Gobburu S. Kumar
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Gobburu S. Kumar has a total of 44 co-authors. Here are the top co-authors by number of shared publications:
- Guduru Prasad
Materials Research Laboratory, Department of Physics, Osmania University, Hyderabad 500 007, India
12 shared publications S V Suryanarayana
Osmania University
6 shared publicationsT Bhimasankaram
Osmania University
5 shared publicationsA Srinivas
Osmania University
3 shared publicationsM Mahesh Kumar
Osmania University
3 shared publications- Muga Vithal
Department of Chemistry, Osmania University, Hyderabad, India
3 shared publications
Latest Publications
- 13 August 2015
- Published by Springer Nature in Journal of Materials Science: Materials in Electronics
- Vol. 26 (11) , 9122-9133
Impedance analysis and dielectric properties of Ce modified bismuth titanate lead free ceramics synthesized using solution combustion route
- 13 August 2015
- Published by Springer Nature in Journal of Materials Science: Materials in Electronics
- Vol. 26 (11) , 9122-9133
Impedance analysis and dielectric properties of Ce modified bismuth titanate lead free ceramics synthesized using solution combustion route
- 1 June 2015
- Published by Taylor & Francis in Ferroelectrics
- Vol. 481 (1) , 89-97
Temperature and Stress Induced Electromechanical Coupling in Relaxor Ferroelectric Compounds
Temperature and stress induced electromechanical coupling studies were carried out for relaxor ferroelectric ceramics Ba(NdxTi(1-2x)Nbx)O3, Ba(NdyTi(1-2y)Nby)O3 and [Ba(Nd0.1Ti0.8Nb0.1)O3](1-z)[Na0.5Bi0.5TiO3]z. The thickness mode of electromechanical coupling and effective electromechanical coupling factors obtained from capacitance measurements were in the range 0.40–0.78 depending up on the compound, its composition and temperature. From modulus measurements the thickness and effective mode of electromechanical coupling factors obtained are in the range 0.9960–0.9998 depending up on the composition z.
- 1 June 2015
- Published by Taylor & Francis in Ferroelectrics
- Vol. 481 (1) , 89-97
Temperature and Stress Induced Electromechanical Coupling in Relaxor Ferroelectric Compounds
Temperature and stress induced electromechanical coupling studies were carried out for relaxor ferroelectric ceramics Ba(NdxTi(1-2x)Nbx)O3, Ba(NdyTi(1-2y)Nby)O3 and [Ba(Nd0.1Ti0.8Nb0.1)O3](1-z)[Na0.5Bi0.5TiO3]z. The thickness mode of electromechanical coupling and effective electromechanical coupling factors obtained from capacitance measurements were in the range 0.40–0.78 depending up on the compound, its composition and temperature. From modulus measurements the thickness and effective mode of electromechanical coupling factors obtained are in the range 0.9960–0.9998 depending up on the composition z.
- 1 November 2014
- Published by Horizon Research Publishing Co., Ltd. in Universal Journal of Electrical and Electronic Engineering
- Vol. 2 (8) , 320-327
Electrical Measurements on Musa Acuminata Colla
Typical Electrical feature of Musa acuminata colla (common name of commercially available banana) peel was identified as inhomogeneous lossy-dielectric. Considering in this direction, detailed impedance analysis was made at room temperature in the frequency range of 0.001 Hz to 1 M Hz. Impedance relaxation was well-fitted into Gaussian curves. The complex impedance plot, associated with two depressed semicircles, indicates Warburg-diffusion phenomenon. Randles's plot and frequency vs. admittance plot confirm the same. The results were corroborated by Jonscher's Universal law for better understanding of the inhibitor (corrosion-free) nature of the banana-peel.
- 1 November 2014
- Published by Horizon Research Publishing Co., Ltd. in Universal Journal of Electrical and Electronic Engineering
- Vol. 2 (8) , 320-327
Electrical Measurements on Musa Acuminata Colla
Typical Electrical feature of Musa acuminata colla (common name of commercially available banana) peel was identified as inhomogeneous lossy-dielectric. Considering in this direction, detailed impedance analysis was made at room temperature in the frequency range of 0.001 Hz to 1 M Hz. Impedance relaxation was well-fitted into Gaussian curves. The complex impedance plot, associated with two depressed semicircles, indicates Warburg-diffusion phenomenon. Randles's plot and frequency vs. admittance plot confirm the same. The results were corroborated by Jonscher's Universal law for better understanding of the inhibitor (corrosion-free) nature of the banana-peel.
- 1 January 2013
- Published by Taylor & Francis in Ferroelectrics
- Vol. 445 (1) , 121-135
Effect of Simultaneous Substitution of Sm and Pr Ions on Dielectric and Ferroelectric Properties of Strontium Bismuth Titanate
Sr Smx Bi(4−x) Ti(4−y) Pry O15 (for x = 0, y = 0 and x = 0.1, y = 0, 0.1 and 0.2 and also for x = 0.2, y = 0.1) ceramics were prepared by Sol-gel Pechni method. Single phase of compounds was confirmed by XRD analysis and Lattice parameters were calculated. Microstructure and chemical analysis were performed using SEM and EDS techniques. The effect of addition of Sm3+ and Pr3+ ions on dielectric and polarization properties of Sr Bi4 Ti4 O15 was studied and shift in transition temperature was observed. The dc conductivity of the samples measured as a function of temperature.
- 1 January 2013
- Published by Taylor & Francis in Ferroelectrics
- Vol. 445 (1) , 121-135
Effect of Simultaneous Substitution of Sm and Pr Ions on Dielectric and Ferroelectric Properties of Strontium Bismuth Titanate
Sr Smx Bi(4−x) Ti(4−y) Pry O15 (for x = 0, y = 0 and x = 0.1, y = 0, 0.1 and 0.2 and also for x = 0.2, y = 0.1) ceramics were prepared by Sol-gel Pechni method. Single phase of compounds was confirmed by XRD analysis and Lattice parameters were calculated. Microstructure and chemical analysis were performed using SEM and EDS techniques. The effect of addition of Sm3+ and Pr3+ ions on dielectric and polarization properties of Sr Bi4 Ti4 O15 was studied and shift in transition temperature was observed. The dc conductivity of the samples measured as a function of temperature.
- 1 January 2011
- Published by Taylor & Francis in Ferroelectrics
- Vol. 413 (1) , 357-370
Synthesis and Dielectric Properties of Novel BaBi x Ti 1-x O 3-? Ceramics
Novel polycrystalline materials of bismuth substituted barium titanate, namely, BaBixTi1-xO3-δ , (x = 0.025, 0.075, 0.125 and 0.175) was prepared by sol-gel chemical route and characterized by X-ray diffraction and scanning electron microscopy. Bismuth ion was added in place of titanium of B-site of ABO3 perovskite structure and both the site-balance as well as charge-balance was considered. The substitution of bismuth for Ti-site is clearly seen in both the XRD as well as IR spectroscopic data. Dielectric and impedance analysis were also made on the present novel ceramics. The above mentioned substitution involves ionic compensation, through creation of cation vacancies and is explained by proposing the defect dynamics. The results were corroborated with dielectric and complex impedance analysis for further understanding of ionic motion in this kind of disordered diffused materials.
- 1 January 2011
- Published by Taylor & Francis in Ferroelectrics
- Vol. 413 (1) , 357-370
Synthesis and Dielectric Properties of Novel BaBi x Ti 1-x O 3-? Ceramics
Novel polycrystalline materials of bismuth substituted barium titanate, namely, BaBixTi1-xO3-δ , (x = 0.025, 0.075, 0.125 and 0.175) was prepared by sol-gel chemical route and characterized by X-ray diffraction and scanning electron microscopy. Bismuth ion was added in place of titanium of B-site of ABO3 perovskite structure and both the site-balance as well as charge-balance was considered. The substitution of bismuth for Ti-site is clearly seen in both the XRD as well as IR spectroscopic data. Dielectric and impedance analysis were also made on the present novel ceramics. The above mentioned substitution involves ionic compensation, through creation of cation vacancies and is explained by proposing the defect dynamics. The results were corroborated with dielectric and complex impedance analysis for further understanding of ionic motion in this kind of disordered diffused materials.
- 12 August 2009
- Published by Taylor & Francis in Ferroelectrics
- Vol. 386 (1) , 22-35
Impedance and Pyroelectric Measurements on Dy 0.75 Bi 3.25 Ti 2.9625 Nb 0.03 O 12 Ceramics
Tri (Dy 3 + ) and pentavalent (Nb+5) modified new polycrystalline material of Aurivillius family (Dy 0.75 Bi 3.25 Ti 2.9625 Nb 0.03 O 12 ) was prepared by solid-state reaction method and the lattice parameters were calculated by using X-ray diffractogram. Impedance measurements were carried out from room temperature to 500°C in the frequency range of 100 Hz to 1 M Hz. Impedance spectroscopic plots show non-Debye type and detailed ac-conductivity analysis was also employed to understand the heterogeneity of the present electro-ceramics. The results were corroborated with the proposed defect formula and in addition, thermal stimulated current measurements show that the present sample has an excellent pyroelectric response.
- 12 August 2009
- Published by Taylor & Francis in Ferroelectrics
- Vol. 386 (1) , 22-35
Impedance and Pyroelectric Measurements on Dy 0.75 Bi 3.25 Ti 2.9625 Nb 0.03 O 12 Ceramics
Tri (Dy 3 + ) and pentavalent (Nb+5) modified new polycrystalline material of Aurivillius family (Dy 0.75 Bi 3.25 Ti 2.9625 Nb 0.03 O 12 ) was prepared by solid-state reaction method and the lattice parameters were calculated by using X-ray diffractogram. Impedance measurements were carried out from room temperature to 500°C in the frequency range of 100 Hz to 1 M Hz. Impedance spectroscopic plots show non-Debye type and detailed ac-conductivity analysis was also employed to understand the heterogeneity of the present electro-ceramics. The results were corroborated with the proposed defect formula and in addition, thermal stimulated current measurements show that the present sample has an excellent pyroelectric response.
- 1 December 2007
- Published by Springer Nature in Journal of Materials Science
- Vol. 42 (24) , 10275-10283
Impedance spectroscopy and conductivity studies on B site modified (Na0.5Bi0.5)(NdxTi1 − 2xNbx)O3 ceramics
- 1 December 2007
- Published by Springer Nature in Journal of Materials Science
- Vol. 42 (24) , 10275-10283
Impedance spectroscopy and conductivity studies on B site modified (Na0.5Bi0.5)(NdxTi1 − 2xNbx)O3 ceramics
- 1 August 2006
- Published by Springer Nature in Bulletin of Materials Science
- Vol. 29 (4) , 347-355
Impedance and a.c. conductivity studies on Ba(Nd0.2Ti0.6Nb0.2)O3 ceramic prepared through conventional and microwave sintering route
- 1 August 2006
- Published by Springer Nature in Bulletin of Materials Science
- Vol. 29 (4) , 347-355
Impedance and a.c. conductivity studies on Ba(Nd0.2Ti0.6Nb0.2)O3 ceramic prepared through conventional and microwave sintering route
- 1 February 2006
- Published by Springer Nature in Bulletin of Materials Science
- Vol. 29 (1) , 35-41
Electrical conduction in (Na0.125Bi0.125 Ba0.65Ca0.1)(Nd0.065Ti0.87Nb0.065)O3 ceramic)O3 ceramic
- 1 February 2006
- Published by Springer Nature in Bulletin of Materials Science
- Vol. 29 (1) , 35-41
Electrical conduction in (Na0.125Bi0.125 Ba0.65Ca0.1)(Nd0.065Ti0.87Nb0.065)O3 ceramic)O3 ceramic
- 30 November 2005
- Published by Elsevier in Solid State Ionics
- Vol. 176 (37-38) , 2701-2710
Preparation, characterization and impedance study of AgTaMP3O12 (M=Al, Ga, In, Cr, Fe and Y)
- 30 November 2005
- Published by Elsevier in Solid State Ionics
- Vol. 176 (37-38) , 2701-2710
Preparation, characterization and impedance study of AgTaMP3O12 (M=Al, Ga, In, Cr, Fe and Y)