Alfonso Fondado
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Alfonso Fondado has a total of 87 co-authors. Here are the top co-authors by number of shared publications:
- Jose Rivas
NANOMAG Laboratory, Applied Physics Department, iMATUS Materials Institute and Health Research Institute of Santiago de Compostela (IDIS), Universidade de Santiago de Compostela, 15782, Santiago de Compostela, Spain
26 shared publications - Jorge Mira
Universidade de Santiago de Compostela
23 shared publications - Maria Antonia Señaris-Rodriguez
University of A Coruna, QUIMOLMAT Group, Dpt. Chemistry, Faculty of Science and Centro Interdisciplinar de Química e Bioloxía (CICA), Zapateira, 15071 A Coruña, Spain
14 shared publications J. Rivas
7 shared publications- Francisco Rivadulla
Centro Singular de Investigación en Química Biolóxica e Materiais Moleculares
6 shared publications - Luis E. Hueso
CIC nanoGUNE BRTA
6 shared publications
Latest Publications
- Open Access
Development of a Novel Magnetic Reactor Based on Nanostructured Fe3O4@PAA as Heterogenous Fenton Catalyst
With the recent development of nanotechnology, magnetic nanoparticles (mNPs) have received increasing attention as potential heterogeneous Fenton catalysts in wastewater treatment applications, as an alternative to the conventional Fenton process using dissolved iron salts. Due to their superparamagnetic properties, Fe3O4 mNPs can be easily recovered and reused by applying a magnetic field. However, Fe3O4 mNPs have a marked tendency to form aggregates in water, leading to a decrease in their catalytic yield. To overcome these limitations, this work explores the catalytic activity of Fe3O4 coated with poly(acrylic acid) (Fe3O4@PAA) as stabilized Fenton heterogeneous nanocatalyst, in the degradation of C.I. Reactive Blue 19 (RB19). To maximize the catalytic potential of Fe3O4@PAA, an experimental design based on the Response Surface Methodology (RSM) has been developed to optimize the conditions of the Fenton process in terms of Fe3O4@PAA concentration (100–300 mg L−1) and H2O2 dose (100–400 mg L−1). Based on the results obtained, a novel sequential batch reactor (SBR) coupled to an external magnetic separation system has been developed, guaranteeing the complete retention of the mNPs in the system. This system allows the reuse of Fe3O4@PAA for at least 10 consecutive cycles, with a successful decolorization of RB19 after 4 h of treatment.
Open AccessDevelopment of a Novel Magnetic Reactor Based on Nanostructured Fe3O4@PAA as Heterogenous Fenton Catalyst
With the recent development of nanotechnology, magnetic nanoparticles (mNPs) have received increasing attention as potential heterogeneous Fenton catalysts in wastewater treatment applications, as an alternative to the conventional Fenton process using dissolved iron salts. Due to their superparamagnetic properties, Fe3O4 mNPs can be easily recovered and reused by applying a magnetic field. However, Fe3O4 mNPs have a marked tendency to form aggregates in water, leading to a decrease in their catalytic yield. To overcome these limitations, this work explores the catalytic activity of Fe3O4 coated with poly(acrylic acid) (Fe3O4@PAA) as stabilized Fenton heterogeneous nanocatalyst, in the degradation of C.I. Reactive Blue 19 (RB19). To maximize the catalytic potential of Fe3O4@PAA, an experimental design based on the Response Surface Methodology (RSM) has been developed to optimize the conditions of the Fenton process in terms of Fe3O4@PAA concentration (100–300 mg L−1) and H2O2 dose (100–400 mg L−1). Based on the results obtained, a novel sequential batch reactor (SBR) coupled to an external magnetic separation system has been developed, guaranteeing the complete retention of the mNPs in the system. This system allows the reuse of Fe3O4@PAA for at least 10 consecutive cycles, with a successful decolorization of RB19 after 4 h of treatment.
- 1 October 2018
- Published by Elsevier in Journal of Environmental Chemical Engineering
- Vol. 6 (5) , 5950-5960
A novel enzyme catalysis reactor based on superparamagnetic nanoparticles for biotechnological applications
- 1 October 2018
- Published by Elsevier in Journal of Environmental Chemical Engineering
- Vol. 6 (5) , 5950-5960
A novel enzyme catalysis reactor based on superparamagnetic nanoparticles for biotechnological applications
- 16 September 2013
- Published by Royal Society of Chemistry (RSC) in RSC Advances
- Vol. 3 (44) , 22404-22411
Coexistence of magnetic and electrical order in the new perovskite-like (C3N2H5)[Mn(HCOO)3] formate
In this work we further the structural characterization of the recently discovered (C3N2H5)[Mn(HCOO)3] metal–organic framework with perovskite-like structure, and we present its magnetic and dielectric properties up to 350 K. At low temperature, the C3N2H5 + imidazolium cations, that sit oblique within the cavities of the [Mn(HCOO)3]− framework structure, show a cooperative order resulting in an antiparallel arrangement of their electrical dipole moments. Very interestingly, it is only above 220 K that thermal energy seems to be able to break this antiferroelectric order, resulting in a linear increase of its dielectric constant with temperature. In addition, this Mn(II) compound is antiferromagnetic below TN = 9 K, with a slightly non-collinear arrangement of its magnetic moments, yielding to a weak ferromagnetism. Therefore, this is a new multiferroic material which exhibits coexistence of magnetic and electric ordering.
- 16 September 2013
- Published by Royal Society of Chemistry (RSC) in RSC Advances
- Vol. 3 (44) , 22404-22411
Coexistence of magnetic and electrical order in the new perovskite-like (C3N2H5)[Mn(HCOO)3] formate
In this work we further the structural characterization of the recently discovered (C3N2H5)[Mn(HCOO)3] metal–organic framework with perovskite-like structure, and we present its magnetic and dielectric properties up to 350 K. At low temperature, the C3N2H5 + imidazolium cations, that sit oblique within the cavities of the [Mn(HCOO)3]− framework structure, show a cooperative order resulting in an antiparallel arrangement of their electrical dipole moments. Very interestingly, it is only above 220 K that thermal energy seems to be able to break this antiferroelectric order, resulting in a linear increase of its dielectric constant with temperature. In addition, this Mn(II) compound is antiferromagnetic below TN = 9 K, with a slightly non-collinear arrangement of its magnetic moments, yielding to a weak ferromagnetism. Therefore, this is a new multiferroic material which exhibits coexistence of magnetic and electric ordering.
- 19 April 2010
- Published by AIP Publishing in Applied Physics Letters
- Vol. 96 (16) , 162904
Particle size reduction: A way to enhanced dielectric properties of magnetocapacitive La2/3Ca1/3MnO3
We report the optimization of the dielectric properties of . This is achieved by synthesizing this material with small particle size, strategy that reduces the conductivity of the sample and its dielectric losses, while retaining a reasonably high dielectric permittivity and a good magnetocapacitive response. In order to further improve the properties of these nanoparticles, we have also prepared core-shell composites but in this case the magnetocapacitive effect is strongly reduced.- 19 April 2010
- Published by AIP Publishing in Applied Physics Letters
- Vol. 96 (16) , 162904
Particle size reduction: A way to enhanced dielectric properties of magnetocapacitive La2/3Ca1/3MnO3
We report the optimization of the dielectric properties of . This is achieved by synthesizing this material with small particle size, strategy that reduces the conductivity of the sample and its dielectric losses, while retaining a reasonably high dielectric permittivity and a good magnetocapacitive response. In order to further improve the properties of these nanoparticles, we have also prepared core-shell composites but in this case the magnetocapacitive effect is strongly reduced.- 1 December 2008
- Published by Elsevier in Journal of Non-Crystalline Solids
- Vol. 354 (47) , 5328-5330
A new approach to diffusion-like relaxation processes
- 1 December 2008
- Published by Elsevier in Journal of Non-Crystalline Solids
- Vol. 354 (47) , 5328-5330
A new approach to diffusion-like relaxation processes
- 20 November 2007
- Published by Wiley in Bioelectromagnetics
- Vol. 29 (3) , 163-168
In vitro electrical impedance spectroscopy of human dentine: The effect of restorative materials
The influence of different restorative materials on in vitro dielectric properties of sound dentine was investigated. The studied samples were three-layer materials consisting of successive disks of dentine and silver amalgam or nanohybrid composite resin. Before being tested, the samples were maintained in physiological solution never more than 48 h from the extraction. Also, sections of intact dentine were similarly prepared for electrical measurements. Complex dielectric permittivity of these specimens was determined in a wide frequency range using the parallel-plate capacitor technique. Very similar dielectric responses of intact dentine and amalgam-dentine material were observed. This is explained on the basis of high dc conductivity exhibited by both samples. In contrast, resin-dentine specimen revealed a much more insulating behavior. A simple theoretical model for heterogeneous systems could be applied to these dental three-layer materials. The dielectric properties of restored dentine are strongly dependent on the kind of restorative material employed in each case. This suggests that electrical data should be used carefully in caries diagnosis on restored teeth. Bioelectromagnetics 29:163–168, 2008.
- 20 November 2007
- Published by Wiley in Bioelectromagnetics
- Vol. 29 (3) , 163-168
In vitro electrical impedance spectroscopy of human dentine: The effect of restorative materials
The influence of different restorative materials on in vitro dielectric properties of sound dentine was investigated. The studied samples were three-layer materials consisting of successive disks of dentine and silver amalgam or nanohybrid composite resin. Before being tested, the samples were maintained in physiological solution never more than 48 h from the extraction. Also, sections of intact dentine were similarly prepared for electrical measurements. Complex dielectric permittivity of these specimens was determined in a wide frequency range using the parallel-plate capacitor technique. Very similar dielectric responses of intact dentine and amalgam-dentine material were observed. This is explained on the basis of high dc conductivity exhibited by both samples. In contrast, resin-dentine specimen revealed a much more insulating behavior. A simple theoretical model for heterogeneous systems could be applied to these dental three-layer materials. The dielectric properties of restored dentine are strongly dependent on the kind of restorative material employed in each case. This suggests that electrical data should be used carefully in caries diagnosis on restored teeth. Bioelectromagnetics 29:163–168, 2008.
- 1 June 2007
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1565-1568
Measurement of Electrical Parameters in High-Current Arc Furnaces
The correct measurement of electrical parameters is a fundamental requirement for the accomplishment of suitable regulatory and protective actions in electric arc furnaces. The Spanish ferroalloy company Ferroatlantica has devoted many efforts during the last years to the development and improvement of an efficient silicon production technology, based on the so-called ELSA electrodes. Previous works concentrate on the electrical characterization of ELSA electrodes for on-line monitoring purposes. In this paper, a system to measure the high currents flowing through the bus-bars of the electrodes is presented and the issues related to data acquisition from the current probes and to the calculation of significant electrical parameters of the furnace are discussed.
- 1 June 2007
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1565-1568
Measurement of Electrical Parameters in High-Current Arc Furnaces
The correct measurement of electrical parameters is a fundamental requirement for the accomplishment of suitable regulatory and protective actions in electric arc furnaces. The Spanish ferroalloy company Ferroatlantica has devoted many efforts during the last years to the development and improvement of an efficient silicon production technology, based on the so-called ELSA electrodes. Previous works concentrate on the electrical characterization of ELSA electrodes for on-line monitoring purposes. In this paper, a system to measure the high currents flowing through the bus-bars of the electrodes is presented and the issues related to data acquisition from the current probes and to the calculation of significant electrical parameters of the furnace are discussed.
- 1 June 2007
- Published by Elsevier in Materials Letters
- Vol. 61 (14-15) , 2990-2992
Increase of the dielectric constant near a magnetic phase transition in La0.5Ca0.5MnO3
- 1 June 2007
- Published by Elsevier in Materials Letters
- Vol. 61 (14-15) , 2990-2992
Increase of the dielectric constant near a magnetic phase transition in La0.5Ca0.5MnO3
- 1 April 2007
- Published by Elsevier in Physica D: Nonlinear Phenomena
- Vol. 228 (2) , 107-111
Scale properties as a basis of power law relaxation processes
- 1 April 2007
- Published by Elsevier in Physica D: Nonlinear Phenomena
- Vol. 228 (2) , 107-111
Scale properties as a basis of power law relaxation processes
- 30 June 2006
- Published by Elsevier in Boletín de la Sociedad Española de Cerámica y Vidrio
- Vol. 45 (3) , 163-168
Comportamiento dieléctrico de La1-xCaxMnO3 (0.4 ≤ x ≤ 0.5)
- 30 June 2006
- Published by Elsevier in Boletín de la Sociedad Española de Cerámica y Vidrio
- Vol. 45 (3) , 163-168
Comportamiento dieléctrico de La1-xCaxMnO3 (0.4 ≤ x ≤ 0.5)