CNChe Ani Norhidayah

Che Ani Norhidayah

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Che Ani Norhidayah has a total of 30 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Development and Acoustic Analysis of a Speaker-Output Stethoscope for Low-Cost Clinical Applications

    by Kusnanto Mukti Wibowo, Abdul Latif, Fani Susanto, Fatiatun Fatiatun, Norhidayah Che Ani

    This study addresses the limitations of traditional stethoscopes, which are constrained by their single-user design, dependence on auditory acuity, and susceptibility to background noise. These limitations hinder collaborative learning and diagnostic accuracy, particularly in noisy environments or during infectious disease outbreaks. The aim of this work is to develop a low-cost, speaker-output digital stethoscope that enables multiple users to simultaneously listen to heart sounds, improving both clinical training and infection control. The main contribution of this study is the integration of a conventional analog stethoscope with a high-sensitivity microphone preamplifier, an external speaker, and digital signal processing (DSP) algorithms. This configuration allows the amplification and filtering of heart sounds, enabling group auscultation without the need for earpieces. The device casing is constructed from High-Pressure Laminate (HPL) sheets and multiplex wood panels, while acoustic foam is used to reduce noise interference. Heart sounds are captured via a microphone, amplified, and processed using Fast Fourier Transform (FFT) and band-pass filtering (20–150 Hz) to isolate the key frequencies. The system was tested in a quiet clinical setting, and the resulting audio was analyzed for clarity and frequency spectrum. The prototype successfully captured heart sounds, with a dominant spectral peak around 97 Hz, consistent with the primary frequency of heartbeats. It also clearly identified the first (S1) and second (S2) heart sounds. However, ambient noise affected sound clarity, indicating the need for further noise reduction. Despite this limitation, the device successfully enabled group auscultation. In conclusion, the speaker-output stethoscope offers an affordable and effective alternative to traditional auscultation, enhancing medical training and improving infection control. Although noise reduction requires further refinement, the system demonstrates strong potential for application in clinical and educational settings, particularly in low-resource environments


  • Unveiling the influence of ferromagnetic Gd-doped ZnO films on the performance of organic solar cells

    by Norhidayah Che Ani, Mohd Zainizan Sahdan, Kusnanto Mukti Wibowo, Nafarizal Nayan, Feri Adriyanto

    Organic solar cells (OSCs) have emerged as a promising technology for renewable energy generation due to their low cost, lightweight, flexibility, and compatibility with roll-to-roll manufacturing. However, OSCs still face challenges in achieving high power conversion efficiency (PCE) due to various factors, including recombination loss. In this study, we investigated the effect of introducing a layer of eight atomic percent gadolinium-doped zinc oxide (Zn0.92Gd0.08O) between the poly(3-hexylthiophene) (P3HT): [6,6]-phenyl butyric acid methyl ester (PCBM) active layer and the fluorine-doped tin oxide (FTO) electrode of the OSC. The reference cell, which has an Au/P3HT:PCBM/ZnO/FTO structure, exhibits a PCE of 0.52%. Remarkably, when the Zn0.92Gd0.08O layer was inserted (Au/P3HT:PCBM/Zn0.92Gd0.08O/FTO), the PCE increased significantly to 3.42%, which is more than six times the increase. Through further analysis, we present that the insertion of the Zn0.92Gd0.08O layer induces spin polarization in the P3HT:PCBM layer, leading to enhanced charge transport and reducing the recombination rate. Based on the findings, it can be concluded that the Zn0.92Gd0.08O film can potentially improve OSC performance.


  • Metamorphosis of the ZnO buffer layer thicknesses on the performance of inverted organic solar cells

    by M. Z. Sahdan, M. F. Malek, M. S. Alias, S. A. Kamaruddin, C. A. Norhidayah, N. Sarip, N. Nafarizal, M. Rusop


  • Effect of Rare-Earth Gd Incorporation on the Characteristics of ZnO Thin Film

    by S. N. M. Tawil, C. A. Norhidayah, N. Sarip, S. A. Kamaruddin, A. R. Nurulfadzilah, A. Miskon, M. Z. Sahdan

    The doping of oxide-based semiconductors with rare-earth ions may serve as an alternative to transition metal doping with the possibility of room-temperature ferromagnetism. Here, highly transparent thin films of ZnO doped with a rare-earth element, Gd, were prepared via a sol–gel-derived precursor. A series of Gd-doped ZnO films with different Gd concentrations (0 to 8 at.%) were deposited onto glass substrates. XRD analysis revealed that the FWHM of the diffraction peaks increased with the increase of Gd composition which may indicate that the Gd incorporation decreased the crystallinity. However no new peaks associated with the formation of secondary phases such as GdO and Gd metal clusters were detected. The MFM images were seen to be more pronounced with the incorporation of Gd ions where we could clearly observe the magnetic signals at room temperature especially for the samples with higher Gd doping of 4 and 8 at.% Gd. Evidently, the magnetic domain size exhibited a significant increase with the increase of Gd composition in contrast to the undoped sample.


  • Fabrication of inverted bulk heterojunction organic solar cells based on conjugated P3HT:PCBM using various thicknesses of ZnO buffer layer

    by M.Z. Sahdan, M.F. Malek, M.S. Alias, S.A. Kamaruddin, C.A. Norhidayah, N. Sarip, N. Nafarizal, M. Rusop


  • A Study on the role of solvent on properties of GdxZn1xO films synthesized by sol-gel method

    by C.A Norhidayah, S.A Kamaraddin, N. Nafarizal, M.Z Sahdan, A.R Nuralfadzilah, S.N.M Tawil

    The increasing demand for high-performance and low cost optoelectronic devices motivates many researchers to develop more efficient transparent conductive oxide (TCO) films. Among the popular TCOs, the past decade has seen the emergence of zinc oxide (ZnO) as one of the potential materials for the fabrication of transparent conductive electrodes. The aim of this work is to study the influence of different solvents on the properties of Gd x Zn 1-x O (x ≤ 0.01) films synthesized by sol-gel spin coating technique. Consequently, three different solutions were prepared with different solvents [2-Methoxyethanol (2-ME), ethanol (EtOH) and isopropanol (IPA)]. The structural, surface roughness and optical properties were investigated using an X-ray diffractometer (XRD, PANanalytical xpert-pro), atomic force microscope (AFM, Park XE-100) and ultra violet-visible spectrophotometer (UV-Vis, Shimadzu UV 1800), respectively. As a result, all films were found to have polycrystalline with hexagonal wurtzite structure. In addition, AFM analysis revealed that the film synthesized using EtOH exhibiting the smallest surface roughness of about 4.12 nm compared with IPA and 2-ME of about 5.12 nm and 12.22 nm, respectively. Also, the optical transmittance spectra indicate that all films exhibit good transparency in the visible spectral range with an average transmission of approximately 97.5%, 97.2% and 96.1% for EtOH, IPA and 2-ME, respectively. The optical band gap energy (Eg) values was estimated to be around 3.26 ~ 3.30 eV using Tauc's model with the lowest value for IPA (3.26 eV) and highest for 2-ME (3.30 eV). In a nutshell, the solvents are playing a key role for controlling the growth and nucleation in the preparation of Gd x Zn 1-x O solution and it strongly affects the properties of the film.

  • Physical and optical studies on ZnO films by SOL-GEL

    by A. R. Nurulfadzilah, S. N. M. Tawil, C. A. Norhidayah, N. Nafarizal, M. Z. Sahdan

    Zinc oxide (ZnO) is a new material used in electronics applications such as spintronics, diluted magnetic semiconductor (DMS) and thin films. In this paper, the findings in fabrication and characterization of ZnO nanoparticles are reported. ZnO thin films were deposited onto glass substrates using a spin coating techniques at different pre-annealing temperatures. The optical transmittance measurement of the ZnO nanostructures was examined using an ultraviolet-visible spectrophotometer (UV-Vis) with wavelength ranging from 300-800 nm. On the other hand, the topography and film roughness were, measured by an atomic force microscope (AFM). The surface morphologies was obtained using a field emission scanning electron microscope (FESEM) and showed that the ZnO nanoparticles are distributed uniformly.


  • Performance of P3HT:PCBM Organic Solar Cell with ZnO Buffer Layer

    by M.S Alias, Sharul Ashikin Kamaruddin, Che Ani Norhidayah, Nurulnadia Sarip, Nafarizal Nayan, Sahdan Mohd Zainizan

    In this paper, we explore the characteristics of bulk heterojunction solar cell based on poly (3-hexyl thiophene) [P3HT] and [6,6]-phenyl-C61-butyric acid methyl ester [PCBM] by introducing a buffer layer with device configuration of ITO/ZnO/P3HT:PCBM/Au. Nanostructured ZnO with individual diameter around 20-50 nm was used as the buffer layer and its effects on the short circuit current density, Jsc and open circuit voltage, Voc were investigated. It was found that, the electrical characteristic of the organic solar cell was obviously changed by introducing the buffer layer. Solar cell characteristic with Voc of 0.3939 V was obtained but the Jsc was very small. The surface topology of the P3HT:PCBM was investigated using an atomic force microscopy (AFM). ZnO nanoparticles were observed using a field emission scanning electron microscope (FESEM) and the electrical properties of the solar cell was measured using a solar simulator with a current – voltage (I-V) measurement system.


  • Effects of Ageing Time of ZnO Sol on Properties of ZnO Films by Sol Gel Spin Coating

    by Che Ani Norhidayah, Sharul Ashikin Kamaruddin, Nafarizal Nayan, Siti Nooraya Mohd Tawil, Mohd Zainizan Sahdan

    In recent years, there are many techniques developed to synthesize zinc oxide (ZnO) films. However, among the synthesis methods available, sol-gel has the most advantageous which offers cost effective features. In the present work, ZnO films were prepared by solgel spin coating technique. The effects of solution ageing times which varies at 2h 15 min, 3h 30 min and 24h were investigated. The structural, morphological and optical properties were studied using an x-ray diffractometer (XRD, Bruker D8 Advance), atomic force microscope (AFM, Tenko XE-100) and ultra violet-visible spectrophotometer (UV-Vis, Shimadzu UV 1800), respectively. Based on the XRD measurement, it was revealed that ZnO films were polycrystalline with hexagonal wurtzite structure. The crystallite size is in the range of 34.4 ~ 28 nm which decreased with ageing time increment. On the other hand, the AFM analysis revealed that the surface roughness of the films increased due to the increment of ageing times. Optical transmittance spectra indicate that all films were transparent (>75%) in the visible range which slightly improved with increasing of ageing times. The optical band gap was estimated to be around 3.24 ~3.26 eV using Taucs plot. We revealed that the ageing time of ZnO sol influenced the material properties of ZnO films. Based on our finding we proposed that 24h ageing time is optimum for the fabrication of high quality ZnO films.