QLQiang Li

Qiang Li

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Qiang Li has a total of 9 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Joint Channel Estimation and Precoding for Faster-Than-Nyquist Signaling

    by Qiang Li, Feng-Kui Gong, Pei-Yang Song, Guo Li, Sheng-Hua Zhai

    The performance of existing frequency-domain channel estimation and equalization algorithms for faster-than-Nyquist (FTN) signaling is seriously hampered with the noise enhancement phenomenon that results from their inverse or pseudo-inverse operations. Through simulations, we show that the linear precoding can effectively mitigate the above-mentioned noise enhancement phenomenon. At first, a low complexity precoding-based channel estimation (PCE) algorithm is proposed for FTN signaling over frequency-selective fading channels. In contrast with most existing frequency-domain channel estimation algorithms, the proposed PCE algorithm has much better mean square error performance, and the performance improvement enlarges with the increase of signal to noise ratio. Furthermore, a joint channel estimation and precoding (JCEP) algorithm is proposed to perform data detection for FTN signaling over frequency-selective fading channels. On the one hand, compared with the existing frequency-domain channel estimation and equalization algorithms, the JCEP algorithm greatly reduces the complexity of signal processing at receivers since it performs the linear precoding processing at transmitters. On the other hand, even with estimated channel state information (CSI), the proposed JCEP algorithm can approach the bit error rate (BER) performance of the Nyquist signaling for all the modulation types adopted in digital video broadcasting-satellite-second generation extension (DVB-S2X). More precisely, the BER performance degradation with perfect and estimated CSI is 0.06 dB and 0.07 dB respectively when the time acceleration parameter equals to 0.7 and the rolling factor is 0.45.


  • Beyond DVB-S2X: Faster-Than-Nyquist Signaling With Linear Precoding

    by Qiang Li, Feng-Kui Gong, Pei-Yang Song, Guo Li, Sheng-Hua Zhai

    Faster-than-Nyquist (FTN) signaling with linear precoding is investigated as a potential technique to transcend digital video broadcasting-satellite-second generation extension (DVB-S2X). Combining cyclic prefix (CP), cyclic suffix (CS) and discrete Fourier transform (DFT) with existing linear precoding algorithms, such as G-to-minus-half (GTMH) precoding (GTMHP), the CPS-GTMH-DFTP algorithm is proposed to eliminate inter-symbol interference (ISI) for FTN signaling. By comparison with most existing algorithms, our proposed CPS-GTMH-DFTP algorithm requires much lower implementation complexity. Specifically, only two multipliers and the corresponding fast Fourier transform (FFT)/inverse fast Fourier transform (IFFT) operations are required with the proposed CPS-GTMH-DFTP algorithm, which makes our proposed algorithm more suitable for practical implementation. Furthermore, the CPS-GTMH-DFTP algorithm has better bit error rate (BER) performance than most existing precoding algorithms. Simulation results show that even when the time acceleration parameter and roll-off factor equal to 0.75 and 0.35 respectively, our proposed CPS-GTMH-DFTP algorithm can still approach the BER performance of the ISI-free Nyquist signaling for all the modulation types adopted in DVB-S2X. More precisely, with 256-amplitude phase shift keying (APSK), the BER performance degradation is almost 0.03 and 0.01 dB in uncoded and coded FTN systems respectively. As far as we know, with regard to low complexity ISI elimination algorithms for FTN signaling, this is the first time to achieve such excellent performance with a time acceleration parameter 0.75 and a practical roll-off factor 0.35.


  • Open Access

    Symbol‐based multi‐layer iterative successive interference cancellation for faster‐than‐Nyquist signalling

    by Qiang Li, Feng‐Kui Gong, Pei‐Yang Song, Sheng‐Hua Zhai

    A symbol‐based multi‐layer iterative successive interference cancellation (MLISIC) algorithm is proposed to eliminate the inter‐symbol interference (ISI) for faster‐than‐Nyquist signalling. The computational complexity of the proposed MLISIC algorithm is much lower than most existing block‐based estimation algorithms. By comparison with existing symbol‐based algorithms, the proposed MLISIC algorithm has higher estimation accuracy. Furthermore, by means of utilising more accurate symbols and elaborate length of successive interference cancellation, an improved MLISIC (IMLISIC) algorithm is presented to further promote the estimation accuracy. Simulation results show in mild ISI cases, the proposed MLISIC and IMLISIC algorithms can approximate the theoretical performance even using 256‐amplitude phase‐shift keying which is adopted in digital video broadcasting‐satellite‐second generation extension, i.e. bit error rate (BER) performance degradation is about 0.03 dB when the signal‐to‐noise ratio is high. In other words, using the proposed MLISIC and IMLISIC algorithms in mild ISI cases, the spectrum efficiency can be improved with negligible BER performance degradation. Besides, compared with existing symbol‐based algorithms, the greater BER performance improvement can be achieved under severer ISI circumstances.


  • Open Access

    Pre-Equalized Interference Cancellation for Faster-Than-Nyquist Signaling

    by Qiang Li, Feng-Kui Gong, Pei-Yang Song, Sheng-Hua Zhai

    An affine projection (AP)-based equalizer (APE) is introduced to eliminate inter-symbol interference (ISI) for faster-than-Nyquist (FTN) signaling. Based on the APE, a pre-equalized interference cancellation (PIC) algorithm is proposed to eliminate the ISI for FTN signaling. By utilizing interference factors in the FTN system and low complexity APE, the computational complexity of the proposed PIC algorithm is much lower than most existing block-based estimation algorithms, which makes it more practical for implementation. Besides, the proposed PIC algorithm has higher estimation accuracy by comparison with most existing algorithms. Simulation results show that APE has satisfactory bit error rate (BER) performance in moderate ISI cases. In uncoded FTN systems, for all the modulation types adopted in digital video broadcasting-satellite-second generation extension (DVB-S2X), the proposed PIC algorithm can approximate the BER performance of the ISI-free Nyquist signaling when the time acceleration parameter and rolling factor equal to 0.8 and 0.3 respectively, which is beyond the performance of most existing low-complexity algorithms. Even for 256-amplitude phase shift keying (APSK), the BER performance degradation is no more than 0.05 dB when the BER is 10..5. Furthermore, compared with the state-ofthe-art frequency-domain equalization algorithm, the proposed PIC algorithm performs well in coded FTN systems.


  • A Versatile FPGA-Based Multi-Rate and Multi-Channel Transmission Loss Tester

    by Qiang Li, Feng-Kui Gong, Guo Li, Pei-Yang Song

    Based on the field-programmable gate array (FP-GA) structure, a versatile transmission loss tester for wireless communications, especially satellite communications, is developed to obtain the bit error rate (BER) and transmission loss efficiently. The hardware of the tester can be treated as an integrated radio frequency (RF) transmission system with an embedded additive white Gaussian noise (AWGN) module. The FPGA-based RF system can generate at most 10 independent channels (ICs) with multiple rolling factors. Multiple symbol rates from 2 Ksps to 34 Msps can be supported with an appropriate multistage up-sampling processing. Furthermore, at most 640 sub-channels can be generated with the help of poly-phase filter banks and a well-designed FPGA realization of quadrature phase shift keying (QPSK) modem. The precomputation and test results show that a high dynamic range of transmitting and receiving signal levels can be supported. In addition, the expected transmission loss at one specific BER can be easily observed and acquired with the help of an integrated automated monitoring software developed by Qt development tool.