can in most cases be cleaner than with the methane. The best results are obtained if the combustion is flameless, i.e., takes place entirely inside the bed.
- 1 January 2005
- Published by The Hong Kong Institution of Engineers in HKIE Transactions
- Vol. 12 (3) , 37-41
The Use of AB FBC for the Utilisation of Raw Animal Wastes
In 1980s change in meat and bone meal production technology led to the spread of BSE and massive culling of beef cattle in many countries. Adding meat and bone meal to animal feed was banned, but animal carcasses still have to be disposed of. In this work the operational parameters and efficiency of a utilisation process for raw meat wastes and emissions of CO, NOx , SO2 and VOC were studied. A 5 kWth fluidised bed combustor was used and tests were repeated in a 150 kWth (KFD-s14u) boiler, with combustion of meat wastes (biomal). With combustion, the heat generated can be recovered, the meat waste is completely burned, bone pieces mineralised and fragmented and flue gas composition is similar to that with coal alone. The potential of the technology for raw meat waste utilisation has been demonstrated on a technical scale, with waste throughput of 180 kg/h*m2 (with respect to distributor area) and factors limiting the combustion efficiency have been determined. An installation (up to 3 MW thermal) has been designed for the utilisation of 500 kg/h of raw meat waste in cocombustion with coal. The installation should fulfil the requirements with respect to waste utilisation efficiency and thermal energy production.
- 1 January 2005
- Published by The Hong Kong Institution of Engineers in HKIE Transactions
- Vol. 12 (3) , 37-41
The Use of AB FBC for the Utilisation of Raw Animal Wastes
In 1980s change in meat and bone meal production technology led to the spread of BSE and massive culling of beef cattle in many countries. Adding meat and bone meal to animal feed was banned, but animal carcasses still have to be disposed of. In this work the operational parameters and efficiency of a utilisation process for raw meat wastes and emissions of CO, NOx , SO2 and VOC were studied. A 5 kWth fluidised bed combustor was used and tests were repeated in a 150 kWth (KFD-s14u) boiler, with combustion of meat wastes (biomal). With combustion, the heat generated can be recovered, the meat waste is completely burned, bone pieces mineralised and fragmented and flue gas composition is similar to that with coal alone. The potential of the technology for raw meat waste utilisation has been demonstrated on a technical scale, with waste throughput of 180 kg/h*m2 (with respect to distributor area) and factors limiting the combustion efficiency have been determined. An installation (up to 3 MW thermal) has been designed for the utilisation of 500 kg/h of raw meat waste in cocombustion with coal. The installation should fulfil the requirements with respect to waste utilisation efficiency and thermal energy production.
- 1 February 2003
- Published by Elsevier in Combustion and Flame
- Vol. 132 (3) , 319-327
Flame flashes when bubbles explode during the combustion of gaseous mixtures in a bubbling fluidized bed
- 1 February 2003
- Published by Elsevier in Combustion and Flame
- Vol. 132 (3) , 319-327
Flame flashes when bubbles explode during the combustion of gaseous mixtures in a bubbling fluidized bed
- 1 March 2002
- Published by Elsevier in Combustion and Flame
- Vol. 128 (4) , 410-421
Combustion of hydrocarbon fuels in a bubbling fluidized bed
- 1 March 2002
- Published by Elsevier in Combustion and Flame
- Vol. 128 (4) , 410-421
Combustion of hydrocarbon fuels in a bubbling fluidized bed