Anatoliy A. Tunik
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Anatoliy A. Tunik has a total of 27 co-authors. Here are the top co-authors by number of shared publications:
- Vladimir B. Larin
S. P. Timoshenko Institute of Mechanics, National Academy of Sciences of Ukraine, Kyiv, Ukraine
12 shared publications - Olha Sushchenko
National University «Kyiv Aviation Institute», Ukraine
5 shared publications - Valerii Azarskov
National Aviation University, Kyiv
2 shared publications B. Yu. Mandrovskii-Sokolov
1 shared publicationE. V. Vyshnyakova
Scientific and Education Center “Aerospace Center”, National Aviation University, Kiev, Ukraine
1 shared publicationElena A. Abramovich
1 shared publication
Latest Publications
- 1 March 2022
- Published by Springer Nature in International Applied Mechanics
- Vol. 58 (2) , 208-218
Onboard Stabilization of the Information and Measurement System in the Double Gimbal Suspension of Aircraft
- 1 March 2022
- Published by Springer Nature in International Applied Mechanics
- Vol. 58 (2) , 208-218
Onboard Stabilization of the Information and Measurement System in the Double Gimbal Suspension of Aircraft
- Open Access
- 21 December 2021
- Published by State University "Kyiv Aviation Institute" in Electronics and Control Systems
- Vol. 3 (69) , 48-55
On Features of Planning Trajectories for Quadrotors
The paper deals with studying the process of planning trajectories during the quadrotor flight. The typical trajectories of the drone flights have been analyzed. Block diagram of the control system in the nonholonomic case and the horizontal flight is given. Comparative analysis of the most widespread trajectories is represented. The possibility to use two types of Dubins trajectory is analysed. Introducing polar coordinates for forming flight trajectories is proposed. The grounded choice of the quadrotor trajectories for different cases of the holonomic and nonholonomic closed-loop control systems was proposed. The advantages and disadvantages of the trajectories planning in each of these cases were analyzed. The Simulink models for generators of the quadrotor trajectories have been developed. The simulation results of generations of these trajectories have been represented. The possibilities of MATLAB for simulating flight trajectories are shown. The obtained results can be applied for unmanned aerial vehicles of different types.
- 21 December 2021
- Published by State University "Kyiv Aviation Institute" in Electronics and Control Systems
- Vol. 3 (69) , 48-55
Open AccessOn Features of Planning Trajectories for Quadrotors
The paper deals with studying the process of planning trajectories during the quadrotor flight. The typical trajectories of the drone flights have been analyzed. Block diagram of the control system in the nonholonomic case and the horizontal flight is given. Comparative analysis of the most widespread trajectories is represented. The possibility to use two types of Dubins trajectory is analysed. Introducing polar coordinates for forming flight trajectories is proposed. The grounded choice of the quadrotor trajectories for different cases of the holonomic and nonholonomic closed-loop control systems was proposed. The advantages and disadvantages of the trajectories planning in each of these cases were analyzed. The Simulink models for generators of the quadrotor trajectories have been developed. The simulation results of generations of these trajectories have been represented. The possibilities of MATLAB for simulating flight trajectories are shown. The obtained results can be applied for unmanned aerial vehicles of different types.
- Open Access
- 16 September 2020
- Published by Wiley in International Journal of Aerospace Engineering
- Vol. 2020, 1-9
Design of Composite Feedback and Feedforward Control Law for Aircraft Inertially Stabilized Platforms
The design of the control systems of the inertially stabilized platforms (ISPs) as part of airborne equipment for the majority of aircraft has its peculiarity. The presence of rate gyros in the inertial measurement unit gives the possibility to measure the rotation rate of the ISP base, which is the main disturbance interfering with the ISP accuracy. Inclusion of the feedforward disturbance gain in the control law with the simplest PI feedback significantly improves the accuracy of stabilization by the invariance theory. A combination of feedback and feedforward controllers produces a synergetic effect, thus, improving ISP accuracy. This article deals with the design of the airborne ISP control systems consisting of two stages: the parametric optimization of the PI feedback control based on composite “performance-robustness” criterion and the augmentation of the obtained system with feedforward gain. To prove the efficiency of the proposed control laws, the simulation of the ISP was undertaken. We have used a simulation of the heading-hold system of the commuter aircraft Beaver and the yaw rate output of this closed-loop system we have used as a source of the disturbance. The results of modeling proved the efficiency of the proposed design method.
- 16 September 2020
- Published by Wiley in International Journal of Aerospace Engineering
- Vol. 2020, 1-9
Open AccessDesign of Composite Feedback and Feedforward Control Law for Aircraft Inertially Stabilized Platforms
The design of the control systems of the inertially stabilized platforms (ISPs) as part of airborne equipment for the majority of aircraft has its peculiarity. The presence of rate gyros in the inertial measurement unit gives the possibility to measure the rotation rate of the ISP base, which is the main disturbance interfering with the ISP accuracy. Inclusion of the feedforward disturbance gain in the control law with the simplest PI feedback significantly improves the accuracy of stabilization by the invariance theory. A combination of feedback and feedforward controllers produces a synergetic effect, thus, improving ISP accuracy. This article deals with the design of the airborne ISP control systems consisting of two stages: the parametric optimization of the PI feedback control based on composite “performance-robustness” criterion and the augmentation of the obtained system with feedforward gain. To prove the efficiency of the proposed control laws, the simulation of the ISP was undertaken. We have used a simulation of the heading-hold system of the commuter aircraft Beaver and the yaw rate output of this closed-loop system we have used as a source of the disturbance. The results of modeling proved the efficiency of the proposed design method.
- 1 March 2020
- Published by Springer Nature in International Applied Mechanics
- Vol. 56 (2) , 170-175
Avoiding Switching Upon Failure of a Sensor in the Lateral Control System of a Quadcopter
- 1 March 2020
- Published by Springer Nature in International Applied Mechanics
- Vol. 56 (2) , 170-175
Avoiding Switching Upon Failure of a Sensor in the Lateral Control System of a Quadcopter
- 1 October 2019
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 112-116
LMI-based Synthesis of Quadrotor Guidance and Control System
The problem of quadrotor guidance and control system synthesis based on Linear Matrix Inequalities approach is considered in this paper. Extended quadrotor's mathematical model is proposed, which takes into account the inertia of its motors. Due to the additional state variable appeared in the quadrotor's mathematical model, which is not measured in practice, it became impossible to apply the linear quadratic regulator approach that is quite simple for practical implementation. The chosen Linear Matrix Inequalities approach produces control laws as static output feedback and guarantees H-infinity rejection of external disturbances. The synthesis of the quadrotor control system based on the parametrization of all stabilizing H-infinity static output feedback is presented. The transient processes for one of the quadrotor's axis motion control illustrate the efficiency of proposed control law. Taking into account the symmetry of quadrotor, the same static output feedback coefficients were used for another axis. The simulation results of the quadrotor guidance for the circular reference track following in a horizontal plane for the cases of calm and perturbed atmosphere confirmed that proposed control laws were appropriate.
- 1 October 2019
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 112-116
LMI-based Synthesis of Quadrotor Guidance and Control System
The problem of quadrotor guidance and control system synthesis based on Linear Matrix Inequalities approach is considered in this paper. Extended quadrotor's mathematical model is proposed, which takes into account the inertia of its motors. Due to the additional state variable appeared in the quadrotor's mathematical model, which is not measured in practice, it became impossible to apply the linear quadratic regulator approach that is quite simple for practical implementation. The chosen Linear Matrix Inequalities approach produces control laws as static output feedback and guarantees H-infinity rejection of external disturbances. The synthesis of the quadrotor control system based on the parametrization of all stabilizing H-infinity static output feedback is presented. The transient processes for one of the quadrotor's axis motion control illustrate the efficiency of proposed control law. Taking into account the symmetry of quadrotor, the same static output feedback coefficients were used for another axis. The simulation results of the quadrotor guidance for the circular reference track following in a horizontal plane for the cases of calm and perturbed atmosphere confirmed that proposed control laws were appropriate.
- 1 October 2018
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 83-89
Simplified Path Tracking Control Laws for Quad-rotor Considered as Nonholonomic System
The problem of the quad-rotor guidance system based on the control of the quad-rotor instantaneous velocity vector with simultaneous its stabilization on the given reference track is considered in this paper. One of the ultimate goals of this paper is the elaboration of the guidance control system with simplified structure at the cost of some attenuation of system's accuracy. That is why structure of this guidance system is based on the combination of the PD and LQR approaches. Two structures of guidance system were proposed: the circular path following system and linear piecewise path following system. The results of design were proved by simulation of these guidance systems during flights in the calm and perturbed atmosphere.
- 1 October 2018
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 83-89
Simplified Path Tracking Control Laws for Quad-rotor Considered as Nonholonomic System
The problem of the quad-rotor guidance system based on the control of the quad-rotor instantaneous velocity vector with simultaneous its stabilization on the given reference track is considered in this paper. One of the ultimate goals of this paper is the elaboration of the guidance control system with simplified structure at the cost of some attenuation of system's accuracy. That is why structure of this guidance system is based on the combination of the PD and LQR approaches. Two structures of guidance system were proposed: the circular path following system and linear piecewise path following system. The results of design were proved by simulation of these guidance systems during flights in the calm and perturbed atmosphere.
- 1 October 2018
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 279-282
Experimental Investigation of Multi-GNSS in Static Mode
Due to the numerous beneficial features quadrotors possess, such as high maneuverability, low flying speed, an ability to perform vertical take-off and landing, slow precise movements and hovering, they attract attention of researchers and designers worldwide. Development of reliable autopilot is one of the core challenges they face. Simulation and modeling constitute an important part in system development. The paper presents practical use of the SITL and FlightGear simulators for studying the quad-rotor dynamics and control algorithms. In the proposed approach a part of the SITL codes have been substituted by the own ones, responsible for the quad-rotor control through sending separate PWM signals per each engine. The results of quad-rotor control in simulator are presented for two cases: hovering and motions along specified heading.
- 1 October 2018
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 279-282
Experimental Investigation of Multi-GNSS in Static Mode
Due to the numerous beneficial features quadrotors possess, such as high maneuverability, low flying speed, an ability to perform vertical take-off and landing, slow precise movements and hovering, they attract attention of researchers and designers worldwide. Development of reliable autopilot is one of the core challenges they face. Simulation and modeling constitute an important part in system development. The paper presents practical use of the SITL and FlightGear simulators for studying the quad-rotor dynamics and control algorithms. In the proposed approach a part of the SITL codes have been substituted by the own ones, responsible for the quad-rotor control through sending separate PWM signals per each engine. The results of quad-rotor control in simulator are presented for two cases: hovering and motions along specified heading.
- 1 March 2018
- Published by Springer Nature in International Applied Mechanics
- Vol. 54 (2) , 239-247
A Flight Control System for Small Unmanned Aerial Vehicle
- 1 March 2018
- Published by Springer Nature in International Applied Mechanics
- Vol. 54 (2) , 239-247
A Flight Control System for Small Unmanned Aerial Vehicle
- 1 October 2017
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 175-179
Robust digital gain-scheduling control of the UAV altitude
Design of the small unmanned aerial vehicle altitude-hold autopilot for the entire flight envelope on a basis of the robust gain-scheduling control is considered. As far as flights are performed within restricted altitude range, the entries of the matrices of the state-space unmanned aerial vehicle model are assumed to be functions of the true air speed only. So the real time true air speed measurement by airborne air data system is used for gain-scheduling of the altitude control system. The gain scheduled static output feedback was applied as the simplest implementation of altitude control system for unmanned aerial vehicle. For numerical implementation of the design procedure, the mathematical model of the Aerosonde flight dynamics was used as the test-bed. The full range of true air speed for the Aerosonde flight envelope was divided by 6 sub-ranges. The static output feedback parameters for each sub-range were determined by linear matrix inequalities approach for discrete systems, which produces the suboptimal robust controller. Continuous gain-scheduling of the static output feedback gains was achieved by usage of simple Lagrange interpolation between true air speed sub-ranges. The efficiency of this approach was proved by simulation of the control processes in Simulink.
- 1 October 2017
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 175-179
Robust digital gain-scheduling control of the UAV altitude
Design of the small unmanned aerial vehicle altitude-hold autopilot for the entire flight envelope on a basis of the robust gain-scheduling control is considered. As far as flights are performed within restricted altitude range, the entries of the matrices of the state-space unmanned aerial vehicle model are assumed to be functions of the true air speed only. So the real time true air speed measurement by airborne air data system is used for gain-scheduling of the altitude control system. The gain scheduled static output feedback was applied as the simplest implementation of altitude control system for unmanned aerial vehicle. For numerical implementation of the design procedure, the mathematical model of the Aerosonde flight dynamics was used as the test-bed. The full range of true air speed for the Aerosonde flight envelope was divided by 6 sub-ranges. The static output feedback parameters for each sub-range were determined by linear matrix inequalities approach for discrete systems, which produces the suboptimal robust controller. Continuous gain-scheduling of the static output feedback gains was achieved by usage of simple Lagrange interpolation between true air speed sub-ranges. The efficiency of this approach was proved by simulation of the control processes in Simulink.
- 1 May 2017
- Published by Springer Nature in International Applied Mechanics
- Vol. 53 (3) , 342-348
On Problem of Synthesis of Control System for Quadrocopter
- 1 May 2017
- Published by Springer Nature in International Applied Mechanics
- Vol. 53 (3) , 342-348
On Problem of Synthesis of Control System for Quadrocopter