Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Aleksandar Fišteš has a total of 72 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Protein Level and Particle Size-Dependent Stabilization of Oil-in-Water Emulsions by Sunflower Meal

    by Strahinja Vidosavljević, Nikola Maravić, Zita Šereš, Aleksandar Fišteš, Nemanja Bojanić

    Sunflower meal represents a protein- and fiber-rich by-product of the oil industry with potential application as a natural stabilizer in food emulsions. Building upon previous findings that emphasized the role of protein content in emulsion stability, the present study further investigated the combined effect of protein level and particle size distribution of sunflower meal fractions on the formation and stability of oil-in-water emulsions. Two sets of sunflower meal fractions were prepared from finely milled material, fractionated, and blended in controlled proportions to obtain four protein-enriched (30 ± 1%) and four cellulose-rich (15 ± 1%) fractions, each defined by particle size ranges of 250/200, 200/125, 125/100, and <100 µm. Emulsion stability was evaluated through droplet size analysis, zeta potential measurements, and creaming index determination during seven days of storage. The results demonstrated that both protein content and particle size significantly affected the emulsifying and stabilizing behavior of sunflower meal fractions. For the low-protein group (15%), larger particle sizes (250/200 µm) yielded smaller emulsion droplets (D[4.3] = 66.03 µm) and higher zeta potential values (−15.53 mV), while in the high-protein group (30%), droplet size distribution was more uniform (D[4.3] from 72.13 to 76.29 µm). During seven days of storage, all emulsions exhibited a gradual increase in creaming index, followed by partial stabilization at later time points. Emulsions prepared with sunflower meal fractions of higher-protein content showed consistently lower creaming index values, indicating improved physical stability throughout storage. Overall, the study confirmed that the interplay between composition (protein level) and physical structure (particle size) governs the emulsification efficiency of sunflower meal fractions, providing insights for their potential application as plant-based stabilizers in food systems.


  • Open Access

    Fortification of Bread with Carob Extract: A Comprehensive Study on Dough Behavior and Product Quality

    by Jana Zahorec, Dragana Šoronja-Simović, Jovana Petrović, Ivana Nikolić, Branimir Pavlić, Katarina Bijelić, Nemanja Bojanić, Aleksandar Fišteš

    The integration of functional ingredients into staple foods like bread offers a promising strategy for improving public health. Carob (Ceratonia siliqua L.) flour, rich in bioactive compounds, has potential as a functional additive. However, its incorporation into bread negatively affects dough behavior and product quality due to high levels of insoluble dietary fibers. This study investigates the use of carob extract (PCE) as a functional additive to enhance the nutritional and bioactive profile of bread while preserving its rheological behavior and sensory quality. PCE was obtained via microwave-assisted extraction and spray drying, and incorporated into bread formulations at 1%, 3%, and 5%. The addition of PCE reduced water absorption by 1.5% and increased dough stability three times. Dough resistance increased by 15%, while extensibility decreased by 5%. The viscoelastic properties of dough were preserved, as the storage modulus increased and Tan δ values remained stable. Changes in specific volume, crumb texture, crumb porosity, and bread color of produced bread with PCE were minimal; however, aroma, taste, and overall sensory quality were improved. Additionally, the incorporation of PCE resulted in a significant increase in total phenolic content and antioxidant activity, indicating an enhancement of the bread’s functional properties. These improvements were achieved without negatively affecting the dough rheology or bread quality parameters. Overall, the findings suggest that PCE can be a promising functional ingredient in bread formulations, contributing to both nutritional value and technological performance.


  • Open Access

    Optimising soybean molasses in broiler feed diet: influence on pelleting process and pellet physical quality

    by Viktor Stojkov, Slađana Rakita, Vojislav Banjac, Dušan Rakić, Aleksandar Fišteš, Strahinja Vidosavljević, Luciano Pinotti


  • Open Access

    Application of Optimized Dry Fractionation Process for Nutritional Enhancement of Different Sunflower Meals

    by Strahinja Vidosavljević, Nemanja Bojanić, Danka Dragojlović, Viktor Stojkov, Tea Sedlar, Vojislav Banjac, Aleksandar Fišteš

    Sunflower meal (SFM), a byproduct of sunflower oil extraction, is a relatively inexpensive protein source with high potential for feed formulations. Dry fractionation methodologies are emerging as ‘green’ and affordable technologies with the potential to additionally enhance the nutritional quality of plant-based raw materials for animal feed, including sunflower meal. Following the optimization of a dry fractionation process in a previous study of the authors, this research aims to validate the defined parameters through the processing of three sunflower meals (SFM1, SFM2, and SFM3) with different characteristics. The dry fractionation process includes two-stage grinding using hammer mill and roll mill and fractionation of sunflower meal by sieving. The process successfully increased the protein content of sunflower meals in the range of 17.5% to 31.2%, reaching levels high enough to be categorized as “high protein” sunflower meals of first quality (42% as is). Exceptionally high fraction yields (76.5–78.9%) were obtained for all three sunflower meals. The lowest energy consumption was recorded for SFM1 (8.44 Wh/kg), while slightly higher values were observed during the processing of SFM2 and SFM3 (9.30 and 9.93 Wh/kg, respectively). Relative amino acid enrichments ranging from 13.35% to 26.64% were achieved, with lysine enrichment ranging from 18.9% to 36% and methionine from 30.6% to 44.1%.


  • Open Access

    Effects of Roller Milling Parameters on Wheat-Flour Damaged Starch: A Comprehensive Passage Analysis and Response-Surface Methodology Optimization

    by Nemanja Bojanić, Dušan Rakić, Aleksandar Fišteš

    Damaged starch typically arises from mechanical damage caused by the action of the roller mills during the wheat flour milling process. The content of resulting damaged starch in the flour significantly influences its characteristics, emphasizing the importance of understanding and controlling the formation of damaged starch for the production of specialized flours. A detailed passage analysis from three different commercial mills revealed that starch damage control is primarily achievable at front passages of the sizing and reduction system, which generate the majority of the flour release in the mill. Also, it revealed that damaged starch content increases progressively from the initial to the final passages during milling in the break, sizing and reduction system. To investigate the effects of milling parameters on damaged starch, flour yield, and energy consumption, a three-level and three-variable Box–Behnken experimental design with response surface methodology was applied. As independent variables roll gap (0.05–0.35 mm), feed rate (0.15–0.35 kg/cm min), and fast roll speed (400–800 rpm) were employed. The obtained models were utilized to optimize milling conditions for producing flours with special characteristics.


  • Open Access

    Optimization of Grinding Process of Sunflower Meal for Obtaining Protein-Enriched Fractions

    by Strahinja Vidosavljević, Nemanja Bojanić, Petar Ilić, Dušan Rakić, Olivera Đuragić, Vojislav Banjac, Aleksandar Fišteš

    In this study, dry fractionation process was proposed in order to obtain protein-enriched sunflower meal fractions. The process includes two-stage grinding using a hammer mill and a roll mill, and fractionation of sunflower meal by sieving. Central composite design (CCD) with four variables on three levels within response surface methodology was applied in order to estimate the influence of grinding parameters (sieve openings diameter of the hammer mill: 2, 4, and 6 mm, roll gap: 0.15, 0.2, and 0.25 mm, feed rate: 0.1, 0.175, and 0.25 kg/cm min, and roll speed: 400, 500, and 600 rpm) on responses (protein content, fraction yield and grinding energy consumption). Sieve openings diameter expressed the highest impact on fraction yield while roll gap expressed the most dominant influence on protein content in the fraction and grinding energy consumption. The highest protein content obtained was 48.06%(dm) with fraction yield of 77.22%. A multi-response optimization procedure was performed and optimal values were: sieve openings diameter of 2 mm, roll gap of 0.25 mm, feed rate of 0.2 kg/cm min, and roll speed of 400 rpm, while predicted values for a desired range of responses were: protein content 45.5%(dm), fraction yield 77.89%, and grinding energy consumption 8.31 Wh/kg.


  • Open Access

    Whey as a Carrier Material for Blueberry Bioactive Components: Incorporation in White Chocolate

    by Petar Jovanović, Biljana Pajin, Ante Lončarić, Antun Jozinović, Jovana Petrović, Aleksandar Fišteš, Danica Zarić, Vesna Tumbas Šaponjac, Đurđica Ačkar, Ivana Lončarević

    White chocolate is considered an unhealthier product than dark and milk chocolate due to the absence of cocoa solids containing polyphenols and other valuable components such as minerals and dietary fiber. This paper aimed to improve the nutritional value of white chocolate (C) by adding blueberry bioactive compounds. Since natural polyphenols are easily degradable because of their sensitivity, whey, as a rich source of proteins, was used as a material for encapsulating blueberry juice. Whey proteins protect blueberry anthocyanins and increase their bioaccessibility in the human body. Blueberry juice encapsulates (B) were added to white chocolate, replacing 8% (C-B8) and 10% (C-B10) of white chocolate mass. Blueberry encapsulates significantly (p < 0.05) increased the viscosity of chocolates (from 0.63 Pa·s in C to 1.13 Pa·s in C-B8 and 1.40 Pa·s in C-B10) with no significant impact on their melting peak. Both enriched chocolates had significantly (p < 0.05) higher protein and dietary fiber content and lower fat content than white chocolate. The total polyphenol content increased 3.7-fold, while antioxidant capacity increased 5.2-fold in C-B10. The oxidation stability, determined by pressurized accelerated oxidation, was also improved in enriched chocolates. Blueberry juice encapsulated in whey positively influenced the color and sensory characteristics of fortified white chocolates, where C-B10 had higher sensory scores for blueberry odor and taste than C-B8. The obtained results open up a possible pathway and indicate opportunities and limitations for the incorporation of other materials, such as various dietary/fruit components, in white chocolate.


  • Open Access

    The Influence of Extruded Sugar Beet Pulp on Cookies’ Nutritional, Physical and Sensory Characteristics

    by Sonja Simić, Jovana Petrović, Dušan Rakić, Biljana Pajin, Ivana Lončarević, Antun Jozinović, Aleksandar Fišteš, Sanja Nikolić, Marijana Blažić, Borislav Miličević

    Sugar beet pulp (SBP) is a by-product of the sugar industry in which the dietary fiber content ranges from 73% to 80%. Compared to cereal fibers mainly used in biscuit production, sugar beet fibers are gluten free and have a perfect ratio of 2/3 insoluble fiber. In this work, sugar beet pulp was extruded with corn grits (ratios of corn grits to sugar beet pulp in extrudates were 85:15, 70:30, and 55:45), and the obtained sugar beet pulp extrudates (SBPEs) were used for improving the nutritional quality of cookies. The wheat flour in cookies was replaced with SBPEs in the amount of 5, 10, and 15%. The influence of three factors (the percentage of sugar beet pulp in the SBPEs, the size of the SBPE particles, and the percentage of wheat flour substituted with SBPEs) and their interactions on the nutritional quality of cookies, as well as their physical and sensory characteristics are examined using the Box–Behnken experimental design. The addition of extruded sugar beet pulp (SBPEs) significantly increased the amount of total dietary fiber and mineral matter of cookies. On the whole, the addition of SBPEs increased cookie hardness, but the hardness decreased with an increase in extrudate particle size. Sensory characteristics (except for the taste) were the most influenced by extrudate particle size.


  • Study on the effects of smooth roll grinding conditions on reduction of wheat middlings using response surface methodology

    by Nemanja Bojanić, Aleksandar Fišteš, Dušan Rakić, Samuel Kolar, Bojana Ćurić, Jovana Petrović

    Influence of the milling parameters on the reduction process of the wheat middlings by the smooth rolls was investigated. Three level and four variables Box-Behnken experimental design with response surface methodology was applied in order to evaluate effects of milling parameters and to optimize grinding conditions for various responses. As independent variables roll gap (0.04-0.1 mm), differential (1.1.-1.9), roll speed (300-500 rpm) and feed rate (0.2-0.4 kg/cm min) were employed. Responsive variables were flour yield, ash content and energy consumption. In order to optimize milling process adequate models were obtained by regression analysis. Possibilities of the optimization of the milling parameters in order to obtain different combination of the desired outputs are illustrated by four examples.