Camila Sarto
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Camila Sarto has a total of 22 co-authors. Here are the top co-authors by number of shared publications:
Beatriz Temer
Biochemistry and Microbiology Department, Biosciences Institute, UNESP - Univ Estadual Paulista. Av. 24A, 1515, 13506-900, Rio Claro - SP - Brazil
1 shared publicationCarlos Roberto Sette-Junior
Federal University of Goiás, Goiânia, Brazil
1 shared publication- Carlos de Melo e Silva Neto
Universidade Estadual de Goiás
1 shared publication Cláudio Angeli Sansígolo
FCA/UNESP
1 shared publication- César Rafael Fanchini Terrasan
Biochemical and Microbiology Department, Univ. Est. Paulista, Rio Claro, Brazil
1 shared publication - Deborah Rodrigues de Souza Santos
University of São Paulo, Luiz de Queiroz College of Agriculture, Department of Forest Sciences, Piracicaba, São Paulo, Brazil
1 shared publication
Latest Publications
- Open Access
- 4 January 2023
- Published by IntechOpen
Wood Quality and Pulping Process Efficiency of EliteEucalyptusspp. Clones Field-Grown under Seasonal Drought Stress
- 4 January 2023
- Published by IntechOpen
Open AccessWood Quality and Pulping Process Efficiency of EliteEucalyptusspp. Clones Field-Grown under Seasonal Drought Stress
- Open Access
- 4 May 2015
- Published by BioResources in BioResources
- Vol. 10 (3) , 4026-4037
Performance of Schizolobium amazonicum Wood in Bleached Kraft Pulp Production
This study aimed to evaluate the characteristics of Schizolobium amazonicum wood, specifically its performance in bleached kraft pulp production and the characteristics of its pulp. Chips of Schizolobium amazonicum and Eucalyptus grandis x Eucalyptus urophylla (reference) were used. The following parameters were evaluated in the wood: basic density, total extractives, total lignin, holocellulose, and fiber morphology. The pulping simulations were carried out in a laboratory digester, with parameters set to obtain pulp with kappa number 19 ± 0.5. Both pulps were bleached in a PFI mill and submitted to physical-mechanical tests. The results showed that S. amazonicum wood has low basic density and higher content of extractives when compared to E. grandis x E. urophylla wood. For pulping, S. amazonicum required higher alkali charge and H factor to achieve the same delignification level of E. grandis x E. urophylla, resulting in a lower yield, pulp with lower viscosity, and higher wood specific consumption. During bleaching, the brightness gain and final viscosity of S. amazonicum pulp were lower than E. grandis x E. urophylla pulp. Moreover, S. amazonicum pulp had worse physical-mechanical characteristics than E. grandis x E. urophylla.
- 4 May 2015
- Published by BioResources in BioResources
- Vol. 10 (3) , 4026-4037
Open AccessPerformance of Schizolobium amazonicum Wood in Bleached Kraft Pulp Production
This study aimed to evaluate the characteristics of Schizolobium amazonicum wood, specifically its performance in bleached kraft pulp production and the characteristics of its pulp. Chips of Schizolobium amazonicum and Eucalyptus grandis x Eucalyptus urophylla (reference) were used. The following parameters were evaluated in the wood: basic density, total extractives, total lignin, holocellulose, and fiber morphology. The pulping simulations were carried out in a laboratory digester, with parameters set to obtain pulp with kappa number 19 ± 0.5. Both pulps were bleached in a PFI mill and submitted to physical-mechanical tests. The results showed that S. amazonicum wood has low basic density and higher content of extractives when compared to E. grandis x E. urophylla wood. For pulping, S. amazonicum required higher alkali charge and H factor to achieve the same delignification level of E. grandis x E. urophylla, resulting in a lower yield, pulp with lower viscosity, and higher wood specific consumption. During bleaching, the brightness gain and final viscosity of S. amazonicum pulp were lower than E. grandis x E. urophylla pulp. Moreover, S. amazonicum pulp had worse physical-mechanical characteristics than E. grandis x E. urophylla.
- Open Access
- 5 November 2012
- Published by BioResources in BioResources
- Vol. 8 (1) , 1292-1305
Xylanase and β-Xylosidase from Penicillium janczewskii: Production, Physico-chemical Properties, and Application of the Crude Extract to Pulp Biobleaching
Extracellular xylanase and β-xylosidase production by a Penicillium janczewskii strain were investigated in liquid cultures with xylan from oat spelts under different physical and chemical conditions. The selected conditions for optimized production of xylanase and β-xylosidase were 7 days, pH 6.5, at 30 °C and 8 days, pH 5.0, at 25 °C, respectively. The xylanase exhibited optimal activity in pH 5.0 at 50 °C and the β-xylosidase in pH 4.0 at 75 °C. The xylanase was more stable at pH 6.0 to 9.5, while the β-xylosidase remained stable at pH ranging from 1.6 to 5.5. The xylanase half-life (T50) at 40, 50, and 60 °C was 183, 15, and 3 min, respectively. β-xylosidase half-life was 144, 8, and 4 min at 50, 65, and 75 °C, respectively. When applied to the biobleaching of Eucalyptus kraft pulp, xylanase dosages of 2 and 4 U/g dried pulp reduced, respectively, kappa number by 3.0 and 3.3 units after 1 h treatment, demonstrating that the use of P. janczewskii xylanases in this process is quite promising. The pulp viscosity was not altered, confirming the absence of cellulolytic enzymes in the fungal extract.
- 5 November 2012
- Published by BioResources in BioResources
- Vol. 8 (1) , 1292-1305
Open AccessXylanase and β-Xylosidase from Penicillium janczewskii: Production, Physico-chemical Properties, and Application of the Crude Extract to Pulp Biobleaching
Extracellular xylanase and β-xylosidase production by a Penicillium janczewskii strain were investigated in liquid cultures with xylan from oat spelts under different physical and chemical conditions. The selected conditions for optimized production of xylanase and β-xylosidase were 7 days, pH 6.5, at 30 °C and 8 days, pH 5.0, at 25 °C, respectively. The xylanase exhibited optimal activity in pH 5.0 at 50 °C and the β-xylosidase in pH 4.0 at 75 °C. The xylanase was more stable at pH 6.0 to 9.5, while the β-xylosidase remained stable at pH ranging from 1.6 to 5.5. The xylanase half-life (T50) at 40, 50, and 60 °C was 183, 15, and 3 min, respectively. β-xylosidase half-life was 144, 8, and 4 min at 50, 65, and 75 °C, respectively. When applied to the biobleaching of Eucalyptus kraft pulp, xylanase dosages of 2 and 4 U/g dried pulp reduced, respectively, kappa number by 3.0 and 3.3 units after 1 h treatment, demonstrating that the use of P. janczewskii xylanases in this process is quite promising. The pulp viscosity was not altered, confirming the absence of cellulolytic enzymes in the fungal extract.
- Open Access
- 9 November 2010
- Published by Universidade Estadual de Maringa in Acta Scientiarum. Technology
- Vol. 32 (3) , 227-235
Cinética da remoção dos extrativos da madeira de Eucalyptus grandis durante polpação Kraft
Cinética da remoção dos extrativos da madeira de Eucalyptus grandis durante polpação Kraft - doi: 10.4025/actascitechnol.v32i3.4237
- 9 November 2010
- Published by Universidade Estadual de Maringa in Acta Scientiarum. Technology
- Vol. 32 (3) , 227-235
Open AccessCinética da remoção dos extrativos da madeira de Eucalyptus grandis durante polpação Kraft
Cinética da remoção dos extrativos da madeira de Eucalyptus grandis durante polpação Kraft - doi: 10.4025/actascitechnol.v32i3.4237