Nilanjan Halder
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Nilanjan Halder has a total of 109 co-authors. Here are the top co-authors by number of shared publications:
S. Chakrabarti
13 shared publications- Subhananda Chakrabarti
Department of Electrical Engineering, Indian Institute of Technology Bombay, Mumbai, India
9 shared publications S. Sengupta
Dept. of Electrical Engineering, Center for Nanoelectronics, Indian Institute of Technology Bombay, Powai, Mumbai 400076, Maharashtra, India
8 shared publicationsPrarbdh Bhatt
6 shared publications- Miriam Herrera
Departamento de Ciencia de los Materiales e Ingeniería Metalúrgica y Química Inorgánica, IMEYMAT Universidad de Cádiz, Campus Río San Pedro Cádiz Spain
4 shared publications - Nigel D. Browning
University of Liverpool
4 shared publications
Latest Publications
- Open Access
- 27 May 2026
- Published by Springer Nature in Scientific Reports
- Vol. 16 (1)
Optimization of Material and Bandgap Engineering for Distinctive Layers in Perovskite Solar Cells
The Perovskite-rooted solar cell is a promising candidate to lead the future solar cell industry. Efficiency of perovskite solar cell strongly relies on the thickness and each material's properties. The present research aims at a systematic study of both material and bandgap optimization for each layer to obtain higher efficiency of the device. The comparative analysis of perovskite material with different halide ions exhibits that CH3NH3PbX3 [where X: I] offers the highest efficiency due to an appropriate bandgap. CH3NH3PbI3 based device is proved as the most promising candidate. The current study also demonstrates device-level integration and co-optimization of MASnBr3 and Cd0.5Zn0.5S combination as HTL and ETL layers respectively, along with dual role of ZnO as transparent electrode and encapsulation layer. (300 nm)ZnO/(50 nm)Cd0.5Zn0.5S/IDL/(850 nm)CH3NH3PbI3/IDL/(350 nm)MASnBr3 architecture exhibits best performance, achieving power conversion efficiency (PCE) of 27.12%, a short-circuit current density (JSC) of 25.34 mA/cm2, an open-circuit voltage (VOC) of 1.196 V and the fill factor of 89.50%.
- 27 May 2026
- Published by Springer Nature in Scientific Reports
- Vol. 16 (1)
Open AccessOptimization of Material and Bandgap Engineering for Distinctive Layers in Perovskite Solar Cells
The Perovskite-rooted solar cell is a promising candidate to lead the future solar cell industry. Efficiency of perovskite solar cell strongly relies on the thickness and each material's properties. The present research aims at a systematic study of both material and bandgap optimization for each layer to obtain higher efficiency of the device. The comparative analysis of perovskite material with different halide ions exhibits that CH3NH3PbX3 [where X: I] offers the highest efficiency due to an appropriate bandgap. CH3NH3PbI3 based device is proved as the most promising candidate. The current study also demonstrates device-level integration and co-optimization of MASnBr3 and Cd0.5Zn0.5S combination as HTL and ETL layers respectively, along with dual role of ZnO as transparent electrode and encapsulation layer. (300 nm)ZnO/(50 nm)Cd0.5Zn0.5S/IDL/(850 nm)CH3NH3PbI3/IDL/(350 nm)MASnBr3 architecture exhibits best performance, achieving power conversion efficiency (PCE) of 27.12%, a short-circuit current density (JSC) of 25.34 mA/cm2, an open-circuit voltage (VOC) of 1.196 V and the fill factor of 89.50%.
- 29 December 2025
- Published by Elsevier in Ceramics International
- Vol. 52 (6) , 7279-7289
Tuning the morphology and defect density of Mg(OH)2 nanoplatelets through microwave-assisted wet synthesis for photocatalytic applications
- 29 December 2025
- Published by Elsevier in Ceramics International
- Vol. 52 (6) , 7279-7289
Tuning the morphology and defect density of Mg(OH)2 nanoplatelets through microwave-assisted wet synthesis for photocatalytic applications
- 25 November 2025
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Photonics Technology Letters
- Vol. 38 (5) , 325-328
Enhanced NIR Modulation of GLAD-Deposited VO 2 Nanocolumns for Smart Radiative Applications
This letter presents a comparative study of phase transition behaviour and near-infrared (NIR) regulation of vanadium dioxide (VO2) thin films (TFs) and nanocolumnar (NC) structures fabricated via glancing angle deposition (GLAD) using electron-beam evaporation. Optical reflectance spectra demonstrate enhanced and reverse NIR modulation and suppressed specular interference in NCs compared to TFs. Raman spectroscopic analysis confirms the formation of monoclinic (M1) VO2 in both morphologies, while in NCs partial stabilization of the rutile (R) phase at room temperature is observed. Reduction in transition temperature, Tc ( $\sim 4~^{\circ }$ C) and hysteresis width ( $\Delta $ Tc) is confirmed from both temperature dependent optical and electrical studies. These findings offer an alternative approach for the development of smart radiative devices and other optoelectronic and thermochromic applications by nano-architecting of VO2 using GLAD.
- 25 November 2025
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Photonics Technology Letters
- Vol. 38 (5) , 325-328
Enhanced NIR Modulation of GLAD-Deposited VO 2 Nanocolumns for Smart Radiative Applications
This letter presents a comparative study of phase transition behaviour and near-infrared (NIR) regulation of vanadium dioxide (VO2) thin films (TFs) and nanocolumnar (NC) structures fabricated via glancing angle deposition (GLAD) using electron-beam evaporation. Optical reflectance spectra demonstrate enhanced and reverse NIR modulation and suppressed specular interference in NCs compared to TFs. Raman spectroscopic analysis confirms the formation of monoclinic (M1) VO2 in both morphologies, while in NCs partial stabilization of the rutile (R) phase at room temperature is observed. Reduction in transition temperature, Tc ( $\sim 4~^{\circ }$ C) and hysteresis width ( $\Delta $ Tc) is confirmed from both temperature dependent optical and electrical studies. These findings offer an alternative approach for the development of smart radiative devices and other optoelectronic and thermochromic applications by nano-architecting of VO2 using GLAD.
- 30 May 2025
- Published by Wiley in ChemistrySelect
- Vol. 10 (21)
Facile Hydrothermal Synthesis of Nb‐Doped WS 2 /WO 3 Nanostructures: Insights into Photoluminescence and Electronic Properties
A one‐pot hydrothermal synthesis of Nb‐doped WS 2 /WO 3 nanostructures (NS) has been reported. Enhanced photoluminescence (PL) is observed due to WO 3 phase coverage, which stabilizes surface and edge defects of WS 2 . Redshift in the UV–vis characteristics of the NS points to the tunable band gap of the material with increasing Nb dopant percentage. PL study of the NS illustrates that the emission property is responsible for the many‐body interaction of excitons at the Nb impurity introduced bound and resonant defect states near valence band of WS 2 and sub‐gap sulfur vacancy defect states. The NS exhibited type I band alignment between WS 2 /WO 3, which is crucial for optoelectronic photodetector devices. The reported synthesis strategy provides a cost‐effective way of producing tunable and stable WS 2 /WO 3 NS with enhanced emission properties, opening an avenue for designing electronic and optoelectronic devices and other functional applications.
- 30 May 2025
- Published by Wiley in ChemistrySelect
- Vol. 10 (21)
Facile Hydrothermal Synthesis of Nb‐Doped WS 2 /WO 3 Nanostructures: Insights into Photoluminescence and Electronic Properties
A one‐pot hydrothermal synthesis of Nb‐doped WS 2 /WO 3 nanostructures (NS) has been reported. Enhanced photoluminescence (PL) is observed due to WO 3 phase coverage, which stabilizes surface and edge defects of WS 2 . Redshift in the UV–vis characteristics of the NS points to the tunable band gap of the material with increasing Nb dopant percentage. PL study of the NS illustrates that the emission property is responsible for the many‐body interaction of excitons at the Nb impurity introduced bound and resonant defect states near valence band of WS 2 and sub‐gap sulfur vacancy defect states. The NS exhibited type I band alignment between WS 2 /WO 3, which is crucial for optoelectronic photodetector devices. The reported synthesis strategy provides a cost‐effective way of producing tunable and stable WS 2 /WO 3 NS with enhanced emission properties, opening an avenue for designing electronic and optoelectronic devices and other functional applications.
- 19 September 2024
- Published by Elsevier in Journal of Luminescence
- Vol. 277
Observation of anomalous excitonic emission in V-doped WS2 QDs synthesized by hydrothermal method and subsequent mechanical exfoliation
- 19 September 2024
- Published by Elsevier in Journal of Luminescence
- Vol. 277
Observation of anomalous excitonic emission in V-doped WS2 QDs synthesized by hydrothermal method and subsequent mechanical exfoliation
- 31 October 2023
- Published by Elsevier in Journal of Luminescence
- Vol. 266
Systematic improvement of excitonic features in hydrothermally synthesized WS2 due to post-synthesis drying
- 31 October 2023
- Published by Elsevier in Journal of Luminescence
- Vol. 266
Systematic improvement of excitonic features in hydrothermally synthesized WS2 due to post-synthesis drying
- 24 January 2023
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 133 (4) , 045302
Positive temperature coefficient of resistance of Mg-GeO2 nanowire array film
Here, glancing angle deposition is employed to synthesize the undoped GeO2 and Mg-doped (0.4 and 0.8 at. %) GeO2 nanowires (NWs) on a Si substrate. The microscopic images show the formation of the NW-like morphology of the grown materials. The gradual decrease in the average ratio of length to diameter depicts the worsening of the formation of NWs with the incorporation of Mg into the GeO2 host lattice. This also affects the crystallinity characteristics of the materials, which have been demonstrated from the selected area electron diffraction (SAED) pattern of the materials. The polycrystallinity nature of undoped GeO2 NWs changes to amorphous due to the introduction of Mg, which has been confirmed from both the obtained SAED and x-ray diffraction patterns of the samples. The presence of Mg was confirmed from the obtained broad bands at 473 and 437 cm−1 in the Fourier transmission spectrum of the doped samples. The increasing conductance with the temperature of Au/undoped GeO2 devices can be explained by the thermionic emission process, whereas the Mg-GeO2 device shows an overall decrease in conductance with increasing temperature. We have ascribed the origin of this abnormal conductance as the positive temperature coefficient of resistance, which is one of the first reports, due to the generation of random grain boundaries and enormous electron trapping at the Au/Mg-GeO2 NW junction. Furthermore, the undoped GeO2 NW device shows good temperature-dependent conductivity as well as stability compared to the doped one.
- 24 January 2023
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 133 (4) , 045302
Positive temperature coefficient of resistance of Mg-GeO2 nanowire array film
Here, glancing angle deposition is employed to synthesize the undoped GeO2 and Mg-doped (0.4 and 0.8 at. %) GeO2 nanowires (NWs) on a Si substrate. The microscopic images show the formation of the NW-like morphology of the grown materials. The gradual decrease in the average ratio of length to diameter depicts the worsening of the formation of NWs with the incorporation of Mg into the GeO2 host lattice. This also affects the crystallinity characteristics of the materials, which have been demonstrated from the selected area electron diffraction (SAED) pattern of the materials. The polycrystallinity nature of undoped GeO2 NWs changes to amorphous due to the introduction of Mg, which has been confirmed from both the obtained SAED and x-ray diffraction patterns of the samples. The presence of Mg was confirmed from the obtained broad bands at 473 and 437 cm−1 in the Fourier transmission spectrum of the doped samples. The increasing conductance with the temperature of Au/undoped GeO2 devices can be explained by the thermionic emission process, whereas the Mg-GeO2 device shows an overall decrease in conductance with increasing temperature. We have ascribed the origin of this abnormal conductance as the positive temperature coefficient of resistance, which is one of the first reports, due to the generation of random grain boundaries and enormous electron trapping at the Au/Mg-GeO2 NW junction. Furthermore, the undoped GeO2 NW device shows good temperature-dependent conductivity as well as stability compared to the doped one.
- Open Access
- 1 January 2023
- Published by AIP Publishing in AIP Conference Proceedings
- Vol. 2752 (1)
Structural and optical characteristics of Nb-doped WS2/WO3 QDs
Tunable band gap in different nanostructure forms is an interesting feature of transition metal dichalcogenides (TMDCs) like WS2, WSe2, MoS2, and MoSe2 etc. We, herein, report the synthesis of Nb doped WS2/WO2 hybrid quantum dots (QDs) by a facile hydrothermal method followed by solution-based probe sonication and centrifugation. The structural characteristics, surface morphology and elemental composition of the hydrothermally synthesized powder samples were investigated. The UV-Vis absorbance spectra of Nb doped WS2/WO2 QDs suggested a red shift in the absorption edge with increased doping percentage.
- 1 January 2023
- Published by AIP Publishing in AIP Conference Proceedings
- Vol. 2752 (1)
Open AccessStructural and optical characteristics of Nb-doped WS2/WO3 QDs
Tunable band gap in different nanostructure forms is an interesting feature of transition metal dichalcogenides (TMDCs) like WS2, WSe2, MoS2, and MoSe2 etc. We, herein, report the synthesis of Nb doped WS2/WO2 hybrid quantum dots (QDs) by a facile hydrothermal method followed by solution-based probe sonication and centrifugation. The structural characteristics, surface morphology and elemental composition of the hydrothermally synthesized powder samples were investigated. The UV-Vis absorbance spectra of Nb doped WS2/WO2 QDs suggested a red shift in the absorption edge with increased doping percentage.